The perioperative nurse's primary responsibility is to care for the patient during the operation?s three phases; before, during and after. The communication between colleagues in the surgical department is increasing opportunities for safe care for the patient and a good dialogue with the patient can alleviate the concerns facing the unknown environment such as an operating theater. The pilot study was to investigate the surgical nurses' perceptions of conversations with the patient one year after graduation. To answer the pilot study's aim a qualitative interview study was chosen with a phenomenographic approach.

The purpose of this degree-project was to investigate the possibilities for primary air preheating into the two smallest waste incineration boilers of Halmstad Energy and Environment. The investigation is a pre-study which has the primary goal to evaluate technical and financial offers from companies that manufacture primary air preheater, and investigate if it is technically and financially profitable to do a purchase on primary air preheaters in the future.In the pre-study it is proposed that it is most efficient to have individual primary air preheater, one for each incineration boiler and the primary air are also proposed to be preheated by hot water in the pre-study. Further in the pre-study it is proposed that the heat-exchanger should have plain tubes instead of finned tubes, to avoid getting dirty fast. The space in the boiler-room is limited, and therefore the major problem was to fit in the primary air preheaters into the boiler-room. By comparing the different offers from the companies, the result in the pre-study shows that the offer from the company C.A.

The Swedish energy system will be influenced by many future changes, such as energy and climate policy objectives. The installation of more renewable electricity could increase by using solar energy. Over the recent years, grid-connected photovoltaic (PV) systems have increased dramatically in Sweden, partly due to various support systems and compensation models. These support systems have been designed to make it easy for individuals and businesses to invest in self-generated electricity and thus contribute to the transformation of the energy system.The introduction of a higher proportion of solar energy may in turn affect the Swedish electricity system. This could mean that the electricity companies will be facing a number of changes in the near future.

In the next few years the pollutants loading at the Slottshagen wastewater treatment plant in Norrköping is going to increase due to the reason that one of the waste water treatment plant in the district will be shut down.A survey of how these different pollutants are divided in the treatment process is therefore necessary for mapping out both the loading and treatment efficiency.This can be achieved by studying mass balances.Mass balances were carried out for the water treatment process for the mechanical/chemical,biological and the chemical stage.The mass balance studies show that the treatment efficiency was very good. However in order for the mass balances to be quite consistent and to ensure complete coverage of results and conclusions i.e. more reliable results, sludge samples should be collected and taken at different times per day and the influent rate should be investigated.In this work mass balance has been set up in order to illustrate and identify the factors that should be considered and taken care of for further estimation using mass balances in the future. Furthermore this survey results in a calculating model for the mass balances at thisplant.This calculating model is used as a tool to facilitate future calculations for mass balances for the water treatment process at Slottshagens wastewater treatment plant.Moreover it provides a basis for carrying out further estimation of the treatment process in the near future.In this project the importance of some operating parameters was also taken in consideration.This calculating model can be modified so that calculations of such operating parameters i.e. sludge loading and sludge age can be easily performed.Such information can be used further to evaluate different operation alternative in order to ensure an optimal use of the treatment process with in the plant..

The company System Andersson is developing systems for controlling materials and production in industries. They want to add a new service, where parts of those systems are accessible through cell phones.In this paper we are investigating which technology are best suited for this kind of application. And then we describe how we are developing a prototype fort this application, based upon that technology. After investigating technologies such as Java ME, Microsoft Silverlight, and web applications we settled upon building the system as a web application, customized for a mobile environment.To build a web page which is readable by many different cell phones we use the markup-languages which are developed for cell phones. We put much effort in reading about the standards and recommendations for the mobile web, produced by the organizations W3C and OMA.

This report that is written in cooperation with Peab Sverige AB, studies the information and knowledge management from the production support to the production management. The conclusion of this report is that to have a good and functional information and knowledge management it is necessary that the company has a good way of regain and handling experiences from its projects. The way to do this is to develop the managing system on the production management?s terms. It is also critical to find an easy way for the production management to use the system..

