This thesis was done after a request from the county?s administrative board of Västmanland to provide the board with a better understanding of how green areas have changed within Västerås municipality over time.The purpose and goal of this study was thus to measure and analyze how much of the green areas within Västerås municipality that have disappeared during the past one hundred years as well as to provide a review of previous studies regarding the importance of green areas for humans as well as the biological diversity.In order to answer these questions I have in this study used a combination of a literature study, cartographic analysis as well as a time series analysis. The computer software used to do the Measurements of the green areas was ArcGIS which is a geographical information system.In the cartographic and times series anlaysis Measurements and analysis was made of the district map of 1911, the economic map of 1950 and the property map of 2011. The Measurements show that the municipality has grown with 46,3 km2 over the last one hundred years. New neighborhoods? have emerged and the municipality has expanded.

The earmould acoustics affect the amplification that the hearing aid is programmed to give to its user. It is therefore important that the choices made for the earmould are correctly done. One choice is regarding the shape of the soundbore that affects the frequency response of the hearing aid above a certain cut-off frequency. The purpose of this project was to measure the frequency response when altering the shape of the soundbore in the earmould. Additionally, the aim was to examine how the frequency response is affected when the shape of the soundbore is not set or is not possible to set in the software when programming the hearing aid.

This thesis concerns how the power quality in the grid is affected by the connection of wind power plants. As things are at present, Fortum Distribution AB has a number of wind turbines and wind parks connected to the own grid. As the pressure on building and connecting additional wind power is increasing, so is also the interest of how the already existing wind power generation affects the power quality in the nearby distribution grids. The study is performed by direction of Fortum Distribution AB and is limited to the 10 kV/40 kV-grid in Bohuslän, Sweden. The methods for calculation of power quality are compared to the results of a number of Measurements.

Former studies have shown that a considerable part of industries? energy usage can stem from idle times in the production. This thesis, carried out at Siemens Industry sector, evaluates the potential for using the control system to automatically put machines into energy saving mode during idle times. The main part of the thesis consists of a case study performed on machine tools at a Scania production site in Södertälje. Through load Measurements the potential for energy savings was determined.The results show that there is a great potential for energy savings during idle times at the site.

Post-anaesthetic myopathy (PAM) is a serious occasional complication of general anaesthesia in horses. It causes not only pain and suffering to the horse, but also suffering (trauma) to the owner with increased veterinary costs. In the worst case PAM can be fatal. The anaesthetic nurse must know which parameters have to be taken into consideration in the prevention of PAM, to be able to prevent it, and use that knowledge for the animals safety. The aim of this literature review was to investigate and make a presentation of the factors and Measurements associated with PAM, with focus on how to monitor these Measurements to prevent it from happening, and the advice a Veterinary nurse can give to the horse owner regarding this condition. According to literature there a few factors that greatly increase the risk of PAM, these include- hypotension, periods less than 60 mmHg significantly increases the risk.

This thesis aims to develop a control system for measuring electromagnetic compability (EMC). This has meant that a controller designed around an ATmega8 microcontroller has been manufactured and programmed. It has also meant the development of a comprehensive control software in the program MATLAB. The control system has been tested with satisfactory results and can now, monitor and control Measurements of the EMC-type..

This is a final thesis done at BT, considering one of their forklift truck models called Reflex. The first part of this report is about a preliminary investigation investigating what kind of diagnostic systems BTwants to use, and also which demands there are to meet all expectations on such system. Secondly a diagnostic system, which will show if the drive wheel is worn out, will be presented. In the preliminary investigation, two kinds of diagnostic systems were mentioned. These were Model based diagnosis and Predictive analysis.

The purpose of this project is to analyze earthing systems for houses. By practical Measurements and theoretical analyzes consequences of possible faults, that can occur within the facility and in the low-voltage distribution network, is illustrated.  The reason for this project is that nowadays one has to arrange with a main equipotential bonding system for buildings. Apart from that, if necessary, bathrooms must be provided with a supplementary equipotential bonding system.The practical Measurements verify that potential differences in facilities may be due to voltage drops in the PEN conductor between the origin of the electrical installation and the power transformer.Based on the theoretical analyzes of possible faults, it is considered that the requirement for  supplementary equipotential bonding systems for bathrooms in most cases can be questioned, when basic insulation, fault protection, residual current devise and main equipotential bonding system already provides an adequate level of protection.A PEN conductor loss may result in a situation where metallic parts attached to the equipotential bonding system starts working as earth electrodes. Equipotential bonding system may also increase the incidence of stray currents. If TN-C-S systems is provided with a local connection to earth a redundant system against PEN conductor loss is obtained.

