This master thesis was carried out for Saab Avitronics, a business unit of Saab ABactive in electronic systems for military aircrafts. Reliability and weight are of crucialimportance in this environment. To improve reliability and lower the weight graphitemay be used for electronics cooling. Graphite is an anisotropic material and hasthereof high thermal conductivity in two directions (in-plane) and a relatively lowconductivity in the third direction (through thickness).The purpose of this thesis was to investigate if graphite is an adequate thermalconductor to use in PCB carriers. The carriers support and cool the PCB by divertingthe heat dissipation from the PCB components to the edge.

Tylö AB is the leading manufactor of sauna cabins in Europe, but there is a lackof a sauna lightning produced by Tylö. The project of developing a new saunalightning series was assigned two students at the developmentengineeringprogram at Halmstad University. The main problem with lightning in the saunais the heat and security aspect. The selection fell on LED technology as thelightning source, thanks to its small measures and low heat emission.The work of constructing of a lightning armature which the capability of coolingdown the LED lightning was carried out during autumn ?06 and spring ?07.

Tylö AB is the leading manufactor of sauna cabins in Europe, but there is a lack of a sauna lightning produced by Tylö. The project of developing a new sauna lightning series was assigned two students at the developmentengineering program at Halmstad University. The main problem with lightning in the sauna is the heat and security aspect. The selection fell on LED technology as the lightning source, thanks to its small measures and low heat emission. The work of constructing of a lightning armature which the capability of cooling down the LED lightning was carried out during autumn ?06 and spring ?07.

AbstractClimate and environmental issues are of paramount importance. Researchers agreethat we must all contribute to a reduction of gases that contribute to climatechange. Energy consumption must decrease within all sectors and the promotionof renewable sources of energy must be introduced.Each sector should aspire to decrease its energy consumption. Energyconsumption is strongly linked to waste gases that contribute to climate change.Passive houses are a part of the construction industry's methods to attain energyconservation.Passive houses are derived from low energy houses and super insulated houses. Apassive house is intended to obtain heat from the inhabitants and through theiractivities.

sustainable development by reducing the energy use by EU:s directive of energy efficiency and the UN Convention. The second purpose is to present the technical solutions regarding ventilation and heating system that is being used in passive houses. This was done using 8 passive houses, 4 germany and 4 swedish passive houses. Even the international and Swedish system requirements for passive houses have been addressed in this project. The goal was also to explain how and why the mechanical system in passive houses has developed to the technology used today.

Every year, KTH participates in the Shell Eco Marathon, a competition whose goal is to design a vehicle that can go as far as possible using only the equivalent energy of one liter of petrol fuel. This year, one of KTH?s contributions to this race is the Agilis prototype; a car powered by a uniquely configured HCCI-engine developed at the university. The engine is dependent of several subsystems in order to work properly, among other, systems for cooling and lubrication.Combustion engines are in need of a cooling system that reduces the heat developed during the combustion. In general, two main types of cooling systems are employed; either air cooling, where the outside of the cylinder is exposed to a flow of the surrounding air, ore water cooling, where water flows in tubes around the engine, and the heat are transferred by the water to the surrounding air through a heat exchanger.The purpose of the lubrication system is to prevent the friction that builds up in the interference between moving parts in the engine.

Today there are a big need for a system that delivers overview of all available units for different municipalities and shipping- and security companies due to the increasing requirements for efficiency. The purpose with this graduation thesis is to find out which systems that is suitable to use while developing cost-effective software for positioning and to produce a prototype for such solution.This assignment has been done at the request of PocketMobile Communications AB. PocketMobile is a company that are specialized on delivering modern mobile software solutions and systems to companies with their own vehicle fleet or mobile workers.This master thesis can be split into two separate parts, the theoretic- and the practical part.The theoretic part includes producing a number of functional requirements in cooperation with PocketMobile and comparing the available systems against the function requirements.The practical part deal with the development of a prototype that demonstrates the software recommended. The development tools that best matched the functionality requirements when the selection was made in May 2007 were Map24 and OpenLayers. The system that was selected to use while developing the prototype was Map24, because this product matches all of the requirements and it is also suited for professional usage regarding support, scalability and reliability.

The use of bio fuel is increasing every year. Nowadays you will find different alternatives to oil and electricity heating system. In this essay I have examined what the economic conditions are to invest in a bio fuel furnace. I have chosen to assume from a specific farm and do a case study on this farm. Malmvik farm is located just outside of Stockholm.

The concentration and storage of organic chlorine and chloride were determined in soil, to a depth of 40 cm, in a coniferous forest in the Stubbetorp catchment area in south-east Sweden. Also, the spatial distribution of the two forms of chlorine was determined. Soil samples were collected at 49 of the nodes in a grid with approximately 105 m between the nodes. The analysis of spatial variability suggested that no spatial autocorrelation was present either within the variable organic chlorine or chloride. This means that no sample was more influenced by another nearby sample, as compared to other samples further away.

