Chapter 1 defines the aim of the project and gives a general orientation about ground heat extractors. In chapter 2 physical processes that could be expected to be involved in the heat transport around a ground heat exchanger are discussed. It is shown from a literature study what amount of Moisture transport due to thermal gradients there could be expected in a ground heat exchanger. The conclusion is drawn that the Moisture gradient (Sr) is of same magnitude as the driving temperature gradient (°C). At the expected amount of increased Moisture around the pipes the Moisture transport could be considered to have a little effect on the brine temperature.

Wood pellets are an upgraded product of residuals from several wood processing industries, for example saw mills and pulp industries. The pellets are produced by pressing the milled and dried sawdust to cylindrical units with a higher density than the initial raw material. Pellets have great benefits compared to the raw material: high energy per volume, good transport and storage properties and homogeneity. Several parameters collaborate in the whole process, which makes it complex. Wood is a heterogeneous material, chemically and structurally dependent on wood parts, habitat and storage procedures.

When the Eolshällproject was completed for the first time, a great deal of Moisturedamage was discovered. Therefore the structure completion was removed andreinstalled. The project was originally planned to cost a total of 126 million SEK, but thefinal costs landed on 271 million SEK. What caused this failure? Were the designs poor,was the technology used too advanced, or was the project not managed properly?Based on the Eolshällproject, theses will be presented about what may have caused theMoisture damage.

In the current situation a big part ofthe settlements that exist in Sweden isin need of renovation and energyefficiency in order to survive.Therefore, also many of the older houseswith a wooden structure are in a need ofenergy efficiency, which can be done ina variety of ways, including addinginsulation.This project deals with whether the useof a diffusion barrier or a vaporbarrier affects a wall structure byadding insulation to an older house witha timber frame. The insulation materialswhich are concidered in thisinvestigation are mineral wool and woodfiber insulation. Efforts are focused onthe effects of Moisture on theseinsulation materials.To demonstrate the differences thatarise the Moisture measurement programWUFI have been used to simulate avariety of wall designs. These designsare developed in consultation with theconstruction carers who are active inthe industry.Using WUFI graphs illustrating theMoisture levels of the wall structureswere obtained and from these conclusionsvould be drawn. The work demonstratesthe differences that arise when using adiffusion barrier or vapor barrier inwall construction.

This report is the result of a degree project in building engineering, at an advanced level. The project evaluated a building from a technical and historical point of view, and focused on its energy consumption, particularly the energy used for heating. The building in question was a small apartment building in Strömsholm, Sweden. It was made in 1902, from vertical logs, a not so common form of the traditional log house. The goal of the project was to evaluate if the energy consumption could be reduced in accordance with building preservation regulations, that is without damaging any of the building?s cultural or historical values.The building was surveyed with the help of archive and literature studies, interviews and inspections.

In this study, the effects of using fine milled cassava stems as an additive in biofuel pellet production was compared to the effects of refined starch addition. The bulk biomass fuel raw material, to which the additive was added, was a blend of spruce and pine sawdust. An experimental design in the factors cassava/starch content, Moisture content and material temperature was used. Measured responses were pellet bulk density, pellet durability, amount of fines, pelletizer motor current, pellet temperature, die temperature and CV for pelletizer motor current (a measure of process stability). Each response was modeled by multiple linear regression (MLR).

There is an uncertainty in the market for grain forcing the meat/milk producers to review alternative feeds to a larger extent, in order to get control over the feed costs. This has led to that the meat/milk producers need to have a good knowledge regarding how the different feeds influences the animals and which technical equipment to use for handling. For those that produce their own feedmix, there is a need to put interest in new crops and their characteristics to be able to get the knowledge of what is required for their own production. It is beneficial to keep an open dialogue with advisors to be updated in new crops and new technology for feeding. When mixing feed at farm level, the legislation is not very clear since it the target group is large scale mixing plants. We have brought up the most important rules and regulations from the EU parliament Council as well as the ones from the Swedish Board of Agriculture (SJV), regarding feed mixing on farm and factory level. We have studied beans and pea at two different Moisture levels, in order to evaluate how the Moisture level affects the distribution of particles when milling with a plaitmill and a hammermill.

