The energy consumption continues to increase as the use of electronics and energy consuming equipment increases. The use of fossil fuels has to be phased out for this to be sustainable in the long run while the use of renewable energy continues to increase. A renewable energy source is solar energy but the production of heat and electricity are today very expensive compared to other energy sources and an important task for the solar energy market to grow is therefore to minimize the production cost of the solar collectors while increasing its efficiency to produce heat and/or electricity. One way to convert solar energy into heat is by using solar collectors and electricity can be produced by utilizing the produced heat, or by applying solar cells.This thesis aims to recommend a reflective material for the next generation solar collectors from Absolicon and to recommend a commercially available coating for the receiver tube of the solar collector. A market study has been carried out to investigate the cost-related aspects along with the optical and durable aspects for the optical material of the solar collector.

The Swedish pulp and paper industry meets higher demand for energy efficiencyi mprovements with increasing energy prices and changes in the Swedish renewable energy certificate system. One action of energy efficiency improvement is by using secondary heat, that otherwise would have been treated as waste heat, for use in a system with lower temperature demands. The aim of this Master´s thesis is to identify possible secondary heat sources in a typical Swedish pulp and paper mill and to investigate what economic benefits the secondary heat will provide when being used for pre heating of wood chips to a kraft digester.The Master´s thesis focuses on three secondary heat sources; dry warm air, warm water and moisture saturated warm air located inside the pulp or paper mill. Two types of kraft digesters are simulated within this study, a typical Scandinavian digester and a modern twin vessel steam phase digester.Due to quality aspects and low temperature level drying is the drying technology with dry warm air rejected. Using warm water in direct contact with wood chips increases the quantity of water to the evaporation plant and thus reduced pulp or paper production and is therefore also rejected.

In this report a study has been done regarding different heating systems on which are the mostcomprehensive with solar heating systems. The report has also been focusing if solar power can beused as a primary heating source for supplying more than 50 % of the buildings total heatingproduction. The University of Dalarna constructed a demo-house for this purpose and according tocalculations the total solar usage is more than 50 %. This house has been made for referenceregarding the design of the heating system of property 5:37.Further studies have been made to compare different heating systems that are compatible with asolar system, where the compared systems purpose is to be independent of direct using electricity. Asystem of this design is regarded as sustainable according to environmental as economic issues.

Today many buildings and it´s nearby surroundings are designed to achieve some kind of environmental goal.The issue concerning energy consumption is currently at focus and it is relevant that we start increase the share of renewable energy. Solar energy is an infinite resource and should therefore be considered when selecting an energy supplier. Uppsala University hospital is facing major restructuring when parts of the existing buildings will be refurbished and a large new building will be constructed. White Architects have developed a study concerning the new building and for some of the existing buildings on the hospital campus. Uppsala County requires tough energy measures and wants the new building to be classified as an eco-building in Whites following work. The classifications will involve high energy source requirements. This work has been conducted to see if solar power can be envisaged as a supplementary energy source for the University hospital and also to investigate the aesthetic impact of solar cells on the new building.

A possible way to reduce pollution and slow down the process of global warming is to increase the usage of renewable energy sources. One of these renewable energy sources is solar power. With the aid of solar panels and solar cells the energy from the sun can be transformed into both heating and electricity. The requirement to use the sun in this fashion is a suitable surface, for example a big roof, an angle between 40-60 degrees and that the surface should be exposed to the south. Almost every farm meets these requirements.

The purpose of this thesis is to investigate and clarify the facts surrounding one of Vattenfall's district heating plants; The "solar field" and associated rock cavern in Lyckebo, Storvreta. The plant was built in the '80s by the formerly municipal utility,Uppsalakraftvärme AB, as an experimental building. A ground water filled cavern would serve as seasonal storage of solar heat from an adjacent solar field. Since both the energy company and the facility itself has undergone major changes over the past 30 years, there was a great need to gather facts in order to provide a picture of its current condition and potential for continued use. The thesis investigates the plant's history and problems with the rock cavern losses, and how the operation developed. It also presents the calculations regarding the possibilities of again supplementing the facility with solar energy - which is not the case today - as well as the economic conditions for it. Regarding a re-launch of solar energy, primarily a concentrating solar collector has been studied, as it has the advantages of an integrated control system.

