The Swedish road transport sector relies almost completely on fossil fuels. In 2007, as much as 96 percent of the total sales of fuels was made up of petrol and diesel, while at the same time the share of total emissions of greenhouse gases in Sweden that came from road transports amounted to close to 30 per cent. Sweden is by no means worse off than any other European country in these respects. In order to address the questions of high oil dependence and CO2 emissions the European Commission has proposed a reinforcement of the legislative framework, with a 10 percent minimum for the market share of biofuels in 2020. Furthermore, the proposed target is binding for the member states, unlike the current voluntary target of 5.75 percent by 2010. More than doubling the usage of biofuels in only a bit more than a decade will most likely not be possible without policy interventions.

The biogas plant Kungsängens gård, owned by Uppsala Vatten och Avfall AB, produces biogas and biomanure from organic household waste, food processing waste and slaughterhouse waste. In year 2012, 4.4 million Nm3 of biogas were produced from 25 200 tons of waste. Before digestion all substrate is sanitized by one hour?s pasteurization at 70°C in order to kill pathogens. Another method, integrated thermophilic sanitation (ITS), is of interest in order to decrease the energy demand.

In connection with the admittance of the EC-directive (99/31/EC) in Swedish politic, through the constitution of waste depositing (2001:512) at year 2001, the rules about management the landfills and leachates tightened. At the landfill Vissberga in the municipality of Hallsberg, a leachate treatment plant was constructed just a year thereafter. This treatment plant consisted of an aerated pond with a following land treatment and a willow cultivation to replace the land treatment during the summer. In this case the parameters, which were estimated as the most important to reduce, were iron and nitrogen. The iron would react with the oxygen-rich water in the aerated pond and precipitate to ferric-hydroxide and than settle in a calm zone of the pond.

By immersion in the situation of the food production today and a historical study of how past development has led us to this point, one goal of this essay is to discuss whether the current way of farming can be applied in a sustainable future. Another objective of the essay is to study the vision Vertical farming as an alternative approach, and to focus on different aspects of this phenomenon in order to provide as comprehensive a picture as possible.The paper, thus, seeks to broaden the views for alternative approaches regarding a well-established method which we often take for granted. The aim is also to initiate a discussion around the need to also take radical ideas in regard if we want to face the future in a sustainable manner. The method is a qualitative literary study where scientific articles and papers have been used to discuss the issues: why has the idea of Vertical farming arisen, what is Vertical farming and how is the Vertical Farm meant to operate? Does Vertical farming have a place in the sustainable city of the future? For a long time us humans lived as one with nature, in a symbiotic relationship in which we gave and took as a functioning part of an ecosystem.

The examination has been performed at Bjerking AB, which is an architectural and engineering company. Bjerking AB has the ambition to be a member of Green Building.The Green Building program developed in year 2005 by The European Commission, the program is an environmental system with the aim to improving energy efficiency within the sectors of non-residential buildings. The minimum requirements to participate the program are following: in new-built buildings the calculated energy consumption must be 25 % lower than the requirements in the BBR (Building regulations) and in refurbishment the reduction must be 25 % lower than before the optimization.The aim of this study has been to examine and review the company Bjerking AB's energy efficiency work in the project of building the school/kindergarten S:ta Maria Alsike, where the goal is to get this building Green Building classed. A description of requirements to become a member of the Green Building has also accomplished in the thesis.The methods performed in this study are literature review, searches on the Internet, studies on the project database for facts/values, calculation of energy consumption and interviews of members of the Green Building. The following issues have been dealt with in the report;-          Did the building in the project manage the requirement to achieve an   energy consumption that is 25% lower than the requirements in BBR?-          What technical measures/system was selected in the building?-          What kind of cooperation was the project based on?-          What is required for consultancy companies and real estate owners to become members of the Green Building?The study of the project and calculation of estimated energy consumption in the building, give the result 47 kWh/m2, year.

A Swedish electronics company wants to make the cooling of one of their electronic components more efficient. They propose that a retrofit liquid cooler is the way to achieve this goal. The current air cooling has high energy cost due to the high amount of power needed to power fans and heat exchangers. Using high volumes of air for cooling also leads to noise pollution. The conversion from air to liquid cooling would possibly make the operation of the electronics more cost efficient and less noisy.The purpose of this project is to theoretically evaluate different concepts of drawing the heat generated by the electronic component in to a fluid, using numerical calculations in Matlab and FEM simulations in ANSYS.

