Sökresultat:
498 Uppsatser om Load cycles - Sida 9 av 34
En studie av retentionen i floden Oder och dess avrinningsområden, Polen.
Nutrient enrichment is the main cause of the increasing eutrophication process in the Baltic Sea during last century. A prerequisite counteract this process the load of nutrients to the Sea must be investigated. The large contribution of nutrients to the Sea is caused by emission from the rivers within the drainage basin. For the total emission of nutrient into the Sea the retention process in the rivers has big influence. This process in the river system has been assumed as a not important part of the nutrient cycle.
Värmning av avloppsvatten med spillvärme för att förbättra kvävereningen -Temperaturens inverkan på kvävereningen
The goal for this master thesis project has been to investigate the power quality in adistribution grid, which has a high fraction of dispersed power production due towindmills. The study has been done on a grid in Laholm South of Halmstad, whereapproximately 45 windmills are connected to the distribution grid owned by SHKEnergi. The investigation has been focused on to two radialy fed 20 kV lines, wheretwelve windmills are connected.Voltage variations have been studied by creating a model of the grid in the simulationprogram SIMPOW. The largest deviation that has been found in any point of the gridis ±1.9 % of the nominal voltage. This deviation is a result of varying powergeneration from the windmills and the voltage regulation at the connection point ofthe line.
Övergripande kvalitets och kapabilitets granskning av produktionsprocessen ? en implementering av SPS. : Overall Quality and Capability Study of the Production Process ? an Implement of SPC.
Quality was earlier only an issue for the company?s quality departments but today is the entire organization involved in quality- and improvements work. With the customers in focus, both external and internal, quality and improvement work should be integrated in the daily activities. The management shall state goals and visions together with a policy. Through participation the correct requirements for a successful work are created.With SPC, statistics process control, there is an opportunity to perceive variations in the process and with the correct tools make it stable.
Konstruktion av infästning till dysa
The goal of this thesis is to design an attachment between a duct and a pod. A pod is what could be compared to an outboard engine for larger vessels. The pod is placed on the outside of the ship?s hull and can rotate 360 ?. A duct is a large steel ring that can be placed around the propeller on the pod to increasethe propulsion force of the ship in lower velocities.
En tidsseriestudie av varviga sjösediment fra?n Kassjön
This thesis aims to analyse a time series containing the annual accumulation rate of minerogenic matter in the lake Kassjo?n. First there is a theoretical survey of some frequently used tools for the analysis of time series in the time domain and in the frequency domain. This survey is followed by a simulation study that illustrates how the theoretical tools work in practice. After this, the time series "toolbox" is used to analyse the time series from Kassjo?n (5701 data points).
Stabilitetsberäkningar och åtgärdsförslag vid islast på Skålandammen
Hydropower is an important source of energy in Sweden and accounts for about 46 % of the total energy production. Sweden has about 1 200 hydropower plants and with the intention of raising the pressure head of the water and to store water, dams are built by the power plants. The storage reservoirs make it possible to adjust the energy production by demand and season. Dams in connection to the reservoirs are subjected to additional loading during periods of high floods or when an icecap in the winter is formed on the reservoirs. In order to maintain the dam safety, the power companies in Sweden are working with guidelines for dam safety from RIDAS.
Utökning av mätområdet för turbinverkningsgraden på avgasturbo
The Goal with this Master of Science thesis is to expand the possible turbine efficiencymeasurements on an exhaust turbocharger. It was done as a part of the CICERO competencecentre. To feed the turbine with air a special flow rig has been used. Instead of loading theturbine by just restricting the compressor flow a docking system for an electrical dynamometer isdesigned to use the dynamometer as an additional loading source. By using an electricaldynamometer as loading device for the turbine, measurements are not depending on compressorperformance.A large part of the work consists in designing accessories for the dynamometer.
Riktlinjer för enskilt avlopp : Underlag för bedömning av normal och hög skyddsnivå i Köpings kommun
In Sweden, the eutrophication of lakes, water courses and the coastal areas is considered the major threat to aquatic ecosystems and therefore actions taken to reduce the nutrient load to aquatic system including the Baltic Sea has high priority. There are many different sources of phosphorous and nitrogen and domestic wastewater is one contributing factor to the high load. Especially waste water from households that is not connected to municipal sewage treatment or a local small scale plant with appropriate nutrient removal efficiency is considered a problem. These types of households are quite common in rural areas in Sweden and in areas where summer houses has been converted to permanent living. Swedish legislation now permit the municipalities to decide in which areas within the municipality higher demands of the local small scale treatment facility should be met by the households (i.e.
