On a request from the water sewage plant Gryaab in Gothenburg a power quality survey wasperformed. The voltages and currents have continuously been sampled in the incoming 10 kVsubstation HSP01 from April-August 2008. Power quality measurements were also performedin Gryaabs other 10 kV substation HSP04 fed from HSP01 and at the terminals of theinduction motor IN_PU4040 of 1.3 MW which controls one of the four large inflow pumps tothe plant. The reason for the latter measurement was due to registered negative transients eachtime the motor was connected to the grid. The cause of the transients could be explained by thecoupling in the substation, the ageing of the motor which could result in damage of thebearings or resonance in the motor circuit which amplifies high frequency harmonics.

Detta examensarbete behandlar barns motoriska förmåga på tre olika förskolor, utifrån ett MUGI-test. Vårt syfte var att undersöka om det går att utföra ett MUGI-test på femåriga barn. Vi har observerat barnen som utförde övningar i MUGI-testet. Vi har kommit fram till ett resultat, som vi sedan har diskuterat och analyserat. Resultatet visar att nästan alla övningar är för svåra för barnen att genomföra, därför blir vår slutsats att MUGI-testet inte går att genomföra med femåringar på grund av att de inte kommit så långt i sin motoriska utveckling..

The task was to design and manufacture a submersible displacement pump working with the wobble plate principle. The main task for the Wobble plate pump is to be used as a sewage pump for smaller households or dewatering pump in environments where small flows and high pressures are acquired. For these purposes ITT Flygt sell a screw pump, PC-Grinder 3068. The hydraulic part of the PC-Grinder is manufactured by a subcontractor. Therefore ITT Flygt wants to evaluate an alternative to their screwpump PC-Grinder, which can be entirely manufactured by them self.

Med detta examensarbete vill vi belysa problematiken runt tredimensionell fastighetsbildning. Som objekt har vi använt oss av ett bergrum på Liljeholmskajen i Stockholm..

AbstractThis report is about the creation of a test system for development of a control system for a off the shelf RC-helicopter, which can be bought for about two thousand SEK. The test system consists of both electronics for controlling the helicopter and mechanical constrainer. The constrainer is used for mounting the helicopter so that it won´t crash.A circuit board including processor and sensors was manufactured. This was used for doing test of the different control algorithms. In this way were we able to analyze the quality of the sensors chosen, and what other sensors that could contribute to the control of the system.Basic helicopter control have been studied and presented in the report.

On a request from the water sewage plant Gryaab in Gothenburg a power quality survey was performed. The voltages and currents have continuously been sampled in the incoming 10 kV substation HSP01 from April-August 2008. Power quality measurements were also performed in Gryaabs other 10 kV substation HSP04 fed from HSP01 and at the terminals of the induction motor IN_PU4040 of 1.3 MW which controls one of the four large inflow pumps to the plant. The reason for the latter measurement was due to registered negative transients each time the motor was connected to the grid. The cause of the transients could be explained by the coupling in the substation, the ageing of the motor which could result in damage of the bearings or resonance in the motor circuit which amplifies high frequency harmonics.

On a request from the water sewage plant Gryaab in Gothenburg a power quality survey was performed. The voltages and currents have continuously been sampled in the incoming 10 kV substation HSP01 from April-August 2008. Power quality measurements were also performed in Gryaabs other 10 kV substation HSP04 fed from HSP01 and at the terminals of the induction motor IN_PU4040 of 1.3 MW which controls one of the four large inflow pumps to the plant. The reason for the latter measurement was due to registered negative transients each time the motor was connected to the grid. The cause of the transients could be explained by the coupling in the substation, the ageing of the motor which could result in damage of the bearings or resonance in the motor circuit which amplifies high frequency harmonics.

On a request from the water sewage plant Gryaab in Gothenburg a power quality survey was performed. The voltages and currents have continuously been sampled in the incoming 10 kV substation HSP01 from April-August 2008. Power quality measurements were also performed in Gryaabs other 10 kV substation HSP04 fed from HSP01 and at the terminals of the induction motor IN_PU4040 of 1.3 MW which controls one of the four large inflow pumps to the plant. The reason for the latter measurement was due to registered negative transients each time the motor was connected to the grid. The cause of the transients could be explained by the coupling in the substation, the ageing of the motor which could result in damage of the bearings or resonance in the motor circuit which amplifies high frequency harmonics.

