In the future network-based Swedish Defence (NBD), attaining information superiority will be of great importance. This will be achieved by a network of networks where decision-makers, information- and weapon-systems are linked together. As a part of the development of NBD, we have performed a study of user interface design for a future network-based tool package for analysis of sensor systems, referred to as the C2SR-system. This thesis was performed at Ericsson Microwave Systems AB, Sensor and Information Networks, during the autumn 2002. A pre-study concerning the requirements of usability, trustworthiness and functionality of a user interface for the C2SR-system was performed.

This is a dissertation for a Bachelor Degree Project at the University of Skövde. The project is carried out in cooperation with the company Kinnarps AB.The objective of this project was to develop a new chair for café and lunch rooms, which should satisfy the markets expectations and demands and match Kinnarps AB?s assortment today. The project has contained everything from identification of user and customer needs and requirements to evaluation and building of a prototype.The result is a chair with a frame of tubular steel and there is nothing like it in Kinnarps AB?s assortment today.

Starting in January 2007, capital adequacy of internationally active banks will be regulated by the new Basel Capital Accord, International Convergence of Capital Measurement and Capital Standards ? a revised framework, [Basel II]. The framework introduces for the first time minimum capital requirements for operational risk and encourages market discipline of capital adequacy by initiating requirements for public disclosure of quantitative and qualitative information on operational risk exposure. This thesis examines the nature, definition, management and public disclosure of operational risk in Scandinavian banks based on regulations and recommendations presented in Basel II. We find that the models currently available for addition of operational risk to the capital requirement do not reflect actual operational risk exposure of banks.

Wavecraft AB develops medical equipment for heating of organic synthesises. The heating is done with microwaves, which improves the process in both speed and accuracy compared to the more traditional methods where heating elements are used. This report discusses the developement of an automatic lid mechanism for one of Wavecraft's product prototypes. The company assumes that the final product will be integrated by customers into fully automated systems, and the upgrade from a manually to an automatically controlled lid is therefore an important step in the product's developement process.The first stage och the project was an idea generation process. The ideas generated here were organized into five different concepts of which the best one was selected through the use of a concept matrix.

Building Automation Systems in commercial buildings are often designed and installed by different contractors, using equipment and components from different manufacturers. The lack of an accepted communication standard has resulted in a few different standards. Many manufacturers of building automation systems only support one, a few or none of these standards, while developing proprietary system solutions. Regin, who develop such equipment, are planning to adopt an open communication protocol specially designed for building automation - BACnet. As a step in that direction this thesis was announced with the purpose to investigate the possibility to implement BACnet in one of their products and to gain more knowledge of the BACnet protocol.

There are problems with poor quality, poor scheduling and poor working climate in the Swedish construction industry. Many parts have been involved, trying to solve the problem.This spring a new planning and building-law becomes final. In this law, the requirements set on the controls are greater. Hopefully this will lead to fewer construction errors. The requirements set on the working environment have also increased, forcing consultants and contractors to focus on safe workplaces.For each project requiring a building permit, an inspection plan has to been drawn.

I contacted the production company Salmonfox in the hope that they would have any projects that they needed help with. It showed that Salmonfox just started up an old project that they needed to complete. They wanted my help to edit some trailers and one crowdfundingfilm for the short film called, Captain Sweden (Kapten Sverige). Salmonfox are hopefully going to use the different trailers and crowdfundingfilm to promote the short film and get help with the funding to make a feature. The project began with a pilot study in which I made a time plan and a requirements plan, where the different requirements were set.

As the globalization of companies increases day by day, the need for a clear and comprehensible legislation to overcome the problems with transfer pricing transactions increases as well. Incorrect pricing in transfer pricing situations between companies with close economic ties to each other makes countries risk parts of their taxation income.Swedish legislation uses the internationally accepted arm?s length principle to regulate the transfer pricing transactions. Through the correction rule, the rule is upheld that the pricing between two companies with close economic ties to each other must apply to the same conditions as it would have been if it was between two companies without close economic ties to each other.To ensure that enough material is provided to base the assumption whether or not the correction rule has been followed or not, Swedish legislation provides a number of paragraphs to regulate the matter. The legislation is spread all over and is hard to interpret.

