In this study the hygienic quality of minced moose meat was examined with regard to the prevalence of different bacteria. The methods used are described in NMKL, "Nordic Method Committee for Food". The results show that the levels of Escherichia coli and coagulase positive staphylococci in the meat are too high. The reason for this might be environmental factors, such as high temperature and humidity during the time when the carcasses are hanging and when the meat is cut up..

Female growth, number of eggs and egg growth of Daphnia pulex were studied at four temperatures, 12, 16, 18 and 20°C. I hypothesized that female growth and number of eggs would be lower and the size of the eggs larger in the presence of a predator (kairomones) than in its absence. This effect was expected to be more evident at lower temperatures. I could not find any effect of kairomones on female growth, number of eggs or egg size, although there was a weak tendency for an effect on number of eggs. There was, however, an effect of temperature, regardless of predator treatment (i.

The master thesis, conducted at Metrima AB, concerns the development of a non-intrusivedistribution meter as a basis for individual tap water billing in apartments.The project is conducted in response to the market interest in individual tap water billing inapartments as an answer to environmental concerns regarding water consumption. Due to thehigh installation cost of traditional water meters, a new method of determining waterconsumption, without having to cut water pipes, is proposed.The proposed method distributes the total water consumption for an apartment complex toindividual apartments according to distribution meters, measuring water run-time, in eachapartment. The water run-time is estimated by measuring the water pipe?s outward vibrationsand temperature changes.A test environment was established and a prototype built, using a tilt- and vibration sensor forvibration sensing and a precision temperature sensor to measure temperature changes. As bothsensors work well in the test environment, further testing was done in 3 apartments for aduration of 5 days.

In the spring of 2014 Sweco Systems AB were commissioned to design a ventilation system for a newly built preschool in Linköping. Terms from the client was that it cost efficiency would cope with the energy demands that are placed on the building. The unit chosen was a cross-flow heat exchanger, and this work is to compare it with two other heat exchangers to see if a more energy and cost efficient could have been chosen. The heat exchangers that was chosen for the comparison was a rotating- and a counterflow heat exchanger. Simulations have been made to the different heat exchangers by the manufacturers.

This report describes the building of a computer model that makes it possible to simulate the thermal climate in a greenhouse. The computer model is built on the physical theory of heat exchange that occur in a greenhouse, such as radiation and convective heat exchange. The model also includes the heat storage that is active in a greenhouse.The computer model is used to simulate the thermal climate in a greenhouse under three periods, winter, spring and summer. It also investigates which effect a concrete wall has on the thermal climate in a greenhouse. The purpose of putting a concrete wall in the greenhouse model is to investigate the possibility to store heat during the day and then use this heat when the temperature drops during the night.The result from the simulations shows that a concrete wall levels the big difference in temperature that normally occurs under a day in a greenhouse.

This thesis is the result of the author?s interest in music and electronics, namely the design and manufacturing of a stereo sound system with an active crossover. In short it can be stated that an active crossover has many advantages over its traditional passive counterpart. The active design naturally results in a more complex system comprised of a multiple number of components. This report deals with the theoretical aspects of preamplifiers, crossovers and power amplifiers as well as power supply and control.

If a building is heated by a heat pump, it is of high importance that the heat pump has a high coefficient of performance. An exhaust air heat pump extracts heat from the building?s exhaust air. The air has a relatively high and constant temperature all year around, leading to a high seasonal coefficient of performance. This thesis examines whether it is profitable to complement an exhaust ventilation system with an exhaust air heat pump in an apartment block that already has geothermal heat pump, district heating, oil- or biofuel heated system.

This report is made as a literature review, focusing on the work done to increase understanding of efficiency in the categories of substations and secondary heating systems, with respect to the deviation from the theoretically possible cooling off in the distribution network as well as the economic benefit that appear. The main purpose of a considerable part of the literature used in this report addresses the issue of identifying individual causes of reduced cooling in district heating systems. These literature resources have been compiled and summarized as part of the report.The technology of district heating is associated with benefits such as better use of the energy in a fuel. This is the case of cogeneration plants where serial generation of electricity and thermal energy increases efficiency compared with the parallel generation where heat is generated locally and electricity is generated centrally. Serial generation thus allows for lower primary energy demand.

