Sökresultat:
1846 Uppsatser om Functional requirements - Sida 20 av 124
Webbgra?nssnitt pa? pekska?rmsdatorer : En anva?ndarstudie av webbplatser pa? Ipad
Nowadays, the establishment of new touch screen technology has changed significantly the way we navigate on the Internet. The requirement to design websites that adapt to various artifacts such as touch screen computers are increasingly a need to consider. The purpose of this study is to discover - What are the specific usability requirements should be addressed in designing of websites for touch screen computers? - In order to examine the essay?s question, it presents a study where five people visiting three different websites on the touch screen computer Ipad. The study was conducted using a participant and structured interview observation in form of a think-aloud method.
Hållbarhetsredovisning i svenska företag: - utveckling, trender och drivkrafter
This study aims to investigate development and reasons behind sustainability reporting in large Swedish companies. By examining 15 companies? environmental and sustainability reports between the years 2000 and 2008, data was collected on matters such as frequency, scope and design. Identified trends were to a large extent in line with previous studies on international development; sustainability reporting is growing in several aspects. The authors have found one major reason for this development to be increasing requirements and expectations from stakeholders and a need for companies to legitimize their actions.
Verksamhetsanalys Jämförelse mellan IAEA och OKG AB inom E.ON-koncernen
The safety and safety work on OKG, Oskarshamns Kraftgrupp, is supervised by SKI, Swedish nuclear power inspectorate. The task of SKI is to inspect that the nuclear power plants of Sweden runs in a safe way. The proprietor of the permit who runs nuclear power plants has the responsibility to maintain the required safety to run a plant. SKI publishes a number of statue books that OKG has to meet to be able to run the plants. SKI recommends in SKIFS 2 004:1, that OKG work with the safety requirements of IAEA.
Direktsamplande digital transciever
Master thesis work at ITN (Department of Science and Technology) in the areas of A/D-construction and RF-circuit design. Major goal of project were to research suitable possibilities for implementations of direct conversion in transceivers operating in the 160MHz band, theoretic study followed by development of components in the construction environment Cadence. Suitable A/D- converter and other important parts were selected at the end of the theoretic study. Subsampling technique was applied to make A/D sample requirements more realistic to achieve. Besides lowering requirements on A/D-converter it allows a more simple construction, which saves more components than subsampling adds.
Byggutbildningen : En undersökning av före detta elevers åsikter om byggutbildningen
How do we match our education with the needs of the construction line of business and the requirementsof the Swedish National Agency for education? Is there something that we have to change?In this study I have asked our former students about their opinion of our education and I have also asked them to give me their view on what a good teacher is like. I have been able to benefit a lot from their answers in my efforts to be that good teacher. This survey took place at Facebook.The answers showed that we carry on a piece of solid workmanship. But you can always improve, try harder.
Språkutveckling med hjälp av Tragetons metod; möjligheter och hinder : Att skriva sig till läsning med dator och surfplatta
The purpose of this study is to describe some primary school teachers understanding of language development and approach of first and second language speakers with Arne Tragetons Writing to reading, for pupils in early ages.By using a qualitative method with interviews and participant observations and informal conversations, the basis for the survey was collected. Four teachers in three schools participated. The proportion of second-language pupils at each school was 35%, 17% and 0%. My theoretical starting point in the study was the hermeneutic research tradition, which has been used to interpret and understand the collected material. Theories of behaviorism, constructivism and socio-cultural perspective has been used in the analysis part of this study.
Kartläggning av källor till organiska föroreningar i avloppsvatten från svenska hushåll
At this point seamen have a lot of tasks of administrative character, beyond the traditional tasks aboard a ship. Due to the new conventions that are formed by IMO, more requirements are added which often lead to time consuming administrative tasks and documentation that should be spent on activities which are contributing to the ships safety. The issue has been observed by IMO that has through BIMCO done a study with the aim to identify and reduce administrative burdens at sea.The primary aim of this study is to find out if safety officers aboard Swedish ferries consider that SOLAS Chapter III, 8.3 och 19.5 regulations are administrative burdens, restricted to muster lists and documentation of training aboard the ship.The secondary questions to the study are if it is possible to remove, combine or change the documents and how much time can be saved by doing this. The question about timesaving could not be answered, because the values were scattered and could not be used for further investigation. The observed values were accumulated by a survey and the result indicated that safety officers did not experience the two regulations as administrative burdens.
AB Volvo Pentas emballagesystem - processen och förpackningslogistisk betydelse
Title AB Volvo Pentas packaging system ?process and packaging logisticsAuthor Peter Powell, Lund's Technical CollegeSupervisors Annika Olsson, Lund's Technical CollegeJan Svensson, AB Volvo PentaProblem - Packaging requirements ? Which requirements are there, how do they affect each other and how are they fulfilled?- Packaging process ? what is the line of action when developing new packaging and making adjustments in existing ones? Who has the responsibility to do what?- Packaging logistics ? How is the packaging system adapted to transport efficiency and handling?Objective To create an overall picture over how the packaging system affects and is affected by different functions and players within and beyond the company boundaries, to give a clear picture of how changes in the packaging system is made today and how it could work and finally to give suggestions for cost savings affected by the packaging system.Method The methods used for this thesis has mainly consisted of action research and at some extent case studies. As a previous employee at the department of logistics at Volvo Penta I?ve taken part of the environment, information and prerequisites that this thesis discusses on a daily basis. Case studies have been used for the collection and analysis of data concerning packaging logistics as I?ve chosen to consider only specific markets and packaging.Conclusions This thesis has highlighted the demands that are placed upon engine packaging throughout all concerned units and how these demands affect each other, positively and negatively.
