The incidence of damage to the claws and legs in piglets caused by the floor in farrowing pens is a widely known problem and very common in today's pig herds. Although the association between floor and damage has been known for over 35 years, no suitable solution has been found to reduce the negative impact. The purpose of this study was to make a literature study to document the experiences of the use of different types of flooring in farrowing pens and also, in an own study, examine if soft floor in farrowing crates could lead to reduced damage to the claws and legs in piglets compared to concrete floor. The study was conducted in two herds, A and B. In each herd, farrowing pens with concrete floor and concrete floor with polyurethane coating were compared.

AbstractThis report intends through a case study to investigate if lightweight concrete isappropriate as main material in the outer wall of a seven storey residential building.A technical design is carried out in accordance with the definitions and requirementsfor passive houses, given by FEBY?s1 ?Demand specification for passive houses?.A literature review is also carried out for a comparison between regular bolt wall andlight weight concrete wall, with a focus on the safety of moisture.The lightweight concrete block used in the report is as a celblock produced by thecompany H+H Sweden AB.The methods used have resulted in compliance with requirements andrecommendations from authorities. Calculations of energy, noise and moisture riskassessment has been carried out.The work has resulted in the conclusion that the lightweight concrete itself is notable to isolate in the extent necessary to obtain chosen U-value of 0,1 W/m2 ° C,without getting to thick. Therefore additional insulation is needed. There are fewrelevant reference objects built with only light weight concrete.

AbstractThis report intends through a case study to investigate if lightweight concrete isappropriate as main material in the outer wall of a seven storey residential building.A technical design is carried out in accordance with the definitions and requirementsfor passive houses, given by FEBY?s1 ?Demand specification for passive houses?.A literature review is also carried out for a comparison between regular bolt wall andlight weight concrete wall, with a focus on the safety of moisture.The lightweight concrete block used in the report is as a celblock produced by thecompany H+H Sweden AB.The methods used have resulted in compliance with requirements andrecommendations from authorities. Calculations of energy, noise and moisture riskassessment has been carried out.The work has resulted in the conclusion that the lightweight concrete itself is notable to isolate in the extent necessary to obtain chosen U-value of 0,1 W/m2 ° C,without getting to thick. Therefore additional insulation is needed. There are fewrelevant reference objects built with only light weight concrete.

Floor surface in pig facilities can have an impact on animal welfare and pig health, as it can cause the pig physical damage and thereby increased risk of infectious diseases and lameness. The development of pig housing systems has resulted in a decreased use of bedding. It seems hard to find the optimal floor in farrowing pens, as it must suit both the sow and piglets. The floor friction needs to be adequate to avoid slips and at the same time should the floor be non-abrasive. Abrasions and lesions caused by the floor are not only causing the animal suffering, but are also negative from an economical aspect.

At the beginning of 2011, Sweden started using the European rules for structural design, the Eurocodes, instead of the previous national rules. In both the previous rules and the Eurocodes, it is possible to dimension concrete columns using tabled values. However, the required cross section measurements have increased considerably. Moreover, it is possible to dimension concrete columns using calculations, however, this is unusual.The development of a fire in a fire cell can be divided into the growth stage, the fully developed fire and the cooling phase. The duration of each phase, as well as the temperature, is dependent on a number of factors, e.g.

ADORABLE CHILD OF ITS TIMEThis text will describe a inovative project about material, traditions and someideas about furniture for work in an home inviroment. The content is partlyabout exploring ancient marine- and textile techniques to find somethinguseful for furniture of the twenty first century. It is also about the designprocess of creating a sustainable piece of furniture that questions the paradigmathicsabout usage and the context about manufacturing furniture.The text will briefly describe the design process and then reason about theresult in a deeper sense. Questions that has been considered from the verybeginning of the project as well as those one stumbled across during theevolution of the work will be objectives for the discussion. The result will bein focus as a foundation for the discussion and also the values and issuesabout that.

A trend in modern landscape architecture is to design pedestrian streets so that vehicles and people move in the same area. By doing this, traffic tends to slow down. On the market though, there is a lack of furniture that corresponds to the requirements of these kinds of public places. Therefore, I have designed this furniture, called VOX, which is planned to be used on streets, schoolyards and squares. One objective has been to promote the product to the industry.To achieve this, I have been in contact with people from different professions, which have all influenced my designprocess.

