An important process for grid companies in order to reduce power losses in electricity distribution grids is to figure out where and how they appear. This report describes the factors that cause power losses in low voltage distribution grids and methods for how they could be measured and analyzed. Measurement data for consumed and injected energy were collected for twelve low voltage distribution grids owned by Gävle Energi AB in order to analyze the size of the power losses and how the measurement uncertainty affects the collected data. Then models of three of the grids were created in MATLAB in order to analyze the data and the power losses were calculated to be compared to the collected data. Curve fitting were also used as a method in order to analyze the power losses from collected data.The results show that the losses in the studied grids are low.

This final year project is made for Peab Jönköping and its target group is the construction industry. The main focus is the use of unutilized building material in the most economical and environmental-friendly way. Unutilized building material is here defined as material purchased for a construction project that for different reasons not has been used. The most important thing to find out was how much building material considered as being waste is actually useable material, and how much less it costs to use that building material instead of throwing it away.When this information was gathered a proposal on how to efficiently use the unutilized building material instead of wasting it was designed. Costs and incomes were investigated and the proposal suggested a storage area where Peab can store their unused building material.

The objective of this study was to study the agreement between two methods of indirect bloodpressure measurement in dogs and cats and to establish the within-method variation for the methods. The utility and practicality in the clinical setting were also evaluated for the both methods. The techniques evaluated were the oscillometric method and the Doppler ultrasonographic method. Thirtytwo dogs and 26 cats were used in the study and seven dogs and five cats out of these animals had diseases that may effect the bloodpressure. Bloodpressure was measured in both anesthetized and in conscious animals.

This study was conducted at Glimek AB, a company that has chosen to decentralize its central storage unit in order to increase production efficiencies. The purpose of the study was to identify the problems in the production cycle that lead to the decision to decentralize the central storage unit, as well as identifying what the decentralization entails. The effects of the decentralization have not been analyzed in the study, and consequently neither financial nor production disadvantages have been considered.Appropriate questions were formulated based on the chosen underlying theories, and were asked to selected individuals with relevant knowledge. The study is based on the information that was gathered from interviews with management as well as staff within the company. In addition, supporting information such as flowcharts, drawings, orders and decision support documents were supplied by the company.

Rapid Granulator is one of the world's largest producers of granulators, which is a kind of grinderwho grinds discarded plastics to granules which later can be reused when pressure molding plastics.The company wanted help in developing a new, or alternatively extending their previous,measurement equipment. The old equipment was hard to use, required changes in the code fordifferent measurement scenarios and had a limited array of measuring quantities. Rapid had an ideaof a similar concept only with a greater number of input ports, better range of applicable sensors andan advanced yet easy to use interface. The system is supposed to be placed at Rapid's test departmentwhere it will be used as a tool for finding faults and provide data which can be used for furtherdevelopment of the granulators.The project's members accepted the task and immediately began searching for suitable componentsfor the system. After the search was completed a list of costs, limitations, sensors, I/O's anddevelopment environment was presented to Rapid's staff.

To be able to measure high-surge voltages and transients with short rise times youneed measuring instruments with a high sampling frequency and large Bandwidth.These surges and transients occur primarily at lightning but can also occur at forexample at connecting errors at an electrical switch-gear. This report describes thework with finding two solutions for measuring and log data from these surges andtransients. One temporary solution where a measurement program has beendeveloped. A second solution where different company solutions have been analyzedto decide which fits best. For these measurement solutions two solutions for bringingdown the voltage has been used.

Humanity stands before a huge challenge to lower its emissions of carbon dioxide and its use of energy at the same time as the global population is rising and the developing countries are being industrialized. A lot of newly built buildings are due to this challenge, designed to be more energy efficient but also use renewable energy resources instead of pollutant fossil fuels .Solar energy is one of the purest forms of energy that exists in abundant amounts, which is why it is most likely that it could come to play a major part in the future energy market. The main purpose of this report is to investigate the possibility to implement a sustainable energy system with solar thermal heat and  heat storage as main sources of energy in the neighborhood ?kvarteret Lagern?, which is the area where the old football stadium ?Rasunda Stadion? was located. New developments within different heat storage techniques have opened up new approaches to enable buildings an all year round heat supply from solar energy. This report will focus on heat storage in boreholes. At the present here is only a preliminary plan of how the neighborhood is supposed to be designed.

