The company Olofsfors AB manufactures drive belts for forest machinery, known as ECO-Tracks, and abrasion-resistant steel and cutting edges for graders, excavators and tractors, known as Bruxite and SharqEdges. Manufacturing these products requires the steel to be heated and molded, then submerged in water and hardened. The water used in the hardening of steel is pumped to the process from pits below the floor and then pumped back to the pit after it?s been used. Since the temperature of this water rises after being used to harden the steel the temperature of the pumping pit needs to be adjusted to maintain its setpoint of 21°C.

With numerous applications in both military and civilian life, the demand for accurate 3D models of real world environments increases rapidly. Using an airborne laser scanner for the raw data acquisition and robust methods for data processing, the researchers at the Swedish Defence Research Agency (FOI) in Linköping hope to fully automate the modeling process.The work of this thesis has mainly been focused on three areas: ground estimation, image segmentation and classification. Procedures have in each of these areas been developed, leading to a new algorithm for ground estimation, a number of segmentation methods as well as a full comparison of various decision values for an object based classification. The ground estimation algorithm developed has yielded good results compared to the method based on active contours previously elaborated at FOI. The computational effort needed by the new method has been greatly reduced compared to the former, as performance, particularly in urban areas, has been improved.

I have in my thesis, examined the possibilities in terms of energy for a condominium association.To have an effective and good energy is becoming increasingly important with today's rising electric and oil prices. In my thesis I have used the condominium association Kärralyckan, which is situated in Falkenberg. The buildings at Kärralyckan are built in the mid-1970s, and are heated by electric radiators. The tap water is heated by an electric boiler.Based on that calculation I can show the various energyststem. The different solutions have been developed by contact manufacturers and installers through phone calls and e-mail.According to the results shows that geothermal heating has been a great solution for Kärralyckan.

The main purpose with the project has been to approximate the magnitude of the pollution transport from the actual road surfaces and to get an approximation of the possibility to collect the pollutants to reduce the load to the water and improve the water quality.The quantity of pollution transport from the most trafficated roads areas in Örebro city has been calculated. Roads whith a traffic exceeding 10 000 vehicle/day. The study has been done with the calculation tool StormTac. Through analysis of traffic loads and road surface, which together with a different kinds of parameters gives an approximation of the pollutant transport.The calculation has included some metals and other substances in the stormwater and has also included the present of suspended solids. Included the overall study, some smaller areas has also been calculated for the possibility to remove pollutants.The work also includes calculation for three different areas for stormwater treatment.

This report is about the impact climate change has on the water and sewage systems in general, and the situation in the municipality of Karlstad in particular. Which vulnerabilities are linked to water and sewage systems with regard to climate change and extreme weather situations, what are the possibilities to adapt the system to this and what significance does climate adaptation of the water and sewage systems have in relation to sustainable development?To answer these questions I have studied literature on the subject and interviewed several people who work with these types of questions. The answers I have received state that there are a multitude of vulnerabilities linked to the water- and sewage systems, but that there are also many strong interests which strive to take measures and adapt to a changed climate. I have also come to the conclusion that the starting points and views of the possibilities to act differs between the people that I have interviewed, but that theses problems are built into the concept of democracy..

This Master degree project has been performed at the Braviken paper mill on papermachine 53 (PM53) which produces newsprint paper. The current economic situationhas contributed to declining demand for newsprint, which means it is extra important tobe competitive by high energy efficiency. Particularly as energy prices are expected torise when the economic growth returns.One way to increase energy efficiency is by reducing the water use in paper and pulpmills and consequently save energy through reduced heating of water. The thesis's maintask is to evaluate whether a water purification plant (microflotation plant) forpurification of process water in PM 53 is profitable. The microflotation plant enablesreuse of warm process water instead of losing the energy to receiving waters.

When stormwater occurs near human activity the water gets polluted. The purity and composition vary widely depending on the types of activities in the area, the type of surface the water comes in contact with, precipitation and many more parameters. It has long been known that stormwater quality can affect both human health and the environment as stormwater is a major contributor to pollution of receiving waters.A human activity that has an impact on the environment in several different ways is traffic and stormwater is no exception. Airborne gases that react with precipitation, oil leaks and fuel systems that drops down on the ground, metals from brake linings and rubber particles from tire wear are some of the aspects you have to take into account when categorizing the relationship between traffic and polluted stormwater.In this project, stormwater samples from a parking lot in Halmstad, Sweden were collected and analyzed with an atomic spectrophotometer. The presence and relationship between copper, cadmium and zinc with different rainfall parameters have been studied.

