The stretch from the riparian zone of a major river, through the mouth and upstream in tributaries forms a range of differing habitats. The aim of this study was to investigate the effect of these different habitats on the riparian frog community in primary rain forest in Borneo; i.e. examine whether any gradients could be demonstrated in terms of species composition, diversity and density of frogs, as well as which environmental characteristics that seem to be of most importance in forming habitats of high conservational value. A major river, Segama, and three of its tributaries were investigated. The surveys were carried out at night by searching for frogs visually and acoustically along the streams, from the shore of the Segama river and 400 metres upstream in the tributaries.

When harvesting ley you hope to get a fast drying and a faster harvest. If there is a system with round bales, you need to have a dry matter close to 45 %. To make this as fast as possible, there is made a machine which pick up the grass with an pick-up. It turn the grass over and put it behind the machine (figure 2 and 4). There are few tests to prove the efficiency of this machine.

Abstract  The development and onset of diseases such as cardiovascular disease (CVD) and Type 2 diabetes are closely linked to genetics and lifestyle factors including physical activity and diet. A cluster of metabolic disorders called the metabolic syndrome (MetS) is a high-risk factor in developing these diseases. Acording to the International diabetes institute, one fourth of the worlds adult population has MetS. These individuals are twice as likely to die from CVDs compared to individuals without MetS. Physical activity (PA) and exercise has been shown to provide a number of positive effects that are considered to reduce the risk of developing sickness and premature mortality among both men and women of all ages, independent of other risk factors.

This bachelor thesis is about illustrating the fundamental principles for planning, locatingand designing bicycle parking spaces. The study aims to give an understanding of theneed and demand for bicycle parking spaces today, as well as to determine how these canbe met according to different theories. The study also aims to investigate the issue withincorrectly parked bicycles, which occurs frequently in the cityscape and therefore createsan obstacle in street spaces.An observational study on the new bicycle lots along Götgatan was conducted in orderto analyze how the theories of bicycle parking spaces are applied in practice. Cyclistswere then interviewed in order to obtain a deeper understanding of the cyclists? revealedpreferences.

Previous research has confirmed that the ability to repeat non-words has a close connection to a child?s language acquisition (Adams & Gathercole, 2000; Gray, 2003; Sahlén, Reuterskiöld-Wagner, Nettelbladt & Radeborg, 1999). It is also known that a repetition task is aided if the word is well known to the child (Roy & Chiat, 2004; Sahlén, m.fl., 1999). A relatively under-investigated area is that of the influence of prosodic variables on repetition of words and non-words.In the current study, 44 Swedish children between the ages of four and six years with typical language development were tested regarding word- and non-word repetition abilities. The words and non-words were matched based on stress, tonal word accent and number of syllables.

Title: Learning to read music notation on the guitar ? an analysis of various guitar schools on the market with added own examples. Purpose: To analyse currently available teaching materials on the subject of guitar notation on the market. A comparative analysis is made of five chosen books on the topic. Four criteria for the analysis of these five books are stated: 1) Structure and progression of the study of reading music on the guitar.

Purpose: The aim with the report is to investigate if the South East Asian customer on the food processing market base their investments on Total Cost of Ownership and if so, which are the cost drivers considered most vital. Moreover, do these cost-drivers diverge from the perception FP Ltd has, and if so, can a Total Cost of Ownership-model help to achieve a mutual understanding? Methodology: First a descriptive approach will be taken, identifying FP Ltd?s employers? perception on how to meet the customer. This will later be compared to our empirical findings of the actual customer behaviour in Thailand and Vietnam. Thorough analyse of the gap between the two parts will give us the outcome whether or not FP Ltd will have any use of presenting a quantitative model justifying their higher price.

To design new and high tech products the engineers rely more and more on computer based simulations to investigate the properties and behavior for a component or system.To verify these computer based simulations the dynamic properties for the components of the drivetrain needs to be verified. Therefore measurements of the stiffness and vibrations for the rear axle has been performed. This report show how the measurements has been implemented and evaluated, along with some interesting results for the rear axles properties.The static stiffness for the drive shaft along with the axle-gear has been determined. It is found that the stiffness for the whole rear axle is near the stiffness for the drive shaft, which means that the drive shaft becomes the dominant component of the system and affects the rear axle stiffness the most. The measured stiffness of the driveshaft is close to its theoretical stiffness.The stiffness for solely the hypoid-gear have been calculated using the stiffness for the rear axle and driveshaft, and thus has a range for the stiffness of the hypoid gear been determined.The backlash for the whole rear axle and for some individual components has been determined, where the backlash between pinion and crown-wheel has negligible impact on the total backlash.Measurements of the crown-wheel and pinion movements have been conducted, where the direction of movement is consistent with the theoretical direction of the forces.The vibration measurements show that the vibrations are more severe at certain rotational speeds.