Due to a growing interest in communication in today?s society the demand for equipment that is used in communication networks increases while the competition between companies that produce this equipment grows. To meet the increasing demand and at the same time having a competitive product development many companies use some effective product design, such as the modular product design. When a modular product design is used it?s good to compare different module configurations for a certain product and to simplify these comparisons some tool can be used.

The aim with this report was to exam and surveys the internal logistics of Proton Finishing?s production. The basic data should give the company suggestions of more efficient and improved internal logistics. We will also give from our perspective suggestions of improvement, which the company will be able to evaluate.To evaluate these problems we used different kinds of methods. A frequency study was made on the internal forklift.

To be able to measure high-surge voltages and transients with short rise times youneed measuring instruments with a high sampling frequency and large Bandwidth.These surges and transients occur primarily at lightning but can also occur at forexample at connecting errors at an electrical switch-gear. This report describes thework with finding two solutions for measuring and log data from these surges andtransients. One temporary solution where a measurement program has beendeveloped. A second solution where different company solutions have been analyzedto decide which fits best. For these measurement solutions two solutions for bringingdown the voltage has been used.

Authors: Maria Bergholtz, Alexander WestessonTutor: Daniel EricssonTitle: Performance Measurement of Creative work ? a culture study at PS CommunicationKeywords: Key Performance Indicators, Organizational Culture, Macro-culture, Subculture,Micro-culture, Art, Business, Creativity, PS CommunicationIn the paper?s introductory chapter, the chosen problem area regarding art and business willbe presented. The paper?s studied empirical case will also be introduced here. This then leadsto the reports chosen research questions:How do the company management and the companies? creative personnel approach differ inthe discussion regarding performance measurement on PS Communication?-What causes these differences?What impact does the corporate culture have in the discussion about performancemeasurement of PS Communication?-Is the corporate culture weak or strong?The purpose of this paper is to resolve the stand still in the discussion regarding performancemanagement by creating an understanding of different people active in the organization?sapproach to performance measurement.

To be able to measure high-surge voltages and transients with short rise times youneed measuring instruments with a high sampling frequency and large Bandwidth.These surges and transients occur primarily at lightning but can also occur at forexample at connecting errors at an electrical switch-gear. This report describes thework with finding two solutions for measuring and log data from these surges andtransients. One temporary solution where a measurement program has beendeveloped. A second solution where different company solutions have been analyzedto decide which fits best. For these measurement solutions two solutions for bringingdown the voltage has been used.

Soil properties affect the chemical composition of soil water. When studying transport of chemical substances through a basin, it is therefore important to know from which soil layer the main part of the runoff is generated. The aim of this study is to develop an HBV/PULSE model with merged soil moisture and response routines, which generates good approximations of groundwater levels. It should be possible to extend the model to simulate transport of substances and take into account which soil layer the groundwater level is currently in. The hydrological version of HBV/PULSE is used since there is no need to account for pH or alcalinity at this stage.

With increased deployment ofintermittent renewable energy, such aswind and solar power, energy storagebecomes necessary to help reduceproduction peaks. Thermoelectric EnergyStorage is a method still in researchphase, which stores electricity in hotwater at a temperature of 120 ° C. Thisthesis aims to examine whether theThermoelectric Energy Storage would bepossible to integrate into existingpower generation such as a combined heatand power plant, and how the technologypotentially could function in theelectricity market. ThermoelectricEnergy Storage consists of a chargingprocess and a discharging process, bothoperating by the working fluid CO2. Toincrease the efficiency of theThermoelectric Energy Storage, wasteheat from the district heating networkis integrated.A model of the Thermoelectric EnergyStorage has been developed and it wascalculated by thermodynamic propertiesof the working fluid, CO2, in thevarious process steps.

The different characteristics of many food products, such as aroma and texture, changes during storage time and become undesirable. The reason is instabilities within the product which become prominent as the product ages. These changes in characteristics are quality losses caused by changes in the product?s intrinsic and extrinsic environment. The stability in UHT-milk and beverages similar to it have been studied in the past decades and a certain focus have been on age gelation which is a common defect in these type of products.