Fuel pellets are a refined bio fuel mostly consisting of residues from sawmills and wood industry. At Rindi Västerdala AB's combined bio energy plant in Vansbro fuel pellets are produced, while the waste heat from the process is used for district heating. The pellets are produced from sawdust, wood shavings and dry wood chips that is dried, milled and pressed into small cylindrical rods. The advantage of refining the wood material in this manner is that the energy value is greater per unit volume and unit weight, thereby the cost of transportation per energy unit is reduced. Also, less storage space is needed.Pellet manufacturing is a complex process since many parameters affects the final results.

The purpose of this thesis is to investigate and clarify the facts surrounding one of Vattenfall's district heating plants; The "solar field" and associated rock cavern in Lyckebo, Storvreta. The plant was built in the '80s by the formerly municipal utility,Uppsalakraftvärme AB, as an experimental building. A ground water filled cavern would serve as seasonal storage of solar heat from an adjacent solar field. Since both the energy company and the facility itself has undergone major changes over the past 30 years, there was a great need to gather facts in order to provide a picture of its current condition and potential for continued use. The thesis investigates the plant's history and problems with the rock cavern losses, and how the operation developed. It also presents the calculations regarding the possibilities of again supplementing the facility with solar energy - which is not the case today - as well as the economic conditions for it. Regarding a re-launch of solar energy, primarily a concentrating solar collector has been studied, as it has the advantages of an integrated control system.

The energy consumption in the sectors of residential and public buildings is 40 % of the total energy consumption in Sweden. The main part, 85 %, of the energy use in these sectors is for operation of the buildings. The rest is used in the building process. When energy-efficiency measures are taken the energy use during the operation time decreases and the fraction of energy consumption during the building time increases. This project is carried out in cooperation with JM AB and concerns the energy use during the building time of production of blocks of flats at the building site.The main part of the electricity that is used during the production of apartment buildings goes into the heating of portacabins and illumination of the building during the construction phase.

In a sustainable society the use of renewable energy and recycling of materials is of high importance. Wastewater treatment plants use large amounts of energy in the processing of wastewater. This study seeks to evaluate wastewater as an energy resource and to examine treatment plants potential to become sustainable energy producers. The study is based upon the internal processes of Himmerfja?rdsverket.

Problems with the current energy system, which partially relies on non-renewable fuels, are increasingly recognized. Emissions of greenhouse gases from fossil fuels may speed up global warming, which in turn leads to a number of negative consequences. Nuclear energy is risky and relies on consumption of a scarce resource. This leads to a demand of renewable energy that is also economically feasible. One possible renewable source of energy is solar energy.

Industries with energy costs as a large proportion of their total costs are greatly affected by the instruments deployed to cope with the Swedish climate and energy policy goals. With energy costs representing more than 30 % of the total costs, tomato cultivators are one of the affected industries. In order to remain competitive with other countries, a more resource- and cost-efficient cultivation of tomatoes in greenhouses is desirable in Sweden. Based on the concept of industrial symbiosis, this study investigates the prerequisites for a resource-efficient production of locally grown tomatoes in Sweden through the utilization of low grade industrial waste heat. The study is based on the foundry industry as the supplier of waste heat.To investigate the environmental, technical and economic potential of the exchange of waste heat, a comparative life cycle assessment, an inventory of the supply of industrial waste heat in Sweden, a compilation of potential technologies for the recovery of low grade industrial waste heat for heating greenhouses and a comparative life-cycle cost calculation were carried out.

With increased deployment ofintermittent renewable energy, such aswind and solar power, energy storagebecomes necessary to help reduceproduction peaks. Thermoelectric EnergyStorage is a method still in researchphase, which stores electricity in hotwater at a temperature of 120 ° C. Thisthesis aims to examine whether theThermoelectric Energy Storage would bepossible to integrate into existingpower generation such as a combined heatand power plant, and how the technologypotentially could function in theelectricity market. ThermoelectricEnergy Storage consists of a chargingprocess and a discharging process, bothoperating by the working fluid CO2. Toincrease the efficiency of theThermoelectric Energy Storage, wasteheat from the district heating networkis integrated.A model of the Thermoelectric EnergyStorage has been developed and it wascalculated by thermodynamic propertiesof the working fluid, CO2, in thevarious process steps.

