This report discusses the constructionof different types of exterior wallconstructions and analyses wall layers.Standard wall constructions from theSwedish building contractors NCC andSkanska and also from the materialproducer Isover have been chosen for theresearch. Life cycle cost analysis hasbeen made to conclude the mostprofitable wall type, seen from asustainable and economic perspective.The calculations have been made for aperiod of 50 years.The report shows that building with wellinsulated walls is a more profitablesolution both economically and whatconcerns sustainability even though thehigher investment. However, when wallssimilar insulation properties are beingcompared, the study proves that lowerinvestment cost is more profitable.The report introduces requiredconstruction techniques of walls inorder that the reader should understandwall constructions with different layersand properties. The essay shows theimportance of properly constructed wallsto avoid air leakage and moisturedamage.The essay has been implemented byliterature studies, contacts with NCCand Skanska and by energy calculationsmade by hand and using the software VIPEnergy..

Sewer trenches usually contain material with a higher hydraulic conductivity then the adjacent soil. Thus they can serve as paths of preferential flow in a polluted area. Wastewater from factories can also leak from wastewater pipes and pollute the soil in the sewer trenches.The purpose of this project was to investigate pollutions in sewer trenches and in sewer pipes in the industrial area of Köpmanholmen, 20 km south of Örnsköldsvik in the north of Sweden. To make an estimation concerning the potential of transport of pollutions in sewer trenches, hydrological calculations were performed.Leakage to any greater extent did not seem to be a problem in the area. This is the case both for the concrete and the wooden pipes that have served as factory wastewater pipes.

This thesis conducted at the University of Uppsala investigateshow well a prefabricated building component from the manufacturerMasonite Lättelement AB can be incorporated into ahouse projected to accomplish the demanding criteria of a passivehouse. The thesis is organized as a comparison betweenthe prefabricated elements and an on-site built component fromthe passive house area of Oxtorget in Värnamo, Sweden. Theaspects investigated were air leakage, energy, moisture, economyand noise conditions.Results of the comparative analyzes shows that the prefabricatedproducts were capable of accomplishing the requirementsof passive houses and therefore this thesis should beviewed as a basis to confirm that the technology of prefabricatedbuilding components today in Sweden are mature enoughto be a significant part of the passive houses that are to be builtin the near future. The development of prefabricated technologyis of crucial significance if we are to accomplish the goalsof reduced energy consumption by the year 2020..

Lake Bornsjön is situated 30 km southwest of Stockholm in a rift valley lake and consist three basins outstretched in northwest-southeast direction. The surface area is 6,7 km2 with a maximum depth of 18,3 meters, a mean depth of 9,8 meters and a retention time of the water of 6,5 years. The drainage area is 42 km2 and consists mainly of arable land (ca 1000 ha) and productive forestry land (2500 ha), but in the drainage area there are also restored and fairly newly constructed wetlands.Today the Stockholm area receives its drinking water from Lake Mälaren, but if there would be any pollution of this source, Lake Bornsjön would act as the water source. The area surrounding the lake was bought already in 1899 by Stockholm Stad for protection of the lake and was taken over 1993 by Stockholm Vatten AB. It has been a water protection area from 1988 and it was also accepted as a nature reserve in 1995.

This thesis has the overall objective to develop the optimum sealing system between the retarder and transmission. Today, there is a pressure-relief and two radial seals separation between the retarder and transmission. It has been found that carbon residue formation may occur between retarder axle and seal lips with, in some cases, leakage as a result.We have in this thesis tried to explain the phenomenon of carbon residue, how it is formed and why it can be seen just on the seals? A rig test was conducted where we show how friction, speed, transmission temperature and mitigation phases of the retarder affects temperatures in the sealing environment. Factors affecting the coke structure are reported, together with proposals for measures that provide a mitigating seal environment.

Today, there are more than 12 000-14 000 farms worldwide using an automatic milking system (AMS). Studies have shown that transition to AMS affects the udder health of cows adversely, recognized primarily as elevated somatic cell counts. There are several reasons for this, for example the greater variation in milking frequency seen in AMS. On one hand, short milking intervals may lead to bad teat condition of the cows due to the stress the milking procedure exposes the teats to. Too long milking intervals, on the other hand, seem to predispose for milk leakage, which is, in turn, a risk factor for the development of mastitis.

The swedish national board of housing, Building and Planning,recommends that all stakeholders in the construction industryperform a moisture control design to make sure that the buildingachieves good moisture resistance. Since June 1, 2006 there are nospecific requirements or quantitative values for air leakage.Although the swedish national board of housing does presentrequirement that the building envelope must be sealed so that theclient?s requirements for specific energy consumption and installedelectric power for heating purposes are met. Despite this, studiesfrom SP shows that few buildings meet the client?s requirements inspecific energy, which increases the risk of occurrence ofcondensation-related moisture damage.This study aims to evaluate curtain walls connections from airsecurity and moisture safety.