The purpose of this thesis work was to develop an automatic fault detection system for surveillance of bearing temperature in hydropower turbines. The parameters used except the bearing temperature were cooling water temperature and cooling water flow. A simple static model based on data sampled every minute was developed to estimate the bearing temperature. Then a detector for detection of change in bearing temperature based on the CUSUM-algorithm was designed. Since the amount of data was very small the developed model was too uncertain to be used in a working system.The designed fault detection system showed to work well for the available data.

The reasons for hypothermia during general anaesthesia are many and varied. The lowered body temperature causes negative physiological effects and leads to discomfort for the animal during the recovery period. This student report is a combination of field study and literature review. In the field study the changes in ambient temperature and the rectal temperature of dogs were monitored during general anaesthesia. The purpose of the study was to see if the body temperature of dogs was reduced during general anaesthesia.

In the spring of 2014 Sweco Systems AB were commissioned to design a ventilation system for a newly built preschool in Linköping. Terms from the client was that it cost efficiency would cope with the energy demands that are placed on the building. The unit chosen was a cross-flow heat exchanger, and this work is to compare it with two other heat exchangers to see if a more energy and cost efficient could have been chosen. The heat exchangers that was chosen for the comparison was a rotating- and a counterflow heat exchanger. Simulations have been made to the different heat exchangers by the manufacturers.

Aeroseum is an aviation museum located in an old military underground hangar. The ventilation system in the hangar is designed for the military purpose of the hangar. This design includes a solution with air flowing through the space between the construction of the hangar and the rock surface. The solution is intended to avoid a buildup of inflammable gases. This design leads too high humidity levels in the hangar.

This report describes the construction of a climate-cabinet for testing of HV-cards (High Voltage) produced at VG Scienta. The main part of the report describes all the different components of the cabinet. The most important parts are a PID regulator from Eurotherm model 2408, a solid state contactor (SSC), a thermocouple, a finned resistor from DBK and different fans. The report even includes the connection between components by cable wiring, isolation, grounding, fuses and shaping of metal goods.As the cabinet also communicates with a computer, the report includes the solution of the data communication using the software iTools from Eurotherm. The communication part includes information about a converter that converts EIA422 to USB.The cabinet was produced at a company, called VG Scienta, in Uppsala during the spring 2010.

The market for heavy duty engines is constantly requiring engines that should be more andmore powerful, while still maintaining low fuel consumption. As a result of increasing enginepower, the engine and coolant temperature increases as well due to insufficient coolingperformance (because of design issues, cost etc.).Also, emission legislations, both current and future, require more and more measures to betaken by engine manufacturers. One way of meeting the legislations is the use of cooled EGR(Exhaust Gas Recirculation), which also lead to increased coolant temperatures.Both these factors also naturally lead to increased engine oil temperatures, the consequencesof which are not thoroughly investigated.This thesis project aims to investigate effects of high temperatures on engine oil degradation,with focus on the greatest degradation process: oxidation. To do this several engine runs havebeen performed on a 310 hp engine with EGR to see what happens to the engine oil in a realengine when exposed to high temperatures. During the tests oil samples have been taken andanalysed for important parameters.As a complement to these engine tests some laboratory oxidation testing have also beenperformed, to be able to compare engine test data with laboratory tests.One goal of the project was to try to formulate an empirical oxidation model, which would beable to predict oil oxidation levels in an engine, given any running parameters.

Gerbera jamesonii is a plant with a large amount of pollen and various flower colours and a favourite host plant for Frankliniella occidentalis. The best growing temperature for gerbera is approximately 20°C. Frankliniella occidentalis or the Western Flower Thrips is a small insect that has become an important pest in greenhouse cultivation all over the world. The high temperatures in the greenhouse are favourable for F. occidentalis.