The purpose of this thesis was to make an energy survey and quantify energy flows of individual unit operations associated with the biogas production in Uppsala Vatten och Avfall AB:s biogas plant, located at Kungsängens gård. Moreover, large consumers of energy would be identified and analyzed. The objective of this energy survey was to obtain a detailed understanding of the energy use in the biogas production. The energy survey was divided into two parts: electricity and heat. Each part was treated separately and with somewhat different approach. To estimate the electricity usage during the projcet the rated power of each selected unit operation was noted and multplied with the measured time of usage.

The purpose of this thesis was to make an energy survey and quantify energy flows of individual unit operations associated with the biogas production in Uppsala Vatten och Avfall AB:s biogas plant, located at Kungsängens gård. Moreover, large consumers of energy would be identified and analyzed. The objective of this energy survey was to obtain a detailed understanding of the energy use in the biogas production.The energy survey was divided into two parts: electricity and heat. Each part was treated separately and with somewhat different approach. To estimate the electricity usage during the projcet the rated power of each selected unit operation was noted and multplied with thenmeasured time of usage.

The aim of this thesis is to investigate the electric solar potential on the Swedish island Gotland. The Gotlandic habitations have been divided into four house categories. For each category energy demand, roof area, geographic orientation androof tilt have been decided. Solar radiation data have been collected from the Swedish solar radiation model STRÅNG (STRÅNG, 2012).The buildings characteristics and the solar radiation have been used as input values in common solar formulas, the solar potential for each building category have been summed up to a total electric solar potential for the region.The electric solar potential on Gotland was calculated to 242 GWh/year with solar data from 2010. Gotlands largest city, Visby, is marked as cultural heritage by UNESCO (UNESCO, 2012).

Uppsala County has ambitious environmental aims for the planned residential area inÖstra Sala backe. In this thesis different energy sources have been evaluated todetermine which system that would be most favorable given currently availableinformation about the project. Planned energy usage has been divided into tap waterheating, space heating and power. Three base case scenarios were made with districtheating, small scale bio fuel and heat pump. Solar power and solar heating were thensimulated and the production from the two could individually be deducted from theenergy need in the base cases, constituting 9 different scenarios.

Suggestion for a new operahouse in stockholm, förslag på nytt operahus i stockholm. Stockholmsoperan..

Problems with the current energy system, which partially relies on non-renewable fuels, are increasingly recognized. Emissions of greenhouse gases from fossil fuels may speed up global warming, which in turn leads to a number of negative consequences. Nuclear energy is risky and relies on consumption of a scarce resource. This leads to a demand of renewable energy that is also economically feasible. One possible renewable source of energy is solar energy.

Along with rising energy prices and increasing awareness of environmental issues, the criteria for buildings energy performance have been sharpened through the years. Today, ?passive house? and ?low energy house? are commonly used phrases in the construction industry and is expected to become increasingly common in the future.For houses with well-insulated building envelope the importance of well constructed details increases when minimizing the heat losses. Examples of these details are floor-wall junction and window openings in the wall. In such connections thermal bridges occur, which means that heat more easily is transported out of the building, compared to the rest of the building envelope.This report deals with detail solutions around windows and a comparison between a traditional slab and a foundation from Koljern consisting of foam glass.

The high level of energy consumption that the industrialised countries have reached and thepollution that this brings has long been a cause for analysis and debate, development and usageof so called renewable energy sources is therefore more important than ever. The energy in theelectromagnetic radiation from the sun is an interesting alternative. One way of harvesting thisenergy is by using solar cells, devices that generate DC current when exposed to electromagneticradiation.The goal of this master?s thesis was to design a solar powered power supply to Syntronic AB?sMidrange platform. The envisioned application is a stand-alone distributed embedded system,for example a node-based temperature monitoring system.

Overall aim of this master?s thesis is to describe and identify perceived barriers in Swedish businesses within solar energy field and analyze, based on four theoretical viewpoints, how these barriers can be handled. In other words how can the barriers be overcome or eliminated to better succeed in the commercialization process? The method applied is qualitative in which data has been collected through phone interviews originated from seven Cleantech businesses which operate within solar energy. Furthermore this thesis has a descriptive- and an explorative purpose.