The thesis describes the following main question: Will the administrative labour during football tournaments be made easier with the help from a mobile web service or will it convey to unnecessary extra work? To be able to give a good and qualified answer to this question, the thesis will in the beginning describe how the technique for such a system might look like and also describe the existing administrative moments during a football tournament, this is too give the reader a deeper understanding for further reading. The thesis then goes on to describe a concrete system which is tested on three football tournaments. On the basis of the tests, interviews and through analysis of these the thesis will be able to answer our questions. The result which we present in the thesis have unfolded through testing of the system on three chosen football tournaments.

This report describes the design and construction of a prototype that automatically aims a microwave link towards a target. The link, that is located on a mobile aerial mast, is used by Saab Training Systems as a part of an infrastructure network. The report also discusses the development of a GUI that communicates with the control unit by Bluetooth.The control unit, called Pan/Tilt-controller, controls the position of the link by stepping motors. One motor controls the azimuth angle and the other one controls the elevation angle.By a GUI the operator enters the coordinates on its own position and the targets position. Hereafter a bearing is calculated and it will be sent up to the control unit.The control unit will sense its own direction by a magnetic sensor that works as an electronic compass.

There are many barriers and obstacles that need to be removed to make the urban environment more accessible for people with disabilities. There are currently no adequate tools for urban planners to assess and address these obstacles. Geographical Information Systems (GIS) provide powerful methods for the visualization and analysis of spatial data, including the kind of data important in studies of accessibility. This study suggests a method urban planners can use to identify accessibility obstacles and to propose future actions to fix them.A literature review was conducted to find out what has been done and what is new regarding the accessibility issues. Different methods were evaluated which in turn led to the construction of a multi-step analytical strategy.

The study aims to investigate the feasibility of small-scale electricity production with solar electricity systems, also known as PV (photovoltaic) systems, in Australia. Due to the global warming, sustainable energy has in recent years become an increasingly important issue, both internationally and in Australia. With one of the largest dependencies on fossil energy sources in the world, the country's abundant solar radiation is a possible solution to this issue.Both the technical and the economic feasibility of small-scale PV systems were investigated. On the technological side, the electricity generation, distribution and consumption systems were studied. On the economical side, the parameters that drive the profitability of a PV investment were investigated.

Detta examensarbete är utfört på Saab Training Systems AB i Huskvarna. Saab Training Systems utvecklar, tillverkar och säljer kompletta militära träningssystem.Syftet med arbetet var att minska ledtiderna, då korta leveranstider blir ett allt viktigare konkurrensmedel. Arbetet innebar en kartläggning av nuvarande reserv- och reparationsflöde samt att identifiera problem och komma fram till förbättringsförslag.Vidare har vi studerat reservdelslagrets lagernivå och dess kapitalbindning.Arbetet genomfördes med hjälp av intervjuer med berörd personal, observationer, enkätundersökning samt statistiska studier. Vi har även arbetat med Supply Chain Operations Reference Model som är en öppen referensmodell med vars hjälp man kan kartlägga, förändra och optimera sin verksamhet.Saab Training Systems har som mål att ledtiderna för reservdelsflödet och reparationsflödet skall vara 14 dagar, men i själva verket är det inte så. Dessa ledtider är idag längre, hur långa är dock oklart.De långa ledtiderna beror främst på att i flödena förekommer det mycket passiv tid.

This Masters thesis work describes a comparison between two different methods for estimation of the down channel (base station to mobile subscriber) in Wide-band Code Division Multiple Access (WCDMA). The first estimation method, Optimal Feed-forward Channel Estimation (OFCE), is a conventional method that bases the estimates on data that is known to both sender and receiver, so called pilots. The second method, Decision Directed Channel Estimation (DDCE), is an elaboration of OFCE. It also uses user data for estimation. Simulations show that DDCE, in comparison to OFCE, does not attain an improvement in signal-to-noise-ratio (SNR) for high bit error rates (BER). An improvement is only seen when the BER becomes much lower than what is common in real situations. In conclusion DDCE is complicated, involves many mathematical operations and gives insignificant improvement of SNR when BER takes common values. It is legitimate to question if it is possible to use the method in a real mobile phone system..

This thesis deals with the goods classification of the Nordic alcoholmonopolies, viz. Alko in Finland, Rúsdrekkasøla Landsins in the FaroeIslands, Systembolaget in Sweden, Vínbúðin in Iceland, andVinmonopolet in Norway. The focus of the study is the web pages of thecompanies (as they appeared April 10th 2011) and the printed pricecatalogue of Alko, from which information on class division has beenexcerpted. The emphasis lies on the division into product groups and theinformation about origin. Within these facets, which partly overlap insome of the classification systems, the principles of division and thehierarchical relations between classes are studied.

