This is a report written for an examination project C-level, on the subject of energy. The examination project is a product of the FVB Sweden AB (district heating bureau). It started with a meeting with Stefan Jonsson FVB Sweden AB, were he explained the content of the project, and from this a presentation of the problem was made. The problem that needed to be solved was how they could control the valves in the system to provide heating to everyone in the system. The valves are often oversized so the pump in the heating plant would have to be enormous to be able to provide enough flow to be sufficient, if everyone in the system had there valves fully opened. I came up with two solutions to the problem, one was a wireless network that could keep track of the valves and the other solution was an extra sensor that was placed on the radiator.

Many of todays studies show that district heating is one of the betteralternatives as heating source because of its low environmental load.The energy source is often leftovers from other processes producing energy or waste, like garbage or chips.Electricity in combination with geothermal heating is another Heating system that has increased sharply during the last years, and also this system decreases the discharges that have negative affectson the environment compared to several other heating methods.This report aims to, concentrated towards these two different Heating systems, estimate the amounts of discharges they indirect cause and how the environment is affected.We have calculated the mean value for discharges of carbon dioxide, nitrogen oxide, sulphur oxide and dust generated from electrical power used in Sweden.Through interviews and research we have gained data for the same substances that district heating based on combustion of garbage and biofuel generates.We have also in cooperation with a housing company chosen a building we see representative for many of the new single-family houses built in Sweden today.Based on its shape and appearance we theoretically created three alternatives of the same house, each of them with climate screens different from each other.Together with the amounts of discharged environmental affecting substances, these houses were the base for our calculations and studies when investigating the different heating sources environmental effect.The results have thereafter been analyzed and discussed from different angles..

Energy efficiency is today more important than ever, mainly due to the high energy prices and the approaching climate changes. Heating of buildings is an essential area within energy efficiency. Many buildings are old and were built at a time when the energy prices were low and the term ?energy efficiency? was unheard of. By applying today?s broad range of energy saving actions on these old, and thereby often, heating ineffective buildings, this area has a large potential in reducing energy consumption and costs.Churches and chapels are generally old buildings with, in many cases, ineffective Heating systems and therefore consume much more energy than needed.

Heat is distributed to the district heating customers through pipes with water as a heat carrier. The district Heating system is complex. To decide what is leakages from the district heating net versus what is the water consumption of the plant, is difficult. Therefore, the purpose of this master thesis is to establish a model where the district heating net?s leakages but also the water consumption of the plant can be followed daily. The project is performed at Vattenfall´s district heating power plant in Uppsala. Information is gathered through discussions, drawings of the plant and guided tours of the plant.

The Work has been performed to, and in cooperation with Vetlanda Energi och teknik AB.District heating for commercial purpose started in the USA in 1877. Today the network has grown into big and complex systems, which demand maintenance and service to keep up the security of the delivery. When a district heating network expand, it becomes difficult to perform reliable calculations. For this purposes there are a few suppliers who design and deliver systems for documentation and calculation of district heating networks.Vetlanda Energi och Teknik AB is in the position where they must get a system for documentation and calculation for district heating, and therefore they need a basis to get a system. The target is to write a requirement specification that will follow the basis.The Swedish market has been inventoried, and suitable systems have been selected.

The Work has been performed to, and in cooperation with Vetlanda Energi och teknik AB.District heating for commercial purpose started in the USA in 1877. Today the network has grown into big and complex systems, which demand maintenance and service to keep up the security of the delivery. When a district heating network expand, it becomes difficult to perform reliable calculations. For this purposes there are a few suppliers who design and deliver systems for documentation and calculation of district heating networks.Vetlanda Energi och Teknik AB is in the position where they must get a system for documentation and calculation for district heating, and therefore they need a basis to get a system. The target is to write a requirement specification that will follow the basis.The Swedish market has been inventoried, and suitable systems have been selected.

The purpose with this report is to examine how the implemented energy efficiency measures on Bokelundskolan in Växjö have had impact on the energy use. The measures which have been implemented are, new ventilation system, new Heating system, optimized adjustment of the Heating system, new windows with U-value 1.2 and lower window height, insulation under windows and in the crawl space. The school's energy use before and after rebuilding has been calculated with the calculation program, Vip-Energy 1.5.5.Calculations of energy use for the school with windows on U-value, 0.9 and 0.7 have also been done. The replacement of windows has been studied from a cost perspective. The conclusion is that the exchange of heat and ventilation system was the biggest contributor to reduced energy use on Bokelundskolan.

The projects objective is to find an alternative method of heating (the current method being via electric heating) the sewage treatment plant on the island Utö in Stockholm?s archipelago in order to reduce the energy consumption and ultimately the cost for heating the plant. The project is given by ?Skärgårdsstiftelsen? (The Archipelago Foundation) and is a part of the larger EU-project ?Green Islands?.A model for the plants total heating demand is established in order to get a good perception of how much money can be saved using alternative heating methods. The heating demand model gives an annual heating demand of approximately 32 500 kWh and a maximum heating power demand of around 24,7 kW.

