On a request from the water sewage plant Gryaab in Gothenburg a power quality survey wasperformed. The voltages and currents have continuously been sampled in the incoming 10 kVsubstation HSP01 from April-August 2008. Power quality measurements were also performedin Gryaabs other 10 kV substation HSP04 fed from HSP01 and at the terminals of theinduction motor IN_PU4040 of 1.3 MW which controls one of the four large inflow pumps tothe plant. The reason for the latter measurement was due to registered negative transients eachtime the motor was connected to the grid. The cause of the transients could be explained by thecoupling in the substation, the ageing of the motor which could result in damage of thebearings or resonance in the motor circuit which amplifies high frequency harmonics.

Active headsets have been on the market for years and now it is time for something else to enter the stage. The technology of active noise reduction can for exmple also be used in ventilation systems for reducing ventilation noise. An active control system principally consists of four important components, namely the downstream error microphone, the upstream detection or reference microphone, the digital signal processor (DSP) and a loudspeaker. The upstream reference microphone listen to the primary ventilation noise and sends it to the DSP which makes a phase shift to the signal and sends it to the loudspeaker. The loudspeaker sends out the opposite waveform of the incoming one and reduce the primary ventilation noise.

On a request from the water sewage plant Gryaab in Gothenburg a power quality survey wasperformed. The voltages and currents have continuously been sampled in the incoming 10 kVsubstation HSP01 from April-August 2008. Power quality measurements were also performedin Gryaabs other 10 kV substation HSP04 fed from HSP01 and at the terminals of theinduction motor IN_PU4040 of 1.3 MW which controls one of the four large inflow pumps tothe plant. The reason for the latter measurement was due to registered negative transients eachtime the motor was connected to the grid. The cause of the transients could be explained by thecoupling in the substation, the ageing of the motor which could result in damage of thebearings or resonance in the motor circuit which amplifies high frequency harmonics.

On a request from the water sewage plant Gryaab in Gothenburg a power quality survey was performed. The voltages and currents have continuously been sampled in the incoming 10 kV substation HSP01 from April-August 2008. Power quality measurements were also performed in Gryaabs other 10 kV substation HSP04 fed from HSP01 and at the terminals of the induction motor IN_PU4040 of 1.3 MW which controls one of the four large inflow pumps to the plant. The reason for the latter measurement was due to registered negative transients each time the motor was connected to the grid. The cause of the transients could be explained by the coupling in the substation, the ageing of the motor which could result in damage of the bearings or resonance in the motor circuit which amplifies high frequency harmonics.

As a consequence of increasing wind power installations in the Nordic grid the last years, the need for regulating power has become larger. In the Nordic grid, regulating power is mainly provided by hydro power. One part of the regulating power is called frequency control, which ensures that the grid frequency is stable and close to 50 Hz.However, setting the turbine into frequency controlled operation may cause stress and wear of the components in the mechanical control system. Frequency controlling implies large and frequent servo forces and longer travelling distance of the sliding bearings in the Kaplan turbine.Based on one selected Kaplan turbine, Selsfors G1, measurements and MATLAB calculations have been performed in order to determine forces and movements of the linkage system. With these forces and movements as input, stresses and fatigue have been determined as well as sliding distances, bearing pressures and wear of bearings during a typical lifetime of 40 years.The results indicate that no severe wear exists on the bearings during 40 years of service.

The objectives of this research were to determine whether the natural rattan resources in Sulawesi, Indonesia can cope with the strongly increased harvesting pressure that has occurred over the last centuries. I was furthermore looking for patterns in the rattan population dynamics that might give a hint on how the harvesting system could be improved to ensure a maximum sustainable yield. To answer these questions, I developed an individual-based model to analyse the dynamics of rattan growth in connection with rattan harvests by locals to identify sustainable levels of rattan harvests around villages in Sulawesi, Indonesia. Scenarios with different harvesting intensities were run to compare the change in harvest amount. For a given harvesting pressure, scenarios with a high number of harvesters and a low harvesting frequency had the same effect as scenarios with high harvesting frequencies and a low number of harvesters.

The aim of this work was to study if the edge of the forest is more resistant to heavy winds than the trees located further in from the edge, and how this edge effect changes between different types of tree species and site types. The data was collected from an electric power line going from the north to the south of Sweden. The mean value of the clearcutted area around the power line was 120 meters. The main direction of the storm in January 2005 was west-southwest and thus the power line was a perfect place for gathering a large data set. The main parameter studied was the damage frequency at the edge of the forest compared to the trees located further in from the edge (up to 100 m from the power line). Tree species mixture, soil moisture class, soil type, topography, stand height, stand height of the stand on the other side of the power line and wind exposition was estimated. The results showed a distinct edge effect. The edge of the forest had clearly lower damage frequency for all tree species. A marked difference was observed between tree species and damage frequency.

