Nutrient enrichment is the main cause of the increasing eutrophication process in the Baltic Sea during last century. A prerequisite counteract this process the load of nutrients to the Sea must be investigated. The large contribution of nutrients to the Sea is caused by emission from the rivers within the drainage basin. For the total emission of nutrient into the Sea the retention process in the rivers has big influence. This process in the river system has been assumed as a not important part of the nutrient cycle.

This master of science thesis is focusing on how the fault handling on hardware connected toa control unit on a Scania vehicle is working. To the hardware counts buttons levers, sensorsand CAN. The work has been concentrated upon how the fault handling is working and if it ispossible to find any new fault modes.The control unit that has been studied is called the Coordinator and is the core in Scanias threenetworks of control units. The Coordinators work is to transmit messages between the threenetworks and to process signals from buttons, levers and sensors. The values is then usedinternally or is sent to other control units on the CAN networks.

This is a final thesis done at BT, considering one of their forklift truck models called Reflex. The first part of this report is about a preliminary investigation investigating what kind of diagnostic systems BTwants to use, and also which demands there are to meet all expectations on such system. Secondly a diagnostic system, which will show if the drive wheel is worn out, will be presented. In the preliminary investigation, two kinds of diagnostic systems were mentioned. These were Model based diagnosis and Predictive analysis.

The power system modelled in this thesis work has been developed for simulationwhen e.g. the production in some part of the power system is changed. The powersystem has been modelled according to the swing mass of the system, the frequencydependency of the load and the turbine governor. The model determines the systemfrequency, the period of regulation and the power exchange between the differentsubsystems in the Nordic synchronized system.In this model the system frequency is assumed to be the same in all different parts ofthe power system and the voltage conditions in the power system are neglected. Forthat reason power swings does not occur between different subsystems in the powersystem, which usually occur as a result of the swinging connection between thetransmissions line.

The thesis deals with three document retrieval models based on logic: the Boolean model,the fuzzy model and the Van Rijsbergen model.In Chapter 1, the author presents the purpose of the thesis. This is to give the logical foundationof the models, to describe them and to examine them critically. In Chapter 2, some importantnotions in document retrieval are presented. Chapter 3 is devoted to the Boolean model, Chapter4 to the fuzzy model and Chapter 5 to the Van Rijsbergen model.These three chapters are organized in the same way. First, the logical foundation of the modelis given.

A problem in the field of district heating is the oil burners needed to provide power when a peak load occurs. One possible way of reducing the needed amount of oil is to reduce the power demand for space heating in the district-heating substations when the need for district heating water exceeds a certain limit. This can be done by use of a locally working controller function.In this Thesis the options concerning load priority are evaluated. To evaluate the potential for using controller functions concerning peak load priority an experiment was brought out in a chosen district-heating substation. The impact on the indoor thermal comfort during a heat reduction was also taken into account.

This master thesis project at KTH is performed in the Mechanical and Aerospace Engineeringdepartment at University of Florida (UF). The thesis is a small part of a gas turbine researchproject where a vapour absorption refrigeration system (VARS) and a high pressure regenerativeturbine engine (HPRTE) are integrated together. The main objective is to build a computermodel of the VARS. The computer model is supposed to be used to analyse the off-designperformance of the VARS and should also be easy to integrate as a subroutine in a more complexsystem model. To model the VARS some knowledge of the absorbent/refrigerant mixture had tobe well known, in this case a mixture of ammonia and water.

Lerbodaälven is a river in the municipality of Kil which, due to high phosphorus content is not meeting the requirements for good ecological status according to the Water Framework Directive. The purpose of this report is to investigate the causes for the high content of phosphorus that has been measured in Lerbodaälven between 1995-2010. Four questions will be answered in this report. 1. Does the sewage treatment work affect the phosphorus level in Lerbodaälven? The result from the time series analysis shows that the sewage treatment works have a small impact on the phosphorus level in Lerbodaälven.

Every day we make numerous decisions. Some are better than others. Intuitive decisions usually results in less good decisions when we do not reason about our choices. Research has been interested about the process that is behind how we make good decisions. Decisions we face every day, such as when we shop, determined using various mental shortcuts that we use unconsciously.

The purpose with this masters thesis was to model the scanner in a system for laser bathymetry. The model was then used to develop a controller for the scanner so a good search pattern was achieved. Two different types of models have been tested, a physical model and a Black Box model of Box Jenkins type. The physical model has been derived from Lagranges equations. Identification experiments have been used to compute the Black Box model and to find the unknown parameters in the physical model.

The aim of this study was to evaluate the effects on a simulated wastewater plant regarding GHG emissions and use of energy and resources when implementing source separated wastewater systems. The effects were studied for different restrictions of effluent quality and for different temperatures on the influent. The simulation model BSM2G calibrated for Käppala wastewater treatment plant was used. The task was executed by simulating nine different scenarios with an increase in influent load from new connections equivalent to 3, 10 and 30 % of the present connections. These new connections were served by conventional, urine separated or black water separated systems.

The aim of this study was to examine the current and historic mercury(Hg) load of the lake Storjuktan due to its recent exposure to a local potential source of Hg in form of the Sulphide mine Blaikengruvan(2006) and an earlier potential sources of Hg-load, the damming of the lake(1960s). Sediments were extracted using a HTH-sampler, freeze-dried, and analyzed for tot-Hg, LOI and activity of 210Pb and compared to samples extracted prior to the opening of the mine(2006). Constant initial concentration (CIC)-dating model was used for dating the samples. Low levels of Hg (100ng/g) were found throughout the lakes sediment. The highest levels of Hg(220ng/g) was detected at a depth of 4-5cm dating back to the mid 1970:s, suggesting that increased levels of atmospheric Hg rather than damming of the lake has caused the increase of Hg.

In this thesis a concept for floor hatches for foam pits has been developed. Since there is an existing solution that is powered by hydraulics and is expensive, the goal was to develop a cheaper solution, as simple as possible.A number of different concepts were developed and evaluated. A concept with five sections that are pulled to the side and stacked on each other was chosen as it was thought to have the lowest risk of crush injuries and to be easiest to manage and control. In the opening behind the foam mattress a lifting table is placed to regulate the height of the stacked sections.To be allowed to be installed in the floor of sports halls the sections must be dimensioned according to the construction standards for these types of buildings. Different dimensions of beams in steel and wood materials were evaluated and of those, who lived up to the requirements of the standard, a concept was chosen.

One step towards a more sustainable energy system is to create a more flexible electrical grid, where increased demand response among electricity consumers can play an important role. A distribution grid owner can encourage their customers to use electricity more evenly distributed during the day by introducing different types of grid fees such as time-differentiated power tariffs. In this master thesis, the theoretical economic impact of a flattened load profile for a distribution grid owner is investigated. Different factors that impact the distribution grid owner?s economy are identified and two are chosen to be quantified; losses in the grid and the fee to the feeding grid.

This master thesis has been done in cooperation with Sweco Viak AB in Sundsvall. The aimwith the project is to investigate the purifying effect of percolation filter due to iron andmanganese. The overall goal was to investigate how the parameters surface load,sandfractions, and burden time affect the purifying effect. The expectation is to optimize thedesign and find a demouldning of the filter that gives sufficient purifying with a highersurface load. As an attempt to accelerate the curing of the filter, experiments with a layer ofsand which surface has been covered with manganese ore (MnO2) on top of the filter havebeen done.As test filters 10 L bars were used and the experimental work was performed at thewaterworks in Hassela and Munkbysjön.In Hassela different sandfractions were tested.