My Finnish grandfather had a passion for architecture, eventhough he wasn?t an architect. In the end of the 1950s he builta wooden summerhouse on a lot outside of a small villagecalled Lempäälä, close to the city of Tampere. Today the lotbelongs to my mother. Every time I visit our summerhouse, itmakes me want to do as my grandfather did ? to build a smallhouse next to it.My project is a proposal for a wooden house on mymothers lot.

The energy consumption in the sectors of residential and public buildings is 40 % of the total energy consumption in Sweden. The main part, 85 %, of the energy use in these sectors is for operation of the buildings. The rest is used in the building process. When energy-efficiency measures are taken the energy use during the operation time decreases and the fraction of energy consumption during the building time increases. This project is carried out in cooperation with JM AB and concerns the energy use during the building time of production of blocks of flats at the building site.The main part of the electricity that is used during the production of apartment buildings goes into the heating of portacabins and illumination of the building during the construction phase.

This final project discusses renewal and upgrading of the area of Prim. It is discussed how this industrial area can be an attractive neighborhood with a varied range of services and commercial trade. Prim is located 2km north-east of the center of Barcelona. The area boarders to a deep railway valley that historically has separated Prim from its neighboring districts. At present there is almost no housing, services or commercial trade within the area and the industry is discontinued or the existing industrial buildings are derelict. There is also a lack of green recreational areas.

Stenebergs sockerbruk is a large log-timber construction, purpose built as a sugar refinery in 1739 and is one of Sweden's oldest Industrial buildings constructed entirely out of wood. Despite receiving the status of a listed building (in Swedish: Byggnadsminne) in 1977, there exists today a surprisingly low amount of documentation of the building itself. In order to enhance the existing and lacking building documentation, this case study aims to shed light on the building's log-timber built frame, focusing on how it was constructed, how the long lengths of its walls were handled and what type of joinery and tools were used. A thorough investigation of the building is conducted on site, followed by gathering of information which is then presented through text and illustrations. The findings indicate the orientation of timbers, location of joints and scarfs as well as tool marks which together contribute to the forming of a basis of understanding of the building's construction..

The purpose with this thesis is to investigate how the logistic and the configuration of the terminal buildings and the perceptions of the passengers at Stockholm Arlanda Airport are related to each other, and what effect it has on the passengers and their traveling within the airport.The focus will be on the logistic at all four terminal buildings that is within the Airport. To create a perception of the logistic at the Airport and how it is related to the passengers perceptions, the investigators need to make knowledge of the terminal buildings, and thereby try to link the logistic with the perception of the experience room.Swedavia is the company that own, operate at and manage Stockholm Arlanda Airport. The investigators will make an interview with employees at Swedavia to get a more profound understanding of how the company is thinking about the logistic issues that they need to overlook. There will also be interviews with travelers to get their perception of the logistic, design and atmosphere at the Airport.Observations will also be made at various times at the Airport with focus on all of the terminal buildings. The investigators use qualitative and quantitative methods to reach a result. To achieve a result, the investigators will use theories and scientific facts and other available facts that will be helpful to reach a result that will be analyzed..

Rooted in Industrial Ecology (IE) theory, this report evaluates how urban agricultural concepts and techniques, can contribute to improved ecological sustainability within the inner city boundaries of Stockholm. An overarching literary study as well as an interview was carried out, resulting in a qualitative analysis followed by suggestions for practical implementations. A substantial convergence was found between the eco-restructuring objectives of IE and the principal motives for urban agriculture. Consequently, eco-restructuring objectives are found in varying degrees in the presented urban agricultural techniques. Industrial symbioses, permaculture and combinations of urban agricultural techniques are tools which are capable of corresponding adequately to the diversity of urban settings.

I chose to do this work because I believe that today?s industrial designprofessionals lack in their task of creating aesthetic experiences and aestheticdiversity.With my work, I want to question why the majority of today?s technical, massproducedeveryday products have such a similar design expression, andwhy alternatives are so few. Most of all, I take a critical attitude to today?sstereotypical industrial design aesthetics that I would describe as technical,masculine, and unnecessarily complex.I have designed a number of products that show alternative aesthetics in thissegment and as such I have chosen the vacuum cleaner. The idea is that mydesign will serve as an eye opener and demonstrate that there are alternativesto today?s homogeneous market.The result is three vacuum cleaners claiming three alternatives to currentofferings.

