One of ABB Power Systems´s business areas is HVDC (High Voltage Direct Current) technology. HVDC is used for transmissions for both short and long distances. One of Power Systems?s products is called HVDC Light. HVDC Light is a relatively new technology for power transmission, but have before only been used for motor drives applications.

In this thesis some different modulation schemes for xDSL-techniques are compared. The investigated techniques are ADSL, G.lite, ADSL2, HDSL, SHDSL and VDSL. The modulation methods used are DMT, CAP and different versions of PAM. Several broadband techniques also use Trellis Coded Modulation (TCM) to increase the coding gain of the transmission. For each one of the different modulation methods the signal-to-noise ratio is calculated for generating a bit error rate probability of 10-7.

This report is a degree project performed at Freudenberg Household Products AB, (FHP). The degree project comprises measurement and analysis of the power net at FHP Basproduction. The content is divided between one theory-part, one document- part with measurements and also conclusions and a list of measures to be taken. During the project the purpose and restriction change from a quality investigation to only concentrate on harmonics and finding the reason why they exist, and also to find a solution to the problem with harmonics. The measurements shows that the power net contains harmonics of different order and intensity.

Harmonics are a well-known problem that has to be dealt with in the design of thegenerator. Internationally accepted standards limits the amount of harmonics allowedin the no-load voltage. These limits can be difficult to fulfill with integral slot winding,where the number of slots per pole and phase is an integer. The presence of thedamper winding often makes the problem with harmonics even worse and harmonicswith frequencies of order 6q±1 arise with significant amplitude. How the damperwinding is designed affect the content of harmonics in the no-load voltage and the aimwith these ? has been to investigate in which extent design of the damper windingaffects the contents of harmonics.Simulations with the 2-D finite element method have showed that if the damper barsis centered in the pole shoe, the amplitude of the harmonics of order 6q±1dependsboth on the ratio between the stator slot pitch and damper bars slot pitch and if thedamper bars are connected between the poles or not.If the damper bars is displaced with ¼ stator slot pitch alternately, the amplitude ofthe harmonics of order 6q±1 is reduced and the influence of the ratio between thestator slot pitch and the damper bars slot pitch will vanish.

Övertoner orsakade av varvtalsstyrda motordrifter ger problem i industrisystem. Syftet med studien är att identifiera problemen och ge rekommendationer för att undvika dem. Studien utfördes som examensjobb på KTH för konsultföretaget Ramböll. En litteraturstudie i ämnet kombinerades med elkvalitémätningar på drifter hos Sandvik Mining.Elkvalitéproblem orsakade av varvtalsstyrda motordrifter kommer till stor del av att frekvensstyrningen ger olinjärt strömuttag som, om nätet inte är tillräckligt starkt, påverkar spänningskvalitén. Problemen kan vara driftstopp, störd utrustning och ökat slitage på utrustning för att nämna några.Denna studie visar att vid ändringar i system innehållande övertoner kan framtida övertonshalter approximeras för vissa fall.

The aim of this project is to find a concept solution for a wireless transmitting system, installed to transmit data from a hydrophone of the ocean floor down by a wave power generator to the office on shore. The project is a literature review in which previous observations and tests are analyzed and put together to find a solution. The result was a comprehensive solution that includes an acoustic modem to transfer captured information from the bottom to the surface, wirelessly through the water. The information is then sent fron the surface on radio waves through the GSM network to the office on land. Between under and over water there are components to convert information between acoustic waves and radio waves, but also various types of modulation, such as amplitude and frequency modulation is required..

The majority of all power cuts that affects individuals and communities are caused by earth faults on the power transmission lines at 10kV and 20kV level [1]. If these power cuts could be eliminated, less disturbances and interrupts would lead to large amounts of money savings.Swedish Neutral has developed such a protection system. When an earth fault occurs power is injected into the neutral point of the transformer. The RCC (Residual Current Compensation) protection calculates a compensation current exactly 180 degrees out of phase to the fault current. Doing this, the voltage at the fault location becomes very close to zero, without affecting the power transmission.The protection system can only compensate automatically for the fundamental frequency (50Hz), and manually for the 3rd, 5th, 7th and 9th harmonics.

This report deals with the modeling of a part of the communication system based on the IEEE 802.11a standard which represents the next generation of wireless LAN with greater scalability, better interference immunity and significantly higher speed, up to 54 Mbps. 802.11a uses Orthogonal Frequency Division Multiplexing (OFDM) where modulation is performed by an IFFT and the demodulation by an FFT. After modeling the FFT in Matlab and C, the FFT implementation has been validated using a soft microprocessor core by Xilinx (Microblaze) and the results were compared..