Lake lowering in sulphide-rich areas is currently a major environmental impact for surface water. This study focuses on whether there is a relationship between a gradient of lake lowering and surface water impacts in areas of sulphide-rich sediments, in order to better understand their contribution of heavy metals and sulfuric acid. Also, is it a reasonable method to use the reduced lake area in order to quantify the gradient? The survey was conducted by collecting water samples from reference lakes and lowered lakes from south to north in coastal areas within the county of Västerbotten. Water samples were then analyzed for TOC, pH, conductivity, anions, base cations, alkalinity, acidity, sulfate, Al, Cd, Fe, Mn, Cu, Zn and Pb.

ICA vill utveckla sitt miljöarbete i vattenfrågor. Denna rapport syftar till att öka medvetenheten hos ICA om verksamhetens miljöpåverkan genom att analysera vattenfotavtrycket ? vanligen kallat Water Footprint ? för ett livsmedel. Vattenfotavtryck är ett verktyg inom miljösystemanalys som används för att kartlägga sambandet mellan produktion och konsumtion av produkter och vattenanvändning. Studien visade att vattenfotavtrycken är ungefär 14 500 liter/kg och 16 500 liter/kg för svensk respektive irländsk nötfärs.

Amongst the published literature researching wet cleaning of paper there is a limited amount of studies conducted researching the method simmering water treatment. There are even less studies conducted on how simmering water affects the paper being treated when used as a cleaning method. Despite the limited research, there are literary reviews describing the method and suggesting it as an alternative for conservation of paper with iron-gall ink. The following study will therefore be examining, the somewhat unusual method, simmering water treatment, and comparing it to one of the more common wet cleaning methods: immersion washing. This is done to compare how the different temperatures of the water affect the paper. The types of paper used in this study consists of three dyed and four undyed papers. All of the papers are new, apart from one sample originating from 1847.

An increasing number of heat pump producers have developed heat pumps that can be connected to solar panels. In this thesis we have examined the possibilities of connecting solar panels to existing ground source- and geothermal heat pumps that has not been adapted to solar panels. During the work process, a prototype plant has been built to compare our theory with the practical results and with our designed sizing tool. The work has rendered in knowledge that will be used to build a sun module that can be easily connect to the existing heat pump system. The existing heat pump, our test plant, has been supplemented by an advanced storage tank used to allow different operating modes.

Floating housing is a concept gaining ground in Sweden. The dwellings are different in many ways from traditional homes, not only regarding flotation, but also several other technologies. The purpose of this thesis is to emphasize the qualities that exist in living on water. The ambition was to present a proposal for a floating residential area located in Jönköping, containing homes of varying sizes, and to present their technologies. In order to find inspiration and solutions studies have been made on existing floating homes in Stockholm and Kalmar, focusing on their technical and functional solutions.

The company Olofsfors AB manufactures drive belts for forest machinery, known as ECO-Tracks, and abrasion-resistant steel and cutting edges for graders, excavators and tractors, known as Bruxite and SharqEdges. Manufacturing these products requires the steel to be heated and molded, then submerged in water and hardened. The water used in the hardening of steel is pumped to the process from pits below the floor and then pumped back to the pit after it?s been used. Since the temperature of this water rises after being used to harden the steel the temperature of the pumping pit needs to be adjusted to maintain its setpoint of 21°C.

The environment that surrounds us affects us all. Research has shown that we feel physically and emotionally best in natural environments with greenery or water elements. Urban environments are likely to be more stressing then natural environments. How we experience specific elements, as water, of an environment is not as much investigated. There is a need of further knowledge for us to fully understand the interplay between our senses and the environment. Human beings have always been depending on water and the search for it has characterized our deeds and doings through out evolution.

In the production of pulp, paper and cardboard, a large amount of water is used daily. The water has to be purified in the internal purifying plant before it reaches the receiving body of water. In the biological purifying stage at the Stora Enso Skoghall mill, an aerated basin is used where the microorganisms, using oxygen, oxidize the organic material to carbon dioxide. The air is pumped from the bottom of the basin and the oxygen can then be transported from the air bubbles to the water through diffusion. The problem with aeration of waste water from the forest industry is that wood residues, such as fatty acids, are making the transport of oxygen in water more difficult.