This final thesis is performed on commission of Hargs Bruk Ltd. Hargs Bruk manages one of Sweden?s largest privately owned forests. A main part of the managed forest is situated in Roslagen in eastern Uppland. Since 1934 felling calculations have been performed within the estate every tenth year.

The Swedish Government has decided that Wind power should have a higher contribution to the electricity generation in Sweden. Their goal is that, by 2015, the yearly production by Wind power should generate 10 TWh. In year of 2006, the 760 wind mills in Sweden generated only 0,936 TWh. Despite good wind conditions in a large extend of Sweden's land- and coast areas, the slow rate of new wind mills establishments will likely result in unattainable goals. The major problem for new establishments of wind mills is the extensive and complicated permission process. An expert group of environmental studies (Expertgruppen för miljöstudier) was commissioned by the Government to make a report concerning the problems with the expansion of wind power in Sweden.

Sitka spruce (Picea sitchensis (Bong.) Carr) is just like Norway spruce (Picea abies) a species in thegenus picea. The natural range of Sitka spruce is a narrow strip along the west coast of North America. Itis the most coastal of all picea species, and very dependent on the mild and humid climate along thepacific coast.Sitka spruce has been grown a long time in the countries around the North Sea, particularly in GreatBritain where it currently is the most important species in British forestry. Sitka spruce has not beenplanted in Swedish forests to any large extent before the storm Gudrun in 2005. Several studies indicatethat the production of wood biomass is higher for Sitka spruce compared to Norway spruce.

Växande städer leder till att naturmark omvandlas till stadsmiljöer. Det skapar mer hårdgjorda ytor och därmed ökade volymer dagvatten som behöver hanteras. Modellering av dagvattennätet används ofta för att bedöma kapaciteten och risk för översvämningar. Avrinningsområdets storlek är en avgörande parameter för att bedöma hur mycket vatten som kommer till en viss ledning. Traditionellt har automatisk bestämning av avrinningsområden gjorts enbart utifrån topografin.

AbstractThis report intends through a case study to investigate if lightweight concrete isappropriate as main material in the outer wall of a seven storey residential building.A technical design is carried out in accordance with the definitions and requirementsfor passive houses, given by FEBY?s1 ?Demand specification for passive houses?.A literature review is also carried out for a comparison between regular bolt wall andlight weight concrete wall, with a focus on the safety of moisture.The lightweight concrete block used in the report is as a celblock produced by thecompany H+H Sweden AB.The methods used have resulted in compliance with requirements andrecommendations from authorities. Calculations of energy, noise and moisture riskassessment has been carried out.The work has resulted in the conclusion that the lightweight concrete itself is notable to isolate in the extent necessary to obtain chosen U-value of 0,1 W/m2 ° C,without getting to thick. Therefore additional insulation is needed. There are fewrelevant reference objects built with only light weight concrete.

This report presents suggestions and recommendations on how to convert an old industrial building, built in 1958, to an office hotel. One of the main criteria was that the floor plan should be flexible. The building is situated at Jonsereds Fabriker and the study was conducted for Hantverkslokaler i Göteborg AB, the estate owner.The survey is initiated with study visits at various office hotels, together with studies of literature regarding office planning. One conclusion from the study visits is that meeting-places, where the different companies can meet and exchange ideas and services, are important. Another one, and probably the most important parameter when planning offices is that they should have windows.

This thesis is an evaluation of a new design concept for statorfeets in Gallejaur hydro power plant. Founder of the work is Vattenfall AB Vattenkraft. During the 70- and 80´s nuclear power began to be phased in to the Swedish grid, which meant that hydropower became an important source of rules. The generators began running in so called intermittent operations instead of basic operations, which meant 300-600 start/stop per year instead of one-ten numbers start/stop per year. In order to deal with the thermal forces that arise at every start and stop suppliers began to mount so called sliding joints, which is to take advantage of these forces and maintain the stator shape.

I Jönköpings Län och då särskilt Jönköping som stad råder i dagsläget storbostadsbrist. Bostadsbolag och fastighetsägare vill få in fler bostäder på befintligafastigheter samt bygga nya bostäder för att få Jönköping att växa och bli något utavnavet i mitten av Sydsverige. Där har uppdragsgivaren till denna rapport, Vätterhem,en stor roll, som det i dagsläget största bostadsbolaget i Jönköpings Kommun.Vätterhem planerar en nyproduktion av upp till 800 lägenheter på ett stycke mark vidVätterns västra strand 1-2 km norr om Jönköping. Dessa 800 lägenheter fördelade påtvå etapper, 400 lägenheter per etapp. Denna rapport behandlar översiktligt ett förslagtill planerad bostadsbebyggelse på denna plats, då endast etapp ett (400 lägenheter).Utifrån en genomförd områdesinventering, där rådande förutsättningar, bebyggelseoch växtlighet inspekterades, har olika förslag diskuterats fram, varav två olikapresenteras i denna rapport.

