The purpose of this master thesis is to investigate how nearby forests affect the energy production in wind turbines. To reach the purpose a case study is performed on three wind turbines sited on a field in a north-south line at Andersfält in the municipality of Halmstad, Sweden. Approximately 100 meters south of the southern wind turbine a forest is situated. The case study is divided into three sub studies where the difference in energy production, the affect of the forest and a wind meteorology model, WAsP, is studied. The result show that the forest have a significant influence and that the WAsP-model gives an incorrect result of the energy production in wind turbines sited near a forest..

På uppdrag av Sweco Systems i Umeå har detta examensarbete utförts under våren 2013. Syftet var att undersöka huruvida något av de energiberäknings-program som används på företaget kan anses vara lämpligt vid energikartläggningar av befintliga fastigheter.Inledningsvis utfördes en energikartläggning av fastigheten Odin 12 i Umeå, som i huvudsak utgörs av gallerian MVG. Med resultaten från denna energikartläggning som grund beräknades därefter fastighetens energianvändning i två olika program ? VIP-Energy och IDA Indoor Climate and Energy.Resultaten från den inledande kartläggningen visar att fastigheten har ett lågt behov av fjärrvärme, vilket förklaras av fastighetens höga elförbrukning. Den stora användningen av el genererar stora mängder internvärme som, förutom att sänka fjärrvärmebehovet, även medför att fastigheten under hela året har ett kylbehov.Utvärderingen av de två beräkningsprogrammen visar att VIP-Energy är ett lämpligt program att använda vid energikartläggningar.

An energy study has been performed on two blocks in an area called Gävle Strand. The buildings are owned by a tenant-owner?s association called brf Carolina and were built by the company Skanska 2008. The builder as well as brf Carolina are pussled by the fact that electricity use is higher than expected while heating is less. Skanska is also very interested in finding out how much heat recovery from stale exhaust air through a geo-thermal heat pump is contributing to the general heating requirement and energy balance in four out of the ten buildings located on the properties.To find possible answers to the higher electricity use a literature survey on user behaviour was conducted.

This study concerns the energy future of the county of Stockholm up until 2050 and describes how the energy consumption can be compared to today with the use of scenario methodology. Within energy future studies the backcasting approach is well known and has been put to use in this study. Due to the characteristics of backcasting the study is self-fulfilling, i.e. the future energy scenarios presented in this study satisfy the targets set up in this study. In the light of what may be the largest challenge of our time ? the climate change - the aim of this study is to describe how the energy consumption in a fossil fuel free Stockholm county in the year of 2050 may be.

The purpose of this study was to investigate the association between physical activity and perceived stress, energy and musculoskeletal disorders among office-workers and warehouse-workers and also to see if there were any differences depending on work-place and gender. The method that was used to collect data was three different validated questionnaires that measured stress and energy (the Stress-Energy questionnaire), musculoskeletal disorders (intensity and localization of pain, a Pain Drawing questionnaire with a VAS-scale) and physical activity (IPAQ ? the short version). Eighty-eight workers participated in the study. Forty-seven of them were office-workers and forty-one were warehouse-workers.

To be able to handle tomorrows need for limited energy consumption we need to reduce our use of energy. The building sector stands for around 40 % of all energy consumption in the society. The government has put up a goal to reduce the energy consumption in our buildings with 20 % by year 2020 and 50 % by year 2050 compared with year 1995. To be able to do reach that goal we need a more energy efficient building stock.The main part of the energy used in our buildings is used for space heating. By installing ventilation systems with heat recovery on the exhaust air it is possible to use the heat-energy in the exhaust air to warm up the incoming air.

In the current situation a big part ofthe settlements that exist in Sweden isin need of renovation and energyefficiency in order to survive.Therefore, also many of the older houseswith a wooden structure are in a need ofenergy efficiency, which can be done ina variety of ways, including addinginsulation.This project deals with whether the useof a diffusion barrier or a vaporbarrier affects a wall structure byadding insulation to an older house witha timber frame. The insulation materialswhich are concidered in thisinvestigation are mineral wool and woodfiber insulation. Efforts are focused onthe effects of moisture on theseinsulation materials.To demonstrate the differences thatarise the moisture measurement programWUFI have been used to simulate avariety of wall designs. These designsare developed in consultation with theconstruction carers who are active inthe industry.Using WUFI graphs illustrating themoisture levels of the wall structureswere obtained and from these conclusionsvould be drawn. The work demonstratesthe differences that arise when using adiffusion barrier or vapor barrier inwall construction.

This report is a study in voltagelevel in connection with regeneration of brake energy from the tramtype M31 in Gothenburg.In the act of braking, the tram M31 uses electrical braking where the electrical motors generates energy and if possible send it back to the overheadline, where other trams in the nearby can use this regenerated energy for its own driving force. In cases where no other energyconsumers are located in the same section, there is a resistance witch task is to convert this energy into heat. The regulation of this resistance appears to cause an increase in the voltagelevel into far too high levels.Investigations of the trams regulationequipment and its construction have been done. Further have measurements on the overheadline been performed in order to map the voltagevariations during a longer period of time.The result have been showing that the voltagelevel during regeneration often is as high as 880V-920V, more extreme values have not been observed in a large scale. The values are especially high compared to the nominal voltagelevel.

