Water is our most important provision and its quality is above all dependent on the geological conditions in the area from where it is extracted. Due to geological properties there are certain areas with an elevated risk of high uranium levels in the ground water, which in turn constitutes a risk for human health. Consumption of water that contains a high concentration of uranium implies a health risk due to the chemical characteristics of uranium. Livsmedelsverket (The National Food Administration) and Socialstyrelsen (The National Board of Health and Welfare) therefore recommend that precautionary measures should be taken when the uranium concentration in ground water exceeds 15 micrograms per litre. In particular, drinking water collected from wells in areas with uranium-rich bedrock may have a harmfully high level of uranium. One of the wells of the Ärla water purification plant, located near Eskilstuna, Sweden, contains water that exceeds the guideline of 15 micrograms per litre. One interesting technique for removing uranium from drinking water is adsorption to reactive filter materials.

The student project Elba at KTH started in 2011 and is a project where a battery driven prototype car is developed. The vehicle competes in Eco Shell Marathon in Rotterdam, Holland. In this competition the vehicle that travels a certain distance including several starts and stops with the lowest energy consumption wins. To minimize the consumption is therefore very important, which requires knowledge of the vehicles energy losses.A vehicle's energy losses depends on several factors and can be divided into the powertrain efficiency and the driving resistance. The driving resistance can then be divided in to rolling and air resistance, if smaller losses like vibrations are ignored.

Different field tests are currently used in a wide extent in different levels of soccer teams. To be able to assess the players? physiological status the tests must have high validity, reliability and external validity. Many different tests have been developt, but currently only five of these tests are most commonly used: Yo-Yo intermittent recovery test (YIRT), Yo-Yo intermittent endurance test (YIET), Multi-sprint-test, Beep-test and Cooper-test. Presently there is no definitive conclusion regarding which of these tests is most suitable for soccer players.

A one-cylinder research engine has been used for studies with a Diesel Dual Fuel concept (DDF). DDF is a concept that utilizes a pilot diesel injection to ignite a homogenous natural gas/air mixture. Emissions and engine efficiency have been analyzed in an emission cycle called European Stationary Cycle (ESC) and the knock/pre-ignition problems with this type of engine have been investigated.At low and mid torque levels, an early diesel injection around 60 crank angles degrees (CAD) before top dead center (TDC) was used. At these loads raw NOxemissions was below EURO 6 level (0.2 g/kWh). NOxwas at EURO 5 level over the complete ESC without after treatment and with SCR at high loads it should be possible to reach EURO 6.One issue with DDF is the high HC emission levels.

In this report a study is carried out with the aim to identify added values of EPC projects implemented in schools in order to increase the interest of EPC projects on the market. The report examines how the planned maintenance, supervision, maintenance and corrective maintenance is affected, how insurance premiums and terms are affected, the indoor environment and how the tasks of the operating staff is changing. A literature study of energy savings, energy use in schools, maintenance and insurance as well as how energy efficiency improvements are related to the Swedish environmental objectives has been made. Visits were carried out in Ludvika, interviews were also carried out with operation technicians and local strategists in Ludvika as well as employees of insurance companies.Schools often have neglected maintenance and problems with ventilation and indoor environment. Schools also have a large energy saving potential due to their low utilization, mainly because they are empty parts of the year.

The use of Power Line Communication, PLC, as a communication solution for Automated Meter Reading, AMR, is popular by utilities in Sweden and other parts of the world due to demands of accurate and fast meter reading. However the use of the electrical grid as a communication medium is complex and sometimes problematic. This report handles some of the issues and problems that are important to understand when using the grid as a communications medium. Focus is mainly on investigating high frequency distortion in the Kristianstad power grid own by C4energi caused by a frequency converter. Measurements on site are done to investigate signal damping in the grid, different configurations for the frequency converter and signal strength of the PLC-system.

The use of Power Line Communication, PLC, as a communication solution for Automated Meter Reading, AMR, is popular by utilities in Sweden and other parts of the world due to demands of accurate and fast meter reading. However the use of the electrical grid as a communication medium is complex and sometimes problematic. This report handles some of the issues and problems that are important to understand when using the grid as a communications medium. Focus is mainly on investigating high frequency distortion in the Kristianstad power grid own by C4energi caused by a frequency converter. Measurements on site are done to investigate signal damping in the grid, different configurations for the frequency converter and signal strength of the PLC-system.

