The hybrid larch (Larix x eurolepis Henry) is a fast growing tree species and was introduced in Sweden for about 50 years ago. The high growth and expected resistance to diseases are probably the main reasons of introducing the tree species into the Swedish forests. The purpose of this thesis was to document the production of hybrid larch planted in the Snogeholm landscape laboratory and to compare the production in the pure hybrid larch stand with the mixture together with pedunculate oak (Quercus robur). The data collection in Snogeholm since the establishment has been carried out by the Swedish University of Agricultural Science (SLU). The fieldwork for the thesis was carried out in 3 stands, containing hybrid larch, pedunculate oak and a mixture of hybrid larch and pedunculate oak, in order to be able to compare the total stand production of the areas. The results show that the total production of hybrid larch in the mixed stand only is 35 % compared with the total production of hybrid larch in the pure stand. Therefore, the hypothesis that the total production of hybrid larch is equal to the planted mixture with pedunculate oak was rejected. The other hypothesis that the total production of a 2 hectare large stand containing a mixture of hybrid larch and pedunculate oak would be greater than the total production of two pure stands of 1 hectare containing hybrid larch and oak each was also rejected. In the studied case the total production was 45 % greater if hybrid larch and pedunculate oak was planted in pure stands. The results from the case-study only indicate that the total production of hybrid larch and oak under the investigated conditions can be higher when planting the two species in pure stands compared with a mixture of the two species.

AbstractLean production has become one common concept within industries to make the work more effective and to meet today?s hard competition. A challenge for Chinese production is the threat from new low cost countries. It will become very difficult to succeed to produce to a lower cost than these countries; this led to that Chinese companies must develop new strategies, according to Lee and Zhou (2000). This will put China in front of new challenges and new strategies can be needed to retain their strong competitive advantages.

This graduation work is a result of implementing Lean Production using OEE and SMED at Enics Sweden AB in Malmö. Enics doesn?t have an established improvement concept and therefore should this work serve as an introduction to possibly start with Lean Production. A result in this report is that an OEE value has been identified within a common order at Enics. Other results are that an implementation of a Lean-board has been implemented and furthermore, within SMED, a flag that indicates changeover..

When a company in the manufactory industry makes costly investments, it's important that these are used as much as possible. The company in this case claims that their invested robot cell, with CNC machine isn't used enough. The questions here are: How can we improve the use of the robot cell? Which products are appropriate for the production in the robot cell? As a method to come to a conclusion, an analysis has been made over the manufactured products. And also interviews with machine operators and the production management.

The purpose of this study was to evaluate the different substrates that enter the digestion on Sundet wastewater treatment plant for production of biogas.This work have done an analysis of data about the biogasproduction from January 2012 to feburari 2013, this showed that the food substrates has a greater gas production than internal sludge.Through laboratory test the VS, TS and COD values for all the substrates used in the biogas production could be determinded. But the COD-method was less optimal for analysis of fat and food, therefore it optimized the method for fat but due to time constraints, this could not be done on the food substrates..

The report is about efficiency of a current production group where there is no clear production flow and there are some buffers between the operations. The efficiency is done with the help of a tool that is calledWork process of flow production which is used by Atlas Copco CTO. The most obviously results are that the lead time drops from 25 hours to 425 minutes and that the balancing loss decreases from 85 % to 8 %. The report focus on decreasing transports, decreasing buffers, more reliability in lead time and quality. And a more stimulating labour content for the workers is another result..

The resting area is the most important place in the barn for the dairy cow, sometimes called the heart of the free stall system. Inadequate design of the lying area, and lack of or poor quality of bedding materials may reduce the hygiene of the stall. Poor management regarding the cleanliness of the resting area may lead to poor animal hygiene and increased bacterial growth. This in turn will lead to increased risk for environmental mastitis as well as impairing milk quality through contamination with spores. In this literature study the most commonly used bedding materials; straw, sawdust, wood shavings, clean sand, recycled sand, peat and recycled manure solids, are compared to one another with regards to their ability to resist bacterial growth. Effects of adding hydrated lime to bedding materials have also been studied. Most bacteria need humidity and prefer a quite high water activity to be able to grow.

Large amounts of birch-timber are imported to Sweden, from particularly the Baltic States, since the domestic production can?t support the pulp industry. The goal of this study was to show the potential of birch and the area?s most suitable for birch production. The study was limited to Gävleborg County. Using site characteristics, site index (SI) for birch was estimated on all National Forest Inventory plots in Gävleborg County.

