Sweden has a natural gas grid extending along the west coast, from Trelleborg to Stenungsund. There are also several smaller local networks where a planned natural gas pipeline from Skutskär to Hofors prompted the need for a comprehensive study. This study examines the linkages that exist in terms of technology and market of natural gas and biogas in Sweden. Sweden has set high targets for the future with ambition to become independent of coal and oil as energy sources. Since 1985, a part of the solution has been import of Danish natural gas.

AbstractThis report is about the creation of a test system for development of a control system for a off the shelf RC-helicopter, which can be bought for about two thousand SEK. The test system consists of both electronics for controlling the helicopter and mechanical constrainer. The constrainer is used for mounting the helicopter so that it won´t crash.A circuit board including processor and sensors was manufactured. This was used for doing test of the different control algorithms. In this way were we able to analyze the quality of the sensors chosen, and what other sensors that could contribute to the control of the system.Basic helicopter control have been studied and presented in the report.

This Masters thesis work describes a comparison between two different methods for estimation of the down channel (base station to mobile subscriber) in Wide-band Code Division Multiple Access (WCDMA). The first estimation method, Optimal Feed-forward Channel Estimation (OFCE), is a conventional method that bases the estimates on data that is known to both sender and receiver, so called pilots. The second method, Decision Directed Channel Estimation (DDCE), is an elaboration of OFCE. It also uses user data for estimation. Simulations show that DDCE, in comparison to OFCE, does not attain an improvement in signal-to-noise-ratio (SNR) for high bit error rates (BER). An improvement is only seen when the BER becomes much lower than what is common in real situations. In conclusion DDCE is complicated, involves many mathematical operations and gives insignificant improvement of SNR when BER takes common values. It is legitimate to question if it is possible to use the method in a real mobile phone system..

The aim with this study was to investigate the effects a change of manufacturing process would have on the mechanical properties of drill bits made of a WC/Co composite used for stone cutting. The method used today is sintering, where the material is heated in a conventional sintering oven. The other method was microwave sintering, where the material is heated by radiation in the microwave region. Also an investigation of the manufacturing cost were made.The main difference between the two heating methods is that the conventional way is a rather slow process and the microwave method is very fast. The material is also heated homogeniously in the method with mirowaves, aposed to the case with the conventional sintering where the material is heated from the outside in.This makes the material harder and more wear resistent.

Purpose/Aim: The aim of this study is to (1) analyze the amount of exposure disability sports get in Swedens biggest newspaper (Aftonbladet), (2) look at how Aftonbladet portraits disability sports and it?s athletes, and finally (3)  to see if there has occurred any change over time (during the last eight years). Material/Method: The first method used is a quantitative analysis to measure exposure.The second method is a quantitative content analysis which is used to analyze how disability sports are portrait.The third method is rhetorical and is also used to analyze how disability sports are portrayed. Main results: The study has shown that disability sports get very little exposure in Aftonbladet. The articles in the newspaper that cover disability sports are portrayed from a personal point of view without much focus on the athletes achievements regarding his or her sport.

Aquatic organisms are usually not exposed to single substances but rather to mixtures of toxicants in streams located in agricultural areas. The transport of pesticides used in the agricultural area in Sweden is monitored with continuous environmental supervision every year. During 2002-2008 an average of 10 pesticides were found in each sample and 40% of the samples contained substances with concentrations higher than the Water Quality Standards. Chemical risk management is normally based on single-test evaluations. A problem when assessing mixture toxicities is that the constituents and concentrations of pollutants in the environment vary greatly.

This study was conducted in the Master program at The Music Pedagogical Center (MPC) at The Royal College of Music in Stockholm. Korta musikresor (Short Music Journeys) is the Swedish term used for a receptive method of music therapy adapted from the tradition of The Bonny Method of Guided Imagery and Music (BMGIM) and the theory and practice of Expressive Arts Therapy. The KMR method uses carefully selected short pieces of music, lasting between 2 and 5 minutes, to work on various psychological problems and life- crises. The music session is conducted in a slightly altered state of consciousness with a clear focus being established beforehand in a verbal dialogue with the psychotherapist. There is also the possibility of using artwork to process and explore the imagery after the music listening.

The development of five individual pupils? writing abilities, as reported by six of their teachers, is analysed. The thoughts and reflexions inspired by the everyday interaction between the teacher and the pupil suffering from some kind of reading and writing disability are presented. The purpose is to capture what was unique and characteristic in the measures that triggered a positive response in the pupils. Some of the questions answered in this study are: How does the phenomenon of reading and writing disabilities manifest itself in the classroom, and what are the consequences for the individual pupil of the various pedagogical measures available?One conclusion that may be drawn from this study is that there is no cut-and dried method for working with pupils suffering from reading and writing disabilities.

