This is a final thesis done at BT, considering one of their forklift truck models called Reflex. The first part of this report is about a preliminary investigation investigating what kind of diagnostic systems BTwants to use, and also which demands there are to meet all expectations on such system. Secondly a diagnostic system, which will show if the drive wheel is worn out, will be presented. In the preliminary investigation, two kinds of diagnostic systems were mentioned. These were Model based diagnosis and Predictive analysis.

The objectives of this research were to determine whether the natural rattan resources in Sulawesi, Indonesia can cope with the strongly increased harvesting pressure that has occurred over the last centuries. I was furthermore looking for patterns in the rattan population dynamics that might give a hint on how the harvesting system could be improved to ensure a maximum sustainable yield. To answer these questions, I developed an individual-based model to analyse the dynamics of rattan growth in connection with rattan harvests by locals to identify sustainable levels of rattan harvests around villages in Sulawesi, Indonesia. Scenarios with different harvesting intensities were run to compare the change in harvest amount. For a given harvesting pressure, scenarios with a high number of harvesters and a low harvesting frequency had the same effect as scenarios with high harvesting frequencies and a low number of harvesters.

The Multispectral Canopy Reflectance Model (MCRM) by Kuusk (1995) has beenused to simulate the reflectance of a sugarbeet canopy. The simulated reflectancevalues show high absorptance in the VIS area, compared to field measurements, andhigh reflectance values in the NIR area. The errors may be due to overestimation ofclorophyll content in the sugarbeet leaves and scattered light during fieldmeasurements. The estimation of the clorophyll content where carried out using thePROSPECT-model by Jacquemoud & Baret (1990).During the vegetation period, the state of the canopy moves towards a closed canopy,with sparse vegetation in spring. The MCRM-model was used to perform a ?spring?simulation, which was compared to the original simulation.

Based on laboratory studies with lysimeters, the concentrations of dissolved reactive phosphorus(DRP) and particulate phosphorus, which is the main part of other P (OVRP), has been studied inpercolating water. The experiment was conducted through irrigation of small soil columnscontaining clay topsoil from an experimental field in Västergötland. Three rain simulations wereconsecutively performed. DRP concentrations in the percolating water ranged between 0.2 - 0.3mg·Lclearly related to the phosphorus concentration in the soil, measured in a soil extract ofammonium lactate (P-AL). Concentrations of OVRP were relatively low and ranged between0.12 and 0.16 mg·Lwas not proven and the experiment may reflect how a relatively slow percolation of water mayrelease DRP.

Business Process Modelling Notation (BPMN) is a way to graphically draw a diagram of a business process. A BPMN diagram consists of several so-called flow objects. These are interconnected in the graph through sequence  flows. BPMN models are merely graphical representations of business process and there is a need to simulate these diagrams for different purposes. The simulation that now is available for BPMN is that the model is evaluated by checking if it is correct.

Delar av marken i Uppsala består av mäktiga lerlager. Naturliga krypsättningar pågår ständigt i området, en process som i litteraturen benämns geologisk åldring. Ökad belastning i form av uppfyllnad kring byggnader och sänkt grundvattenyta till följd av pumpning av färskvatten bidrar också till sättningar. I ett nybyggt bostadsområde på Kapellgärdet har marksättningarna intill de pålade husen på vissa platser uppgått till 0.3 m på 10 år.Med geotekniska data för området har en jordprofil tolkats. Analys har gjorts utifrån den klassiska sättningsteorin för primärsättningar till av ökade effektivspänningar från fyllnadsmassor och grundvattensänkning.

This bachelor thesis in mechanical engineering was performed during the spring2015 in collaboration with Composite Consulting Group in Laholm. TheComposites Consulting Group works mainly with design and details of differentcomposite projects, their main area is FE-calculations, 3D-modelling andmechanical tests with composite materials.The aim of this bachelor thesis was to simplify the calculation process of solidmechanics for sandwich panels by simulation with computer software. The goalwas to decrease the time for the design and calculation process of the constructionand the cost of the practical tests. Our task was to build a static three dimensionalmodel with the computer software Abaqus, where the result should correspondwith the practical pressure tests in laboratory.The project started with collection of material data from Composites ConsultingGroup and by learning the software Abaqus, simultaneously a specification wasdeveloped in corporation with the company. Later on, a static wheel pressuremodel in the software Abaqus was produced which simulated the behavior of thesandwich panel during static wheel-pressure by a pallet truck.

