The purpose with this thesis was to examine the cold rolling mill located at Högskolan Dalarna and to stabilize the rolling process, to achieve steady state. Experiments with cold rolling of an aluminium strip have given results for rolling force, friction, reduction, strip tension and strain hardening. Results show that steady state has been found for the experiments with roll force and strain hardening, and not been found for the experiments with friction and reduction. Results show that increased strip tension gives lower roll forces. The roll force equation of Stone shows comparable results with reality for dry contact with reductions up to 30 %, but starts being incomparable with higher reductions.

This paper focuses on the employers? responsibility as described in the 11th section in the Employment (co-determination in the workplace) Act of 1976. The questions asked are to determine whether the law in the 11th section is followed in real life and if the consequences for breaking the law are a deciding factor. This paper summarizes the law as it is interpreted today and in what situations it is applicable. Since the law and especially section 11 affects certain individuals and organizations, the paper also describes who these individuals and organizations are and how they are affected.

This paper examines the structure of The Golden Notebook and in which way it reflects thethemes in the novel. This paper also describes the context of the 1960`s in which a certaintype of ideas were developing and wants to place The Golden Notebook in this context. Finallythe paper investigates what can be understood by reading the novel as a part of that context..

Tree fiber lengths controls properties like strength and smoothness in paper and other wood products. For forest researchers it is of interest to be able to determine the fiber lengths in standing trees. Mo?rling et al. (2003), among others, have developed methods to estimate fiber length distributions in standing trees without damaging them.

This master thesis deals with problems in the arc length control in Pulsed MIG/MAG Welding. The main problem is that it is not possible to measure the arc length. In the present solution the voltage over both the electrode and the arc represents the arc length. To improve the arc length control a model of the electrode melting has been built. One output from the model is the voltage over the electrode and with this voltage together with the measured voltage it is possible to calculate the voltage over just the arc.

Tree fiber lengths controls properties like strength and smoothness in paper and other wood products. For forest researchers it is of interest to be able to determine the fiber lengths in standing trees. Mo?rling et al. (2003), among others, have developed methods to estimate fiber length distributions in standing trees without damaging them.

Tree fiber lengths controls properties like strength and smoothness in paper and other wood products. For forest researchers it is of interest to be able to determine the fiber lengths in standing trees. Mo?rling et al. (2003), among others, have developed methods to estimate fiber length distributions in standing trees without damaging them.

This examination paper is about diseases of rats. The examination paper also includes sampling techniques, administration techniques and radiography. A detailed account of diseases of rats and their symptoms has been included. This examination paper is primarily written for veterinary technicians but also for others with interest in the subject. .

In this paper I study how the repeal of the Swedish wealth tax (1 of January 2007) has affected people´s labour supply behaviour. This particular issue is relevant because it may help us understand some of the effects of the earnings tax changes that have taken place in Sweden. Accoring to standard economic theory a repealed wealth tax is similar to an income effect for the persons who previously paid the tax. That means that they theoretically will want to consume more leisure, that is decrease their labour supply. The method I am using to test this hypothesis is a difference-in-difference approach where the treatment group consists of persons who previously paid the tax and the control group of comparable persons who did not pay the tax.

In this thesis the methane gas potential of three different substrates, two algaes Saccharina latissima and Laminaria digitata and biosludge mixed with paper fiber was studied. This was done by batch experiments in a laboratory environment to examine the gas production and composition of the produced gas.Biogas production is a complex anaerobic digestion process in which various microorganisms decompose the substrate in steps and at the end produce biogas and a residue. Many factors affect the production of gas, for example the substrate content, temperature and pH in the digester.The analysis of methane potential were divided into two experiments. In experiment 1 substrates were digested along with inoculum from Växjö waste water treatment plant in a temperature of about 37 ?C.

This paper is concerning students' with reading and writing difficulties and dyslexia. This paper clarifies the difference between reading and writing difficulties and dyslexia. The essay also gives an insight into dyslexia in an historical perspective. The purpose of the paper is to find out if teachers believe that students with a diagnosis of dyslexia may be more or different help than students with other reading and writing difficulties. By answering this question, I conducted a survey study in two schools in two municipalities.

Conqueror for Indigo is production treated with an active chemical to maximize the ink adhesion.ArjoWiggins has found that another chemical, the candidate compound, would improve the propertiesof the paper. ArjoWiggins therefore wish to replace the current compound. To strengthenthe patent requirements for ink adhesion needs to be determined. A theory is developed to whychemicals with certain properties maximize the ink adhesion. Experiments are performed but theresults are inaccurate.

In this paper I study how the repeal of the Swedish wealth tax (1 of January 2007) has affected people´s labour supply behaviour. This particular issue is relevant because it may help us understand some of the effects of the earnings tax changes that have taken place in Sweden. Accoring to standard economic theory a repealed wealth tax is similar to an income effect for the persons who previously paid the tax. That means that they theoretically will want to consume more leisure, that is decrease their labour supply. The method I am using to test this hypothesis is a difference-in-difference approach where the treatment group consists of persons who previously paid the tax and the control group of comparable persons who did not pay the tax.

In this paper I study how the repeal of the Swedish wealth tax (1 of January 2007) has affected people´s labour supply behaviour. This particular issue is relevant because it may help us understand some of the effects of the earnings tax changes that have taken place in Sweden. Accoring to standard economic theory a repealed wealth tax is similar to an income effect for the persons who previously paid the tax. That means that they theoretically will want to consume more leisure, that is decrease their labour supply. The method I am using to test this hypothesis is a difference-in-difference approach where the treatment group consists of persons who previously paid the tax and the control group of comparable persons who did not pay the tax.

AbstractThis thesis is the final part of the Innovation and Design Engineering Programme (180 ECTS credits)at the Faculty of Health, Nature and Engineering Science at Karlstad University. The extent of thisthesis is 22.5 ECTS credits and has been performed independently by Hannes Jernberg during thespring of 2013. Metso Paper Karlstad AB is the task maker of this project, and Arvid Johansson is thecompany Representative. Metso Paper Karlstad AB is one of the world leading developer andmanufacturer of tissue paper machines.In the current situation, the company has developed and patented a power management systembased on a Cross Flow Turbine. The current construction is limited to a paper width of 2.9 meters.The company wants to take advantage of all the opportunities provided by the patents, to develop aturbine solution paper machine with a paper width that is wider than 5.5 meters, and give the abilityto manufacture paper for lower energy consumption which is an important part of the production asit is very energy intensive.Problems arise with the increasing length of the turbine, ultimately resulting in that the deflectionbecomes too big and that the momentums, due to the increased torque the turbine blades breaks.By applying the design process, this work has resulted in a number of potential solutions to theproblem.