The use of Power Line Communication, PLC, as a communication solution for Automated Meter Reading, AMR, is popular by utilities in Sweden and other parts of the world due to demands of accurate and fast meter reading. However the use of the electrical grid as a communication medium is complex and sometimes problematic. This report handles some of the issues and problems that are important to understand when using the grid as a communications medium. Focus is mainly on investigating high frequency distortion in the Kristianstad power grid own by C4energi caused by a frequency converter. Measurements on site are done to investigate signal damping in the grid, different configurations for the frequency converter and signal strength of the PLC-system.

The goal with the project was to make the graphic for Djungeltrumman.se´s upcomingwebb-TV. Djungeltrumman.se is a clubguide on the internet and as a magazine.Their target group is people in the age between 18-34 with an interest for culture and nightlife that lives in a city where Djungeltrumman.se is active. The purpose of the project was to make a graphical frame that had the feelling ofDjungeltrumman.se. The feeling should capture the interest of the target group and make them care more for Djungeltrumman.se.The graphics will contain an intro, information frames and presentations for the different parts in the program. In this project I focused on making the intro for the program.

Latent heat storage is a way to store thermal energy when a phase change material undergoes a phase change. The advantage of latent heat storage is the capability to store more energy per mass unit than other heat storage methods. The most commonly used phase change in latent heat storage is the transition between solid and liquid. Phase change materials can be divided into organics, inorganics and eutectics.In the Nordic electricity market the price of electricity is set every hour by Nordpool spot, which leads to price fluctuations because of changes in demand. The main goal of this report is to create a latent heat storage system in a single-family home and investigate the possibility to save money by charging the latent heat storage system when the price of electricity is low, and discharge when the price is high.The thermodynamic model consisted of a ?tube-in-tube? heat exchanger with phase change material in the outer tube and water as the heat transfer fluid in the inner tube.

This thesis investigate how energy efficient measures has spread throughout the data centers in Sweden. These questions are put up against a theoretical use of such concepts such as green IT, technological evolution, large technical systems and knowledge dissemination. These theories are used to answer the questions that are encountered during the study, such as how green IT is approached, how big of a role environmental thinking has had in the evolvement of these new technologies. The study has been conducted in a longitudinal manner, it is an observation of the phenomenon that is data centers over a longer period of time. 23 non structured interviews spanning over 27.5 hours of recorded material have been conducted alongside a study of archived material.

My bachelor?s dissertation concerns the creation of a proposal for interior decoration of the Boland High School?s canteen. I have been in contact with personnel, students and the school principal through the duration of the project. In the end, substantive changes of lighting, interior decoration and movement were proposed for the canteen. In the proposal I have focused on accentuating the school?s profile, on creating smaller spatial configurations within the larger configuration of the room, lowering the noise level, creating a good movement flow, increase the number of seats and creating a pleasant environment in which to eat..

The town of Karlstad has a long term project called Vision 100 000 which aim is to increase the population towards 100 000 inhabitants. This will of course put a strain for the town?s energy distribution grid. This is a work about trying to predict the grids power usage would be for the next five years if the city building plan is finalized. Those predictions are mainly going to be done through calculations with a database program called Facilplus and by checking the measured history of power usage per hour on certain selected customers by the program CustCom.

This thesis is about university spin-offs and the competition in high technology industries. In the light of efforts to increase the competitiveness of the European Union, an effective transfer of cutting edge technology from universities to the industry plays an important role. University spin-offs, start-ups founded to exploit academic inventions, are likely to face considerable market entry barriers. This is among other reasons due to high capital requirements for further technology development and lack of complementary resources. With a combination of relevant literature and empirical investigation, commercialisation of technologies within spin-offs is investigated and analysed.

The overall purpose of this essay is to come to a deeper understanding about videos in the Youtube beauty community by using a mixture of qualitative and quantitative methods. By answering the main questions of the essay which are; What quantitatively measurable components are there in the videos that can be seen as contributing factors leading to the fact that some generate more views that others?; Is there a set mold for success containing certain aspects that a video must have to stand out?; What correlations can be found between the two categories of analysis and how do these potential correlations affect the popularity of the video? and What effects do specific components on the level of popularity of the video?, we?ve been able to distinguish differences as well as similarities on both qualitative and quantitative levels. We have also seen that using the two methods together have enabled us to reach more profound results. The main result that we have found on a quantitative level is that there are obvious correlations between a high level of popularity and a good visual quality.