Abstract In order to make the modern agriculture less dependent on non-renewable external inputs, it has to rely more on ecosystem services. The agricultural system produce not only food, fiber and fuel, it also generates other ecosystem services such as e.g. photosynthesis, recycling of nutrients, influencing local microclimate, pollination, biological control and detoxification of noxious chemicals. This study is an attempt to get a better understanding about the interaction among different ecosystem services and different habitats capacity to generate them. An evaluation of eight different methods is done. The ecosystem services studied are the ability to absorb solar energy, biomass production, botanical diversity, decomposition and natural predation of aphids.

The thesis aims to compare differentpiping materials in heating systems interms of cost as well as to illustratethe impact of energy characteristics ofdifferent materials over its servicelife. The methods used for costcalculations regarding piping are alsoto be examined to highlight thedifferences between template basedcalculations and more carefully executedones. The work is delimited to discusspipes of steel, copper, plastics andcomposites. The aim is that the resultcan be compiled to illustrate the prosand cons of various materials whenevaluating investments.The main object of the survey is part ofa heating system in the office-block KVSommaren located in southern Stockholm.The configured piping system is designedwith the mentioned piping materials andis used to make up the data for flow andcost calculations. The differentmaterials are calculated in both aconventional manner with a supplementarycost for additional fittings and with amore accurate quantification of thecomponents.

This thesis work was made to optimize the writing of the construction specificationsat FKA. These construction specifications are created before each plant modificationsthat is started because requirements from the Swedish radiation safety authority(SSM) and internally on Forsmarks nuclear group as constructions / implementationdocumentationThe study was done through seven interviews of two people at three different groupsinvolved in the construction specification and an interview from the group accreditedverification. The four selected groups were selected through an extensive analyticalwork resulted in an elimination matrix where these four groups was considered to bemost involved with the construction specification.The questions asked to these individuals were based on the instructions and sampletext that are described in the construction specification. To ensure the quality of thethesis were to limit itself to the chapters that were considered most relevant toimprove. The analysis revealed a number of points that should be improved, partlyinto the routines when writing the construction specification and when ether sampletext or suggestions should be changed and complemented.

In East Africa live two species of Griffon Vultures; Rüppel?s Griffon Vulture (Gyps rueppellii) and African White-backed Griffon Vulture (G. africanus). One of the apparently most important factors limiting the population of these birds is food supply. Griffon vultures nest for eight months of the year, and are during this period geographically tied down to the nesting place.

After parturition the energy demand for milk production is greater then the energy provided from the diet. The cow mobilises therefore body tissues to compensate for the energy loss. Live weight and body condition scores decreases as a consequence of the mobilisation. The aim of this study was to analyse the relationship between body condition score, live weight and subcutaneous fat depth measured by ultrasound and the changes during the lactation. Possible differences between Swedish Holstein (SLB) and Swedish Red and White Cattle (SRB) were also investigated.

In the middle of Australia there is a city called Alice Springs. The city has one of the highest amounts of daily sunshine hours and sun irradiation in the world. The Australian Government runs a project called Solar Cities, and Alice Springs is one of the participators. The main part of the goal with the Solar Cities project is to increase the amount of electricity generated by solar power and by doing that lower the impact on the environment. This thesis examines the possibilities for construction of a large scale solar power plant in Alice Springs. This is done to determine the potential of creating a more sustainable energy system in the city.

Interest in alternative energies is high in Sweden today, particularly in the agricultural sector. According to the Swedish lantbruksbarometern (2009), almost all respondents consider the use of some form of alternative energy from the farm. While interest in alternative energies is large, attention to the alternative energy straw has fallen and is almost nowhere mentioned in the literature today. Three years ago, in the Lantbruksbarometern nearly 44% of the farmers would be willing to invest in straw as heating system on the farm. How do the farmers decide to invest in alternative energies? With this information a problem is presented for this paper.

With background in the rapidly growing need to find solutions for sustainable energy production and the increasing interest for wind power, this report was written. With take-off point from the wind power plant Big Glenn, which has been built in the harbour of Gothenburg, a model of the adjacent power grid has been created in Simulink/SimPowerSystems. Parameters for the power grid and its components has been provided by Göteborg Energi Nät, that has also been the supplier of measurement data of produced power, the power need from loads in the vicinity, voltage levels, current values and also the variation of power factor at the wind power plant.The SimPowerSystems model has been used to perform simulations of power flow in the grid. These simulated values have then been compared to the measured values to verify the functionality of the model. Further, the model has been used to perform simulations of a grid fault, which causes a voltage drop.

