Highland Group AB was helping a customer of theirs to create an All-Terrain Vehicle (ATV), a project Highland has never been involved with before. For the wishbone arms of the wheel suspension, traditional manufacturing methods and tubes with cylindrical or square shaped cross section was preferred. We performed a simulation where the ATV was driving on a bumpy road too see the forces involved. With the results we proceeded to calculate the strength of the concepts to find out which is best suited for the tough environment in which the ATV is used. The concept that turned out to be the best was a wishbone made of circular cross section, which had good structural strength and did fulfill the demands that we required for the construction.

Landlocked Tajikistan is situated in Central Asia and is not only the smallest republic of Central Asia, but it is also one of the most mountainous with some of Central Asia?s highest peaks. Tajikistan is currently and historically the most financially disadvantaged country within Soviet Union/Russian territories. Agriculture is the main occupation for more than half of the country?s population. Unfortunately, however, only 7% of Tajikistan is arable land and the agriculture productivity is low.

The assignment given to us by NCC was to compose a degree project based on ground excavations for power cables. The aim of the study was to examine suitable excavation methods depending on different possible terrain conditions. The amount of previously written material within this subject is nearly non- existent and therefore there is a genuine interest by the NCC to receive a compilation of different production methods. The greater part of this study is based upon interviews with several companies active within this area of expertise. The technique of placing the electricity grid beneath ground for safety is today getting more and more common.

Digital depth-to-water maps can be produced from a digital elevation model (DEM). Then GIS- based algorithms are used to calculate water flows and the depth-to-water index classes dry, fresh, moist and wet. The purpose of this study was to investigate the possibility to use depth- to-water maps for site adapted planting.The results showed that use of depth-to-water maps for site adapted planting, roughly halved the proportion of improperly planted surfaces from an average of 9 % to 4 %. The variation in the values of proper surface decreased and the result became more even.. In addition, more pine than spruce was incorrectly planted.

If you keep cattle in a herd outside all year round on big varying grounds, their possibilityto perform their natural behaviour increases. This way of keeping cattle requires that youprovide them with their other needs, like shelter and a dry and clean resting place.According to the animal welfare authority´s regulations on livestock farming, only animalsthat are suited to stay outside during the cold season are allowed to be kept outside. Theyshould also have access to a shelter or another building that gives them protection from theweather and wind and provides a dry and clean resting place.Research has shown that as long as cattle do not get exposed to precipitation and wind theywill manage low temperature well. Some of the things that will affect how well the animalshandle different climates are the isolation ability of the fur, the animals´ body size and thefeed intake. A dry lying place that is both insulating and moisture absorbent is also of greatimportance.

A geographical position and its social, cultural and political context as well as climate and specific physical characteristics define the scope for a landscape design project. This has become clearer for us in our master project where we have made a Design Program for the outdoor environment of Wollo University in Dessie, Ethiopia and analysed and reflected on the work and process. The aim for the project has been to design an attractive and functional outdoor environment for the Campus, based on the inventories and the needs and wishes of clients and users. But, the aim has also been for us as landscape architect students to gain a greater knowledge about landscape architecture and the design process by position ourselves outside our usual context. The method has been open and seeking where the site, literature studies, dialogues with people and our own experiences from the field study in Ethiopia has influenced the work. Wollo University is situated 400 kilometers north of Addis Ababa, in a mountainous landscape. It faces problems of heavy rainfall during the summer, soil erosion, a lack of essential facilities, and is still a construction site with empty spaces in-between buildings and infrastructure.

?Development of methods for the planning and implementation of ditch clearing with modern methods?, is a long title for an exam work but that is what this report describes. In Sweden, we have a limited area available, and with the present development with increasing market oil prices, and enormous forces on the renewable energy sources, we need every hectare possible to protect the output of the forests. So with this in mind, many people are now considering how to increase the production of the forests that are already available. A part of production increases is to manage the existing forests, and not to allow this area to go to cultivation or become marshland. We manage our forests in a way that benefits the environment, and we consider that our working practice over the years has shown us to be correct and well functioning. A part of our way of producing forests is to ensure that we have functioning drainage systems in the forest holdings which we administer. The responsible at Holmen Skog requested a good method to make inventories of the drainage systems of Holmen forests. This Degree Project is about ways to identify and implement drainage systems with modern methods. It deals with authorities regulations, and how they operate in different counties.