When drivers overnight in the truck lots of electric energy is consumed by heaters, fans, lights and other extra equipment. If the engine is not running, this energy is taken from the lead/acid batteries of the truck which then needs to be recharged during operating hours. The fact that the charge acceptance of the lead/acid batteries is dependent on the temperature makes it hard to fully recharge the batteries at lower temperatures. A negative charge balance can lead to starting problems within a few days use in cold climate.In this thesis work, the effects of different battery charging concept are evaluated on the most common Scania battery (175Ah). A battery model is implemented in Matlab and some simulations of charging are made.

Interest in the implementation of AGV-systems (Automated Guided Vehicle) has in recent decades increased. The reason is that it allows companies to perform reliably and secure internal transport while reducing the need of personnel. It is one of todays most advanced and complex material handling system that can independently make their own decisions regarding flow paths and traffic control. An AGV-system consists of transport units carrying cargo from point A to point B, and communicates using a computer.The purpose of this study is to develop a model on how to proceed in order to design an AGV system in heavy industry. The model is tested by a case study of a company in the metal industry to determine if the model works and gives the correct result.

This report details the development of an application for personal safety for the Android operating system. Android is a relatively new platform, primarily used on mobile phones.The purpose of the developed application is to give the user the possibility to easily and quickly alert a number of contacts by phone in case of emergencies, and to show the user?s location on a map. This is not only used during emergencies, but for other purposes as well ? for example to monitor a jogging round.The project was carried out in co-operation with the company D-Safety, the developer of the "SoftAlarm" ? the product on which the developed application is based..

The demand for shorter lead-times and increased delivery reliability puts pressure on companies to provide more efficient logistic services. One strategy to deal with this demand is by outsourcing logistics to a third part. The development of logistics information systems enables increased control over business supply chains. This is why Green Cargo aims to create a Logistics Control Tower (LCT) solution to provide it?s customers with better information with higher availability.

The aim of this thesis is to examine what factors that influences the management control in a family business operating in a sector in which they are under-represented. We have therefore conducted a case study of a family business in the finance sector, E. Öhman J: or Fondkommission AB (Öhman). The first conclusion is that the management control in Öhman is influenced by the environment and the increasing size of the company. We have found, however, that it is to an even larger extent affected by the fact that it is a family business even though the company is operating in a sector in which family businesses are not the norm.

When an error occurs in an IT system that is vital for the production of a major industry, the consequences can be great. To quickly identify and correct errors is important as a stop in a system can lead to a break in production, which is costly for the industry. Our task in this thesis has been to develop a system for ÅF that facilitates the debugging process of the system Paperline. The system's target audience is ÅF-call personnel that provides support for Paperline 24 hours a day if something goes wrong. The system consists of a Windows service, a database and a web application and is developed mainly with the techniques C#.NET, MVC 5, Google Charts, Javascript, HTML, CSS, and Entity Framework.

The purpose of this degree-project was to investigate the possibilities for primary air preheating into the two smallest waste incineration boilers of Halmstad Energy and Environment. The investigation is a pre-study which has the primary goal to evaluate technical and financial offers from companies that manufacture primary air preheater, and investigate if it is technically and financially profitable to do a purchase on primary air preheaters in the future.In the pre-study it is proposed that it is most efficient to have individual primary air preheater, one for each incineration boiler and the primary air are also proposed to be preheated by hot water in the pre-study. Further in the pre-study it is proposed that the heat-exchanger should have plain tubes instead of finned tubes, to avoid getting dirty fast. The space in the boiler-room is limited, and therefore the major problem was to fit in the primary air preheaters into the boiler-room. By comparing the different offers from the companies, the result in the pre-study shows that the offer from the company C.A.

The purpose of this Master?s Thesis is to examine the information use and information behavior of the scientists at the company ?Forskningsbolaget?. For this purpose an Information Audit was carried out using both interviews with six managers and a questionnaire, which was sent out to the entire population of 213 scientists. After finding out what information the scientists use and how they obtain it the aim was to answer the question of to what extent the company?s Information Centre can meet these needs.

Arbetet undersöker grafikkortets lämplighet att tolka L-system i realtid. L-system är ett strängomskrivningssystem som beskriver strukturen hos botaniska former. Lsystem tolkas med hjälp av sköldpaddstolkningen för att få en geometrisk tolkning. För att utvärdera om grafikkortet är lämpat att tolka L-system i realtid har två system implementerats. Det ena systemet tolkar L-system på processorn och det andra systemet tolkar L-system på grafikkortet.