The use of Power Line Communication, PLC, as a communication solution for Automated Meter Reading, AMR, is popular by utilities in Sweden and other parts of the world due to demands of accurate and fast meter reading. However the use of the electrical grid as a communication medium is complex and sometimes problematic. This report handles some of the issues and problems that are important to understand when using the grid as a communications medium. Focus is mainly on investigating high frequency distortion in the Kristianstad power grid own by C4energi caused by a frequency converter. Measurements on site are done to investigate signal damping in the grid, different configurations for the frequency converter and signal strength of the PLC-system.

Aquatic organisms are usually not exposed to single substances but rather to mixtures of toxicants in streams located in agricultural areas. The transport of pesticides used in the agricultural area in Sweden is monitored with continuous environmental supervision every year. During 2002-2008 an average of 10 pesticides were found in each sample and 40% of the samples contained substances with concentrations higher than the Water Quality Standards. Chemical risk management is normally based on single-test evaluations. A problem when assessing mixture toxicities is that the constituents and concentrations of pollutants in the environment vary greatly.

The use of Power Line Communication, PLC, as a communication solution for Automated Meter Reading, AMR, is popular by utilities in Sweden and other parts of the world due to demands of accurate and fast meter reading. However the use of the electrical grid as a communication medium is complex and sometimes problematic. This report handles some of the issues and problems that are important to understand when using the grid as a communications medium. Focus is mainly on investigating high frequency distortion in the Kristianstad power grid own by C4energi caused by a frequency converter. Measurements on site are done to investigate signal damping in the grid, different configurations for the frequency converter and signal strength of the PLC-system.

The use of Power Line Communication, PLC, as a communication solution for Automated Meter Reading, AMR, is popular by utilities in Sweden and other parts of the world due to demands of accurate and fast meter reading. However the use of the electrical grid as a communication medium is complex and sometimes problematic. This report handles some of the issues and problems that are important to understand when using the grid as a communications medium. Focus is mainly on investigating high frequency distortion in the Kristianstad power grid own by C4energi caused by a frequency converter. Measurements on site are done to investigate signal damping in the grid, different configurations for the frequency converter and signal strength of the PLC-system.

Volvo Human Monitoring (VHM) is an ongoing project at Volvo Cars where they measure, amongst other parameters, inhalation and exhalation through a device called Respiratory Inductance Plethysmograph (RIP), on drivers. RIP measures changes in the cross-sectional area of the chest and abdomen. When the driver is in motion, such as when she is turning the vehicle, the cross-sectional area changes and noise in the RIP signal may arise.The noise results in a large number of manual adjustments in the analysis of the RIP signal, which is very time consuming and the validity of the device for measuring inhalation and exhalation is questioned.The purpose of this study was to improve the efficiency of the analysis of the RIP signal. The goal was to create a new data processing tool in Matlab that automatically detects inhalation and exhalation from a RIP signal with higher validity compared to the previous data processing tool.In this study, nine tests were performed on drivers while they were driving in different scenarios such as highway, country road and in city traffic. Inhalation and exhalation was measured using a RIP, a pneumotachograph with a tightly sealed facemask and a thermocouple placed between the nose and mouth, which was used as reference to the RIP.The result of this study was a data processing tool that automatically detects inhalation and exhalation with higher validity compared to the previous data processing tool.

Endocrine disruptive chemicals (EDCs) are found in many everyday products and can cause adverse effects on human health. Small children are particularly sensitive to EDCs and they are also exposed to them in a greater extent than adults. Despite this, EDCs are only banned in a few toys and childcare products. There are many sources of exposure and if no steps are taken to reduce the incidence of EDCs we may face an increasing number of people diagnosed with obesity, diabetes type 2 or various types of cancer.The Swedish Government has set a number of environmental objectives, one of which is calleda non-toxic environment. The Swedish Chemicals Agency was instructed to produce and conduct a national action plan to achieve this goal.

In recent years, existing solutions for cooling personal computer CPUs have been supplemented by a new product category, factory sealed water cooling loops. These systems, consisting of a water block with an integrated pump, a fan and a radiator, perform well compared to the air cooling solutions but are less effective than larger, custom-built water cooling systems.This project aims to explore the most important aspects of a factory sealed system and to identify possible cost-effective enhancements of the performance.The most significant differences between the different groups of water cooling loops are the block design and the pumping power. The performance of both categories is also largely dependent on the fan power, but increasing fan power has a large negative impact on the noise level.Both radiator size and fan model choice appear, in tests, to be relatively unimportant, presuming that the noise level is kept constant. The position and direction of the fan, however, has significant impact on both the temperature and the sound level.Water blocks can be designed in several different ways, both regarding the heatsink design and the flow direction. In simulation, flow with the inlet centered above the heatsink result in considerably lower pressure drop and slightly higher temperatures than flow through the block, for heatsinks with fin arrays.Creating a competitive product in this product segment certainly seems possible, as there are performance-increasing changes to be made that seemingly has little impact on the production cost.

