On a request from the water sewage plant Gryaab in Gothenburg a power quality survey was performed. The voltages and currents have continuously been sampled in the incoming 10 kV substation HSP01 from April-August 2008. Power quality measurements were also performed in Gryaabs other 10 kV substation HSP04 fed from HSP01 and at the terminals of the induction motor IN_PU4040 of 1.3 MW which controls one of the four large inflow pumps to the plant. The reason for the latter measurement was due to registered negative transients each time the motor was connected to the grid. The cause of the transients could be explained by the coupling in the substation, the ageing of the motor which could result in damage of the bearings or resonance in the motor circuit which amplifies high frequency harmonics.

On a request from the water sewage plant Gryaab in Gothenburg a power quality survey was performed. The voltages and currents have continuously been sampled in the incoming 10 kV substation HSP01 from April-August 2008. Power quality measurements were also performed in Gryaabs other 10 kV substation HSP04 fed from HSP01 and at the terminals of the induction motor IN_PU4040 of 1.3 MW which controls one of the four large inflow pumps to the plant. The reason for the latter measurement was due to registered negative transients each time the motor was connected to the grid. The cause of the transients could be explained by the coupling in the substation, the ageing of the motor which could result in damage of the bearings or resonance in the motor circuit which amplifies high frequency harmonics.

The swedish national board of housing, Building and Planning,recommends that all stakeholders in the construction industryperform a moisture control design to make sure that the buildingachieves good moisture resistance. Since June 1, 2006 there are nospecific requirements or quantitative values for air leakage.Although the swedish national board of housing does presentrequirement that the building envelope must be sealed so that theclient?s requirements for specific energy consumption and installedelectric power for heating purposes are met. Despite this, studiesfrom SP shows that few buildings meet the client?s requirements inspecific energy, which increases the risk of occurrence ofcondensation-related moisture damage.This study aims to evaluate curtain walls connections from airsecurity and moisture safety.

Compressed air is a low efficiency media, and is thus very expensive to produce. This thesis work began by mind mapping how to create savings on the compressed air system at Billerud Skärblacka AB. Certain issues have been chosen for further studies.In order to identify the consumption of compressed air at PM 8 and 9, several measurements were made. At PM 8 there were not found any pressure drop, only large pressure variations for short periods of time. The causes of these pressure variations were not established.

With increased need for flexibility in timber deliveries, forest roads become an important factor. The disintegration of roads during the spring season can be avoided if it is possible to rule cutting areas to stands with good carrying capacity along roads with good carrying capacity. The goal with this work was to create a method to find the stands with high carrying capacity located near roads with high carrying capacity, and select them into a collection file. The method was based on Esri ArcGIS 9 and the tables that follow within that program. The method resulted in four different themes: 1. Collections with GYL 100 that cross the bufferzon for 0, 1, 2 and 3 class roads. Result 36 collections. 2. Collections with GYL 100 and 200 that cross the bufferzon for 0, 1, 2 and 3 class roads.

On a request from the water sewage plant Gryaab in Gothenburg a power quality survey was performed. The voltages and currents have continuously been sampled in the incoming 10 kV substation HSP01 from April-August 2008. Power quality measurements were also performed in Gryaabs other 10 kV substation HSP04 fed from HSP01 and at the terminals of the induction motor IN_PU4040 of 1.3 MW which controls one of the four large inflow pumps to the plant. The reason for the latter measurement was due to registered negative transients each time the motor was connected to the grid. The cause of the transients could be explained by the coupling in the substation, the ageing of the motor which could result in damage of the bearings or resonance in the motor circuit which amplifies high frequency harmonics.

On a request from the water sewage plant Gryaab in Gothenburg a power quality survey was performed. The voltages and currents have continuously been sampled in the incoming 10 kV substation HSP01 from April-August 2008. Power quality measurements were also performed in Gryaabs other 10 kV substation HSP04 fed from HSP01 and at the terminals of the induction motor IN_PU4040 of 1.3 MW which controls one of the four large inflow pumps to the plant. The reason for the latter measurement was due to registered negative transients each time the motor was connected to the grid. The cause of the transients could be explained by the coupling in the substation, the ageing of the motor which could result in damage of the bearings or resonance in the motor circuit which amplifies high frequency harmonics.

On a request from the water sewage plant Gryaab in Gothenburg a power quality survey was performed. The voltages and currents have continuously been sampled in the incoming 10 kV substation HSP01 from April-August 2008. Power quality measurements were also performed in Gryaabs other 10 kV substation HSP04 fed from HSP01 and at the terminals of the induction motor IN_PU4040 of 1.3 MW which controls one of the four large inflow pumps to the plant. The reason for the latter measurement was due to registered negative transients each time the motor was connected to the grid. The cause of the transients could be explained by the coupling in the substation, the ageing of the motor which could result in damage of the bearings or resonance in the motor circuit which amplifies high frequency harmonics.

