Vattenfall and Svenska Kraftnät perform start-up tests, where hydropower generators are used to power up the electrical grid in case of a blackout. To monitor the electrical grid, Phasor Measurement Units (PMU) are used. Each PMU is individually equipped with a GPS-receiver to precisely timestamp the data relative to the official time UTC. During the test, it is also of interest to timestamp the measurement signals from individual hydropower generators to later compare with PMU-data, and thus study the power grids impact on the generator. The aim is to work out an appropriate method to make these measurements and to build a data acquisition system, capable of timestamp data relative to UTC, from a generator in one of Vattenfalls hydroelectric power stations. The problem is that the generator is located in an underground station which hampers the reception of GPS-signals and wiring should be avoided if possible. Time synchronization has been solved by using Vattenfalls network, which is synchronized by the network protocol NTP.

In this thesis tests has been performed on the pull strength of screws glued into glulam beams.The experiment is based on the already approved method whereby the diameter of the drilled holes is the same as the screw outer diameter of 1 mm or bigger. The screws strength class shall not be less than 4.6 (EN ISO 898-1:1999, 1999).The difference in the experiments that were performed where that the drilled diameter were 1 mm smaller than the outer diameter of the screw so that the screw thread was worked into the wood.In the tests the gluing where made on M8 glulam beams. The screws where drilled at and angel of 90°tangental to the fiber direction with a diameter of 7 mm. The gluing of the screws where made in three different depths and where later exposed to pulling forces. The results showed both pulling breaks and screw breaks when they reached their maximum capacity.

Today there are many technical solutionsfor the e-commerce industry, incombination with a change in behavior ofthe end user. The consumer of todaydemands more availability andconvenience.This Master?s thesis has examined thecritical aspects of e-commercecompanies, as well as how they candevelop their e-commerce to create valuefor the end user. The aim has been toidentify the more and less importantfactors of the e-commerce business, andto investigate the extent to which thesefactors are used in the e-commerceindustry. To answer these questions, aninteractive, online questionnairecustomized for e-commerce companies wasdeveloped.

Microproduction, also called distributed generation, is something that has become more and more popular in the electric grid. Microproduction can however lead to unacceptable performance if several units are installed in the same low voltage network. It is therefore good to know a limit where the performance of the low voltage network becomes unacceptable based on given parameters. This limit is usually called hosting capacity.In this report the hosting capacity with respect to voltage and current have been studied in three low voltage networks which are located in Falu Elnäts concession area. This has been done by simulations in a GIS-program where critical times of the grid have been simulated.

In this study we try to focus on the costs for wear parts on different type of soil tillage machines and at Väderstad Rapid drilling machine. We have studied some of the leading types of cultivators and disk harrows. Among the cultivators we have investigated Väderstad Cultus, Dalbo Dinkomax, Horsch Tiger and Terrano. At disk harrow we have looked at Amazone Catros and Väderstad Carrier. We have made more detailed study on costs for wear parts, working depth, driving speed and diesel consumption.

The purpose of this thesis is to assist the Swedish energy company NIBE Energy Systems in their studies of adaptive regulation applicable to electrical water heaters. Due to coming energy classifications of these appliances in the European Union, NIBE Energy Systems needs to use adaptive regulation, called Smart Control, to keep their products in the best possible energy class and remain competitive to the market. By using this Smart Control regulation a 2-3 % improve-ment of efficiency can be credited the system. This is a small number, but heavily needed, since the energy classes are based on the idea that the European Union is provided with electricity from coal condensate power resulting in a 40 % maximum efficiency. Furthermore, doing noth-ing will result in some water heaters not being approved to use on the market from 2015 due to low efficiency.

Banking systems in India is quite popular and it needs some more changes to reach all the customers. Lack of the service is main problem in Indian baking system. If the common person wants to open the account, it take?s little bit high cost and banks are not near the people location. Due to the Lack of service, people do not want to be a customer of the bank.

In today?s technological society, there are increasingly less physical demands on the locomotor system. However, despite that notion strength and function in the hand?s complex biomechanical system are in fact both needed to cope with daily life. The grip function is a main function in the hand and is used in many examples of scientific research, for instance when assessing physical health and predicting the probabilities of premature mortality.

