This master thesis is a part of the DySCAS project at ENEA. The purpose of this thesisproject is to add support for streaming media and USB support to the DySCAS demonstratorplatform.To achieve this, some of the widely used middlewares available today were studied. The onethat proved to be of most interest is CORBA. Although CORBA?s solution to streamingmedia couldn?t be used due to their use of object programming, the CORBA solution didprovide some interesting thoughts regarding how the USB devices should be handled, in thiscase their ?resource inspector? and ?trading service?.Ethernet was the chosen network to support streaming media.

Sitka spruce (Picea sitchensis) is not considered to be a native species to Swedish forests. It´s origin is the pacific coast of Northern America, an area that is dominated by a coastal climate which makes it likely to believe that it would be well suited for growing in the south-west of Sweden. This study aims to investigate the gain in production that can be reached by growing sitka spruce instead of Norway spruce (Picea abies) in the county of Halland. A regression model based on data from forest experiments was produced to explain the gain in production. This model was based on elevation and annual precipitation. The model was then used to create a map layer in arcGIS that shows the gain of volume in comparison to Norway spruce in percent. An analysis was carried out to find what share of the forestland in Halland county that fell into four different classes of production gain.

This essay, Pictures from a death-bed, expands on the pictorial genre called post mortem portraits, a field with long history in the western society. A post mortem portrait is an artwork where the artist paint or photograph the model after her or his dead. My survey delineates to treat two specific pictures, one from the seventeenth century and one from the twentieth century. Both of them are portraits of dead boys on their death-beds, but the first one is a painting and the other one is a photo. By this survey I wanted to find both similarities and differentials between the pictures; if they were made by the same reasons, if you could see anything different between the portraits by children and by the portraits of adults, and finally, if there were any cultural or religious connections between the pictures and their existents.

This report describes the design and implementation of a multi-master, packet based protocol for small and tiny microcontrollers where resources are limited. The protocol was named "Tiny Controller Network" or TCN for short. The protocol is meant mainly as a control bus for automation and sensor acquisition applications but due to its flexibility can also be used for other purposes as well. It borrows some of its functionality and design ideas from the well known CAN bus and Modbus but also has a number of major differences like the use of standard hardware and time synchronisation. One of the key aspects during the design was the use of very little system resources and common on-chip hardware peripherals like a UART.

AbstractConsider a ?uid being heated from below. The heating leads to an upward convectiveforce that is counteracted by the viscous forces of the ?uid. If the convectiveforce is large enough in comparison to the viscous forces the ?uid will be put in anunstable state.

AbstractConsider a ?uid being heated from below. The heating leads to an upward convectiveforce that is counteracted by the viscous forces of the ?uid. If the convectiveforce is large enough in comparison to the viscous forces the ?uid will be put in anunstable state.

This study presents results for observing forest changes in Sweden using multi-temporal L-band satellite data and is a part of the JAXA?s ALOS Kyoto and Carbon Initiative. An extensive dataset of images acquired by the Advanced Land Observing Satellite Phased Array type L-band Synthetic Aperture Radar (ALOS PALSAR) is investigated for clear-cut detection in boreal forests in northern Sweden (Lat. 64°14? N, Long.

This report is focusing upon relining from a client?s point of view. Potential buyers are given a presentation of the different methods available today together with a general briefing describing the process. An important part of this report are the interviews that took place with already established customers. Property owners, managers, pipe cleaners, and project managers whom all been in contact with relining have answered the questions given along with their own thoughts and have also given recommendations of other persons to talk to.

The aim of this study was to examine the current and historic mercury(Hg) load of the lake Storjuktan due to its recent exposure to a local potential source of Hg in form of the Sulphide mine Blaikengruvan(2006) and an earlier potential sources of Hg-load, the damming of the lake(1960s). Sediments were extracted using a HTH-sampler, freeze-dried, and analyzed for tot-Hg, LOI and activity of 210Pb and compared to samples extracted prior to the opening of the mine(2006). Constant initial concentration (CIC)-dating model was used for dating the samples. Low levels of Hg (100ng/g) were found throughout the lakes sediment. The highest levels of Hg(220ng/g) was detected at a depth of 4-5cm dating back to the mid 1970:s, suggesting that increased levels of atmospheric Hg rather than damming of the lake has caused the increase of Hg.

The metal mining history goes thousands of years back. The downside of the mining industry is the large amount of tailings created during the mining operations. Drainage and leaching of heavy metals from these tailings may cause major environmental problems including acid mine drainage and leaching of heavy metals. This study examines a pond located near an old mining site, where part of the old mining facility has been recently (1990) restored. The objective was to assess eventual metal contamination from historical mining and the recently performed restoration using a sediment core as a natural archive of historical metal inputs to the pond.

The industrialization in Sweden has increased the large number of areas that have been contaminated with various types of pollution. One of those sites are the property Höjen 3:24 in Arboga where ?Arboga Mekaniska Verkstad? once been. The property wants to increase the use of the old former foundry building with the adjacent ?plate-workshop? and believe there are two options for the building: That the building either should be used as a warehouse/concert hall, or rebuilt into a cultural center. An environmental evaluation has shown that the levels of heavy metals are over the Swedish environmental protection agency guidelines of less sensitive land.

In this project the author made an attempt to, in a short film, visualizean experience of the organic materials that our bodies consist ofand what becomes of it when we die. The intention was to dissect thismatter, break it down to see it in a simpler form and to explore ourrelationship to it, being part of a constant exchange between organicmaterials and having so much power over the environment and otherliving animals. At the very start, the idea was to deal with the relationshipdifferent people have with their bodies. Later in the process, a decisionwas made that the product would be communicating the author?sown experiences of the body materials after studying it and trying torecreate fragments and feelings of them.

Nowadays Wireless LAN is playing a more and more important role in network systems. After 1999, in which the IEEE organization published its Wireless Local Network standard 802.11[1], many people saw the advantages of the standard but also the lack of support for multimedia streaming. A lot of research work has been done on the proposed IEEE 802.11e standard draft during the past 4 years. It is supposed to be able to fully support Quality of Service. The final version will be published early in 2004.

This thesis aims to illustrate how environmental impact can be reduced, through the use of lean concrete. It also illustrates how environmental data can be applied to a house through implementation with BIM. In this study a unique concrete structure developed by Swedish Cement and Concrete Research Institute is assessed for environmental impact, by calculating the carbon dioxide equivalents using LCA methodology. The construction is a sandwich element where the concrete is made ??up of three layers.

Flustret is a restaurant and an entertainment place situated by Svandammen in Uppsala. It all began in 1842 as a café serving coffee, tea, chocolate and pastry. During the years the building has had numbers of different owners. The owners of today are running Flustret in a same friendly spirit that has been characteristic from the beginning. The buldings history is now approaching an age of 165 years. Throughout the years different historical layers have been placed on top of each other, leaving a layer of patches.