Costs of maintenance on combines are a subject of interest thus it constitute a large investment and cost for the individual farmer. Therefore it is important to have up to date knowledge and the right facts to be able to do reliable calculations on one of the largest investments for a farmer. The aim of this study was to compare costs of maintenance on combine/threshingmachine with the computer program for advising environmental issues in agriculture, STANK. Interviews took place and data were collected by handing out questionnaires to 20 farmers. A similar study conducted by Neuman (2003) investigated costs of maintenance and compared these with STANK. The results of this study have also been compared and examined related to data from SLA - Skogs och Lantarbetsgivarförbundet. The result shows that 18 out of 20 combines were given a higher cost of maintenance when using STANK compared to the numbers in this study.

The guest harbor on Utö, Utö Gästhamn, is currently using electricity for heating all of the water used in the showers and taps. Because of the large amount of visitors, especially during the summer months, the hot water usage gets very high and that is also the case for the electrical bills. During the year of 2011 the cost of electricity for Utö Gästhamn reached a total of 257 500 kr. Out of these 257 500 kr approximately 142 000 kr, 55 % of the total cost, were because of the water heating.The report is the result of a cooperation with Skärgårdsstiftelsen, the Green Islands-project and Utö Gästhamn where the mutual goal is to dimension a solar energy system, to promote the sustainable development.Initially the different techniques for the solar energy system are researched. The techniques are plane solar collectors, evacuated tube collectors, pool collectors and photovoltaic cells.

At Flight and Systems test Saab AB, a post-processing software is used to process GPS data. A new software by the name GrafNav has been purchased and the purpose of this master thesis therefore became, partly to make a judgment regarding GrafNav?s ability to estimate position, velocity and accuracy, partly to if needed improve the estimate and finally find one or several methods to estimate the position and velocity accuracy. The judgment of GrafNav was performed partly by a comparison to the former post-processing software (PNAV) and partly by a comparison to the airplane?s inertial navigation system (INS).

Companies financed through borrowed capital are allowed a tax deduction for the costs re-lated to their borrowed capital. A similar tax relief for companies financed through share-holder?s equity does not exist, why these companies are taxed higher than companies fi-nanced by borrowed capital. The result is that there is an asymmetric tax treatment of companies depending on how they are financed.The autumn of 2012, the Swedish government presents a proposal for an investor deduc-tion which seeks to equalize the above mentioned asymmetry. The proposed investor de-duction is a tax relief for investments in shares in a startup- or small company equal to 50 percent of the acquisition cost of that investment.The venture capital deduction, which in this thesis is treated as an alternative to the inves-tor deduction, is an interest-free tax credit which significate that two-thirds of the acquisi-tion cost is deductible from taxation at the time of the acquisition.

Grubbe Ventilation AB is a sheet metal and ventilation company who provides design, installation, service, and repair of ventilation. The company is expanding their business by building a new facility in Umeå, Västerbotten. The property is designed to be used for both office and industrial work.Grubbe Ventelation AB has not yet decided upon wish system which is to be established to provide the building with heating and cooling. The consulting firm Umeå Projekt Team has therefore been asked to investigate the possibilities to invest in geothermal- heating and cooling.If the investigation of a geothermal heating- and cooling system would provide favorable results it would be a very appropriate alternative that provides energy at low costs and are an environmentally friendly option as the energy comes from stored solar energy in the ground is provided by stored solar energy in the ground.The facility ´s heating and cooling consumptions are calculated in the program BV2 and the result indicate a heating demand of 185 000 kWh per year due to thermal transmittance, transmission losses, heating of warm water and a cooling requirement of 5500 kWh.Three different systems of geothermal heating and cooling were tested in the computer program Energy Earth Design. The results show no difference in the dimensioning of the drill hole if merely heating were to be used or both heating and cooling were to be established.

In today's society, the availability of energy plays an integral part in our everyday lives. Unfortunately, the price of energy in Sweden has increased in recent decades. A large part of our energy consumption goes to heating modules for houses, where heating methods that depend on energy sources such as electricity, district heating, fuel oil, gas and biofuels are the most common ones. During the winter period, the increase in energy costs becomes significantly evident, especially for small property owners. This increase in energy cost is most noticeable for home owners with electric heating.This thesis is written at the Halmstad University, in cooperation with a company, which makes parts of this thesis confidential.

This paper analyses how Swedish fine-art oil paintings sold at auctions has performed as a monetary investment during the period autumn 1985 until spring 2006. An average price technique as well as a hedonic regression technique, applied to a sample of 19 213 auction sales, is used to construct price indices. The indices show somewhat different results, which is explained by the inability of the average price model to adjust for relative differences in quality between periods. The hedonic regression model on the other hand captures this effect, why the hedonic index is applied in a financial return model. By adjusting for transaction cost, the financial return of an average investment in paintings is calculated.

