Like many small-time companies there is a need to improve the flow of materials at HSP-Gripen AB. The company develops and manufactures hydraulic-powered grapples for the machine- and forest industry. By mapping the material flow in the current production and gathering necessary data, suggestions on how different parts of the production could be controlled is presented in this dissertation. This has been achieved by the study of relevant scientific literature. The suggested ways of controlling the production consist of 2-bin systems, hybrid material flow system as well as a cyclic product-planning.

As a small and land scarce country, effective waste management is ofoutmost importance in Singapore. In this study the production of biogasthrough anaerobic digestion from the organic fraction of municipal solidwaste (OFMSW) was compared to incineration of the waste. At the momentalmost all of the OFMSW in Singapore is incinerated. Three differentscenarios were compared to the reference scenario (incineration): one with alarge scale biogas plant that can treat half of all OFMSW in Singapore, onewith a medium scale biogas plant about 15 times smaller than the large oneand one with a small scale biogas plant that can treat waste from e.g. ashopping center or a food center.By using life cycle assessment (LCA) the different scenarios were comparedin terms of global warming potential (GWP), acidification, eutrophication,energy use and land use.

The cattle production in the world has been questioned in Sweden due to its negative impacts on the environment. The use of imported soya bean meal as a protein feed for Swedish cattle results in the cutting of rainforest and an extensive use of pesticides in the countries were the soya beans are produced. As a consequence, the environmental impacts caused by cattle production increases. A production of protein feeds in Sweden would decrease the transportations and the cutting of rainforest. For organic beef producers the possibility to produce home-grown protein feeds is important since organic protein feeds can be difficult to obtain in another way.

Until 2020, 49% of Sweden's use of energy must derive from renewable sources. Greenhouse gases must as well decline with 40% compared to 1990 as a part of Sweden's 16 environmental objectives. Biogas is part of the effort to achieve these objectives, but as the demand for biogas increases, more substrates are needed to meet the demand. The purpose is to investigate the conditions for pea residue as substrate by performing lab-scale mesophilic digestion with different fractions and notch lengths and then to summarize pea residue as a substrate for biogas production. During anaerobic digestion, 1000 ml bottles were used as reactors for digestion.

With a growing population on earth the amount of end-of-life vehicles (ELVs) and other scrap steel increases. The European Directive 2000/53/CE? requires a minimum of 95 % reuse and recovery and 85 % re-use and recycling no later than 1 January 2015, for end-of life vehicles. This imposes a need for more efficient recycling and recovery. Despite this shredder residue (SR) is commonly land filled.This report investigated the magnetic fines residue generated at Stena Metall shredder facility in Halmstad, Sweden.

With a shifting world market and periodically profitability issues, Swedish farmers seekalternative ways to enhance their profitability. One interesting alternative to get a highervalue and enhance products is biodiesel, a way to improve the profitability on a farmscale.The diesel that is produced and sold, already have a mixture of 5% biodiesel, andthere is a possibility to add more biodiesel to it. By developing new engines severalengine-manufacturers now allow a mixture up to 100% biodiesel in their engines. Hencethere is a market for an increased production of biodiesel. The aim of this study were toinvestigate the possibilities and the problems related to farm-scale production ofbiodiesel, and to study the profit margin in the production.

The main purposes of this study were to 1) quantify bacterial production in winter during ice conditions, and 2) to compare these production measures with values measured from summer and open water conditions in three humic lakes situated in northern Sweden. Another purpose of this study was to 3) examine whether clear-cutting significantly affected bacterial production or water chemistry in two lakes situated in catchments were a large part of the forest had been removed through logging compared to an undisturbed reference lake. In winter (March/April 2014), the bacterial production ranged from 0, 7 - 2, 2 µgC/L/day and in the summer of 2013 the production values was 4 ? 10 times higher. The main reason for lower bacterial production in winter was ascribed to lower water temperatures as well as to older and more recalcitrant DOC, as there were no significant differences in total dissolved nitrogen or DOC concentration or -quality, that could explain a lower production compared to summer.