Australia is one of the largest producers and consumers of fossil fuels in the world. In a society where the effects of fossil fuels on global warming are constantly discussed, the nation?s production and consumption are subject to debate. Problems arise when negative aspects of consumption, such as emissions of greenhouse gases, are put in relation to an increased need of energy and economic growth. However, it is important to distinguish between different types of fossil fuels when it comes to their individual impact on the environment and to analyze the possibilities to increase the more environmental friendly ones.

Ternary codes for unequal error protection is a part of a communication system where different parts of the information to be transmitted can receive different amount of error protection. There are a lot of applications where the channel conditions fluctuate so that reliable or acceptable communication can not be guaranteed. Regardless whether the fluctuations of the channel are intentional or not the idea is to let the coderate decrease so that the error correcting capability can increase for the part of the information to be more protected. By using the support, the nonzero positions of the ternary code, a new binary code can be extracted with properties different from the ternary code in the sense of cardinality and minimum Hamming distance. When the channel conditions are good the receiver decodes the message using ternary decisions and receives all information included in the codeword.

On a request from the water sewage plant Gryaab in Gothenburg a power quality survey was performed. The voltages and currents have continuously been sampled in the incoming 10 kV substation HSP01 from April-August 2008. Power quality measurements were also performed in Gryaabs other 10 kV substation HSP04 fed from HSP01 and at the terminals of the induction motor IN_PU4040 of 1.3 MW which controls one of the four large inflow pumps to the plant. The reason for the latter measurement was due to registered negative transients each time the motor was connected to the grid. The cause of the transients could be explained by the coupling in the substation, the ageing of the motor which could result in damage of the bearings or resonance in the motor circuit which amplifies high frequency harmonics.

On a request from the water sewage plant Gryaab in Gothenburg a power quality survey was performed. The voltages and currents have continuously been sampled in the incoming 10 kV substation HSP01 from April-August 2008. Power quality measurements were also performed in Gryaabs other 10 kV substation HSP04 fed from HSP01 and at the terminals of the induction motor IN_PU4040 of 1.3 MW which controls one of the four large inflow pumps to the plant. The reason for the latter measurement was due to registered negative transients each time the motor was connected to the grid. The cause of the transients could be explained by the coupling in the substation, the ageing of the motor which could result in damage of the bearings or resonance in the motor circuit which amplifies high frequency harmonics.

On a request from the water sewage plant Gryaab in Gothenburg a power quality survey was performed. The voltages and currents have continuously been sampled in the incoming 10 kV substation HSP01 from April-August 2008. Power quality measurements were also performed in Gryaabs other 10 kV substation HSP04 fed from HSP01 and at the terminals of the induction motor IN_PU4040 of 1.3 MW which controls one of the four large inflow pumps to the plant. The reason for the latter measurement was due to registered negative transients each time the motor was connected to the grid. The cause of the transients could be explained by the coupling in the substation, the ageing of the motor which could result in damage of the bearings or resonance in the motor circuit which amplifies high frequency harmonics.

On a request from the water sewage plant Gryaab in Gothenburg a power quality survey was performed. The voltages and currents have continuously been sampled in the incoming 10 kV substation HSP01 from April-August 2008. Power quality measurements were also performed in Gryaabs other 10 kV substation HSP04 fed from HSP01 and at the terminals of the induction motor IN_PU4040 of 1.3 MW which controls one of the four large inflow pumps to the plant. The reason for the latter measurement was due to registered negative transients each time the motor was connected to the grid. The cause of the transients could be explained by the coupling in the substation, the ageing of the motor which could result in damage of the bearings or resonance in the motor circuit which amplifies high frequency harmonics.

On a request from the water sewage plant Gryaab in Gothenburg a power quality survey was performed. The voltages and currents have continuously been sampled in the incoming 10 kV substation HSP01 from April-August 2008. Power quality measurements were also performed in Gryaabs other 10 kV substation HSP04 fed from HSP01 and at the terminals of the induction motor IN_PU4040 of 1.3 MW which controls one of the four large inflow pumps to the plant. The reason for the latter measurement was due to registered negative transients each time the motor was connected to the grid. The cause of the transients could be explained by the coupling in the substation, the ageing of the motor which could result in damage of the bearings or resonance in the motor circuit which amplifies high frequency harmonics.