Estimation of the variation in the integrated hydraulic conductivity around the Tunåsen infiltration facility - An investigation of the effects of uncertainties in existing informationAlmost half of Sweden?s drinking water volume is produced from groundwater. The main fraction of this is extracted from eskers, some of which allow for very large extraction rates. Despite this, the groundwater volume is not sufficient in some areas. This has led to an extensive use of artificial recharge.In Uppsala, the total volume added through artificial recharge is divided between four infiltration facilities.

Calesco Foil AB is a manufacturer of thin flexible circuits for heating or electric conduction.The plant is located in Kolbäck, Sweden.One of the company?s products, the conducting polymer pasta is in present situationunpredictable. Unpredictable in the way that the same type of heater shows differentresistance, depending on which time they have been produced. The desired repetitivelyprocess is almost non-existing.The aim of this master thesis is to primary identify those parameters that effects theresistance, observe and if possible to perform tests on them. The results from this analysisstand as base for recommendations to achieve a repetitive and standardized printing process.The results and the observations from the tests indicate that a repetitive process is possible toachieve.

This thesis adresses the subject of stormwater management and the problematic with stormwatermanagment and landuse in the compact city. The thesis research different solutions in stormwater managment and how to implement them in the context of the compact city. And at the same time preserve and make good recreaational places and keep quality green land per capita. The thesis also analyses risks and problems that could effect the environment with focus on stormwater managment and hov to minimize these problematic factors an create a good environment. In an urban context where the water has a natrual place, and is used as a asset.

A titania-supported nickel catalyst was prepared and tested in methanation in order to evaluate its catalytic properties (activity, selectivity and specially, activity loss), and compare it with an alumina-supported nickel catalyst.The titania-supported catalyst did not only show higher stability than alumina, but also presented a different cause of deactivation, carbon formation. In addition, a kinetic model was obtained for the titania-supported catalyst, and a study of the effect of different operating conditions (temperature, composition and partial pressures of synthesis gas and water) on the deactivation rate and carbon formation of this catalyst was performed.

The purpose of this investigation was to find out more about students? spontaneous ideas about properties and transformations of matter. Examples of matter chosen are such which students know about from everyday life and focus is mainly on the questions if students know that all matter has weight and that matter is preserved in transformations.The method used is semi structured qualitative interviews with individual students. Different experiments were carried out together with the students who afterwards were interviewed. However, the students show varying answers and no generalizations can be done.

Miljonprogram is a Swedish building program from 1964 to 1975. During that time about a million homes were constructed. Now, almost 50 years later, they are in desperate need of renovation. In order to fulfil the Swedish environmental objective to decrease energy consumption 50 per cent until 2050, considerable housing stock built under the Miljonprogram has to be renovated.Focus in this thesis is on the building services and theirs profitability that can decrease energy consumption in households build during the Miljonprogram. Building construction is not considered in this report.

If you have access to wood, a wood burning boiler is a cheap way to heat your home, but it is certainly not the most convenient option. Wood requires many operations and management, which takes time. One way to reduce this workload is to have a modern boiler with automatic ignition. Enertech/CTC has a desire to create an accessory with automatic ignition to a modern wood burning boiler. Today there is no boiler on the market that can ignite firewood automatically without the introduction of paper and sticks.

Everyone has to take a greater responsibility in energy issues, both individuals and companies. There have been some major developments in the construction industry but there is still a lot to be done. This diploma work thesis presents different methods of making existing construction shed establishments to use less energy. What is possible to do and how much energy is there to be saved? A shed establishment consisting of 8 shed units were studied in this project and the building simulation tool VIP-Energy was used to simulate different types of material in the sheds. An infrared camera was used to locate thermal bridges. There are several factors that can be improved to make a construction shed establishment to use less energy.

This thesis is about a part of the marquetrytechnique, scorching. Scorching is made by heating up something, put a veneer into the heated substance and make a controlled burning. This technique is old but still used today and have according to me great potential for development. In my work I wanted to give the scorching greater room then I earlier have seen. I wanted the scorching to be the dominant ingredient for a decorative element in a piece of furniture or an interior.

With rising energy prices and the threat of climate change, energy costs and energy savings havebecome a central and important part in building. Therefore it is interesting to explore different andnon-conventional methods of energy conservation. Building Earth sheltered houses is such a method.Earth provides good insulation and provides the ability to both reduce the total heating needs and toreduce the maximum power demand. The aim of this study was to construct a house in Malmö and seeif Earth sheltered houses can be a cost effective alternative for the construction of sustainable andenergy-efficient houses.Previous studies have shown that Earth sheltered houses have reduced their power requirement with upto 25% and their use of energy with 10%. Numerical calculations in Comsol Multiphysic 4.2, wasperformed on a house with different degrees of earth covering.

In order to optimize calf welfare and health it is important to know the behavior of cattle in free ranging conditions. When the cow is about to give birth to a calf she will leave the heard about 12 hours before. It is then rather obvious that isolating the cow about calving time in a single pen is imitating the cows? natural behavior. To save space and minimize building cost it?s common that the farmers build calving pens for four of five cows especially at larger farms.

This thesis provides a good introduction to the American environmental certification system LEED, Leadership in Energy and Environmental Design, and trough compar-isons between Sweden and the United States an explanation to the systems design is given. The work is closely linked to a LEED Core & Shell project in Stockholm, Swe-den, where the goal is to reach the second highest rating in LEED - Gold.This thesis gives a broad description of the LEED system and a more profound study of the energy sector, Energy and Atmosphere. Here, for example, an analysis has been made of how the energy consumption of an imaginary building designed according to the requirements of the BBR (Swedish building code) performs in comparison to the Baseline building in LEED.The existing model of Borgarfjord 3, which served as a case study in this work, has al-so been modified to investigate the energy savings that could have been achieved by adding extra insulation to the building. A description of the problems, regarding how the Swedish district heating system (DES) is treated in LEED, is given as well as the suggested modifications. This is an issue that will be pursued during the process of shaping a new, international, version of LEED due to be launched 2012..

With the days DGPS-technology can a position of 5 centimetres decides. With this exactly position is the technology very interesting for the agriculture. I think this technology can come more and more in the future. You can also move the fact and information further to the spreader, sprayer and seeders. If the combine is equipped with harvest accounting, can you with help of the system make harvest maps.

With growing economies and better living standards in many parts of the world today, there is a need of expanding the capacity of generating electricity. The alternatives for renewable energy technologies are not fully developed and have still some problems to conquer.The company Minesto has developed a technology that is called Deep Green. It is designed to gain electricity from tidal currents. Deep Green works in a similar way as a kite that is attached to the seafloor with a moving wire. It contains of a wing that moves due to the water current.

This thesis is a case-study of an ongoing court case between the Swedish Competition Agency and Växjö Municipality about a set-up requirement to the long-distance heating system for newly built private houses on municipality owned land. This requirement was set up as part of the municipality?s long-term environmental goals; however the Competition Agency claims that the demand is damaging the free market in the municipality. The purpose of this thesis is to determine which normative assumptions the decision makers have based their actions and re-action on, and whether or not these assumptions are valid, thru theoretical ideal types. This is determined via method of textual analysis.