Title:Chillchain for cut flowers ? how the distribution works.Author:Anna-Maja Svarén, student at Lund Institute of Technology, mechanical engineering.Supervisors:Annika Olsson, Department of Design Sciences.Bengt Sahlberg, Bioett AB.Problem:How does the distribution of cut flower works regarding temperature, losses, responsibility, complaints, packaging and weak points?Purpose:The purpose is to map the distribution of cut flowers, with focus on losses in the temperature, from farm to store. The goal is to identify weak points in the chillchain and to se how wrong temperatures affect the flowers. The results can be a help to secure the chillchain.Method:The work started with a problem; map the distribution of cut flowers with focus on temperature losses. Data was collected on the basis of this problem, then analysed, and finally conclusions were drawn.Conclusions:The affect handling and distribution has on a cut flower is very complex.

The division of Engineering Materials at Linköping University, department of Management and Engineering, conducted a research project concerning Fatigue life of thermal barrier coatings during 2009. During this project equipment to provoke these fatigue failure by rapidly heating and cooling test subjects in cycles, was ordered.Design and manufacturing of the equipment was handled internally at LIU.The equipment was built using a furnace that is lowered and raised over the table where the test subject is placed. To keep the temperature of the furnace a lid slides in place to close the downward facing opening of the furnace when it is in the raised position. On this door there is nozzle that is used to cooling of the test subject by air.To make sure that the equipment can work independently you need an automation controller that can evaluate if movement can occur without danger of collisions. The control system also needs to monitor that all elements are performed according to plan.This degree project is based on a modular system from OPTO 22 and includes the configuration of a PLC that will be supplied with logic and a user interface.The degree project resulted in a graphic interface in which a user can set desired values for different parameters and get information about current values for them.

Uppdraget som gavs av Brimer VA Produktion AB i Osby var att ?föra fram deras nya vattenledningssystem i ljuset?, göra en FEM-beräkning på en detalj i systemet och ta fram en ekonomisk samt teknisk jämförelse mot det traditionella vattenledningssystemet. Bästa lösningen på uppgiften var att visualisera vattenledningssystemet med hjälp av animerade filmer. Detta med tanke på att visualisering har ingått till stor del i utbildningen Virtuell Produktutveckling & Design..

In this essay I discuss and analyse if we can witness any signs on regional dimension due to regional representation from our elected representatives in the five constituencies Malmö, Blekinge, Norrbotten, Uppsala and Stockholm. Two seperate terms of office between 1991-94 and 1998-2002 has been compared. In political science there has been much debate about the relationship between voters and their elected. By measuring each and everyone elected representatives in the work of produce introduced bills towards their own constitiency during both terms I have tried to see if there is an occurence of a regional dimension.The theory that´s been applied is based on geographical representation where one might aspect that central metropolitan areas and peripheral regions is somewhat over-represented in legislatures. By using a method of comparison between the five chosen constituencies and theirs elected representatives I have come the the conclusion that there is a weak tendency that this might be the case seen to a regional dimension perspective..

Grundtanken med detta arbete är att se om utomhuspedagogik möjligtvis främjar lärandet och om det går att finna stöd inom neurologisk forskning för att ta reda på om lärandet stimuleras vid användandet av utomhusundervisning. Undersökningar har genomförts för att se om lärare och elevers syn på utomhusundervisning sammanfaller. Arbetet bygger på litteraturstudier, intervjuer, en observationsstudie, samt enkätundersökningar för att besvara forskningsfrågorna. I denna studie har det framkommit att utomhusundervisning främjar lärandet, främst beroende på de multipla sinnesintryck som utomhusvistelsen skapar. Denna iakttagelse stöds även av neurologisk och pedagogisk forskning.

Grunden för examensarbetet är den tävling om nytt stadsbibliotek i Stockholm som Stockholms stad utlyste 2006. Det nuvarande stadsbiblioteket från 1928, ritat av Erik Gunnar Asplund, är en av Sveriges mest kända byggnader. Uppgiften har varit att rita en tillbyggnad som kan bilda en helhet tillsammans med det nuvarande biblioteket. Det har handlat om att först värdera det som finns idag och sedan tillföra något för framtiden..