Soil properties affect the chemical composition of soil water. When studying transport of chemical substances through a basin, it is therefore important to know from which soil layer the main part of the runoff is generated. The aim of this study is to develop an HBV/PULSE model with merged soil Moisture and response routines, which generates good approximations of groundwater levels. It should be possible to extend the model to simulate transport of substances and take into account which soil layer the groundwater level is currently in. The hydrological version of HBV/PULSE is used since there is no need to account for pH or alcalinity at this stage.

Storage of biomass is associated with problems like heat development, biomasslosses, and reduction of the fuel quality. Certain processes such as biological- andchemical degradation are responsible for these storage problems. This master?sthesis was carried out at Vattenfall Research and Development AB and is alignedtowards quantifying the biomass losses from short-term storage (1-2 months) ofbark and recovered wood. The biomass was stored in outdoor piles during differentseasons, campaign 1 (summer) and campaign 2 (autumn).

During the 1990?s a large number of building projects were revealed where lack of moistsafety precautions during the construction process had led to extensive Moisture damage. Alsoresent implemented studies have shown that the problems with Moisture damages have ratherincreased than decreased during the past few years. Moist is considered to be one of the mainfactors to cause unhealth due to deficiencies in the indoor-environment and does also causeunnecessary expenses and a reduction of the confidence in the construction industry.In this Bachelor of Science thesis three projects have been reviewed to examine how moistsafetyhas been observed during the construction process. Main focus has been to identify thebuilding components that are the most exposed to moist, and to examine how they have beentaken into account during the period of design and construction.

The aim of this study was to evaluate the stir drying method, for drying of grain during Swedish conditions. The evaluation was done during the harvest year 2004, on four farms with stir driers. The driers were evaluated for their energy consumption, design, stirring effectiveness and how much time the farmer has to spend on every tonne of grain. A comparison was also done with conventional Swedish high temperature driers. Totaly six batches of grain from stir driers were examined, mostly winter wheat, but also barley and wheat.

During the late 1800s fire suppression became increasingly effective in northern Sweden which led to decreased areas of fire-disturbed woodland and successive changes in the structure of forests. In the long run this can pose a serious threat to fire-dependent and fire-favored species. Today some fire-prone forest reserves are burned as a nature conservation act. Often partial cuttings are made before burning, with somewhat different motives. The purpose of the study in Långsidberget nature reserve was to give a general picture of forest history and its affect on today?s forest condition, and to show how partial cuttings affect burning conditions and results. Långsidberget is located close to areas that were colonized during the Middle Ages.

Digital depth-to-water maps can be produced from a digital elevation model (DEM). Then GIS- based algorithms are used to calculate water flows and the depth-to-water index classes dry, fresh, moist and wet. The purpose of this study was to investigate the possibility to use depth- to-water maps for site adapted planting.The results showed that use of depth-to-water maps for site adapted planting, roughly halved the proportion of improperly planted surfaces from an average of 9 % to 4 %. The variation in the values of proper surface decreased and the result became more even.. In addition, more pine than spruce was incorrectly planted.

The number of people of getting allergic symptoms is increasing and the reasons are considered to be many. The human have changed their habits and spend more time indoor. In combination with new building technologies where denser housing constructions and new materials this causes bad indoor climate contributes to a higher occurrence of allergiesThere are several courses of action to deal with this problem. One action is by choosing allergy-free interior surface materials. An allergy-free material emits low concentrations of harmful substances resulting in a great indoor air quality.

Between 1965 and 1974, the Swedish Parliament decided to build one million dwellings, called Million Program. The million program buildings were erected with new, untried design solutions, in a short range of time, and at low cost. The residential buildings from that time are now greatly in need of renovation. The municipal housing company, Gavlega?rdarna, renovates and improves the energy efficiency at some of it?s apartment buildings in the district Sa?tra, Ga?vle.