The purpose of this work was to investigate the adherence to basic hygiene routines among staff and to investigate if there is any difference between the adherences in diverse professions. The purpose was also to study how staff rates their own adherence to current guidelines. Data for the study were collected through observations and questionnaires. Altogether 35 people were observed and 15 answered the questionnaire. Maximum adherence was found in the category of "hand disinfection after patient contact" with a score of 96%.

När individer drabbas av svår sjukdom eller komplicerad fraktur kan det krävas sjukhusvård med immobilisering som följd. Tidigare studier har visat att immobilisering påverkar kroppen negativt och kan leda till exempelvis lunginflammation, blodproppar och förstoppning. En tidig och ökad mobilisering har visat sig leda till färre komplikationer, kortare vårdtid och en positivare sjukhusvistelse. Det är därför viktigt för sjuksköterskor att ha strategier för att främja mobilisering för patienter på sjukhus. Syftet med studien var att beskriva sjuksköterskors strategier för att främja patienters mobilitet i sjukhusmiljö.

In this study bone material from six stone ship settings and a total of seven deposits of bones from two sites on the island of Gotland have been analyzed. Four ship settings from the burial site at Gålrum in Alskog parish and two from Tängelgårda in Lärbro parish. The ships contained both cremated remains and inhumations.  Human remains were identified in five of the analyzed ship settings and a minimum of six individuals was identified in total.  Animals were found in three of the ship settings, where one of them contained only the burned remains of a dog. Two of the ships contained inhumations, one in Gålrum and one in Tängelgårda.

All träning innebär en fysisk påverkan på kroppen och kan anses vara en form av stress, vilket hästar som tränas utsätts dagligen för. Svaret som fås vid stress är till för att mobilisera resurser inför kommande situationer, det sker fysiologiskt bland annat genom det sympatiska nervsystemet som ökar sin aktivitet. Frisättningen av katekolaminer och kortisol ökar.Träning påverkar fysiologiska stressparametrar hos hästar. Den här litteraturstudien tittar på hur kortisol, ACTH, katekolaminer (adrenalin och noradrenalin) och ?-endorfiner har setts variera under träning.

The viscosity of air buildings is a hot topic within the construction performers, which the industry feel they have too little knowledge about. This study is mainly aimed against air density in apartment buildings and airflow measurement. The study consists of a theoretical reference, educational visit, interviews and a survey conducted among construction workers at Magistratshagen in Linkoping.Earlier requirement in terms of air leakage through the climate screen was removed and today there are only energy requirement for a dwelling in Boverkets Building Regulations. The difference between a passive and a typical air tight construction is that the passive house have a maximum requirement of 0.3 l /s m2 of air leakage through the building climate screen. The requirement imposed on passive houses is to minimize the supply of power and energy for heating the building.Air tight constructions have heavy demands on the performance and accuracy of everyone involved with the project. The client must specify their requirements and also be prepared to pay for any additional costs. The architect and building planners have to design the building with regard to air tightness. Finally, the construction workers are required to do a careful work in order to get all the connections in the building air tight.The study suggests that an air tight building is a closed system where no forced ventilation exists. There are no reasons not to build too tight as long as there is a functioning ventilation. In this study the authors ask themselves how an air tight building changes over time. No theoretical information has been found on these changes, but the respondents assume that air density decreases with time. The deterioration is mainly assumed to be caused by construction materials changes over time. The study shows that construction workers knowledge of air tight construction is mixed, which they themselves admit in the survey..

In today?s technological society, there are increasingly less physical demands on the locomotor system. However, despite that notion strength and function in the hand?s complex biomechanical system are in fact both needed to cope with daily life. The grip function is a main function in the hand and is used in many examples of scientific research, for instance when assessing physical health and predicting the probabilities of premature mortality.

The division of Electricity at Uppsala University is developing a wave energy converter(WEC) consisting of a linear generator connected to a bouy at the water surfacethrough a wire cable called the connection line.During extreme conditions, the wave power plant will experience forces up to 500kN, which lead to unnecessary wear and will ultimately cause the failure of theconverter. To prevent this there is a need for a damper.The wave energy converter works at a maximum efficiency when the translator?sare centered with respect to the stator. Due to tidal movements the position of thetranslator can deviate. There for a mechanical divice that will compensate for this isneeded.This report describes the further development of an earlier project where a tidalwave compensator for a wave energy converter of Seabased AB was developed.