Today, the management concept of lean has stretched far from its origins in the Japanese automobile industry. When reaching the Swedish restaurant industry, the conditions for a successful implementation of lean change as a result of the high employee turnover and the significant amount of part-time employees characteristic for the industry. Combined with a high-end service profile, these workforce characteristics seem inconsistent with some of the basic principles of lean. By conducting a case study, this thesis aims to investigate the effects of a variable workforce on the enablers for a successful implementation of lean in a high-end service industry. Using a theoretical framework consisting of enablers for an implementation of lean in services, the study finds that the variable workforce inhibits an implementation of lean by complicating the effects of traditional training, as well as the possibility of understanding the lean concept at all levels of the organization.

Syftet med denna studie är att undersöka elevernas uppfattningar om materians uppbyggnad och om materians och energins bevarande. Den föreliggande studien baseras på en kvantitativ analys i form av en elektronisk enkät, som föregicks av en kvalitativ analys i form av, strukturerade intervjuer och demonstrationer.Eleverna har kunskap om vardagsnära exempel, som till exempel vad en stekpanna är uppbyggd av. De ansåg att dessa är exempel på materia men när det gäller mer abstrakta begrepp som ljus, magnetfält, skugga, vakuum, värme och ljud uppvisar eleverna mer osäkerhet och brist på kunskaper. Hälften av eleverna svarade att luft är materia, vilket tyder på ?gasblindhet? hos de övriga.

This empirical work and base has been to analyze the new high school reform that the Swedish government introduced as a statement 2008/09:199 about: Higher demand and quality within the high school. This statement became legal through the government vote in spring 2010. But above all it is the investigation (SOU 2008:27) that is the central piece for these new examination changes for high school students that will come into effect 1 of July 2011. The purpose and questions asked in this analyze has been if the reform takes its base in a modernistic (traditional) way or a late modern scientific perspective. And also to find out how these new quality amendments in the investigation makes visible about the high school and what the purpose are about the changes. When scientific theories in these analyze is placed against the reform, the result shows that the modernization process reflects more of a late modern aspect, which constantly reappraise in a changeable society.

On a request from the water sewage plant Gryaab in Gothenburg a power quality survey was performed. The voltages and currents have continuously been sampled in the incoming 10 kV substation HSP01 from April-August 2008. Power quality measurements were also performed in Gryaabs other 10 kV substation HSP04 fed from HSP01 and at the terminals of the induction motor IN_PU4040 of 1.3 MW which controls one of the four large inflow pumps to the plant. The reason for the latter measurement was due to registered negative transients each time the motor was connected to the grid. The cause of the transients could be explained by the coupling in the substation, the ageing of the motor which could result in damage of the bearings or resonance in the motor circuit which amplifies high frequency harmonics.

On a request from the water sewage plant Gryaab in Gothenburg a power quality survey was performed. The voltages and currents have continuously been sampled in the incoming 10 kV substation HSP01 from April-August 2008. Power quality measurements were also performed in Gryaabs other 10 kV substation HSP04 fed from HSP01 and at the terminals of the induction motor IN_PU4040 of 1.3 MW which controls one of the four large inflow pumps to the plant. The reason for the latter measurement was due to registered negative transients each time the motor was connected to the grid. The cause of the transients could be explained by the coupling in the substation, the ageing of the motor which could result in damage of the bearings or resonance in the motor circuit which amplifies high frequency harmonics.

On a request from the water sewage plant Gryaab in Gothenburg a power quality survey was performed. The voltages and currents have continuously been sampled in the incoming 10 kV substation HSP01 from April-August 2008. Power quality measurements were also performed in Gryaabs other 10 kV substation HSP04 fed from HSP01 and at the terminals of the induction motor IN_PU4040 of 1.3 MW which controls one of the four large inflow pumps to the plant. The reason for the latter measurement was due to registered negative transients each time the motor was connected to the grid. The cause of the transients could be explained by the coupling in the substation, the ageing of the motor which could result in damage of the bearings or resonance in the motor circuit which amplifies high frequency harmonics.

On a request from the water sewage plant Gryaab in Gothenburg a power quality survey was performed. The voltages and currents have continuously been sampled in the incoming 10 kV substation HSP01 from April-August 2008. Power quality measurements were also performed in Gryaabs other 10 kV substation HSP04 fed from HSP01 and at the terminals of the induction motor IN_PU4040 of 1.3 MW which controls one of the four large inflow pumps to the plant. The reason for the latter measurement was due to registered negative transients each time the motor was connected to the grid. The cause of the transients could be explained by the coupling in the substation, the ageing of the motor which could result in damage of the bearings or resonance in the motor circuit which amplifies high frequency harmonics.