The most predominant method for forest harvesting in Sweden is the cut-to-length method based on two-machines, a harvester that fells trees and cut them in a predefined length, and a forwarder which transports logs to a landing area for further transport to a processing facility. New machine solutions have to be much gentler to the ground than today?s machines. To be able to develop a forestry machine that preserves the terrain requires a proper understanding of the interaction between tire and soil.The goal of the project is to contribute to the existing knowledge of forest machine tire-soil interaction and to develop a tire-soil model that enables dynamic simulations of forest machines operating in rough terrain. The modeling has especially been focused on the interaction between tires and soft ground.A comparison of theoretical data of different WES-based terrain interaction models and a comparison test data from a full scale field test is presented.

Due to excess precipitation that cause runoff, all soils in Sweden naturally leaches nitrogen.High leaching from arable land is an environmental problem when the runoff reacheswaters. In the international agreement, Baltic Sea Action Plan, the aim is to reduce therunoff of nutrients. Sweden has agreed to reduce its load of e.g. nitrogen to the Baltic Sea.One of the proposed measures is an increased use of site-specific N-fertilization, which hasbeen shown to increase nitrogen use efficiency and therefore also reduce the nitrogen runoff.Either yields are increased with the same total amount of nitrogen, or the total quantityof nitrogen is reduced with preserved yield levels, which is profitable for the farmers.The dynamics of nitrogen leaching differs between top dressing applications above orbelow the economical optimum. There is a consensus about a difference in the dynamics,but not about its magnitude.

The cattle production in the world has been questioned in Sweden due to its negative impacts on the environment. The use of imported soya bean meal as a protein feed for Swedish cattle results in the cutting of rainforest and an extensive use of pesticides in the countries were the soya beans are produced. As a consequence, the environmental impacts caused by cattle production increases. A production of protein feeds in Sweden would decrease the transportations and the cutting of rainforest. For organic beef producers the possibility to produce home-grown protein feeds is important since organic protein feeds can be difficult to obtain in another way.

The project concerns a predevelopment work for Scania AB, a leading manufacturer of heavytrucks, and was performed as a master thesis work for the program Design and ProductDevelopment at KTH. The purpose of this work was to examine how the work situation of truckdrivers, especially long-haulage drivers, can be improved with respect to prolonged sedentaryoccupation. Mental fatigue and under-stimulation due to low cognitive load during long drivescan be major risk factors for traffic accidents. Physical strain injuries to both the skeleton andmuscles are common for this working group and minimal opportunity for daily exercise alsoincreases the risk of developing blood clots in the legs, which can have serious consequences forthe driver's health.An extensive background study, both theoretical and exploratory, was performed to identify thedrivers' concerns and comfort needs. Various treatments such as massage and active sitting wereinvestigated and existing products within the area studied.

Intresset kring lågenergibyggnader blir allt större och så kallade passivhus, med god isolering, hög lufttäthet och värmeåtervinning, byggs i allt större utsträckning i Sverige och andra europeiska länder. Vissa frågetecken har dock uppkommit kring inomhusklimatet i husen och risken för både under- och övertemperaturer. En annan viktig aspekt är hur husens egenskaper påverkar värmelasterna och hur detta i sin tur påverkar energiförsörjningssystemet. I detta examensarbete undersöks dessa båda aspekter ? värmelastegenskaper och innetemperaturer ? i fyra likadana nybyggda flerbostadshus i Falkenberg.

The different material layers as part of a road construction fill all a function so theroad becomes durable, safe, comfortable and aesthetically pleasing. Recently, anew group of construction materials started to play an important role in roadconstruction ? geosynthetics.This thesis addresses the two most common types ofgeosynthetics used in modern road construction, namely geogrids and geotextiles.The most common use of geogrids is reinforcement of poor subgrade by usinggeogrid soil reinforcement, which occurs when road material particles wedge inthe geogrid?s mesh. Geotextiles act partly as a barrier that prevents the finermaterial in the below ground from being mixed with coarser upper material andalso act as a load spreader.Road contractors often face a choice of whether geogrids and/or geotextiles areappropriate in a particular road project and also how much profit the choice mightbring. This phase in the tender calculation process is the intended scope of thisthesis.The thesis deals with both the "hard" cost-function aspects and the "softer" values e.g.

Increased resource efficiency in an energy system could result in large economic and environmental benefits. Tekniska verken i Linköping AB (Tekniska verken) is responsible for the district heating network in Linköping. Their vision is to create the world?s most resource efficient region. An important step towards this vision is more efficient usage of produced heat, something which could be achieved through integration of a seasonal heat storage in the energy system.

