High-performance equine athletes have an energy requirement that often reaches twice the maintenance requirement. Horses are grazers and adapted to a grass diet, and diets high in grains and concentrates are associated with digestive upsets and behavioural disorders. It could therefore be of interest if the energy requirement of a high-performing horse could be met by forage. It is important that the forage have a high concentration of energy so that the horse is able to consume the whole amount of energy needed from the forage without exceeding the maximum voluntary intake. The purpose of this literature study was to investigate if the energy demand of a high-performance horse can be covered by forage produced under Northern Swedish climate conditions.

Tail-biting in pigs is an animal welfare issue and in Sweden during 2002 the producers lost tree million Swedish crowns because of tail biting. This economic loss depends on the pigs which are discarded at slaughter because of tail biting. Tail biting can be separated into two stages, "pre-injury" and "injury". The aim of this study is to investigate if tail biting depends on environment or genetic background.A lot of research on the environments effects on the behaviour of pigs but not so much on the genetic effects has been performed. The frequency of tail biting in pig farms influence among others of environment enrichment, ventilation, gender and breed of the pig.

Husums plant has a selection of different pulp pumps at bleaching plant 4 and 5. The displacement- (HC-pump, Sund Defibrator PTD-60) and centrifugalpumps (MC-pump, MCA 42-200, MCP 30/20) are of interest in this report. The centrifugal pumps are controlled by throttle valves, which result in an energy loss. Chemical mixers are used to mix ClO2 into the pulp before proceeding into a holding tower where the bleaching process occurs.The energy demand of the different positions has been measured or calculated to be used in comparisons against new equipment. Quotations were requested and delivered from Valmet and Sulzer.

A helicopter based system equipped with a millimetre-wave fire control radar is studied for improvement of the detection probability for moving ground targets. The system is a pulse doppler radar that sends out the electromagnetic wave in repetitive pulses. The frequency in which radar sends this pulse is called Pulse Repetition Frequency (PRF). The velocity of the moving targets is measured by spectral analysis of the pulses received. With this sort of system some targets will not be possible to detect.

The aim of this study was to describe preferences of geographic direction of ten, oak-living epiphytic lichen species and how they responded to sun exposure, nearby bushes and trees, bark fissure depth and circumference. The frequency of every species was recorded in arcs of ten degrees around the tree at a height of 130 to 180 cm above the ground. An estimation of the amount of every species in every arc was also recorded. To analyse how the distribution of the lichen species responded to the different factors their concentration for every tree was plotted against the four factors. The distribution of Cliostomum corrugatum had a positive response to high sun exposure and a negative response to a thick layer of bushes and trees.

The majority of all power cuts that affects individuals and communities are caused by earth faults on the power transmission lines at 10kV and 20kV level [1]. If these power cuts could be eliminated, less disturbances and interrupts would lead to large amounts of money savings.Swedish Neutral has developed such a protection system. When an earth fault occurs power is injected into the neutral point of the transformer. The RCC (Residual Current Compensation) protection calculates a compensation current exactly 180 degrees out of phase to the fault current. Doing this, the voltage at the fault location becomes very close to zero, without affecting the power transmission.The protection system can only compensate automatically for the fundamental frequency (50Hz), and manually for the 3rd, 5th, 7th and 9th harmonics.

In order to decrease the disturbance from a cable testing equipment, the company Ericsson Network Technologies in Falun determined to design a new series resonant test system with a lower frequency. The new equipment is of series resonant type with a system frequency of 500 Hz. This equipment consists of an inductor, a capacitor and a voltage source. The voltage source is the same as the old one, the cable acts as the capacitor but the inductor has to be designed especially for the new equipment. In this thesis work several air coil inductor types were examined.

An accounting issue that has received attention is the issue of identification of intangible assets in acquisitions. This is because the company's result can be different depending on how much the company chooses to identify intangible assets separated from goodwill. As the practice for identification of intangible assets lacks clarity, companies are able to account for this in different ways. In this study, the manner in which identification of intangible assets are managed by companies listed on Swedish multilateral trading facilities and the manner in which companies distribute the purchase sum on net tangible assets, intangible assets and goodwill in comparison with listed companies is examined. The study emanates from a systems approach and is descriptive.