The scope of this project is to make a comparison of costs associated with wind and nuclear power in order to decide which one of these is the most suitable in the case of an increased demand for electricity. It is also investigated if there are other factors that can influence the choice of energy source.An average cost is calculated in terms of kronor per kilowatt-hour (SEK/kWh) using cost of investment, operation & maintenance and taxes & subsidies. Total investment cost is recalculated to production cost using the annuity method at three different interest rates (6%, 9% and 12%).The comparison is made between three cases of wind power and two cases of nuclear power. For wind power there are two ocean-based (300MW and 100MW installed capacity, respectively) and one land-based (60MW) wind farm. For nuclear power there is one EPR-reactor (1600MW) and one AP1000-reactor (1100MW).

This master thesis is an in-depth study of an existing heating system at a household cooperative in Uppsala that has been converted from district heating to a bedrock heat pump system. The study focuses on an economical system optimisation of the building?s complete heating system. The aim was to determine how well a heat pump system in large buildings actually work, find out possible ways to optimize the existing system and point out important system parameters for new heat pump installations in larger buildings.The project points out a possible energy cost reduction of 45 % without investment and further cost reductions with equipment investments. A reduction by 30 % is possible by improvements in the regulation system and 15 % is possible by maintaining the brine system.

It is found that the properties of the record years of 1965-1975 is leaking a lot of energy andthese properties are facing a major energy efficiency. From the energy aspect, the facade isafflicted with poor thermal insulation which is a big problem. To address this problem addinginsulation is a good alternative to reduce overall energy consumption of a building. Thewindows on these buildings are also a problem from the energy point of view. Therefore,there are many reasons considered for energy upgrading.

With the elevated oil prices of today it is necessary to look for other heating alternatives. If the oil price continues to develop in the same way it has done the last years it will soon be impossible for many producing garden companies to survive. The purpose of this diploma work is to compare three different fuel options in order to find the most economic one considering the conditions of Katrinebergs Handelsträdgård AB. In relation to oil it is profitable to change to any of the three alternatives: wood chips, wood pellets and grain. The most profitable option is to change to wood chips. This alternative has a payoff time less than three years and after that the annual saving compared to the oil is relatively high. The annual cost is 65 % of the cost of the oil alternative.

Business Intelligence (BI) is a competitive concept for enterprises to consider. The concept is based on the idea of using business data in order to effectively analyze activities within an enterprise in order to enhance decision processes in the organization.The purpose with this study is to help Akademibokhandeln AB to analyze what BI-requirements they may have, and to create a recommendation on what sort of BI-tool that would fit the enterprise's needs.The requirements analysis was conducted with the help of internal personnel. Four different tools on the BI-market have been examined, analyzed and compared: IBM Cognos 8 (IBM Cognos), Microstrategy 9 (MCST), Qlikview 9 (Qlikview), and SAP Business Objects BI (SAP BO). These tools have been compared with the help of two models (BRI and BCI) that is based on the BI-requirements analysis, with the cost aspect taken into consideration in the BCI-model.Using the BRI-model, the comparison results in a technical evaluation. Here, IBM Cognos gets the highest result just ahead of MCST and SAP BO.

Purpose: The aim with the report is to investigate if the South East Asian customer on the food processing market base their investments on Total Cost of Ownership and if so, which are the cost drivers considered most vital. Moreover, do these cost-drivers diverge from the perception FP Ltd has, and if so, can a Total Cost of Ownership-model help to achieve a mutual understanding? Methodology: First a descriptive approach will be taken, identifying FP Ltd?s employers? perception on how to meet the customer. This will later be compared to our empirical findings of the actual customer behaviour in Thailand and Vietnam. Thorough analyse of the gap between the two parts will give us the outcome whether or not FP Ltd will have any use of presenting a quantitative model justifying their higher price.

As a result of increased energy prices more and more energy-efficient homes are coveted. An energy-efficient alternative is passive houses, which is characterized by an extremely well insulated building envelope that recovers the heat without the use of radiators or under floor heating. But a passive house requires a higher investment cost than a conventional building project, since it will require more construction materials, training of construction workers, greater land area, and long construction period. But the lower operating cost expects to pay back the higher cost of investment. We therefore question how profitable a passive house is in relation to houses built according to modern conventional building techniques.The aim of our study is to investigate the viability of passive houses compared to convent­ional houses.

Tången 2 is a building situated in Stockholm, Sweden. It´s built in the 1930s and contains both residences and businesses. The property owner, Diligentia AB, wants to lower the energy use in Tången 2. This report consists of an energy audit which clarifies the specific circumstances linked to Tången 2. Collected knowledge is then used, together with the results from the literature study, to decide energy measures to proceed with.