On a request from the water sewage plant Gryaab in Gothenburg a power quality survey wasperformed. The voltages and currents have continuously been sampled in the incoming 10 kVsubstation HSP01 from April-August 2008. Power quality measurements were also performedin Gryaabs other 10 kV substation HSP04 fed from HSP01 and at the terminals of theinduction motor IN_PU4040 of 1.3 MW which controls one of the four large inflow pumps tothe plant. The reason for the latter measurement was due to registered negative transients eachtime the motor was connected to the grid. The cause of the transients could be explained by thecoupling in the substation, the ageing of the motor which could result in damage of thebearings or resonance in the motor circuit which amplifies high frequency harmonics.

On a request from the water sewage plant Gryaab in Gothenburg a power quality survey wasperformed. The voltages and currents have continuously been sampled in the incoming 10 kVsubstation HSP01 from April-August 2008. Power quality measurements were also performedin Gryaabs other 10 kV substation HSP04 fed from HSP01 and at the terminals of theinduction motor IN_PU4040 of 1.3 MW which controls one of the four large inflow pumps tothe plant. The reason for the latter measurement was due to registered negative transients eachtime the motor was connected to the grid. The cause of the transients could be explained by thecoupling in the substation, the ageing of the motor which could result in damage of thebearings or resonance in the motor circuit which amplifies high frequency harmonics.

Emotional intelligence (EQ) has been claimed to be the most critical factor in determining a person's success in life, both personal and professional. EQ highly affects academic and job performance, leadership, stress, and well-being but is still not widely accounted for in recruitment processes. During the last 20 years a large number of researchers have shown interest in the concept of emotional intelligence, but few have studied its practical implications and how EQ-tests are used as a selection tool in recruitment processes. To create an understanding of the motivation for using the test, as well as its role in recruitment decisions, qualitative interviews have been conducted with recruiters at companies in Stockholm, Sweden. All interviewed companies use the self-assessment test EQ:i 2.0.

On a request from the water sewage plant Gryaab in Gothenburg a power quality survey was performed. The voltages and currents have continuously been sampled in the incoming 10 kV substation HSP01 from April-August 2008. Power quality measurements were also performed in Gryaabs other 10 kV substation HSP04 fed from HSP01 and at the terminals of the induction motor IN_PU4040 of 1.3 MW which controls one of the four large inflow pumps to the plant. The reason for the latter measurement was due to registered negative transients each time the motor was connected to the grid. The cause of the transients could be explained by the coupling in the substation, the ageing of the motor which could result in damage of the bearings or resonance in the motor circuit which amplifies high frequency harmonics.

The purpose of the present study was to translate Western AphasiaBattery ? Revised (WAB-R) to Swedish and test the translation on a group of nonlanguage-impaired individuals. The purpose was also to establish equivalencebetween WAB-R and its Swedish translation and to examine a possible correlationbetween test results and the background factors sex, age, educational length andfirst language. 67 subjects participated in the study. The results showed that femalesex, long education (?12 yrs) and being a native speaker of Swedish had significantpositive association to a higher test result.

On a request from the water sewage plant Gryaab in Gothenburg a power quality survey wasperformed. The voltages and currents have continuously been sampled in the incoming 10 kVsubstation HSP01 from April-August 2008. Power quality measurements were also performedin Gryaabs other 10 kV substation HSP04 fed from HSP01 and at the terminals of theinduction motor IN_PU4040 of 1.3 MW which controls one of the four large inflow pumps tothe plant. The reason for the latter measurement was due to registered negative transients eachtime the motor was connected to the grid. The cause of the transients could be explained by thecoupling in the substation, the ageing of the motor which could result in damage of thebearings or resonance in the motor circuit which amplifies high frequency harmonics.

A vehicle that carries a person sitting in a wheelchair has been rebuilt. The original vehicle was provided with a petrol engine, hydrostatic drive and a mechanical steering rod, making it noisy and hard to maneuver. The purpose with this project was to convert the vehicle to make it more environmental and easier to drive.A new design has been proposed where an electrical drive has replaced the noisy combustion engine and an electrical motor with joystick control has replaced the manual steering.The project was divided into two parts. One mechanical part where the construction of the drive and steering were to be decided. The other part involved programming the microprocessor and implementation of all the necessary electrical for the control system of the vehicle.