Aluminium sulphate (Al2(SO4)3) is usually added during the drinking water treatment processin order to precipitate organic and inorganic material, resulting in aluminium-based drinkingwater treatment residual sludge (WTR). Since 2003 Swedish law no longer permits WTR tobe deposited in lakes, and there is an interest to explore the possibility to utilize WTR as soilamendment. The aim of this study was to examine the effects of WTR application on cropgrowth and concentrations of macronutrients and trace elements (including micronutrients andpotential toxic elements). A greenhouse pot experiment was conducted with three soils; a clayloam rich in phosphorous (P), a loamy sand rich in P, and a silty loam with a low soil Pconcentration, and two crop species Italian ryegrass (Lolium multiflorum Lam. cv.

Chile and Santiago are struggling with heavy environmental problems as a consequence of urbanisation and industrialisation. In the Santiago region the air is seriously contaminated and most of the rivers are classified as heavily polluted.The aim of this thesis is to survey the industrial fluid waste situation in the Santiago region and to make suggestions on technological improvements or process changes. The purpose is also to study five different enterprises more closely and to give more detailed suggestions for improvement. Another purpose is to summarize relevant Chilean legislation.Information, provided by the supervisory authority, about the release of industrial wastewater to rivers has been analysed. Deep interviews have been made with authorities and consultants.

The construction of buildings and paved surfaces changes the natural water balance.Precipitation generates surface runoff and storm water instead of infiltrating into the soil.Storm water has come to be considered as a major source of pollution in lakes and streams inthe vicinity of urban areas. Reduction of pollutants in storm water is a key action in order toprotect sensitive recipients and maintain high water quality. Storm water is traditionallytransported by storm sewers to the nearest recipient. In recent years the approach to stormwater management has changed; storm water should primarily be disposed of on site, throughlocal disposal of storm water, LOD. LOD is created by a combination of the function ofseveral smaller local facilities and the general sewer system.

With this study, our purpose has been to achieve profounded knowledge and understanding regarding the use of discretion among social workers specialized in social allowance issues. The Social Services Act, structured as a framework law in the Swedish context, provides the social worker with a certain degree of discretion, in order to enable accommodated decisions depending on client case specifics. This study problematizes these aspects of legal security, and our intention has been to examine which factors impact the assessments social workers carry out in statutory decisions of social allowance applications. To attain this, we narrowed down our intention into a number of distinct and delimitated research questions: (1) Which elements of the client case impact the social worker?s assessment? (2) Which external aspects influence the social worker?s assessments and decisions? (3) How do social workers decide the client?s credibility? In order to establish answers to our research questions, we have utilized a qualitative approach of research by exerting qualitative interviews in addition to a vignette study.

The automotive market is currently undergoing a historical change where stricter emission legislations and ever increasing fuel costs have intensified the search for effective alternatives to the conventional internal combustion engine, which has resulted in a substantial trend towards electrification of powertrains. Storage of electrical energy is the fundamental component in this technology where the lithium-ion batteries are currently considered as the most appropriate solution. Lithium-ion batteries, however, as other types of batteries, can only be used efficiently and durably within a specific temperature range.This Master thesis has been carried out in collaboration with Electroengine in Sweden AB, situated in Uppsala, which has an ongoing project regarding development of a modular battery system for electric powertrains. The project is at a stage where an initial prototype has been developed which provides the foundation for this thesis. The study has addressed the battery system performance from a thermal perspective, in order to validate the ability of the system to create a thermally serviceable environment for the lithium-ion battery cells.

Approximately 60 million cubic meters of round wood are transported every year with trucks in Sweden and stand for 15 % of all truck transportation in the country. The big amount that is transported results in many haulage companies works in different parts of the country with different conditions to get a good flow on their transports. Today the transport pricing is very general and the payment consists of the unit round wood they are transporting and the distance of the transport. The purpose of this study were, from the freighter and the haulage company?s perspective, try to find ways to change the today applied transport pricing to more differentiated and compare them to historic payment of transportation.

Timber floating operations in Scandinavia during the 19th and 20th centuries has contributed to severe negative impacts on riverine ecosystems. Increase in water velocity and lack of stream bed heterogeneity as a result of stream channelization lead to increased bed load transport. Since availability and recruitment of new suitable spawning substrate in Scandinavian watercourses is sparse, spawning habitats for salmonids has become a scarce commodity. Lately, increasingly more attention has been given to the recreation and improvement of brown trout (Salmo trutta) spawning habitats in restoration projects. While much of the research on spawning habitat has been focused on evaluation of the influence that the constructed spawning grounds have on fish populations, few studies have been conducted to evaluate the persistence of these constructions over time. I evaluate erosion of constructed spawning beds as an effect of sediment transport attributable to water discharge.

Stump wood was used between 1850 and 1950 for production of tar and as firewood. In the 1950s the use decreased because of the introduction of the cheap fossil oil. In the 1970s stump wood became an interesting issue again as a raw material for the pulp industry. Stump lifting has today become a possible source for bioenergy. The objectives with this study were to investigate the productivity of stump lifting and stump extraction, and to analyse the economy.