Optimizing energy systems is, in Sweden, as in many other countries, of growing interest. District heating systems are no exception. In 2012, 285 out of 290 municipals in Sweden had district heating in use and the majority of these systems have a higher return temperature than that which is possible with an error-free substation of day current technology. To, when possible, lower the return temperature is a way of increasing the effectiveness of the district heating system.This study means to investigate, through simulations and calculations, how big of a reduction in production cost a lower temperature in the city of Ystad?s district heating system would correspond to.

During 2007 the City of Stockholm installed five grid connected photovoltaic systems. The aim of this master thesis is to quantify the amount of produced energy and recommend routines to collect and analyse production data, to make production data accessible by the public and to gain experience for future installations.The total amount of produced energy until March 2009 is 227 000 kWh, with an annual rate of 150 000 kWh. The expected annual rate was 148 000 kWh.All system owners are positive about their plants and see economical benefits in scaling up such systems.The installations need very little attendance and maintenance, however it is recommended that an alarm function is installed for automatic feedback in case of a system failure. All future systems should be inspected during full operation to determine if the actual capacity is matching the installed capacity..

Six different Digital Proofing Systems from three different techniques have been evaluated as totechnique, printing quality, economy and usability. Digital proof from two paper qualities, coatedand uncoated, has been compared with references printed in offset, to see how good they match eachother. Only two Proofing Systems manage to print on reference paper. The other Proofing Systemsuse special paper for digital proof.Measurements and visuell judgement show that the Digital Proofing Systems visualise referencepictures with quite good quality. Proof optimised for coated paper visualise the colours with goodresult.

Den här uppsatsen behandlar mobilmarknadsföring och ämnar svara på frågan om hur lämplig mobiltelefonen egentligen är som relationsmarknadsföringskanal. Vi har funnit de metoder som är vanligast förekommande för att sprida reklambudskap och jämför hur bra de uppfyller kraven för att vara relationsskapande. För att utröna detta har vi intervjuat branschkunniga personer från två av landets största mobiloperatörer samt personer som arbetar på nordiska mobilmarknadsföringsbyråer. För att mäta styrkan hos mobilmarknadsföring som relationsfrämjande marknadskanal har vi genom modeller från relationsmarknadsföringen skapat ett eget ramverk vilket vi applicerat på olika marknadsföringsmetoder via mobiltelefonen. Resultatet av vår studie visar på att mobilmarknadsföring kan användas för att bygga långsiktiga, ömsesidiga och vinstgivande relationer, vid rätt användning.

The aim of this essay is to examine three separate Swedish public libraries and their respective websites on the grounds of the usability sciences. I firstly had to summarize the main properties of the usability-field in order to gain an extended knowledge of its purposes and possible usage for today?s library systems. I was then able to apply the extended knowledge in the examination of the three library websites and the purpose of determining whether or not they were designed according to the standards set by the usability-sciences.Usability is a rather new science that deals with the dissection and examination of computer-based systems, in order to find the key components that make systems user-friendlier. With user needs being the main focus of its research, usability tries to meet all the different needs of the modern user and construct systems that are less system-centered and more user-centered.

Real-time systems are required to answer to external stimuli within a specified time-period. For this to be possible, the systems behaviour must be predictable. The use of active databases in real-time systems introduces unpredictability in the system, e.g. due to their use of active rules. The behaviour in active databases is usually specified in ECA-rules.

The purpose of this thesis is to investigate if there are environments that use some kind of central authentication system within institutions/schools. The hypothesis is that an institution not using a form of central authentication service has more need for maintenance and as such is considered a higher cost for the organization. The gathering of data has been done through interviews with technical personal at Blekinge Tekniska Högskola and Linköpings Universitet. Based on the technical background of the authors, and the system limited to discussing Windows and UNIX operating systems, a discussion and analysis of the systems working today has been done, with emphasize on the hypothesis..

This report is the result of a thesis as been implemented during the spring term 2009 atthe University of Gävle.The company Bruks produces mobile chippers which are used for chipping loggingslash, roundwood and parts of trees. The chipper is powered by a separate diesel engineand the chipper can be assembled on trucks, trailers or some other carrier vehicles.When the chip has passed the chipper drum, the chip is collected in an integrated binwhich is mounted on the vehicles frame with dumping yokes. When these dumpingyokes were designed they were probably created with large material dimensions. Theaim with the degree project is hence to study the strengths of materials and, if possible,to suggest an arrangement that can decrease the total weight on the dumping yoke onBruks´ mobile chippers 805 CT.The CAD-program Pro/ENGINEER was used during the project for outlining the 2Ddrawings,as distributed of constructors on Bruks, to solid 3D-parts. The three-dimensionalassembly from Pro/ENGINEER was transferred to Pro/MECHANICA.