The private sewage systems in Sweden releases around 600 tons of phosphorus per year, compared to about 350 tons from municipal sewage treatment plants, and they account for approximately 21% of the total anthropogenic discharge of phosphorus into Swedish waters. About 40% of Sweden's nearly 1 million private sewage systems are inferior with respect to emissions to surface and groundwater. The technology of small sewage plants is under development and knowledge of treatment effects for different solutions is poorly consolidated. Municipal authorities lack resources to keep up with the technologic development and assess the reliability of the treatment performances that suppliers report for their products. The thesis aims to conduct a market review and evaluation of wholly or partially prefabricated small sewage plants, to make it easier for municipalities and property owners to assess different technical solutions. The goal is a compilation of the products on the market, evaluated on the basis of the reliability of specified degrees of reduction.Information on sampling procedures and test results were collected through a questionnaire to all active suppliers and the responses were then used to classify the products.

This Master degree project has been performed at the Braviken paper mill on papermachine 53 (PM53) which produces newsprint paper. The current economic situationhas contributed to declining demand for newsprint, which means it is extra important tobe competitive by high energy efficiency. Particularly as energy prices are expected torise when the economic growth returns.One way to increase energy efficiency is by reducing the water use in paper and pulpmills and consequently save energy through reduced heating of water. The thesis's maintask is to evaluate whether a water purification plant (microflotation plant) forpurification of process water in PM 53 is profitable. The microflotation plant enablesreuse of warm process water instead of losing the energy to receiving waters.

Castration of dogs holds many reasons and opinions, therefore methods, traditions and rea-sons vary. The approaches have during time changed from mostly surgical castrations to also including hormonal treatments. Castration is used to control the dog's reproductive abilities, for medical reasons and to possibly rectify problems of behavioral nature. How common a particular method of castration is in a country is highly dependent on the country's traditions. In Sweden it is most common with castration for medical reasons, such as possible elimina-tion of diseases, for example, benign colorectal tumors.

The origin of the word ?communication? is the Latin word communicare, meaning to make common. The reason for our communication is to share thoughts, feelings and information, we want to affect and confirm.We are used to interpersonal communication, but even if we have had a lot of practice at it during our lives, we still find our selves facing misunderstandings and conflicts. The more people we meet during a day, the greater the chance is for interruptions in the communication.In pharmacy practice, good communication is vital for the client?s health and quality of life.

Forest streams and the associated riparian zones are sensitive to disturbances and changes that occur within these riparian areas. Particularly sensitive are small streams of low order, which will have large impacts down-stream. The disturbances that occur in the riparian zones are reflected quickly in the stream. Driving with forestry machines in the riparian zone will have detrimental effects to the soil and water. Driving the machines will lead to changes in the mineral soil composition, resulting in the reduction of porosity, less infiltration, compaction, and an increased bulk density.

The fragmentation and reduction of deciduous forests in Sweden is threatening many species. Particularity worrying is the loss of broad-leaf trees, since a diversity of species is often associated to them. Today many deciduous trees are situated along the border between forested and open areas, and these small fragments can be important for biodiversity.The aim of this study is to analyze if wildlife management can affect the variation of deciduous trees and bushes in the landscape. In brochures and literature Svenska Jägareförbundet (the Swedish Association for Hunting and Wildlife Management) recommend hunters and landowners to promote deciduous trees ? often broad-leaf trees ? as wildlife management measures, while the Swedish forestry laws can be sensed as unclear regarding the treatment of these trees.Five properties in Södermanland, Sweden, were chosen as study areas and inventoried in respect of trees and bushes in September 2013.

Background: Myocardial infarction is the most common individual disease among people in the west world. In Sweden there are over 50 000 women and men who get myocardial infarction every year and about 40 % of them dies. Exercise training is one part of cardiac rehabilitation and since 1980 Sweden use the guidelines from that time. Aim: The aim was to review exercise-training modalities in cardiac rehabilitation after myocardial infarction and the physiologic- and psychological effects. Method: Facts were obtained by searching through the database PubMed for articles published from 1994 and ten years forward.

Abstract Cavities used to be a very common problem but over time humans have learned to take care of their teeth. However, there are still many who have problems. This problem is due to microorganisms and in particular the various streptococci and lactobacilli producing acids which loosens up the enamel on teeth. These bacteria can be found at various places in the mouth and saliva. Besides being a discomfort it can be a major problems and the damaged tooth needs to be removed or make a dental filling. The aim of the study was to see how intake of probiotic tablets containing Lactobacillus reuteri PTA ATCC 5289 and Lactobacillus reuteri DSM 17938 affects the levels of oral Streptococcus mutans and lactobacilli over a three-week period.

Emhart Glass AB är en världsledande internationell tillverkare av automatiska glasformningsmaskiner för framställning av olika glasprodukter bl.a glasflaskor och glasburkar. Emhart Glass AB har i dagsläget 14 kontor i 10 olika länder och är sedan 1998 ägt av Bucher Industries. Den svenska divisionen är uppdelade i två enheter. I Örebro tillverkas maskindelar, reservdelar och strategiska komponenter. Komponenterna skickas sedan vidare till Sundsvall för del- och slutmontage.På Emhart Glass Sweden i Örebro har det uppmärksammats att långa ställtider förekommer vid vissa maskingrupper.