Today dairy farmers in Sweden are obligated to have lights turned on during night time in addition to the mandatory daylight inlet. This presents a cost for the production but many argue that it can be economically beneficial, especially in loose housing of dairy cows. In loose housing and even more so in herds with automatic milking, well functioning cow traffic during all hours of the day is crucial to optimise production. In order to keep the cow traffic flowing, lights may be an important management tool. It is also perceived among farmers with tied up stall that night light decreases the incidents of cows accidental stepping on their own or neighbours udders.

Can you ensure that your smoke detector will sense fire and sound the alarm in the middle of the night?In 80 percent of the cases where emergency pulls out, smoke detectors are missing where the fire occurred. In the year of 2009, 118 people in Sweden died in fires ? most of them would have survived if there had been a functioning smoke detector.Earlier development of smoke detectors has mainly been focusing on components that sense smoke and alert in case of fire. But in most cases the problem has not been whether the smoke detector was working or not as fully assembled, but rather that it was missing.

The number of residential fires has not declined sufficiently since the smoke alarm entranced the Swedish homes, fires lead to devastating consequences in which possessions, homes and worst of all human lives are at stake. Every year, about 80 people get killed and more than 500 get´s injured in residential fires, often due to lack of safety equipment. The number of fires caused by electrical appliances has risen and taken over a period of ten years the fire caused by a forgotten stove has increased by 70 percent. Preventing the risk that a fire would start on the stove would saves money, worry and most importantly, lives..

This essay includes the planning and designing of a house as well as writing a rapport about howto increase fire safety in small buildings.More than 6000 homes burn in Sweden every year (Brandskyddsföreningen, 2012c). Thedevastation and the costs are usually very high. This report examines possible measures to reduceboth personal injuries and economic losses resulting from house fires in small buildings.Swedishbuilding regulationsplay a major role when it comes to constructional fire safety. However therequirements inSwedish building regulations are very low for small buildings and this is anargument for raising the requirements.The report shows and describes possible methods to build safer with regards to fire in terms ofmaterials and different building structures. Major focus has been on fire cells but other solutionsare also examined and described.

To work in an unpredictable work environment requires communication that functions well. In every organization it?s important that employees receive information that is relevant yet not confusing. Due to that, our ambition with this study is to understand how rescue effort organizations communicate in meetings; and whether their communication is clear or not. Our subject for this case study is the Emergency Services in the region of Karlstad.

En studie av kopparvävens egenskaper i kombination med ljus.A study of the copper weave characteristics, in combination with light..

Acquiring a former station building can mean that the property owners must familiarize themselves with a lot of planning and building regulations. After the new Planning and Building Act code into force in 2011, the responsibility lie on the developer to ensure laws and regulations. Based on the regulatory framework that is available occurs sometimes balance issues, between care requirements and building codes. The station building in Ormaryd was acquired in 2009 by two individuals who intended to accommodate office and retail space in the building. In doing so a new local plan of the area was established, including regulations on how the building could be used. By including road safety and noise, the risk was not considered appropriate to use the station building for housing.

This report contains a programming improvement work in a LabVIEW? fire testing furnace control system for SP Fire Technology in Borås. Here materials and products behaviour are tested and evaluated, being exposed to fire. For this task, UGNET is being used for control and surveillance of the testing furnace system. System hardware has been updated gradually through the years, while the software has been neglected.

Då scenkomplexitet och ett högre antal ljuskällor blir vanligare inom spel har ett behov av algortimer för att hantera dessa scener, med bra prestanda, uppståt. En allt vanligare algoritm för detta är Deferred Shading. Rapporten utvärderar två olika metoder för Deferred Shading (traditionell Deferred Shading och Light pre-pass rendering)..

At the beginning of 2011, Sweden started using the European rules for structural design, the Eurocodes, instead of the previous national rules. In both the previous rules and the Eurocodes, it is possible to dimension concrete columns using tabled values. However, the required cross section measurements have increased considerably. Moreover, it is possible to dimension concrete columns using calculations, however, this is unusual.The development of a fire in a fire cell can be divided into the growth stage, the fully developed fire and the cooling phase. The duration of each phase, as well as the temperature, is dependent on a number of factors, e.g.

During the late 1800s fire suppression became increasingly effective in northern Sweden which led to decreased areas of fire-disturbed woodland and successive changes in the structure of forests. In the long run this can pose a serious threat to fire-dependent and fire-favored species. Today some fire-prone forest reserves are burned as a nature conservation act. Often partial cuttings are made before burning, with somewhat different motives. The purpose of the study in Långsidberget nature reserve was to give a general picture of forest history and its affect on today?s forest condition, and to show how partial cuttings affect burning conditions and results. Långsidberget is located close to areas that were colonized during the Middle Ages.

During the 1930´s the hot potato for the Swedish lighting associations were how to create the most suitable light for every situation, either for industries, offices or homes. The light bulb were the most frequently used source of light but due to limitied luminous intensity, big halls sometimes required up to hundreds of light bulbs to produce the right amount of light. Two kinds of different lights, by different reasons, can be titled the predecessors of the fluorescent lighting during the 1930´s: The volfram-filament tube light due to its estetic similarities and the electric discharge (mercury- and sodium-) lamps due to its technical resemblance. Even though they came in quite wide use (the volfram tube in public halls (e. g.

Fire is an important ecological factor, but its consumption of coarse woody debris, CWD, has hardly received any attention. In this study, I investigate the consumption in relation to the time of initial flame exposure and propensity for continued combustion of standing CWD of pine (Pinus sylvestris). Two types of CWD were studied. Firstly, wood that had been dead for one to ten years. Secondly, wood that had been dead for several decades. In the burning experiments, logs of approx.

This report describes a project, which was carried out as a final thesis covering 30 ECTS during the final semester of the Master of Science programme Industrial Design. The assignment was issued by Fagerhults Belysning AB in Habo. The assignment was to design a family of products in which LED was to be used as a source of light. The main focus in the initial part of the project was to find a way to design the inside of armature which was suitable for LED technology. An armature, already in the range of products at Fagerhult, with the desired qualities that was to be strived after was the Zintra. The lighting source of the Zintra is a compact fluorescent lamp.

This project is about color and light and how it affects the atmosphere in the city. I choseto look closer into the central parts of the city, a place where I often feel a lack of lightand color, especially during the winter season. In the beginning of the project I made ananalysis of how intense colors are used in the city and how we can use color as a tool tocreate effectful spaces. Further into the project I chose to look closer into the effects thatare made by the facades, how the light from the windows affects the room outside when the dark falls. At the end of the project I caught a feeling inspired by the city and applied it into an installation of light..