The EU Water Framework Directive has led that management follows the boundaries of natural catchments.The Swedish waters suffer from a nutrient overload that originates mainly from diffuse sources such as agriculture and the subcatchment of Hackstabäcken in Vallentuna Kommun, just north of Stockholm, has been chosen for this study because of its high nutrient load and because it has undergone obvious changes in land use through the years.In this study, the land use in 1902 is compared with the land use in 2011 in order to investigate if it has influenced the ability of the landscape to produce ecosystem services related to nutrient removal. These services will continue to be produced as long as the system is stable and resilient, but when landuse changes and manure from horses increases it will lead to disturbances that can convert a system from one regime in to a completely different one. That will result in loss, or degradation, of ecosystem services such as denitrification, phosphor sedimentation and adsorption, vegetation uptake and infiltration.The results of this study are based upon area calculations of landuse from old maps from 1902 and 2011. Through these maps it becomes clear that the forests in Hackstabäcken, has increased with 170 ha together with an urbanization of 311 ha, at the same time as wetlands and arable land has diminished and lakes has suffered from reductions. Wetlands have been reduced with 76 ha and the ones remaining are of insufficient quality from a nutrient removal perspective.Data from 1902 and 2011 regarding number of horses and bovines indicated a decrease in bovines and an increase in horses.

Phytoestrogens are secondary metabolites produced by plants. Among the plants that make phytoestrogens are soya, red clover and some types of grass. The name phytoestrogen is a collective term for compounds such as genistein, daidzein, biochanin A and formononetin. These compounds are similar to oestradiol-17? in their chemical structure.

The sun is a huge energy source with great potential of providing energy to the heating of homes and other buildings in an environmentally sustainable manner. In order to provide buildings with energy from the sun it is necessary to transfer the energy supply over time to when the demand arises. By storing the heat in a seasonal storage, solar energy from the summer can be used in the winter when the demand for heating is greatest.Today's existing plants are mainly in Europe and particularly in Germany. These facilities are designed to supply heat demands greater than 400 MWh and covers about 40-50 % of this need which consists of energy for space heating and domestic hot water. How much of the heat demand that is covered, the solar fraction, is partly due to losses from the storage which in turn is connected to the surface area of the storage.

Two elementary schools are now being built in Gråbo (in the municipality of Lerum),Röselidsskolan and Ljungviksskolan, which are both designed with solar thermalcollectors for the schools domestic water heating. During the summer while thelargest amount of solar heat can be generated, the activity hence the domestic wateruse in the schools are heavily reduced. Both schools are connected to the local districtheating system which makes it possible to use the solar collectors to deliver heat tothe district heating.The purpose of this thesis is to evaluate the two systems mentioned above and todetermine which system is more suitable to apply on a school. The building whichconditions were used for this evaluation is Röselidsskolan.A solar heating plant of each system type was dimensioned from the expected andknown conditions of the building. The purpose with the dimensioning was to makethe solar plants replace the ordinary energy source as much as possible.

Two elementary schools are now being built in Gråbo (in the municipality of Lerum),Röselidsskolan and Ljungviksskolan, which are both designed with solar thermalcollectors for the schools domestic water heating. During the summer while thelargest amount of solar heat can be generated, the activity hence the domestic wateruse in the schools are heavily reduced. Both schools are connected to the local districtheating system which makes it possible to use the solar collectors to deliver heat tothe district heating.The purpose of this thesis is to evaluate the two systems mentioned above and todetermine which system is more suitable to apply on a school. The building whichconditions were used for this evaluation is Röselidsskolan.A solar heating plant of each system type was dimensioned from the expected andknown conditions of the building. The purpose with the dimensioning was to makethe solar plants replace the ordinary energy source as much as possible.

Two elementary schools are now being built in Gråbo (in the municipality of Lerum),Röselidsskolan and Ljungviksskolan, which are both designed with solar thermalcollectors for the schools domestic water heating. During the summer while thelargest amount of solar heat can be generated, the activity hence the domestic wateruse in the schools are heavily reduced. Both schools are connected to the local districtheating system which makes it possible to use the solar collectors to deliver heat tothe district heating.The purpose of this thesis is to evaluate the two systems mentioned above and todetermine which system is more suitable to apply on a school. The building whichconditions were used for this evaluation is Röselidsskolan.A solar heating plant of each system type was dimensioned from the expected andknown conditions of the building. The purpose with the dimensioning was to makethe solar plants replace the ordinary energy source as much as possible.