Vilka effekter har lojalitetsprogram på kundlojalitet? : En studie om frequent flyer-program och deras effekt på kunderna
The arm?s length principle has existed in Swedish law since 1928 but has previously been given little attention. In 2007, documentation requirements were introduced, and the government began to do tax audits regarding transfer pricing. This thesis examines how the documentation requirements and tax audits affect the application of the arm's length principle. The research consists of nine interviews with a total of ten people at the tax authority (Skatteverket) and audit- and consulting agencies. The results of the interviews are analyzed using the agency theory. Many companies are risk averse and prefer having correct transfer pricing instead of taking on challenging strategies that can be risky in case of an investigation by Skatteverket.
Studium av stomsystem och övrigt klimatskal m.a.p. produktion och långsiktig förvaltning av passivhus
The passive house concept has been known for many years, but it is not yet verywell known in Sweden. The increased energy requirements places greaterdemands on our buildings and to meet these requirements, passive houses is agood option.Svenska Bostäder have built passive houses with good results and intend tocontinue design some of their new buildings as passive houses. This study ismeant to support Svenska Bostäder in their planning of new buildings byanalyze and compare the different frameworks and building shells of passivehouses.In the first chapters (1,2 and 3) we presents the conditions for passive housesand the differing objects we have examined more generally for the reader tobecome familiar with the concept and the objects.The subsequent chapter presents an analysis of each object partial based on thespecifications from FEBY and finally, in Chapter 5, you will find a table ofvalues where the objects are put into relation to each other and valued there by,together with a brief explanation for the table.This chapter also contains texts on the environment, design and futuredevelopment which all includes our own thoughts and reflections.Finally, the gist of the whole work and our conclusion is presented anddiscussed.On the whole, the work has been very enlightening for us and we hope that theconcept of passive houses have a wider impact in the future..
IBS-patienters upplevelse av låg FODMAP-kosten
IBS patients experiences of eating the low FODMAP-dietIrritable bowel syndrome (IBS) is a common, functional gastrointestinal tract disorder. The disease is benign but may cause much suffering for the individual. The treatments available are used to relieve symptoms. One nutrition therapy is to exclude fermentable oligo-, di-, monosaccharide and polyols, so callde FODMAPS, from the diet. This diet is proven successful and even significantly better than the standard nutrition advice for IBS.
Ett kandidatexamensarbete inom lättviktskonstruktioner .
Due to recent legal enactments regarding carbon dioxide emissions, the car industry is facing higher demands. An effective way of reducing these emissions is to minimize the weight of the vehicle. This thesis constitutes a feasibility study on whether or not it is applicable for the car industry to utilize an inner floor structure comprising composite materials. The principal was the projectSåNätt, in which the main participant was Volvo Cars Corp. In consultation with a reference group, consisting of delegates from the industry and KTH, a specification of requirements was produced.
Är fiberarmerad sprutbetong motiverad ur bärighetssynpunkt? : En jämförelse med traditionell släntning och jordspikning
This thesis is written on behalf of Skanska, Väg- och Anläggning Stockholm Mälardalen, vid Nya Karolinska Sjukhuset i Solna, NKS. The report has resulted in recommendations for the method of soil stabilizations of soil nailing, excavation of slope and fiber reinforced shotcrete, which is the most suitable method from a safety and a cost point at the NKS.The aim of this thesis was to investigate whether fiber reinforced shotcrete increases slope stability, with the focus being on the total stability. The main goal was to investigate which method of soil stabilization is the most suitable for the slopes that are analyzed in this report. Through studying literature, the authors have gained an understanding about the theoretical background for the given problem. Through calculations and analyses of the slopes, safety factors have been acquired.
User Interface Design for Analysis of Sensor Systems
In the future network-based Swedish Defence (NBD), attaining information superiority will be of great importance. This will be achieved by a network of networks where decision-makers, information- and weapon-systems are linked together. As a part of the development of NBD, we have performed a study of user interface design for a future network-based tool package for analysis of sensor systems, referred to as the C2SR-system. This thesis was performed at Ericsson Microwave Systems AB, Sensor and Information Networks, during the autumn 2002. A pre-study concerning the requirements of usability, trustworthiness and functionality of a user interface for the C2SR-system was performed.
Utveckling av stol för café och lunchrum
This is a dissertation for a Bachelor Degree Project at the University of Skövde. The project is carried out in cooperation with the company Kinnarps AB.The objective of this project was to develop a new chair for café and lunch rooms, which should satisfy the markets expectations and demands and match Kinnarps AB?s assortment today. The project has contained everything from identification of user and customer needs and requirements to evaluation and building of a prototype.The result is a chair with a frame of tubular steel and there is nothing like it in Kinnarps AB?s assortment today.