Alkoholberoende och missbruk är ett omfattande problem i såväl Sverige som i övriga delar av världen. Med tanke på de fysiska, psykiska och sociala konsekvenser som missbruket leder till för både missbrukaren, och människor i hans eller hennes omgivning, finns det all anledning att undersöka möjligheter för att åtgärda detta. Syftet med detta examensarbete är att kartlägga olika behandlingsmetoder och att med psykologiska teorier om mänskligt beteende som utgångspunkt komma fram till den behandling en alkoholberoende individ behöver. Resultaten visar på att såväl personlighetsfaktorer som det sociala sammanhang individen befinner sig i har betydelse för om han eller hon missbrukar alkohol eller inte. Den sociala miljön bidrar till stor del till en alkoholberoende individs identitet och beteende.

Byggbranschen är inne i en övergångsfas mellan 2D och 3D. BIM, som arbetsmetod, och 3D-modeller blir allt vanligare. I broprojekt är dock efterfrågan på dessa modeller låg. På WSP i Stockholm används 3D-modelleringprogrammet Tekla Structures i stor utsträckning på flera avdelningar. Önskemål finns om att utöka användningen av programmet även inom broprojektering.

Business Process Modelling Notation (BPMN) is a way to graphically draw a diagram of a business process. A BPMN diagram consists of several so-called flow objects. These are interconnected in the graph through sequence  flows. BPMN models are merely graphical representations of business process and there is a need to simulate these diagrams for different purposes. The simulation that now is available for BPMN is that the model is evaluated by checking if it is correct.

Reverse logistics is getting more and more attention both from companies and the public. It is an area with the possibility for companies to do good in the eyes of the public. This work focus on the return system of a one-way handling material called the loading ledge. The loading ledge is developed by IKEA as a substitute for the EUR-pallet in transports from suppliers with a long distance and even flow and in transports from suppliers with short distance and uneven flow. The loading ledge is made out of 100 % recyclable plastic.The purpose of this work is to find the most efficient set-up for recycling of loading ledges within IKEA on a European level from a transport and handling point of view considering aspects like cost, environment, time and, from an administrative point of view, user-friendliness.Who will the participants of the set-up be, where will they be located, which transports are needed and which income and costs does the set-up generate, are questions that will be answered.

Cultural heritages are environments created by humans that are considered to have a conservation value for the posterity. They can be seen as one of society's non renewable resources. It is important to have knowledge of how cultural heritages are affected by future climate changes.The water flow in Uppsala is estimated to increase during winter and decrease during spring and summer. Precipitation will gradually increase as well as the intense short period precipitation. The average temperature is estimated to increase as well.

I samband med att intresset för att bygga högre trähus har ökat så krävs nya lösningar för att t.ex. kunna möta efterfrågan på stora öppna ytor och långa spännvidder. Träbjälklag med lång spännvidd har dock oftast svårigheter med att klara kraven på svikt och vibrationer. Ett nyutvecklat förslag på träbjälklag som förmodas klara dessa krav bättre än traditionella träbjälklag har varit utgångspunkten för detta examensarbete där syftet har varit att undersöka bjälklagets styvhet. Detta gjordes laborativt genom att bygga och testa en prototyp av det föreslagna bjälklaget och genom att en numerisk modell baserad på finita element metoden togs fram och användes för att studera hur olika parametrar påverkar bjälklagets styvhetsegenskaper.Bjälklagets design bygger på fackverksprincipen i primärriktningen och på balkverkan i sekundärriktningen.

Chewing behaviour includes both eating and ruminating activity. Chewing behaviour is of great importance for the feed intake as through the action of chewing (i.e. eating and ruminating) animals mechanically process the forages in small particle sizes and prepare the food for digestion. As cattle grow the chewing behaviour changes along with increasing body weight and chewing efficiency is increased. The aim of this thesis was to review the available scientific literature in order to describe chewing behaviour in growing cattle, as well as the factors that affect this behaviour.

Rapid population growth and the fact that phosphorous is a limited resource implies that the question regarding an efficient use of phosphorus is of great importance, and consequently,that the phosphorous use efficiency should be as high as possible. The view on phosphorous use efficiency, and how this is calculated, has varied over time. This has had great implications on what type of research that has been conducted, which have resulted in an inconsistency between the academic?s view on the subject and recommendations received by farmers. The purpose of this paper is to calculate the phosphorus use efficiency in the Swedish long term fertility experiments.