The report aims to investigate how well a certain type of affordable embedded single board computer can hold up against today's more expensive computers in a computer system by doing various tests on a system with the specified requirements. The system has a Raspberry Pi as the single board computer which task is to control a camera based on coordinates obtained from a server as well as capture and stream a video signal on a network.The researches were conducted to check how much network traffic a single-chip computer sent in different video formats and how much CPU utilization was required. Studies were also made to ensure the accuracy of the camera control. The researches have been experimental, where several tests have been performed and analyzed.The results show that a sufficiently good accuracy can be obtained from the camera steering unit, in which two different servos have been investigated. When the video format MJPEG and H.264 are used, the single-chip computer is able to transmit a video signal up to 1280x720 at 15 fps.

I forskningsprojektet undersöktes hur fem högutbildade utlandsfödda kvinnor har kommit in på arbetsmarknaden och fått ett arbete utifrån sin kompetens. I studien presenteras resultat om hur dessa utlandsfödda kvinnor i egenskap av bland annat ett feministiskt synsätt och utifrån sin egen förmåga har kommit in på arbetsmarknaden. Hinder och framgång som kvinnorna upplever i sin yrkesverksamhet beskrivs i studien. Denna kvalitativa studie genomfördes med e-metodologi, en sammankoppling av den fysiska och den elektroniska världen.  .

During the last part of the 20th century many companies has started to build their organizations on knowledge and information instead of manufacturing of products.  Today it is easier to communicate and spread information. At the same time the numbers of untraditional employments like temporary employments and workers from staffing agencies are increasing. Many organizations have higher employee turnover now than before. This allows more people to have access to confidential information, whose spreading might cause great damage for the employer.

An environmental review has been carried out at FORIA AB, a transportation- and machine service company, to analyze the company?s environmental aspects from the transportation segment. This report describes the essential background and the methods of identifying and evaluate the environmental aspects. It also describes how the work with the environmental aspects often vary between different actors. The design of the ISO 14001 is intentionally broad in order to apply on all sorts of activities and organizations.

This essay addresses and treats the employer's obligation to work adaptation for people with a physical disability according to discrimination law and the work environment law. Furthermore it also treats the employer's obligation to rehabilitation of employees that has a reduced working ability as consequence of their work. The essay also intends to investigate if there are any differences in the employer?s obligation to work adaptation when recruiting and the employer?s obligation to work adaption for an existing employment. In this work, there is a background chapter which describes the UN and the European Union's approach to work reduction ability and disability. Furthermore, there is a detailed description of the work environment law, the discrimination law, the social insurance code and the employment protection legislation.

ÅF Test Center in Borlänge had a need to expand their capacity for compressive and tensile strength tests. They wanted to do this by using a hydraulic cylinder, which they already possessed, to apply the force with. This required a load receiving structure. The aim of this work was to design and dimensioning a test bench for a cylinder marked NIKE 300 tons. The work would result in a completed design proposal on a test bench which could manage to run the compressive and tensile strength tests of up to 3000 kN.

This report aims to examine the design of a passive house. The design addresses the selection ofmaterial, sizing and selection of both building services systems and building technical features suchas load-bearing framework and moisture control. Interior layout is designed for a family of twoadults and one child.A big part of the report is devoted to an in-depth comparison of three different wall constructions ofpassive house standard. The structures that have been compared are a lightweight timber structure, aheavier concrete structure and a sandwich wall of the brand Weber Leca. The report covers variousaspects such as air flow, wall thickness, the risks associated with the construction, U-value, thermalbridges, power consumption, price, and assembly costs.