Kraftanalys och framtagning av mätanordning för vertikala vindkraftverket Lucias bärarmar
The project contains a force analysis of the vertical axis wind turbine Lucia's supporting arms and a measuring device to experimentally measure the forces is made. The forces between the supporting arms and the tower are calculated theoretically and then simulated by a computere. A measuring devise is then designed to measure the forces experimentally. The forces acting on the attachment between the supporting arms and the tower is primarily the centripetal force, gravitational force and the aerodynamic forces on the rotor wings. The maximum forces were theoretically calculated and is 13.38 kN along the x-axis, -0.25 kN along the y-axis and then 0.5 kN along the z-axis.
Separation av två klasser av åtta-dimensionella reella divisionsalgebror
This thesis aims to analyse a time series containing the annual accumulation rate of minerogenic matter in the lake Kassjo?n. First there is a theoretical survey of some frequently used tools for the analysis of time series in the time domain and in the frequency domain. This survey is followed by a simulation study that illustrates how the theoretical tools work in practice. After this, the time series "toolbox" is used to analyse the time series from Kassjo?n (5701 data points).
VVA-strategier för avgastemperaturhöjning på en HD-Dieselmotor
Regulations on the exhaust emissions of HD-diesel engines are becoming more and more stringent, and therefore, emission after-treatment systems are commonly used. These systems rely on catalytic conversion of NOx,CO , and HC emissions, and are thus dependant on temperature. At low load of the engine, exhaust temperatures are not sufficient for the after-treatment components. Therefore, means to increase the exhaust temperature while maintaining low emissions and fuel consumption are needed.The focus of this project has been to develop strategies for the lift profiles of exhaust and intake valves in the engine, with the goal to raise exhaust temperature in combination with low emissions and fuel consumption. The strategies have been tested in a single-cylinder research engine equipped with a hydraulic variable valve actuation system.
Transportoptimeringar med hjälp av flödesanalyser
Detta examensarbete utgör resultatet av en studie på uppdrag av Volvo Cars Torslanda (VCT) i Göteborg. Syftet med studien har varit att undersöka produktflödena mellan VCT och dess leverantörer med hjälp av analyser. Dessutom utreds hur transporterna skulle kunna optimeras och vilka konsekvenser som uppstår. Beräkningar, diskussioner och analyser resulterar i rekommendationer för företaget.För att få mer kunskap om transportlogistik, produktionsekonomi och miljöpåverkan av transporter genomförs först en litteraturstudie. En granskning av nuläget beskriver hur situationen ser ut i dagsläget och ger även en detaljerad bild av flödena från leverantörer till VCT.Sex stycken flöden vars gods transporteras från leverantörer till VCT har undersökts.
KOGNITIV PROBLEMLÖSNING UNDER STRESS : PÅVERKAR FYSIOLOGISK AROUSAL PRESTATIONEN?
Förmågan att prestera under akut eller kraftig stress är en förutsättning för en del yrken. Forskningsresultaten gällande hur stress påverkar prestation pekar åt olika håll. Denna studie undersökte sambandet mellan fysiologisk arousal och kognitiv problemlösningsförmåga under stress. Trettiotvå polisstudenter testades på Ravens test av flytande intelligens APM set II både före och efter att antingen ha sprungit i tjugo minuter eller haft en självskyddslektion på ca fyrtio minuter. Resultaten från en mixed ANOVA för beroende mätningar visade på en signifikant interaktionseffekt (F (30) = 6,547, p < 0,05) ? en ökning i prestationen hos självskyddsgruppen med arton procent och en minskning med femton procent hos löpningsgruppen.
Tillämpning av nya beräkningsmetoder för branddimensionering av träkonstruktioner - analyser och jämförelser
To build high-rise buildings made of timber has for long been limited by national laws, due to the lack of knowledge in engineering solutions. Frame structures made of wood has for a long time been associated with major fire hazards and consequently lower safety and this connection is still being made today. The increased environmental awareness in recent years has contributed to the exploitation of indigenous building materials, including wood from our own Swedish forests and has become increasingly common. Increased knowledge about how structures behave in fire and how they can be protected in order to achieve safe timber structures has resulted in a growing interest in these structures in the construction industry. Research in the area is constantly updated and new laws allow any number of storeys in wooden buildings in Sweden as long as the performance requirements are fulfilled.The main part of this work has involved calculations of the fire resistance and load bearing capacity of floor and wall constructions.
Samverkanspelare i icke bärande fasadelement
AbstractThe tests work is about the subject "synergism of steel and concrete."The construction sector is in a strong competition and the different companies in the PrefabMarket has ever tried to develop new design solutions that are efficient and environmentallyfriendly.The purpose of this report is to highlight different aspects of interaction and size up a columndimension and to examine its efficiency and load capacity as Eurocode 3 and Eurocode 4. A sizing chart that describes the relationship between the torque and normal force shouldalso be made of the interaction . .