With a growing population on earth the amount of end-of-life vehicles (ELVs) and other scrap steel increases. The European Directive 2000/53/CE? requires a minimum of 95 % reuse and recovery and 85 % re-use and recycling no later than 1 January 2015, for end-of life vehicles. This imposes a need for more efficient recycling and recovery. Despite this shredder residue (SR) is commonly land filled.This report investigated the magnetic fines residue generated at Stena Metall shredder facility in Halmstad, Sweden.

The following study aims to investigate the environmental conditions of the harbor of Sk?rhamn, a small fishing community on the west coast of Sweden. The interest to do so rose as a newly built apartment residence failed to connect the sewage pipes of 18 apartments, causing the untreated sewage running into the sea. The parameters accounted for are the C/N ratio, total organic carbon (TOC) as well as total nitrogen present (TN) and ?13C in the top ten centimeters of a sediment core retrieved in the Sk?rhamn harbour.

This thesis examines Swedish composers' modes of work and production within the Swedish film industry. It starts off with a historical overview treating live music in early silent film, the conversion to sound and the Swedish production climate until present time. The analysis consists of contemporary empirical studies; interviews with people writing music for film, TV and commercials. The musician's perspective is in focus but directors and other film workers are heard as well. The situation for female composers in a male-dominated industry is also discussed.

Peat  lands  are  a  great  potential  resource  for  increased  forest  growth  in  Sweden, there  are  approximately  6.5  million  hectares  of  peat  lands,  whereof  around  70% produce less wood than one m3sk/ha and year and are therefore classed as forest waste  land.  There  are  over  200  000  hectares  of  peat  land  that  is  already  drained and  wooded,  and  that may  be  suitable  for  fertilization.  Forest  production  on  peat soils  usually  requires  drainage  and  fertilization.  Dewatering  requires  ditching  the area, so that the roots can have access to oxygen. Nitrogen is often abundant in the peat but other nutrients; especially potassium is in short supply. The  purpose  of  this  work  was  to examine  the effects  of  potassium  fertilization  on the  growth  of  spruces  that  were  planted  on  drained  peat  land  and  how  different amount of fertilizers affects the growth. Potassium deficiency is strongly growth inhibiting, since potassium is important for substance  transport  in  the  tree.  Potassium  is  also  important  for  the  carbohydrate formation, and because increasing the sugar content of the cells constitutes a lower freezing temperature does potassium availability in the soil play a major role in the winter  resistance  of  many  species.  Potassium  is  not  found  in  any  organic compounds in the tree, but is present in cell and tissue fluids. A fertilization trial was started in 1978 in Siljansfors Experimental Forest. The plots in the experiment were fertilized with different amounts of potassium and one plot was  left  without  fertilization.  All  plots  that  were  fertilized  with  potassium  grew considerably better than the unfertilized plot. The difference in production between the unfertilized plot and the plot that received the most potassium was 7.2 m3sk/ha and year. The unfertilized plot can still be classified as waste land. The theoretical production capacity was estimated using a Swedish system for site quality  estimation  of  wetlands  after  ditching  (dikningsbonitering).  The  plot  with most  potassium  produced  after  fertilizationaproximately  in  level  with  theoretical estimations.  Key  words:  Peat  land,  Fertilization,  Ditching,  Growth,  site  quality..

The purpose with this study was to analyze the possibilities to produce organic lambs and to hihglight the most common difficulties in such a production system. A description of current organic and conventional lamb production systems was conducted, both from Sweden and from some other countries. The Department of Animal Environment and Health at SLU in Skara performed the project together with The County Board of Agriculture in Västra Götaland and Värmland and The Swedish Animal Health Service. The project lasted from 2002 to 2004. The student report contains the years 2002 and 2003. In the year of 2003 there were 210 000 adult sheep in Sweden, of which 16 400 adult sheep were certified by KRAV. Of the different countries in Sweden, Västra Götaland and Gotland had the largest number of sheep, 14 and 13 per cent of the total number.

Title: Organic / Synthetic in today's creative music making. This work intends to find out what synthetically versus organically produced music means for a songwriter / producer as well as for an artist in their everyday role of occupation. What are the positions regarding these two methods and how do they relate to these concepts? This study also concerns the general view of music produced with each one of these methods and to which extent there exists prejudice towards them. The method used for data collection is qualitative interviews.

Hammarby Sjöstad is a new district of southern Stockholm built with focus on reduced environmental impact by recirculation of materials and sustainability. The environmental goals aim to cut the water consumption by half and a separate storm water treatment. Thus, the wastewater will be more concentrated and will originate from the households only. The Sjöstad project includes the idea of a local treatment plant for the household wastewater. To evaluate this possibility, Sjöstadsverket, an experimental treatment plant was constructed.