Tången 2 is a building situated in Stockholm, Sweden. It´s built in the 1930s and contains both residences and businesses. The property owner, Diligentia AB, wants to lower the energy use in Tången 2. This report consists of an energy audit which clarifies the specific circumstances linked to Tången 2. Collected knowledge is then used, together with the results from the literature study, to decide energy measures to proceed with.

Svenska Kraftnät is (together with the other transmission system operators of the Nordic power system) responsible for keeping balance between the generated and demanded power in the Nordic power system. Spontaneous load variations and system disturbances, however, lead to power imbalance followed by frequency variations. The frequency deviations can be limited to an acceptable level by the spinning reserve, mainly by hydro power control. But there are also other system properties which have a great influence on the frequency and system stability. The frequency and voltage dependence of the loads have a direct influence on the power balance.

The aim of this thesis was to investigate the relation between different kinds ofremedial teaching models, not specifically addressed to pupils with physicaldisabilities, in the Swedish school context, and to describe and analyze theobjectives related to each model. Research focus was held on professionaldescriptions of school related problems and arguments for different kind of models,but also on objectives formulated in Swedish school policy. As theoretical toolswere used discourse analysis and interpretive policy analysis. The concept ofalienation as it appears throughout Foucault?s work was also used to understand howdifferent knowledge fields as education, special education, psychology and medicinedivide themselves from each other.

This report is a description of a developed educational simulator over rail vehicles and its components. The simulator is a hardware-based prototype over a door system on rail vehi- cles. System specialists and technicians will use the prototype. The Simulator should give the user a technical demonstration on how components work in a door system. The proto- type consists of motor, switch, relay and sensor.

Due to increasing regulations regarding new diesel vehicles particulate matteremissions the new Scania truck, Scania Euro 6, has been equipped with a particulatefilter. This component effectively stores the particles in the exhaust gas but must becleaned in order to prevent itself from clogging. The filter is cleaned through aprocess named regeneration which is a thermodynamic process in which thetemperature of the filter is raised through fuel supplied to the exhaust gas.The purpose of this thesis is to contribute to the development of improved controlstrategies of the temperature during the regeneration process through thedevelopment of model-based controllers. These controllers are designed in order tohave good performance in stationary as well as automatic regeneration.In order to develop these model-based controllers a model of the system isconstructed. The model is described as a linear thermodynamic grey-box model withflow varying parameters, showing good results in validation.The model provides a simulation environment during the controller design, which isfocused around the development of linear regulators with the exhaust gas mass flowas a scheduling variable whose size determines controllers? mode of operation.

This thesis work is the last part of the Master of Science education inmechanical engineering at KTH, Stockholm.The aim of this project was the development of a Multi-zone modelfor NOxformation in Diesel engines. Because of the stringent emissionlegislations, great effort is made to decrease the fuel consumption and theharmful emissions of internal combustion engines. Computer simulationsplay a decisive role in this context because they substitute the expensiveand time-consuming laboratory tests.The model is based on a multi-zone approach and uses the wellknownExtended Zeldovich Mechanism which gives a relation to calculatethe NO formation rate using the concentration of different gas speciesinvolved in the process.All the most important phenomena involved in the Diesel combustionhave been modelled. A special attention is then paid to the equilibriumconcentration calculation; this is a significant part of the model whichstrongly influences the following steps.A Simulink model has also been developed. This second version isbased on the previous model and it is made especially to allow theconnection with other external softwares, GT-power in this case.

The aim of this thesis is to investigate if an automation of the manual packaging process at Legosan AB is profitable. Legosan AB, located in Kumla, performs subcontract work of dietary supplements and medical products to companies within Europe. The chapterportal robot is used in the other. As there are several options in the choice of packaging robot the suggestions of improvement are divided into two different designs. Other machines and equipment necessary for the different suggestions of improvement are showed and their measurements are presented.

To render outdoor scenes with lots of vegetation in real time is a big challenge. This problem has important applications in the areas of visualization and simulation. Some progress has been made the last years, but a previously unsolved difficulty has been to combine high rendering quality with abundant variation in scenes. I present a method to mathematically generate and render vegetation in real time, with implementation in the scene graph Gizmo3D. The most important quality of the method is its ability to render scenes with many unique specimens with very low aliasing.