This thesis raises the problem with acid mine drainage around the closed mine Finngruvan.The purpose of the investigation was to compare metal content in surface water in the areaand its catchments between year 2010 and 2003, also to make calculation of specific runoffand metal load, furthermore determine the recipients in the area. Surface water samplingwhere preformed at the same place as 2003 and also at a few other places of interest. Adigital elevation file were used in GIS to calculate the area of the watersheds in the region,observations in the field where also made. The collected data were used to make comparisons,calculations and conclusions. The result showed that the surface water 2010 had somewhatlower metal concentrations.

The Earths climate is changing at a higher rate, i.e between 1861 and 1994 the annual mean temperature in Scandinavia increased with 0,68º C and according to recent climate models the annual mean temperature is likely to rise with another 3º C during this century.A warmer climate in many ways is associated with changing conditions for lake ecosystems. An expected higher water temperature and a stronger summer stratification of the water column increases the risk of anoxic conditions at the lake bottom. Thus anoxic conditions are likely to cause a phosphate leakage from the sediment, i.e. a higher internal loading of phosphate.In this project, the extremely warm summer of 2002 has been used as an example for a possible scenario for a future climate. By comparing levels of phosphorus in the summer of 2002 with a ten-year median value, a phosphorus related sensitivity to climate change has been analyzed for 55 Swedish lakes.

Gtherm is an innovation company who has an unique air heat exchanger underdevelopment. The purpose of this thesis is to provide data of suitable motors for theheat exchanger and to find suitable motor suppliers.A motor specification was designed. It is an important basis for the search of suitablemotors. A compilation was made of nine motor suppliers and the suitable motorsfrom those. The compilation can be used by GTherm in their choice of suppliers andmotors.The compilation of the demands on the motor and analysis of suppliers indicated thatthere were no standard motors available to GTherms air heat exchanger.

This Diploma work investigates internal air ventilated crawl-space in respect to construction and damp. The Diploma work assumes from a general description of crawl-space and general dump problems in ground construction. An internal air ventilated crawl-space is a construction where you take the ventilation air from the building and bring it down to the crawl-space and lets the air circulate before it passes through a retaining aggregate on the way out from the crawl-space. In this matter you get a worm space under the building and a lot less dump problems in form of · Ground damp · Build damp The ground dump reduces through draining around the building, different layer of gravel between the ground and the building and ventilation of the crawl- space. The build dump reduces through ventilation of the crawl-space as fast as possible.

In this Master's thesis, a direct-conversion receiver front-end has been designed in a 0.18um CMOS technology. Direct-conversion receivers (DCR) have obvious advantages over the heterodyne counterpart. Since the intermediate frequency (IF) is zero, the problem of image is circumvented. As a result, no front-end image reject filter is required and the channel selection requires only a low-pass filter, which makes it easy to integrate directly on chip. However, the DCR also suffers from several drawbacks such as extreme sensitivity to DC offsets, 1/f noise, local oscillator (LO) leakage/radiation, front-end nonlinearity and I/Q mismatch.

This report is focusing upon relining from a client?s point of view. Potential buyers are given a presentation of the different methods available today together with a general briefing describing the process. An important part of this report are the interviews that took place with already established customers. Property owners, managers, pipe cleaners, and project managers whom all been in contact with relining have answered the questions given along with their own thoughts and have also given recommendations of other persons to talk to.

A study was made on four environmental ponds in Sölvesborgs municipality. The reason forthis was to see if the ponds had fulfilled some of the questions that was mentioned in theproject ?Rädda Hanöbukten?. The questions were as following; do the environmental pondsdecrease the leakage of nitrogen and phosphorus into Hanöbukten, do the ponds decrease theuse of groundwater in Sölvesborgs Municipality and are there any restrictions on what thewater in the ponds is allowed to be used for. In order to answer these questions aquestionnaire was made and interviews were held.

Cultivation of grapevine is novel under Scandinavian conditions. We studied the impact of ground cover on frost hardiness of grapevine cultivars in Northwestern Scania in a two-factorial trial with four cultivars Solaris, Pinot Gris, Siegerrebe, Ortega and three kinds of ground cover (open soil, plastic cover and gravel). The study was conducted in a grapevine orchard, planted in May 2009, in Broddarp on Bjärepenisula Sweden (N latitude 56°; longitude E 12°). Soil and air temperature were monitored continuously. Frost hardiness measurements were performed every second week from late September to early December 2009. Frost resistance, LT50, was determined by electrolyte leakage measurement of the upper stems after artificial freezing at -15 °C.