In the beginning of the 21th century several successful companies filed for bankruptcy. These bankruptcies have been known as large accounting scandals and the largest scandals did Enron and Worldcom stand for. These bankruptcies arose without any warning signal from the auditors about the companies? financial problems and their inability to continue as a going concern. The bankruptcies damaged the reputation of auditors and broad criticism has developed at the auditors? inability to discover companies? financial problems and their unwillingness to reveal a going concern opinion in the audit report.

A today common soil reinforcement method is the installation of lime-cement columns. Lime-cement columns have been used since the 1970?s and have been a useful method for stabilizing soil at great depths. It is mostly used for stabilizing road and railway embankments because the method is economically viable and the columns are easy to install. The total costs for the installation of the lime-cement columns is dependent on the numbers of installed columns, what percentage of lime and cement that has been used and the pattern in which the columns has been installed.

The thesis demonstrates protection solutions that can be suitable for a camp during internationalmissions in order to resist complex threats. The threats could consist of small arms, machineguns,RPG 7, anti armour missiles, mortar, artillery, HPM-weapons, car bombs, biological and chemicalweapons as well as sabotage and theft. It?s not the technology itself that makes the threat scenariocomplex it?s the way the opponent acts during the operations. The opponent acts usually incivilian clothes and therefore he is difficult to distinguish from other civilians.

This study is concerned with the region of Öresund and the aspects of work commuting in particular. The purpose is to investigate attitudes and opinions towards the region among work commuters and then apply them to various theories relevant for the questioning, such as globalization, regionalization, ethnicity, nationalism, culture and identity. To investigate the attitudes towards the region we have done a number of interviews with commuters, using qualitative and semi-structured questions. The analysis is divided into three different parts; In Body and in Mind, Us and Them, the Future; and consists of a discussion of our informants? answers related to the theoretical aspects of the earlier mentioned theories.

This thesis has been performed at consulting firm Sweco Position in Jönköping. The thesis is divided into two main sections: theoretical and practical. The theoretical section contains an investigation into the possibilities of implementing a geographical information system (GIS) for administrations of wells with the integration of Bing Maps for Windows 8 and Windows Phone 8. The practical work comprises the development of a prototype for Windows 8 and Windows Phone 8.The students review the Model-View-ViewModel-pattern on a theoretical basis, compares the differences between Windows 8 Pro and Windows RT. The thesis also contains and investigation into the pros and cons of a web based application compared to a native one.The result of the thesis will be comprised of a GIS-service developed in C# in co-operation with XAML with the options of saving data locally and a WMS-based service layer for Windows 8 and Windows Phone 8..

The purpose of this thesis is to examine and present the oportunities of solvingcontrol problems using Modelica. This is done by creating some demonstrationexamples with exercises. These examples should cover as many types of controlproblems as possible. The exercises are aimed for people with basic knowledgein modeling and automatic control engineering but with little or no knowledgein Modelica. There are different types of Modelica implementations and the onesused in this thesis are OpenModelica and MathModelica..

AbstractA continuous improvement of products and production is an important goal for a modern industrial company. A small engineering group located in Sweden came in touch with the authors of this report during the spring semester of 2014. The aim of this report is, as part of the group´s ambition of improvement, to analyse ways in which the quality of component casted parts can be verified. Non-destructive testing (NDT), and methods to use it for quality control, is the main focus of this report. However, fields such as material standards, component casting and quality engineering are analysed as well.

This master thesis encompasses an inventory and risk classification of four disused landfills within the municipality of Uppsala, Sweden. The model of the classification; ?Method of Surveying Contaminated Sites? is developed by the Environmental Protection Agency and can be used as a framework to investigate and describe the environmental damage and the level of risk for each object. The risk classification model has a rating from 1 to 4, where 1 represents a very high risk while 4 is a small risk. Risk class depends largely on the type of land use that exists on the object, and hence, various benchmarks must be taken into account.

Master thesis for Mechanical engineering, at the University of Lund. Incorporated in project Pondora.The purpose of this master thesis is to compare the existing one way packaging system with a proposed return crate system not yet available in Sweden. The comparison is focused on packaging handling in the grocery store.The purpose is also to investigate how operating return crate systems in Norway and Finland function, identify, the problems they have encountered and survey economic and technical aspects. The knowledge we hereby have acquired was subjectively evaluated in the thesis.The Swedish survey has a focus on meat and bread. The surveys in Finland and Norway contain all the products utilizing the studied return crate systems.We have surveyed how the handling of transport packages for meat & provision and bread is done in the store.