Botulism is a serious disease with high mortality that can affect horses. Due to this about 20-30 percent of the horses in Sweden are vaccinated against botulism. The purpose of this study was to see how common botulism is in the Swedish horse population and to se if a connection between feeding with haylage and botulism could be seen. In addition to this, the study aimed to find how common vaccination against botulism is among Swedish horses and on what grounds the diagnosis botulism is made. Medical records of horses being diagnosed with botulism at all the major large animal hospitals in Sweden between 1995-2005 were searched. In addition to this the database where general practitioners report their cases as well as the cases with botulism reported to the insurance companies were included. The results of this study show that only 0,03 percent of the Swedish horse population has been diagnosed with botulism during the time period this study covers. In all the cases included in this study the diagnosis was made based on clinical signs and in none of the cases verification by isolating the toxin was possible. In all cases where forage is noted in the journals the horse has been feed haylage which indicate that there is a connection between the use of haylage and botulism. Three horses died despite being partially vaccinated against botulism type B which indicate that a correct vaccination has to be done before the horse get any protection or that the correct diagnosis was not botulism type B..

Wavecraft AB develops medical equipment for heating of organic synthesises. The heating is done with microwaves, which improves the process in both speed and accuracy compared to the more traditional methods where heating elements are used. This report discusses the developement of an automatic lid mechanism for one of Wavecraft's product prototypes. The company assumes that the final product will be integrated by customers into fully automated systems, and the upgrade from a manually to an automatically controlled lid is therefore an important step in the product's developement process.The first stage och the project was an idea generation process. The ideas generated here were organized into five different concepts of which the best one was selected through the use of a concept matrix.

Introduction: In Sweden the definition of ambulance nursing is the examination and treatment of sick or injured people done by ambulance nurses during transport.  This means not only focus on the illness or injury but also the human being treated. The paramedic service must be based on the presumption that the medical needs of the patients are guaranteed, and that the expectations and demands of the public are satisfied. Competence and availability are basic terms for a well-functional paramedic service. There is a lot of pressure put on the people working with pre-hospital nursing. One mistake can lead to serious consequences for the patient.

Background: Home health care means that patients receive care in their home. Äldrevårdsenheten in Uppsala County treats people, over 65 years, in the patient's home and because of the fact that the quality of care from the patient´s perspective not have been studied previously, this study as part of the quality control of the business.Aim: The aim of this study was to investigate how patients, and family members, who receive care within the Äldrevårdsenheten in Uppsala County experiencing the care provided in the home.Method: Interview study with qualitative analysis.Results: Patients who are cared for within the Elderly Care Unit in Uppsala County Council has a positive experience of home care. Being cared for in the home creates a sense of security and calm in the patients rather than the stress and fear of long waits in the emergency department and planning advice from medical appointments . In contrast, perceived lack of physicians in home care and accessibility to health care staff.Conclusion: In general, patients in the Elderly Care Unit in Uppsala County Council very pleased with the opportunity to the treatment they received at home. However, there are some weaknesses that need improvement. .

Chronic obstructive pulmonary disease (COPD) is a chronic lung disease. The disease is the fourth leading cause of death and more than 5 percent of the adult population worldwide is affected.The aim of this study was to investigate the association between periodontitis and COPD.Search for material for the literature review was done in the medical database PubMed where the keywords were: "Chronic obstructive pulmonary disease" and "Periodontal health or periodontal disease". The result is based on twelve studies that were extracted and analyzed. The studies have investigated pocket depth, attachment loss, plaque index, bleeding on probing and bone loss. Ten studies compared a COPD group with a healthy control group, one study compared two COPD groups and one study examined a COPD group and a group with other lung diseases.Most studies found that people with COPD had a higher incidence of pocket depth, attachment loss, plaque index, bleeding on probing and bone loss.

Introduction: Increased ill health in the workplace in terms of increased workload, stress and pressure from employers is common in Sweden today, which may lead to a future variety of medical conditions and disabilities. Aim: The aim of the present study was to describe what employees at companies in the health industry experienced as a health and illhealth on a workplace. Method: A qualitative approach was used in which the interviews were based on an interview guide. The method of analysis was thematic analysis in which three themes emerged. Results: Tree themes emerged; a social interaction with colleagues, good leadership, and access to health care and movement.

This report is a description of a developed educational simulator over rail vehicles and its components. The simulator is a hardware-based prototype over a door system on rail vehi- cles. System specialists and technicians will use the prototype. The Simulator should give the user a technical demonstration on how components work in a door system. The proto- type consists of motor, switch, relay and sensor.