Denna studie underso?ker hur inta?ktsdiversifiering i europeiska bankverksamheter pa?verkar aktiemarknadens va?rdering och variationen i aktiepriserna. Europeiska bankverksamheter har sedan mitten pa? 1980-talet expanderat mot tja?nster som genererar provisionsinta?kter eftersom den historiska uppfattningen har varit att inta?ktsdiversifiering kan minska variationen i vinsterna och potentiellt o?ka marknadsva?rderingen.Effekten av inta?ktsdiversifiering studeras utifra?n OLS-regressioner pa? paneldata som besta?r av 103 bankverksamheter fra?n 24 la?nder i Europa fo?r perioden 2005 till 2012. Aktiemarknadens va?rdering och variationen i aktiepriserna bera?knas utifra?n data o?ver aktiepriser och fra?n bankverksamheternas finansiella rapporter.

What if the emergency response directly knew exactly where to go and what to do if a road accident occured? During the last ten years the number of motorcyclists in Sweden has doubled. Every year, more than 300 riders are seriously injured and over 40 die in road accidents. Being found in time is critical to increase the chance of survival. The goal of this project is to use design methods to find a solution that enables a fast and adequate emergency response for motorcyclists and other unprotected road users..

The institution of Engineering Sciences at Uppsala University in cooperation with Umea? University is working on a project where they will examine the decision-making in extreme situations. A part of this project is to investigate leadership in high altitudes expeditions.This report will discusses the type of leadership used in high altitudes expeditions. Then, to examine how well you can use it in companies and organizations, and the ability to prevent company?s disasters with this kind of leadership.This is done by studying different company?s stories, where they gone bankrupt or fallen into a deep crisis.

This is a study concern high school student?s view of religion and their religiosity. I dispensed a questionnaire to 124 high school students studying comparative religion in a large high school in Sweden, with the students from different socio-economic backgrounds. The result I came up with is that traditional religion activities have decreased, religion has not disappeared but taken other shapes than before. And I also came up to with the result that more than half of them who answered the survey likes the subject and there are tendencies by them who doesn?t like the high school subject religion that they live in a non-religious family.The study concerns following aspects: sociology, youth, human needs, religion, spirituality and individualization..

To design new and high tech products the engineers rely more and more on computer based simulations to investigate the properties and behavior for a component or system.To verify these computer based simulations the dynamic properties for the components of the drivetrain needs to be verified. Therefore measurements of the stiffness and vibrations for the rear axle has been performed. This report show how the measurements has been implemented and evaluated, along with some interesting results for the rear axles properties.The static stiffness for the drive shaft along with the axle-gear has been determined. It is found that the stiffness for the whole rear axle is near the stiffness for the drive shaft, which means that the drive shaft becomes the dominant component of the system and affects the rear axle stiffness the most. The measured stiffness of the driveshaft is close to its theoretical stiffness.The stiffness for solely the hypoid-gear have been calculated using the stiffness for the rear axle and driveshaft, and thus has a range for the stiffness of the hypoid gear been determined.The backlash for the whole rear axle and for some individual components has been determined, where the backlash between pinion and crown-wheel has negligible impact on the total backlash.Measurements of the crown-wheel and pinion movements have been conducted, where the direction of movement is consistent with the theoretical direction of the forces.The vibration measurements show that the vibrations are more severe at certain rotational speeds.

This study was made for the Swedish forest company Sveaskog because the sawmills they delivered timber to had noticed a high frequency of bucking splits in their products. Coworker Jim Edström at Sveaskog also wanted to know if there was a big difference between different felling heads. The purpose with this study has been to find out the amount of bucking splits and if there is any felling head brand that did a bigger damage that the others. The study was made in two steps, where the first part was a literary review to find out results and conclusions in earlier studies. The best measuring method to check bucking splits was the known ?trissmetoden?.

The aim of the report is to develop a new design proposal for an existingsenior high school building in Skärholmens Center, Stockholm. Theschoolhouse is a result of the extensive residential project during theperiod between the years 1965-75 in our large cities peripheral and holdsanonymousand "gray face" that has characterized many houses from thesame era. Over the years, the number of students steadily declined andthe reason lies partly in the school's physical environment which cancertainly be regarded as substandard. This despite the fact that it islocated right next to Sweden´s largest trading block. A thorough analysisof the school building and the ambient area has been made incombination with a continuous dialogue with students and staff at theschool.