At the beginning of 2011, Sweden started using the European rules for structural design, the Eurocodes, instead of the previous national rules. In both the previous rules and the Eurocodes, it is possible to dimension concrete columns using tabled values. However, the required cross section Measurements have increased considerably. Moreover, it is possible to dimension concrete columns using calculations, however, this is unusual.The development of a fire in a fire cell can be divided into the growth stage, the fully developed fire and the cooling phase. The duration of each phase, as well as the temperature, is dependent on a number of factors, e.g.

This thesis investigates how different Linux-distributions installation interface relate to the ISO 9241 standard, parts 12 and 13, and how they relate to the installation interface of Windows XP, with the hypothesis: "There is a Linux-distribution whose installation interface according to applicable HCIrecommendations is equivalent to that of Windows XP." With the checklists provided by ISO 9241 an empirical study has been made, and so comparable Measurements of how well the Linux-distributions and Windows XP follows the recommendations of the standard was obtained. By comparing the results from the tests similarities and differences between the installation interfaces can be deducted. As the result and the conclusion shows there are Linux-distributions whose installation interface, according to the applicable HCI-recommendations, are equivalent to that of Windows XP..

This study was made in an attempt to give the forest research centre Mógilsá a producedtetratherm map and a better understanding of how topography and temperature influencethe growth of two tree species. The digital tetratherm map model, covering the northernpart of Iceland, was developed to investigate the correlation between tetratherm and thegrowth of Picea sitchensis and Larix (sukaczewii + sibirica). The study confirms theusefulness of digital terrain models in providing data for a lot of different factors and forthe tetratherm model. Hopefully will this tetratherm map be used in future studies.Secondly, investigations were made correlating the growth of the two species againsttopographic factors representing height above sea level, distance to the sea, slope andtopex. Thirdly, investigations were made comparing the aspect and the ground shape tothe growth.The growth rate of Larix had strong significant correlations to the tetratherm and thedistance to the sea- factors.

This report has a dual focus. The first goal was to increase the knowledge of how the use of electricity in a residential building is distributed. Electricity in residential buildings is used for lighting in common areas, elevators, pumps and many other appliances. The electricity used for these different parts is to a great extent unknown. A few studies have been carried out and the result of these is referred to in this report.By means of Measurements and approximations the use of electricity for various appliances became known.

This report has a dual focus. The first goal was to increase the knowledge of how the use of electricity in a residential building is distributed. Electricity in residential buildings is used for lighting in common areas, elevators, pumps and many other appliances. The electricity used for these different parts is to a great extent unknown. A few studies have been carried out and the result of these is referred to in this report.By means of Measurements and approximations the use of electricity for various appliances became known.

The report begins with a general inventory of possible technical faults in a hydropower plant and of possible fault indicating Measurements. Then an investigation is made concerning a few different faults. Based on this investigation a choice on seal box condition and water leakage is made as problem for a more thorough examination, in which it is concluded that the turbine water leakage is larger when the turbine is put into operation. The examination ultimately results in a computer alarm for faults related to the seal box. Finally a few things are mentioned about flow measurement and pressure measurement in relation to the project as a whole..

This report has a dual focus. The first goal was to increase the knowledge of how the use of electricity in a residential building is distributed. Electricity in residential buildings is used for lighting in common areas, elevators, pumps and many other appliances. The electricity used for these different parts is to a great extent unknown. A few studies have been carried out and the result of these is referred to in this report.By means of Measurements and approximations the use of electricity for various appliances became known.