On a request from the water sewage plant Gryaab in Gothenburg a power quality survey was performed. The voltages and currents have continuously been sampled in the incoming 10 kV substation HSP01 from April-August 2008. Power quality Measurements were also performed in Gryaabs other 10 kV substation HSP04 fed from HSP01 and at the terminals of the induction motor IN_PU4040 of 1.3 MW which controls one of the four large inflow pumps to the plant. The reason for the latter measurement was due to registered negative transients each time the motor was connected to the grid. The cause of the transients could be explained by the coupling in the substation, the ageing of the motor which could result in damage of the bearings or resonance in the motor circuit which amplifies high frequency harmonics.

The Multispectral Canopy Reflectance Model (MCRM) by Kuusk (1995) has beenused to simulate the reflectance of a sugarbeet canopy. The simulated reflectancevalues show high absorptance in the VIS area, compared to field Measurements, andhigh reflectance values in the NIR area. The errors may be due to overestimation ofclorophyll content in the sugarbeet leaves and scattered light during fieldMeasurements. The estimation of the clorophyll content where carried out using thePROSPECT-model by Jacquemoud & Baret (1990).During the vegetation period, the state of the canopy moves towards a closed canopy,with sparse vegetation in spring. The MCRM-model was used to perform a ?spring?simulation, which was compared to the original simulation.

This report describes an investigation of the indoor climate in two different workspaces. Since we a big part of our lives are staying indoors in artificial environments, and more particularly in our workplaces, we think it would be interesting to do this investigation. The technical solutions for air treatment systems began with simple natural systems without fans and where the thermal rise of the air applied. In modern time is technical air treating systems used to take care of the fresh air supply. This type of units can supply filtered air with the right temperature to the building. Well-functioning ventilation is essential to bring clean fresh air to the room and effectively remove impurities without sound- or draught problems. The indoor climate is relevant for the output capacity.

On a request from the water sewage plant Gryaab in Gothenburg a power quality survey was performed. The voltages and currents have continuously been sampled in the incoming 10 kV substation HSP01 from April-August 2008. Power quality Measurements were also performed in Gryaabs other 10 kV substation HSP04 fed from HSP01 and at the terminals of the induction motor IN_PU4040 of 1.3 MW which controls one of the four large inflow pumps to the plant. The reason for the latter measurement was due to registered negative transients each time the motor was connected to the grid. The cause of the transients could be explained by the coupling in the substation, the ageing of the motor which could result in damage of the bearings or resonance in the motor circuit which amplifies high frequency harmonics.

Stabilization of subgrade is an internationally common technique to improve the characteristics of a soft soil. Improving the stiffness and bearing capacity of the subgrade enables the pavement to be designed with reduced depths of subbase and basecourse aggregates. This makes the stabilization technique both economically and environmentally interesting. Both natural and stabilized soils have high inherent property variability that should be considered when the characteristic value is derived. By analyzing the spatial variability in stabilized and natural subgrades it is possible get the parameters needed for reliability?based modeling of soil properties.

On a request from the water sewage plant Gryaab in Gothenburg a power quality survey was performed. The voltages and currents have continuously been sampled in the incoming 10 kV substation HSP01 from April-August 2008. Power quality Measurements were also performed in Gryaabs other 10 kV substation HSP04 fed from HSP01 and at the terminals of the induction motor IN_PU4040 of 1.3 MW which controls one of the four large inflow pumps to the plant. The reason for the latter measurement was due to registered negative transients each time the motor was connected to the grid. The cause of the transients could be explained by the coupling in the substation, the ageing of the motor which could result in damage of the bearings or resonance in the motor circuit which amplifies high frequency harmonics.

On a request from the water sewage plant Gryaab in Gothenburg a power quality survey was performed. The voltages and currents have continuously been sampled in the incoming 10 kV substation HSP01 from April-August 2008. Power quality Measurements were also performed in Gryaabs other 10 kV substation HSP04 fed from HSP01 and at the terminals of the induction motor IN_PU4040 of 1.3 MW which controls one of the four large inflow pumps to the plant. The reason for the latter measurement was due to registered negative transients each time the motor was connected to the grid. The cause of the transients could be explained by the coupling in the substation, the ageing of the motor which could result in damage of the bearings or resonance in the motor circuit which amplifies high frequency harmonics.