This report focuses on the upper slit. The upper slit is located between the impeller andthe drive unit. The slit design depends on pump type and application. However it isuncertain why the design varies, The purpose of this report is to clarify why the designvaries and to recommend an improved slit design.A research has been done; information was gathered from interviews, but also fromsearching of databases and studies of drawings, reports and documents. The originalpurpose of the slit was to prevent twining around the driveshaft, and prevent dirt fromentering the cooling system.

From a new perspective, this paper will examine the artillery and the pike role in the period 1700-1712 and the battalion´s battle formation in the Caroline combat tactics. Carolinian battle tactics were practiced during the period 1700-1721. The results from my study will be compared to existing research opinion regarding the selected subject areas, if the result confirms the thesis or question the existing research opinion. The source material used consists of eyewitness accounts from the period consisting of diaries, memoir, biography, general muster rolls and historical literature covering the subject. The analysis shows that the Caroline artillery took part in 12 battles during the period of 1700-1712.

  Aim. The aim of the study was to describe how nurses in home care experience to pursue palliative care in ordinary housing. Methods. The study had a descriptive design with qualitative approach and was carried out through semi-structured interviews with 14 nurses in home health care from two medium-sized Swedish municipalities. The material was analyzed with manifest and latent content analysis. Findings. The underlying theme that emerged in the study was: Working with palliative care in the patient´s own homes is positive but challenging. Informants describe among other things that they perceived palliative home care as meaningful and that relatives have a central role in the palliative home care since they are close to the patient around the clock. The stress that emerges from the heavy work load and the long geographic distances are described as strenuous and to affect the care in a negative way. Informants describe the home environment as challenging as it is often not adapted for care and the collaboration with the palliative team is described to be experienced as both positive and negative.

A piezoelectric injector was modeled, in this Master Thesis Project which was carried out at Scania CV AB in Södertälje, in GT-Fuel. GT-Fuel is simulation program from Gamma Technology.The simulation model for the piezo injector was divided into a hydro-mechanical system and an electrical system (Piezoelectric element). First the hydro-mechanic model was duplicated from Advance Continuous Simulation Language model (ACSL). The simulation results were then compared to the ACSL, to verify that the hydro-mechanical system was modeled correctly. The simulation results for the electrical model were also compared with a Simulink model.

Two different claim relations arises with a damage covered by a liability insurance. The first claim relation is of course the one between the claimant and the liable as a claim for damages. The other claim relation arises between the liable in his capacity of insured and his insurer as a claim for compensation under the liability insurance. There is a tight connection between the two claim relations because of the fact that it is the claimant?s claim for damages that gives rise to the claim for insurance compensation.

The system tungsten-oxygen has potential of being suitable for decorative coatings since ceramic coatings are often hard and wear resistant, and since modulations in oxygen content or incorporation of small ions could give bright colours. The aim of this report was to investigate the relationship between process parameters and  the properties of the films, with the wear resistance being of special interest.Samples with tungsten to oxygen ratios in the range of 100:0 to 25:75 at% were made using reactive sputter deposition, either with constant gas flow, or gas flow controlled by optical emission of the plasma. The hysteresis of the system, which means that a certain gas flow will cause different pressure and/or target voltage depending on in what way the flow is reached, makes it interesting to control the process where the system makes the steep change from metallic tungsten to ceramic tungsten oxide. This is difficult and thus requires precise control equipment.The samples were analysed using X-ray diffraction, X-ray photoelectron spectroscopy and an empirical wear test suitable for small components like cell phone cover for example, in order to characterize the structure, composition and wear resistance of the coatings. The results could be divided into three groups: (I) tungsten-like, with very low oxygen content; (II) mixed phase and (III) tungsten oxide like, with oxygen content close to 75 at%.

The empirical data that lies behind this survey comes from field work between 1992 and 1995. This field work represents work I made myself as a sales-man for the company, Malmberg Original Water. The task was to implement the Malmberg mineral water brand on the restaurant market of the South-Swedish area. Our aim was to reach the upper-scale, premium market of restaurants. The mission was successfully completed, and at 1996 we had completed the position as the most exclusively positioned mineral water brand in Skåne (Southernmost Sweden).