This master thesis was a continuation of a previous study in the diesel exhaust characterization, which is part of the academical work embedded in the EMIR-1 project. The main objective of this thesis work was to finish the installation and make the proper modifications of the particulate mass measuring system located in one of the engine test cells at KTH, in order to be able to measure the mass of the particles from the exhaust of diesel engines.This experiment requires a diluted flow sample from the exhaust that should be sent to the device that makes possible the measurement of particle mass, called TEOM. In the first stage of this project, the objective was to study and make the proper modifications in the existing KTH diluter because there were several problems to obtain a constant dilution ratio from it during tests.This modifications were made and it resulted in a great improvement in the maximum inlet and outlet flow that this diluter can handle. Therefore another modification is proposed for controlling the inlet exhaust flow so it will be possible to regulate the dilution ratio and make it constant along a wide range of engine loads and speeds.The second and most important stage was to make particulate mass Measurements possible by analyzing the frequency signal from the TEOM device. The idea was to obtain the frequency of oscillation from the tapered element in the TEOM, and therefore with the proper correlations, be able to predict the particulate mass concentration in the exhaust flow from the engine.An electrical problem in the TEOM circuit was detected and corrected, so the signal that carries the frequency from the TEOM can be analyzed properly.

This master thesis is one part of a project, called ?StabSim?, with the purpose to develop a simulation model for the align and stabilisation system in main battle tank 122. The origin of this project is that it should be possible to make control analysis without risking any hardware. Besides that it will be easy to change components in order to investigate the behaviour of the system. The report includes modelling of tower and weapon mechanics and also the modelling of the synchronous motors, which control these.

During the last decennium climate issues have become more and more important. Many steps towards an adaption of efficient energy supply systems have been taken all around the world. These steps have been created to ensure the next generation?s energy demand. In EU and Sweden objectives have been set to ensure that the energy consumption decreases by 20% year 2020 and by 50% year 2050 compared with the energy consumption levels of year 1995.

This report has a dual focus. The first goal was to increase the knowledge of how the use of electricity in a residential building is distributed. Electricity in residential buildings is used for lighting in common areas, elevators, pumps and many other appliances. The electricity used for these different parts is to a great extent unknown. A few studies have been carried out and the result of these is referred to in this report.By means of Measurements and approximations the use of electricity for various appliances became known.

Emwiro Vibe is a complete system for seismic Measurements. The functionality of the system was before the completion of this project handled using a software contruction based on a state machine. Emwitech, the company developing Emwiro Vibe, expressed a desire to replace this solution with a real-time operating system (RTOS). The project consisted of two parts. Firstly the existing software was studied, available RTOSes was evaluated, and the RTOS most suitable for the application was selected.

Emwiro Vibe is a complete system for seismic Measurements. The functionality of the system was before the completion of this project handled using a software contruction based on a state machine. Emwitech, the company developing Emwiro Vibe, expressed a desire to replace this solution with a real-time operating system (RTOS). The project consisted of two parts. Firstly the existing software was studied, available RTOSes was evaluated, and the RTOS most suitable for the application was selected.

This work is a combination of a literature study and a practical pilotstudy. In the literature study essential physiological reasons of why anaesthesia of horses is so risky are explained. Diffrent methods of induction and recovery are brought up, together with significant aspects of positioning the horse on the operating table and perianaesthetic complications such as myopathy, neuropathy and limb fractures. The pilotstudy had the purpose of examine the bodytemperature of horses undergoing general anaesthesia and to control the perianaesthetic temperature Measurements performed in Swedish horseclinics and veterinary hospitals. Our hypothesis was that the bodytemperature of the horses would decrease but not enough to cause a problem. The purpose of this work has been to gather more profound knowledges in the subject of perianaesthetic nursing of horses which is an important part of the assignment of a veterinary nurse..

This report is a study in voltagelevel in connection with regeneration of brake energy from the tramtype M31 in Gothenburg.In the act of braking, the tram M31 uses electrical braking where the electrical motors generates energy and if possible send it back to the overheadline, where other trams in the nearby can use this regenerated energy for its own driving force. In cases where no other energyconsumers are located in the same section, there is a resistance witch task is to convert this energy into heat. The regulation of this resistance appears to cause an increase in the voltagelevel into far too high levels.Investigations of the trams regulationequipment and its construction have been done. Further have Measurements on the overheadline been performed in order to map the voltagevariations during a longer period of time.The result have been showing that the voltagelevel during regeneration often is as high as 880V-920V, more extreme values have not been observed in a large scale. The values are especially high compared to the nominal voltagelevel.