As the Swedish governments long term goals include a reduction of fossil fuel dependency, increasing pressure is placed upon energy companies to create and develop new solutions for renewable energy. The following case study was done in collaboration with the company Sydved Energileveranser AB and one of their contractors, Enarssons Skogsentreprenad AB. The objective of the study is to examine the bioenergy situation in region of Skåne and evaluate the potential solutions in the region for a forest-fuel assortment, based on a bioenergy-cutting-system. As a part of this study I have compared ordinary manual cuttings done with a chain saw and cuttings made using the new ?bio- energy cutting system?. The cuttings made under both systems were tested in areas near agricultural fields or pasture land in order to maintain an open landscape.

Overall aim of this master?s thesis is to describe and identify perceived barriers in Swedish businesses within solar energy field and analyze, based on four theoretical viewpoints, how these barriers can be handled. In other words how can the barriers be overcome or eliminated to better succeed in the commercialization process? The method applied is qualitative in which data has been collected through phone interviews originated from seven Cleantech businesses which operate within solar energy. Furthermore this thesis has a descriptive- and an explorative purpose.

This thesis describes the new construction of a small house and it includes studies of three heating systems: geothermal heating, district heating and pellet. The purpose of this thesis is to project a small house which can manage Building Regulations, BBR conditions and then examine three possible heating systems for the small house. This thesis is a literature study which gives an understanding of the heating systems technical structure, properties and costs. An empirical study completes the literature study by giving a deeper understanding of district heating costs and pellet costs. The empirical study contains two interviews, one of which was conducted in a district heating corporation and the other interview was conducted in a pellet corporation.

The house of one of the most prominent Swedish artists of the 20th century, Bror Hjorth (1894-1968), was turned into an artists-museum and opened to the public in 1978. It has since the start held pedagogical activities and during the years developed its own pedagogical approach.I have studied the museums pedagogical work from two perspectives; visiting groups of immigrants and visiting groups of schoolchildren, in search of answers to the questions; can art be used as a way to integrate immigrants into the swedish society, and can artmuseums be a resource for schools?This essay contains my observations, conclusions and theories as well as general facts about Bror Hjorths House..

In modern society in terms of economics and environmental impact, it is important to ensure that a company is as energy efficient as possible to reduce the amount of energy used. About 10 TWh of electricity used annually to pump drives in Swedish industry. Therefore, pumping system has great potential for energy savings.The objective of this report was to determine how much energy and money that can be saved with the insertion of variable speed drive to six pumps on Bleach plant 4 in Skutskär Mill. The work was performed with electrical measurements during one week, analysis of pump curves and the compilation of production data over a year.The results show that four of these six pumps were profitable and yielded an annual saving of 1172 MWh of electricity and 560 000 SEK. With an economic lifetime of 10 years and a discount rate of 6.8% the final result for the entire life-cycle savings became 3 355 000 SEK.

Food is widely consumed and in 2011 an average American devoured approximately one ton of food. The production of these goods requires large amounts of energy and contributes to 22-31 % of all greenhouse gas emissions occurring in Europe. More than one third of the produced food is discarded instead of consumed, and food waste make up about 30 % of the waste generated by households. 60 % of this food waste could be avoided if the eatables were handled in a better way.Avoidable food waste arises partly because residues from food are not taken care of, and because the food is not stored in a way that optimise its durability. Residues arises part- ly because of the contradictory and complex demands of everyday life and are, because of our busy lifestyle, difficult to avoid.

The viscosity of air buildings is a hot topic within the construction performers, which the industry feel they have too little knowledge about. This study is mainly aimed against air density in apartment buildings and airflow measurement. The study consists of a theoretical reference, educational visit, interviews and a survey conducted among construction workers at Magistratshagen in Linkoping.Earlier requirement in terms of air leakage through the climate screen was removed and today there are only energy requirement for a dwelling in Boverkets Building Regulations. The difference between a passive and a typical air tight construction is that the passive house have a maximum requirement of 0.3 l /s m2 of air leakage through the building climate screen. The requirement imposed on passive houses is to minimize the supply of power and energy for heating the building.Air tight constructions have heavy demands on the performance and accuracy of everyone involved with the project. The client must specify their requirements and also be prepared to pay for any additional costs. The architect and building planners have to design the building with regard to air tightness. Finally, the construction workers are required to do a careful work in order to get all the connections in the building air tight.The study suggests that an air tight building is a closed system where no forced ventilation exists. There are no reasons not to build too tight as long as there is a functioning ventilation. In this study the authors ask themselves how an air tight building changes over time. No theoretical information has been found on these changes, but the respondents assume that air density decreases with time. The deterioration is mainly assumed to be caused by construction materials changes over time. The study shows that construction workers knowledge of air tight construction is mixed, which they themselves admit in the survey..