The purpose of this report is to investigate and compare the difference between stand-thinning machines and strip-road thinning machines, and how they affect the stand on behalf of future growth, theoretical economic result, wind impact, snow pressure and density of stand. The investigation is regarding the first commercial thinning of pine stands, after pre-commercial thinning that was well conducted. The investigation area was located near Katrineholm, Sweden. The measurements that were measured were strength of thinning and amounts of wind throws, snow-breaks and hauling damages. The results that emerged, was that thinning with strip-road machines had a significantly higher strength of thinning over all, as compared with the stand- thinning machines (45 percent versus 30 percent). Comparisons between wind-throws, snow-breaks and hauling damages of the stand could not establish any significant differences between the two methods that were investigated. Conclusions, over all, were that if forest owners want to have more timber volume left for second thinning and final cut of the stand, the forest owners should choose the method with stand-thinning machines. From the point of view of gentle treatment of the stand and ground damages the choice should be the same. However, the method with strip-road thinning machines is the most common and accessible method in Sweden. Most likely it is the most economical way to manage the stand for forest owners in present time. If the method with stand-thinning machines is becoming more common in Sweden, it is suggested for forest owners to consider the stand-thinning method as a candidate for treatment due to economic aspects..

This study was conducted in the Master program at The Music Pedagogical Center (MPC) at The Royal College of Music in Stockholm. Korta musikresor (Short Music Journeys) is the Swedish term used for a receptive method of music therapy adapted from the tradition of The Bonny Method of Guided Imagery and Music (BMGIM) and the theory and practice of Expressive Arts Therapy. The KMR method uses carefully selected short pieces of music, lasting between 2 and 5 minutes, to work on various psychological problems and life- crises. The music session is conducted in a slightly altered state of consciousness with a clear focus being established beforehand in a verbal dialogue with the psychotherapist. There is also the possibility of using artwork to process and explore the imagery after the music listening.

Aquatic organisms are usually not exposed to single substances but rather to mixtures of toxicants in streams located in agricultural areas. The transport of pesticides used in the agricultural area in Sweden is monitored with continuous environmental supervision every year. During 2002-2008 an average of 10 pesticides were found in each sample and 40% of the samples contained substances with concentrations higher than the Water Quality Standards. Chemical risk management is normally based on single-test evaluations. A problem when assessing mixture toxicities is that the constituents and concentrations of pollutants in the environment vary greatly.

A group of two people, Jelena Durkan and Johan von Heideken, have worked together on an assignment from the company August Lundh AB. The company manufactures plastic products for all sizes of catering establishments. The basis for this thesis is a pre-study which shows that many of the users would be more drawn to the plates that the company manufactures, if there was a motif on the plates.This thesis will present the method of application for the motif that best benefits the company, with regard to the requirements placed on the motif, application method and the costs. The group found five relevant methods that were more carefully examined and compared to each other. Those are:Laser engraving, Hot-stamping, Injection molding, In-mould labeling and Pad-printing.The tools that have been used to solve this problem are: Requirement specification, QFD and OEE.

This thesis takes on a broader perspective of the modern age phenomenon we call spam. One of the aims of this thesis is to present and to compare the variety of methods used in the day-to-day fight against spam, as far they have evolved today, but also to present and discuss some alternative methods for suggested future use. The properties of a common e-mail spam are analyzed to show how the components that make up the structure in an e-mail can be used to classify spam. Furthermore I explain the naïve Bayesian classification methods, the signature-based method, the commonly used rule-based method and the challenge and response method and discuss these. The widespread use of blacklists is also explained and a close new variant to blacklisting, Turntide is presented and discussed.

 AbstractSystem methodology is in the very heart of system development, it is a crucial part of how you define your work, how you choose to approach the actual problem at hand and how to solve it. Researchers in the system development field has shown that not all methods in theory are in compliance with how it is practiced by the companies who use them. In our thesis we have studied a larger international IT- company and one of their local offices in Sweden, who some years back changed their system development method from a more traditional to an agile one. Our aim of this study has been to establish whether both of these methods has differed between theory and in actual use, and if so, why this has occurred and what the underlying rationality might have been to promote this change. Our questions that we sought to answer were; 1.

The Swedish government have a goal that wind turbines shall produce 30 TWh by the year 2020, compared to about 3,5 TWh produced in Sweden during 2010. To minimize the disturbance that wind turbines create the Swedish Environmental Protection Agency has stated a guideline value that noise from wind turbines at nearby residents shouldn?t exceed 40 dBA, at 8 m/s wind speed. With advanced calculation models, like Nord 2000, the emitted sound from future wind turbines can be calculated at an early stage to optimize the power production without exceeding the 40 dBA. When the turbines have been built there is a need to verify that they really are within the guideline.