AbstractThis report intends through a case study to investigate if lightweight concrete isappropriate as main material in the outer wall of a seven storey residential building.A technical design is carried out in accordance with the definitions and requirementsfor passive houses, given by FEBY?s1 ?Demand specification for passive houses?.A literature review is also carried out for a comparison between regular bolt wall andlight weight concrete wall, with a focus on the safety of moisture.The lightweight concrete block used in the report is as a celblock produced by thecompany H+H Sweden AB.The methods used have resulted in compliance with requirements andrecommendations from authorities. Calculations of energy, noise and moisture riskassessment has been carried out.The work has resulted in the conclusion that the lightweight concrete itself is notable to isolate in the extent necessary to obtain chosen U-value of 0,1 W/m2 ° C,without getting to thick. Therefore additional insulation is needed. There are fewrelevant reference objects built with only light weight concrete.

The aim of this paper was to study incoming complaints to The County Administrative Board in Västra Götaland during 2011 and examine if it was possible to see a connection between warranted and unwarranted complaints and informer, animal species and type of inadequate. In Västra Götaland, a complaint is classified as warranted if the inspection leads to a reprimand, whether it regards what was reported or not. Data were collected during three weeks through The County Administrative Board´s record system Platina and a total of 456 complaints were studied. The parameter ?complainant? was categorized into four groups according to The County Administrative Boards own division; public with the subgroups anonymous and non-anonymous, animal health staff and others.

Storm water management has become a more important matter as urban areas are expanding and natural areas are being exploited. As nature landscapes are being converted into hard surface areas storm water flow is affected both in terms of velocity and size. A flow increase can easily result in a flooding if the dimensions of the pipeline system are inadequate. Considering predicted upcoming climate changes, flooding?s may become more common in urban areas in the future.

Syftet med detta arbete var att studera skillnader mellan de tre energi- och klimatsimuleringsprogrammen IDA Indoor Climate and Energy (IDA ICE), VIP-Energy (VIP) och IES Virtual Environment (IES) med avseende på funktioner, användarupplevelse och simuleringsresultat.Av dessa tre olika alternativ för jämförelse lades störst vikt vid simuleringsresultat. En byggnad ritades upp i programmen med samma indata så långt det var möjligt där resultaten för byggnadens specifika energianvändning (BSE), enligt definition av Boverkets Byggregler (BBR), och årlig energianvändning kartlades. Utöver denna simulering gjordes en känslighetsanalys av indata där flera parametrar ändrades stegvis och resultat för BSE jämfördes med grundsimuleringen.  De parametrar som testades var bl.a. U-värden för klimatskalets samtliga delar, rumstemperatur, ventilationsflöden samt även programspecifika inställningar.Resultat från simulering av årlig energianvändning visade att IDA ICE och VIP båda räknade med en total energianvändning på ca 129 MWh per år med jämlik fördelning både för tillförd och avgiven energi. IDA ICE beräknade BSE till 101,4 [kWh/(m2 år) Atemp] medan VIP räknade med 102,9 [kWh/(m2 år) Atemp].

This report examines the industrialization of a newly developed household machine on behalf of Technogarden Engineering Resources in Karlstad, Sweden. The report is a part of the final course in the Bachelor Program in Mechanical Engineering at Karlstad University and takes place in spring 2014.An innovator, an investor and a engineering consultant firm have through collaboration developed a new type of gruel machine. The product is in its final stage of construction and is planned to be manufactured in a production located in Sweden, autumn of 2014.To compete against today?s trend in outsourcing manufacturing to low cost countries for better profitability, the industrialization of the gruel machine must be done with a minimum amount of resources in order to become successful, which also describes the problem of this study. Using pre-study material in form of Lean production literature, visiting a successful production site and gathering data from involved engineers a specification was developed which describes what this industrialization must achieve and which requests can be accomplished.

The purpose of this study was to evaluate which apple cultivars are best suited for production of juice and cider. The study was limited to 41 cultivars. Common as well as uncommon apple cultivars were selected from available cultivars in the cold storage at Balsgård, Department of Horticultural Plant Breeding and Biotechnology, SLU.The practical part of the study consisted of the apples being pressed, and then the juice characteristics being assessed by appropriate criteria and methods of analysis. The analyses consisted of measurment of soluble sugars with a refractometer (Brix), titration of total acidity, determination of total phenolic content with a spectrophotometer, estimation of alcohol content by density meters and qualitative taste tests.The study did not account for different maturity of cultivars. Different apple cultivars were pressed on separate occasions, before and after Christmas 2010.

Aquatic organisms are usually not exposed to single substances but rather to mixtures of toxicants in streams located in agricultural areas. The transport of pesticides used in the agricultural area in Sweden is monitored with continuous environmental supervision every year. During 2002-2008 an average of 10 pesticides were found in each sample and 40% of the samples contained substances with concentrations higher than the Water Quality Standards. Chemical risk management is normally based on single-test evaluations. A problem when assessing mixture toxicities is that the constituents and concentrations of pollutants in the environment vary greatly.