Important issues for the local authorities are what to do with the sludge produced insewagetreatment plants. The tax for landfill leads to higher costs with 250 SEK/ton. On the 31December 2004 it will be forbidden to landfill sludge.In Sweden the yearly production of sludge is 240 000 tons, counted as DS. The phosphorouscontent is 3 % in sludge. The total yearly production of sludge gives 6000 tons of phosphorous.

The report is about efficiency of a current production group where there is no clear production flow and there are some buffers between the operations. The efficiency is done with the help of a tool that is calledWork process of flow production which is used by Atlas Copco CTO. The most obviously results are that the lead time drops from 25 hours to 425 minutes and that the balancing loss decreases from 85 % to 8 %. The report focus on decreasing transports, decreasing buffers, more reliability in lead time and quality. And a more stimulating labour content for the workers is another result..

Calculations are an important part of planning around a construction project. From concept to completion of the project calculation is a tool to try to predict the actual cost. During the production stage in particular, deviations occur which makes the actual cost different from the calculations.This thesis is done in collaboration with JM Residential Stockholm. The study includes a cost follow-up in which a comparison was made between the calculated production cost and actual cost for the five projects. The aim of the study was to observe the most common reasons that a project deviates from the calculated production cost and then summing these causes in a number of categories.

The hybrid larch (Larix x eurolepis Henry) is a fast growing tree species and was introduced in Sweden for about 50 years ago. The high growth and expected resistance to diseases are probably the main reasons of introducing the tree species into the Swedish forests. The purpose of this thesis was to document the production of hybrid larch planted in the Snogeholm landscape laboratory and to compare the production in the pure hybrid larch stand with the mixture together with pedunculate oak (Quercus robur). The data collection in Snogeholm since the establishment has been carried out by the Swedish University of Agricultural Science (SLU). The fieldwork for the thesis was carried out in 3 stands, containing hybrid larch, pedunculate oak and a mixture of hybrid larch and pedunculate oak, in order to be able to compare the total stand production of the areas. The results show that the total production of hybrid larch in the mixed stand only is 35 % compared with the total production of hybrid larch in the pure stand. Therefore, the hypothesis that the total production of hybrid larch is equal to the planted mixture with pedunculate oak was rejected. The other hypothesis that the total production of a 2 hectare large stand containing a mixture of hybrid larch and pedunculate oak would be greater than the total production of two pure stands of 1 hectare containing hybrid larch and oak each was also rejected. In the studied case the total production was 45 % greater if hybrid larch and pedunculate oak was planted in pure stands. The results from the case-study only indicate that the total production of hybrid larch and oak under the investigated conditions can be higher when planting the two species in pure stands compared with a mixture of the two species.

AbstractLean production has become one common concept within industries to make the work more effective and to meet today?s hard competition. A challenge for Chinese production is the threat from new low cost countries. It will become very difficult to succeed to produce to a lower cost than these countries; this led to that Chinese companies must develop new strategies, according to Lee and Zhou (2000). This will put China in front of new challenges and new strategies can be needed to retain their strong competitive advantages.

This graduation work is a result of implementing Lean Production using OEE and SMED at Enics Sweden AB in Malmö. Enics doesn?t have an established improvement concept and therefore should this work serve as an introduction to possibly start with Lean Production. A result in this report is that an OEE value has been identified within a common order at Enics. Other results are that an implementation of a Lean-board has been implemented and furthermore, within SMED, a flag that indicates changeover..

When a company in the manufactory industry makes costly investments, it's important that these are used as much as possible. The company in this case claims that their invested robot cell, with CNC machine isn't used enough. The questions here are: How can we improve the use of the robot cell? Which products are appropriate for the production in the robot cell? As a method to come to a conclusion, an analysis has been made over the manufactured products. And also interviews with machine operators and the production management.

The aim of this study is to review the commercial quail production for eggs and meat in the world. Another aim is to review the potential for increased production. Globally the quail production is very small, except in China where it is the second largest poultry industry. The production globally is small despite the quail's rapid growth, early sexual maturity and its high feed efficiency. The quail is also used as a laboratory animal and can be reared to be released in hunting areas.