Aeroseum is an aviation museum located in an old military underground hangar. The ventilation system in the hangar is designed for the military purpose of the hangar. This design includes a solution with air flowing through the space between the construction of the hangar and the rock surface. The solution is intended to avoid a buildup of inflammable gases. This design leads too high humidity levels in the hangar.

This thesis work has been carried out at the consultant company Pöyry Sweden AB in Norrköping, whom performs the task for E.ON heating Sweden AB, Händelöverket in Norrköping. The report shows methods to manufacture slurry consisting of fly ash and water. The slurry shall be pumped into several former oil storage rock shelters that E.ON has put into operation for the specific purpose. The ash mixture also develops hydrogen gas in contact with water.The work has aimed to produce different suggestions of methods and equipment that can be used for the objective. Mixing method and security issues were in centre while working with the suggestions.

The purpose of this master?s thesis is to contribute to the development of business relationships between a supplier and its customers. The research area and research problem was further developed into three research questions. The research questions concerns the following subjects: the substance of business relationships and dimensions within relationships management that can be used in order to contribute to the development of a company?s business relationships.

Traditionally, rolling mills use emulsions based on a mixture of oil and water for lubrication. Since two years ago SAPA has been using (instead of oil) a synthetic lubricant so called conditional emulsion for hot-rolling of aluminum. This lubricant is water based and homogenous at ambient temperature, but switches to a two-phase system at heating above the cloud point.This project aims to validate and if necessary modify an existing HPLC method for quantifying two out of three key components (A, B and C) in the conditional emulsion. Attempts to develop a method to quantify the pH adjusting components, X and Y were also made. These two methods are required to optimize the lubricant.Due to the complexity of the components, it has been difficult to present a method for quantification, and HPLC with ELS detection was chosen after a long series of trials.

Med ett energikombinat vid Lillesjöverket vill Uddevalla Energi energieffektivisera samt sänka temperatur på återkommande fjärrvärmevatten, för att kunna utnyttja rökgaskondensorn effektivare. Uppdraget var att utreda mängden tillgänglig energi under sommarhalvåret och utföra en matematisk kalkyl som ska ligga till grund för val av tork. Valet stod mellan två alternativ av tork där storlek på värmeväxlararea och investeringskostnad skilde dem åt. Sedan följde dimensionering av fjärrvärmeledning samt cirkulationspump från fjärrvärmenätet till tork. Syftet var att ge Uddevalla Energi ett tekniskt beslutsunderlag för val av storlek på tork samt dimensionering av energiöverföring till densamma.

This report describes the construction of a climate-cabinet for testing of HV-cards (High Voltage) produced at VG Scienta. The main part of the report describes all the different components of the cabinet. The most important parts are a PID regulator from Eurotherm model 2408, a solid state contactor (SSC), a thermocouple, a finned resistor from DBK and different fans. The report even includes the connection between components by cable wiring, isolation, grounding, fuses and shaping of metal goods.As the cabinet also communicates with a computer, the report includes the solution of the data communication using the software iTools from Eurotherm. The communication part includes information about a converter that converts EIA422 to USB.The cabinet was produced at a company, called VG Scienta, in Uppsala during the spring 2010.

This study has been carried out in the spring of 2014 on behalf of PQR Consult AB in Stockholm. The aim of the study has been to analyse the energy usage of the building Skarpövägen 1 in order to explore the possibilites of saving energy by using appropriate equipment. These possible solutions have been simulated by using the programe IDA Indoor Climate and Energy, combined with a life cycle cost analysis. The laundry building, Skarövägen 23, has also been analysed due to its high amount of energy usage. The result of the energy analysis showed that the energy usage was much higher than the energy declaration.

This report contains a study of replacing nuclear power with biofuel. The nuclear plant, OKG north of Oskarshamn in Sweden has been chosen and an extensive literature study about the nuclear plant has been implemented. The main aspect of this report is the availability of biofuels and whether it would be economically sustainable. Sweden?s most common biofuels are examined with regard to scope of use and potential.