The use of Power Line Communication, PLC, as a communication solution for Automated Meter Reading, AMR, is popular by utilities in Sweden and other parts of the world due to demands of accurate and fast meter reading. However the use of the electrical grid as a communication medium is complex and sometimes problematic. This report handles some of the issues and problems that are important to understand when using the grid as a communications medium. Focus is mainly on investigating high frequency distortion in the Kristianstad power grid own by C4energi caused by a frequency converter. Measurements on site are done to investigate signal damping in the grid, different configurations for the frequency converter and signal strength of the PLC-system.

The use of Power Line Communication, PLC, as a communication solution for Automated Meter Reading, AMR, is popular by utilities in Sweden and other parts of the world due to demands of accurate and fast meter reading. However the use of the electrical grid as a communication medium is complex and sometimes problematic. This report handles some of the issues and problems that are important to understand when using the grid as a communications medium. Focus is mainly on investigating high frequency distortion in the Kristianstad power grid own by C4energi caused by a frequency converter. Measurements on site are done to investigate signal damping in the grid, different configurations for the frequency converter and signal strength of the PLC-system.

Various electromagnetic (EM) treatments has been investigated for their potential in improving crop productivity over the past century. There is today an increasing amount of scientists advocating EM treatments as an organically compatible method for improving plant growth and yield. However, failure to produce repeatable effects and defining causal mechanisms has made it a study of much controversy and debate. The subject requires indepth interdisciplinary knowledge, making it inaccessible for the majority of biologists, horticulturists and growers. In this combined literature review and pilot study, these issues are addressed by providing a comprehensive introductory review of the topic plant bioelectromagnetics and its potential horticultural usability.

AimThe aim of this study was to investigate and describe qualified nurses? worries related to handling chemotherapeutic drugs, further is the aim to explore if the nurses comply with the guidelines at a haematological ward. MethodThe cross-sectional study uses a descriptive design and a quantitative approach to analyze nurses? worries at a haematological ward. The data has been collected through questionnaires which were handed out to 42 nurses at the haematological ward. The questionnaires included 17 questions that were designed by the authors of this study, and 32 nurses returned the questionnaire. ResultsThe majority of the nurses declared that they handle chemotherapeutic drugs once or more a week. The results of the study show that the nurses´ comply with the available guidelines are relatively good.

AbstractIntroduction: Hand Arm Risk Assessment Method (HARM) is a tool to assess the risks of deve­lo­ping complaints of the arm, neck or shoulders during manual work. The method was developed in the Netherlands primarily for employers, but is also used as an aid to work environment in­spec­tors. The purpose of this study was to evaluate the HARM-method for assessment of biomecha­nical exposure of the upper limbs when performing manual tasks as well as its suitability to be used within work environment inspection. Methods: Ten labour inspectors conducted assessments of five video-recorded work tasks. Assess­ments made with HARM were compared with those made with the Assessment of Re­pe­titive Tasks (ART) tool and with ACGIH Hand Actvity Level (HAL) - both methods for assess­ment of bio­mecha­nical exposure of the upper limbs - and with the model for the assessment of re­pe­titive work in the pro­visions of the Swedish Work Environ­ment Autho­rity on ergonomics for the prevention of mus­culo­skeletal disorders, AFS 1998:1.

Beacon AB has been producing Gobos for some time. A Gobo is a small round sheet used in projectors almost like a slide. It is used mostly in the commercial and entertainment business. Today these Gobos are created by using a film (also called mask). A digital exposure machine called LIOS has been developed to make it possible to create Gobos using direct exposure.

Teorier inom Kognitiv hörselvetenskap beskriver hur uppfattning av tal beror på två olika typer av processer. Bottom-up processer associeras med akustiska och fonetiska egenskaper hos en inkommande signal och top-down processer associeras med lexikala, syntaktiska, semantiska samt kontextuella egenskaper. Förmågan att utnyttja top-down processer tros bero på kapaciteten hos arbetsminnet. För att undersöka en skillnad mellan bottom-up och top-down samt deras förhållande till arbetsminnet har ett Speech-in-Noise (SIN) test utformats och genomförts på 15 försöksdeltagare. Testet undersöker skillnader i tröskelvärden för att identifiera ett enstavigt ord i ett uppåtgående förhållande till stationärt brus, mot tröskelvärden för att identifiera ett enstavigt ord i stationärt brus med hjälp att top-down stöd.

Volvo Human Monitoring (VHM) is an ongoing project at Volvo Cars where they measure, amongst other parameters, inhalation and exhalation through a device called Respiratory Inductance Plethysmograph (RIP), on drivers. RIP measures changes in the cross-sectional area of the chest and abdomen. When the driver is in motion, such as when she is turning the vehicle, the cross-sectional area changes and noise in the RIP signal may arise.The noise results in a large number of manual adjustments in the analysis of the RIP signal, which is very time consuming and the validity of the device for measuring inhalation and exhalation is questioned.The purpose of this study was to improve the efficiency of the analysis of the RIP signal. The goal was to create a new data processing tool in Matlab that automatically detects inhalation and exhalation from a RIP signal with higher validity compared to the previous data processing tool.In this study, nine tests were performed on drivers while they were driving in different scenarios such as highway, country road and in city traffic. Inhalation and exhalation was measured using a RIP, a pneumotachograph with a tightly sealed facemask and a thermocouple placed between the nose and mouth, which was used as reference to the RIP.The result of this study was a data processing tool that automatically detects inhalation and exhalation with higher validity compared to the previous data processing tool.