Gunsta is situated about 10 km east of Uppsala. Today there are plans to establish 1000 new households in Gunsta before year 2030. The required energy for heating houses and water would be distributed via a district Heating system, which also includes 200 existing residences. The annual required energy, according to this study, would be 16.2 GWh with a maximal peak effect of 6.9 MW. To meet this need, the study suggests a system with heat pumps to upgrade the 31?C water from a 1.8 kilometre deep borehole.

This report is a bachelor's thesis of two students from the Energy and Environment degree at KTH Stockholm. Grinda is an island situated Stockholm archipelago. Skärgårdsstiftelsen is landowners and manages the area. Grinda Wärdshus, a guest house located in the island, currently uses an oil-fired boiler as a Heating system. The aim of this thesis is to investigate whether wood chips or pellets is, from a sustainability standpoint, a suitable heating method for the guest house.

District heating covers most of the residential areas and industries in the twoneighbouring Swedish municipalities Nyköping and Oxelösund. In Nyköping,Vattenfall AB Värme produces heat in a bio-fuelled CHP plant. In Oxelösund,waste heat and use of waste gases from the steel production at SSABOxelösund is the basis in the district Heating system.This report examines the environmental consequences of a connection betweenthe two district Heating systems. A broad system approach is used and the focusis on environmental effects in the system.A system analysis has been performed on the result of simulations of differentheat and electricity production alternatives. The alternatives simulated wereone where Vattenfall Nyköping covers the base load in the joint district heatingsystem and two where the power plant at SSAB Oxelösund supplies the heatbase load.The conclusion in this report is that the consequences of connecting the twodistrict Heating systems can be both positive and negative, depending onsystem boundaries and on the environmental focus.

Grubbe Ventilation AB is a sheet metal and ventilation company who provides design, installation, service, and repair of ventilation. The company is expanding their business by building a new facility in Umeå, Västerbotten. The property is designed to be used for both office and industrial work.Grubbe Ventelation AB has not yet decided upon wish system which is to be established to provide the building with heating and cooling. The consulting firm Umeå Projekt Team has therefore been asked to investigate the possibilities to invest in geothermal- heating and cooling.If the investigation of a geothermal heating- and cooling system would provide favorable results it would be a very appropriate alternative that provides energy at low costs and are an environmentally friendly option as the energy comes from stored solar energy in the ground is provided by stored solar energy in the ground.The facility ´s heating and cooling consumptions are calculated in the program BV2 and the result indicate a heating demand of 185 000 kWh per year due to thermal transmittance, transmission losses, heating of warm water and a cooling requirement of 5500 kWh.Three different systems of geothermal heating and cooling were tested in the computer program Energy Earth Design. The results show no difference in the dimensioning of the drill hole if merely heating were to be used or both heating and cooling were to be established.

This rapport contains an examination of the energy consumption of a kindergarten, which areas that have the largest impact on the energy consumption and what can be done to reduce those areas in ways that are relatively easy and profitable. It is also analyzed if it is possible to reduce the energy consumption from today?s consumption to a consumption that fulfils the demands placed on low energy houses by FEBY.The focus has been on reducing the energy consumption of the areas ventilation, Heating system and hot water system, since those seemed to be the easiest ones to affect and since the building is quite recently built.There are different kinds of ventilation systems, at the moment the building have a CAV-system, which means that the ventilation is too high during large parts of the day. There are different ways to manage the ventilation system, for example presence detection, humidity sensors, CO2 sensors, temperature sensors and season adjustment. Many of those are in the end dependent on CO2 sensors to guarantee a good indoor climate, therefore the focus have been placed on this system.

In today's society, the availability of energy plays an integral part in our everyday lives. Unfortunately, the price of energy in Sweden has increased in recent decades. A large part of our energy consumption goes to heating modules for houses, where heating methods that depend on energy sources such as electricity, district heating, fuel oil, gas and biofuels are the most common ones. During the winter period, the increase in energy costs becomes significantly evident, especially for small property owners. This increase in energy cost is most noticeable for home owners with electric heating.This thesis is written at the Halmstad University, in cooperation with a company, which makes parts of this thesis confidential.

In cooperate with Asko Cylinda we have developed a new heat system too short the process time and reduce the energy consume in a dishwasher and still have it too be a class AAA. The environment and quality is important for the company too still be the number one on the market, If they want too keep that position the product developed of new innovations will be very important. The systems we have developed are more effective and reduce energy up too 25 %. The process time is reduced too less than two hours, from the today two and half-hour. The solutions are too heat up the rinse water and the dishwater at the same time, with a new Heating system and it make are solutions unique and effective. Its good for the dish and the environment.