The genus Borrelia is a widespread, pathogenic pest and the causative of among others borreliosis or Lyme disease. The vector for the bacteria is the hard tick, Ixodes ricinus and the infection is transferred through a bite. Untreated, Borrelia may cause arthritis, heart damage or neuroborreliosis. Infection is made possible through different strategies for avoiding the body?s complement system.

During the years 1950-75 was the construction of building apartments in high speed. A rapidly growing reconstruction requirement is the consequence of the rapid construction speed in these years. The technical lifetime of the different parts of the buildings is about to end and the needs for reconstruction is huge. One of Sweden's national environmental objectives is to reduce the urge of energy in buildings. This calls for radical measures to implement energy efficiency of existing assistance particularly in the assistance that is now facing reconstruction.

Glycogen is the storage form of glucose and is used by the skeletal musculature as energy both for intense and endurance events. The glycogen content in the horse?s middle gluteal muscle is more than 600 mmol/kg dry weight, and almost 400 mmol/kg dry weight in the human?s Vastus lateralis. In some special occasions, for example in competitions with several moments on following days, there is a need of a fast muscle glycogen resynthesis. The feed intake is of importance for the velocity of the resynthesis.

The main goal with this thesis report was to come up with ideas of how to make the use of energy more effective and thus save money for the company.First a survey was made to find out where and how the energy consumers were divided within the company. The results were then used in calculations to find out how much money that could be saved and how long it would take to get back the investments.There is a big potential in saving money by recovering heat from the UV-lamps with a heat exchanger. It would also even out the pressure in the factory which is a source to heat loss and a cause for discomfort amongst the employees. It?s possible to save 105 000 kr in a year and the money needed for the investments is 600 000 kr.By using the recovery air more effectively the company could save up to 250 000 kr a year in lowered heat purchases, but this would require the use of automatic dampers.If you reschedule the running times for the wood chipper and invest in some kind of load management, for example Sydkraft?s ?Energidirigent? you can save at least 42 000 kr.

I dagens samhälle blir det allt mer intressant att spara energi, dels med tanke på miljön och dels föratt minska på utgifterna. Denna energi ska sparas på ett sådant sätt att effekten för användarna blirså liten som möjligt.I denna rapport beskrivs hur ett reglersystem kan byggas för att minska energiförbrukningen hosväxthus genom att reglera belysningen på ett effektivt sätt. Systemet är helt automatiskt vilket göratt användarna inte behöver tänka på styrningen av lamporna alls när väl systemet är uppsatt ochkonfigurerat.För att styra lamporna på ett bra sätt mäts det inkommande ljuset med en PAR-sensor. Lampornatänds och släcks därefter beroende på ljusmängden och även på hur varmt, eller kallt, det är iväxthusen.Styrningen av belysningen sker med en mikrokontroller från Microchip, en PIC18F4620 som ärprogrammerad i C18. Kringkomponenter som portexpasioner, klocka och reläer användes också föratt bygga ett bra reglersystem.Resultatet är att det är möjligt att bygga ett reglersystem med begränsad budget som styr lampornapå ett effektivt sätt.

The environmental work in Sweden has developed a lot over the past fifty years. Today, most companies have some kind of environmental work. Environmental activities are regulated by the Environmental Code, which applies in parallel with other laws. This report is an environmental review for Bräcke Diakoni. The report aims to find out how much environmental impact Bräcke Diakoni has.

The purpose of this thesis has been to develop a tool for modelling and simulating the nuclear plant Ringhals 3. The model should be used to improve the knowledge on the dynamics of the plant. Ringhals 3 is being upgraded to produce more power and a tool for analyzing the new operating conditions is needed.The work in this thesis has consisted of improving and developing an existing model of Ringhals 3 made with the modelling tool Dymola. The model has been validated by comparing the results of a simulated house load transient with data from the actual plant. Validation shows good agreement with data from the real plant.