Användandet av betong som ersättare för stål vid produktionen av vindkraftverkstorn har ökat den senaste tiden. Betongtorn är betydligt billigare än ståltorn men problem som sprickbildningar, frostsprängningar och följaktligen armeringskorrosion har uppstått bl a på grund av vibrationer från rotorn. I fundamentet i vindkraftverk kan ovan nämnda problem också uppstå och det uppfyller således inte alltid funktionskraven. Det här examensarbetet undersöker möjligheten att eliminera dessa problem genom att använda en sorts högpresterande betong kallad UHPC 2.2 med syntetfiberarmeringen, STRUX. Jämförelser mellan tidigare empiri om högpresterande betong och laborativa tester på UHPC 2.2 visar att den senare är beständigare och ger möjligheter till en större sprickfrihet.

This Master thesis is about a postal- and telegraphic building in Eskilstuna, Sweden. The construction methods for the specific building and buildings in general from the same time are described. The purpose of the report is to describe the loads acting on the building and how it has been built and why it has been rebuilt during the years. After this, possibilities of reconstruction and adaptation for today?s demands can be evaluated.

This report is a thesis for collegeengineering program in structuralengineering at Uppsala University andwas commissioned by the Swedishcontractor Svevia. The study aims toprovide an overview of the mostbeneficial bridge material from bothenvironmental and economic point ofview.The life-cycle analysis covers onlycarbon dioxide emissions, since it isthe most spoken of in today?s climateagenda. Furthermore, this study aims tohighlight which parts, of the systemboundary, that contributes to greatercarbon emissions for the wood- and theconcrete bridge.The life-cycle cost analysis wascalculated with a lifespan of 40 yearsand covers the basic cost of investment,operating and maintenance, anddecommissioning costs.The analyzed constructions in this studyare existing projects that are almostcompleted. Both bridges were designed tohandle loads up to 60 tons.

This report examines the possibility of developing a modular system for concrete homes that cancontribute to greater diversity of today's market. The issue was whether it ? from a competitive pointof view ? is possible to produce smart prefab modules that customers themselves can combine to avilla. The report addresses the question how the modules and wall panels should be designed for thegreatest variety of floor plans.With regard to what is asked of the customer interviews where held for the purpose ofunderstanding concrete's popularity and elements of high value in their homes today. The answersfrom the interviews laid ground for four prototype homes which were made to demonstrate how theelements can be combined to achieve different types of houses..

This report describes a new foundation method and compares it with a traditional founding of concrete. This new method is called the Koljern technique and uses cellular glass which is called Foamglas. The Foamglas is compounded to founding elements by lightweight steel beams. Foamglas is an insulation material with high compressive strength, and is rot, insect, vermin and acid proof. The cellular glass is also fire proof and watertight, which makes it a very good construction material.The report contains a study of a number of cases for which the Koljern technique is compared with a foundation of concrete.

This study investigated the effects of rubber alley flooring on cow locomotion, claw and leg health, production, cleanliness, grooming behaviour and cow exclusion rate in a free stall herd. The study was conducted in a new dairy house with a rotary milking system, with a matched group of cows on traditional scraped concrete alleys used for comparison. All claws were trimmed and lesions recorded at the beginning and end of the 4-month study. Locomotion, claw and leg health, behaviour and hygiene were observed and scored at regular intervals during the study. The results showed that cows on rubber alley floors displayed significantly (p.

The number of products offered by retailers has increased immensely during the last two decades, which has resulted in an increase of naming decisions having to be made. The importance of product names has become more significant for retailers offering their products online, as these are more visible to the customer in comparison to products offered offline. Consequently, it is of great value for retailers to gain knowledge about how a product name affects the customers' perception of the product. The purpose of this study is to examine whether product names affect customers perception of the relevant products in the online environment. This has been illustrated by applying the following theories to the relevant product names; meaningful and meaningless brand names as well as concrete and abstract words.

Before the European construction standards were introduced in January 2011, it was mainly themethod in BBK04 that was used for calculating punching capacity in concrete structures, and in lesscommon cases the method in BHB. The method of BBK04 is easy to use and have had the samestructure since the first was published in 1979. The Concrete handbook method (BHB) where usuallyonly used when a higher punching capacity was needed and the cross-sectional height where fixed,calculations using this method entails more work, but will in return usually give a higher capacity. Italso allows the use of shear reinforcement to increase the cross-section capacity. The method ofcalculating punching shear in EC2 differs largely from the methods of BBK04 and BHB.