Active headsets have been on the market for years and now it is time for something else to enter the stage. The technology of active noise reduction can for exmple also be used in ventilation systems for reducing ventilation noise. An active control system principally consists of four important components, namely the downstream error microphone, the upstream detection or reference microphone, the digital signal processor (DSP) and a loudspeaker. The upstream reference microphone listen to the primary ventilation noise and sends it to the DSP which makes a phase shift to the signal and sends it to the loudspeaker. The loudspeaker sends out the opposite waveform of the incoming one and reduce the primary ventilation noise.

The aim of this study was to, using previously collected data from self-declared antisocial behaviour questionnaires, examine if the crime frequency has been different between adolescents that have either been referred to two different forms of open care in social service, child and youth psychiatric inpatient care or have been sent to Homes for Specialised Supervision. The criminality frequency and the most common crimes committed were compared between the study groups and further between genders in each particular study group. Statistical significance testing was used and the results of the survey revealed that juvenile delinquents that had committed severe criminal acts were represented in all four groups. The study group with adolescents in national care was the most different from other groups. These youths seemed to have had a lower crime frequency than the other groups with the exception assault and robbery.

This paper describes a method for wireless energy transfer via near-field electromagnetic inductionthat is inexpensive, simple and can be applied to almost any type of system, regardless of size andenergy demands.The method uses a primary unit consisting of an oscillator, amplifier and inductive coil thattransfers energy to a secondary unit consisting of a coil, rectifier and voltage regulator. Two typesof oscillators and several amplifier designs were realized and evaluated together with a multitudeof flat coils of both monofilar and bifilar type.The results show that it is important to use an oscillator whose frequency is dependent on theinductance of the connected transmission coil, such as the Colpitts oscillator. This is preferable toan oscillator with a preset frequency, such as a Schmitt-trigger oscillator..

Superficial digital flexor tendon injuries are common causes of premature retirement or pre-longed convalescence periods for race horses. The curve gradient at Täby Galopp race track is very small and most races as well as high speed training are done on the left rein. It is believed that the horses left foreleg is under considerably more strain then the right foreleg when being ridden on the left rein during gallop at high speed. During gallop on the left rein the horse puts its entire weight on the left foreleg when regaining ground contact. The purpose of this study has been to find out, through analyzing the statistics concerning the horses that visited the ATG clinic at Täby during a period between January 2003 and September 2006, whether there is a higher frequency of superficial digital flexor tendon injuries on the left leg rather than the right and if so, can this support the theory that the design of the race track in combination with continuous left rein races can be a contributing cause of these injuries. The result of the study shows that 57% of the tendon injuries occurred on the left front leg and 38% on the right front leg. The difference is not large enough to support the above theory of the underlying cause of these injuries..

Tail-biting in pigs is an animal welfare issue and in Sweden during 2002 the producers lost tree million Swedish crowns because of tail biting. This economic loss depends on the pigs which are discarded at slaughter because of tail biting. Tail biting can be separated into two stages, "pre-injury" and "injury". The aim of this study is to investigate if tail biting depends on environment or genetic background.A lot of research on the environments effects on the behaviour of pigs but not so much on the genetic effects has been performed. The frequency of tail biting in pig farms influence among others of environment enrichment, ventilation, gender and breed of the pig.

Cheetahs in the wild are declining due to hunting, lack of prey, exploitation of habitats and loss of cubs to predators. Those are the main reasons to why cheetahs are kept in captivity today for conservation. Many cheetahs kept in captivity are seen pacing ? a behaviour that arise when the animal is prohibited from performing natural behaviours. It is believed to being attributed to a lack of stimulation in the environment where they are being held.

Tail-biting in pigs is an animal welfare issue and in Sweden during 2002 the producers lost tree million Swedish crowns because of tail biting. This economic loss depends on the pigs which are discarded at slaughter because of tail biting. Tail biting can be separated into two stages, "pre-injury" and "injury". The aim of this study is to investigate if tail biting depends on environment or genetic background.A lot of research on the environments effects on the behaviour of pigs but not so much on the genetic effects has been performed. The frequency of tail biting in pig farms influence among others of environment enrichment, ventilation, gender and breed of the pig.

Tail-biting in pigs is an animal welfare issue and in Sweden during 2002 the producers lost tree million Swedish crowns because of tail biting. This economic loss depends on the pigs which are discarded at slaughter because of tail biting. Tail biting can be separated into two stages, "pre-injury" and "injury". The aim of this study is to investigate if tail biting depends on environment or genetic background.A lot of research on the environments effects on the behaviour of pigs but not so much on the genetic effects has been performed. The frequency of tail biting in pig farms influence among others of environment enrichment, ventilation, gender and breed of the pig.