The work examines geographical variations of bicycle use in Trondheim municipality with the aim to create an understanding of what influences the use of bicycles and explain the geographical travel pattern for cycling. The work focuses on the how physical structures generates different transports effects. Where bicycle travels in Trondheim municipality are undertaken is described by using network analysis in ArcGIS, based on aggregated data from the travel habit survey (RVU) in 2009/2010. Trondheim municipality is divided into smaller geographical units (zoner) whose characteristics are described by 19 variables, categorized into 6 groups; Distance, Land use, Topography, Bicycle Facilities, Road characteristics and Demographic factors.By linear regression analysis in SPSS and ArcGIS Spatial Analyst, an explanatory model is elaborated. The variablesdistance to the regional center, workplace density, percentage separate bike paths and hilly terrain explains 78 percent of where cycle journeys are undertaken.

Den amerikanska armén har under lång tid haft doktriner som behandlat strid i bebyggelse medolika typer av motståndare, från sovjetiska divisioner som anfaller in i Västtyskland tillupprorsbekämpning i Mellanöstern och Afrika. Uppsatsen handlar om hur den amerikanska taktiskasynen på strid i bebyggelse har utvecklats från 1979 till 2003.Syftet med den här uppsatsen är att skapa en större förståelse för den taktiska utvecklingen somskett kopplat mot de grundläggande förmågorna verkan, skydd & rörlighet.En kvalitativ textanalys har använts som metod för att analysera de aktuella doktrinerna. Teorinutgår ifrån Doktrin för markoperationer och i synnerhet ifrån de grundläggande förmågorna verkan,skydd & rörlighet.Resultatet visar att användningen av dessa förmågor utvecklas med hänsyn till förväntadmotståndare och civilbefolkning. Utvecklingen av verkan går mot mer kvalitativa medel ochmetoder, motståndarens rörlighet har förändrats och så har också hans vilja att strida i bebyggelse.Användningen av assymmetriska metoder för att uppnå skydd är en ny metod som uppkommit.Värdering av den terrängen är däremot något som inte har förändrats..

A growing number of cities and municipalities in Sweden begin to work with city models in 3D. For the most part the models are used for visualizations of ongoing planning processes, but also for the analysis of noise, shadow studies and environmental disaster simulations.Gothenburg continues to develop the use of 3D maps in municipal operations and is demanding a way to create building elements (walls), which generates in 3D buildings, from roof constructions that are mapped from the primary map. A method has been investigated in the present study. The results are then presented as a 3D model of buildings, along with a terrain map that will facilitate the localization of the area. The created 3D buildings are then compared with roof-data from the primary map to see how well they harmonize with each other.

This thesis is a feasibility study for a future product development project. The purpose ofthis project is to evaluate the possibilities and difficulties associated with the design of anelectric power assist servo for all terrain vehicles (ATVs). The project has been carriedout in collaboration with Nira Control AB. Nira designs and manufactures electric andelectro mechanic products mainly for the motor sport market segment.Nira Control AB is developing a fuel injection system for a new line of large ATVs oncommission. To be able to compete with manufacturers like Yamaha and Honda thecommissioner should be able to offer optional power assist steering.

Beef cattle wintering outdoors should be provided a shelter, e.g. a type of barn or corresponding. This type of production requires appropriate soil types and secured animal welfare. For example, a clean and dry resting place needs to be provided to the animals. To receive an exemption for buildings the farmer has to have something equivalent that provides an adequate shelter.

In this paper I have sought a suitable level of abstraction in my models describing the landscape; the models are made to be viewed from eyelevel. Because of the spectator being ?in the model? the objects included need a certain degree of realism. I have sought what is needed in the model to be able to comprehend that the model is showing a landscape. Some details might be unnecessary.

It is sixty years since Sweden's first star-shaped housing estate was built in Gröndal, a suburb of Stockholm. Olle Engkvist, the building contractor, was the driving force behind the residential area and it was designed by architects Sven Backström and Leif Reinius. The estate comprises detached star-shaped houses suited to a more hilly terrain and terraced star-shaped houses on the flat land. The eight gardens of the terraced houses form the shape of a hexagon. It is these gardens, designed by Sven Hermelin and Per Friberg, which are the main focus of this thesis. The buildings on the estate have recently been renovated and it is now time for the gardens to be restored.

A common problem in forestry is plant death caused by frost. The risk of frost is highest on wind protected, flat or low-lying areas in the terrain. Here you often have regeneration problems with Norwegian spruce which is especially sensitive to spring frost. Swedish tree experiments have shown that the black spruce can be a suitable alternative on these areas, for example on moisture frost prone areas. The species originates from North America and its pioneer tree characteristics make it more frost hardy than Norwegian spruce.