This thesis approaches the problem of estimating the arm angles of an industrial robot with flexibilities in joints and links. Due to cost-cutting efforts in the industrial robots industry, weaker components and more cost-effective structures have been introduced which in turn has led to problems with flexibilities, nonlinearities and friction. In order to handle these challenging dynamic problems and achieve high accuracy this study introduces state observers to estimate the tool position.The observers use measurements of the motor angles and an accelerometer and the different evaluated observers are based on an Extended Kalman Filter and a deterministic variant. They have been evaluated in experiments on an industrial robot with two degrees of freedom. The experimental verification shows that the state estimates can be highly accurate for medium frequency motions, ranging from 3-30Hz.

In this masters thesis we consider a method for experimental identification of the inertial parameters of an industrial robot, using measured torques and joint angles. A dynamic model of the first three joints of the robot has been identified.To achieve good identification results, it is important to carefully choose the trajectory for the experimental identification. A method to generate trajectories using two suggested design criteria has been used and evaluated using an ABB industrial robot, and one of them yields good identification results..

Unauthorized changes in listed buildings and environments occur all around Sweden. The main purpose of this thesis is to examine how these forms of transgressions have been and are being handled in some Swedish county administrations. What do legislation within conservation of heritage expresses when transgressions occur? How do county administrations interpret and apply legislation to actual situations? What methods do county administrations make use of to prevent unauthorized changes?16 out of Sweden´s 21 county administrations have been studied and used as an empirical basis. This basis has led to a general conclusion of the county administrations experiences and working processes when handling unauthorized changes in listed buildings.

A uniform environmental rating system for green buildings is demanded in today's society, where the requirements of the energy consumption for real estate are increasing. There are several different systems around the world used to rate buildings, all with different assessment criteria and starting points, which make it difficult to compare environmental rated buildings with each other.The purpose of this paper is to acquire knowledge about the differences between the Swedish environmental rating system Miljöklassad Byggnad and the American LEED, to discover which system is most advantageous. We also examine whether environmental rating affect the value of a property.Miljöklassad Byggnad is relatively simple structured, which makes it possible for private individuals to rate their property. LEED is better structured on the other hand in the case of environmental classification of commercial properties, because there are manuals for among others hospitals, schools and retail. The rating system for Miljöklassad Byggnad is good since the system seeks to fix the number of errors and deficiencies as soon as possible.

This is an essay concerning the density of the city. An increasing amount of today?s cities have a shortage of space available for the erection of new buildings and settlements, especially in areas close to the city-centre. New buildings and settlements are therefore often found in the outskirts of the city, resulting in long distances between work and living for many people. These long distances are a waste of limited resources and are inconsistent with the vision of the sustainable city.The challenge for the future is to insert new buildings and settlements in the existing city-structure and in this way reduce the distances between different city-functions.The density of the city can be increased in two different ways; by inserting new buildings between existing ones or by extension existing buildings, for example by an additional floor.

Background: The standard of living should be the same for everyone, whether the apartment is placed in an old or new building. The residential properties that were built from 1965 until 1974 is now beginning to become old and in need of restoration. The financial crisis during the nineties contributed to the lack of maintenance on the buildings in Sweden. As the public buildings gets older more and more defects occurs. The coordination and maintenance will therefore have a more significant role in the housing company ?s work.The increasing interest about how old a building can be, attract much attention.

Sweden has formulated ambitious energy goals which signify that by year 2050 the energy usage should be halved. One of the objectives is the reduction of energy usage by 20% by year 2020 and that it should be compared to the usage of energy from 1995. In parallel with increased energy requirements for buildings the demand on housing conservation, by highlighting also buildings from the last 50 years as part of the building heritage, continues to enhance, which in theory means that there is a conflict between these.The law will never be able to point out unique buildings and PBL (planning and building act) is not especially concrete. The National Housing Board has tried to make this more concrete by the new BBR regulations though there are still an enormous variety of interpretations.This report deals with the conflict between conservation requirements and additional insulation of the building envelope and is limited to multi-residential buildings built between the years 1945 and 1975. It is the stock with the greatest energy consumption and that is where the big challenge lies.

The starting point for this master thesis was the product of the company "Humlegården", which allows its tenants in office buildings to follow their electricity consumption in real time, through their Smartphone's. The idea that resulted from that application is to investigate if it is possible to direct the tenants in office buildings to reduce their energy consumptions, but also to be satisfied with the indoor environment. This work addresses the factors which are the main energy consumers in office buildings. It addresses legal requirements and standards which are important to follow in order to achieve good thermal comfort in buildings. Some of them are physical climate factors like thermal environment, air quality and lightning.