Fuel pellets are in Sweden mainly produced from sawdust and cutter shavings. Before the pelletising process the raw material is dried to attain consistent moisture content and ground up in a hammer mill. In the densification process (pelletising) the ground material is forced through holes in a rotating die. This heats up the wood particles which cause them to soften and self bond. After the process the pellets are cooled, sieved and bagged. The milling process creates a wide range of particle sizes.

Syftet med detta examensarbete är att effektivisera monteringsprocessen genom att hitta en lämplig produktionslayout i den gemensamma monteringsavdelningen. Rapporten bygger på följande frågeställningar:1. Hur fungerar den befintliga produktionslayouten för de fyra olika teamen?2. Vilken/Vilka kriterier kan påverka effektiviteten i den gemensamma monteringsavdelningen?3.

Bachelor thesis, Trolley Innovation Project, has been unique in the sense that it has been carried out over the borders of Sweden. Iacobucci S.p.A, located outside of Rome in Italy is one of the largest manufacturers of interior equipment for aircraft in the world. With approximately 30% of the market Iacobucci S.p.A is one of the world's largest manufacturers of catering trolleys.The aim has been to produce a new competitive catering trolley for the airline industry. With customers and users in focus, the project team found that weight, ease of use, ergonomics and design were important aspects. Having a low weight of all the interior is particularly important when there is lots of money for the airlines to save in reduced fuel costs.

Organic agriculture is financially promoted in Sweden by special environmental support and as consumers we are all encouraged to buy organic food. At the same time scholars at the Swedish University of Agricultural Sciences claim that organic farming does not provide any environmental benefits. The main criticism is that organic farming has lower yields than conventional, which means that more land is needed to produce the same amount of food as in conventional farming, leading to deforestation and loss of biodiversity. As for climate change, the critics claim that the significantly higher productivity in conventional crop production compared to organic, releases surplus land, which could be used for bio-fuel production and thereby replace the fossil fuels. The critics also claim that organic farming causes higher nutrient leaching than conventional.

Emission of nitrogen oxides as well as carbon monoxides is an inevitable result of combustion. A Swedish law "Law of environmental fee for emissions of nitrogen oxides as a result of energy production" (lagen om miljöavgift på utsläpp av kväveoxider vid energiproduktion (SFS 1990:613)) controls the emission of NOx from energy production by a system of fees. The system has resulted in a strong approach toward less emissions of NOx among the energy production plants. High emission levels, today exceeding 52 mg/MJsupplied fuel, leads to costs for energy production companies. This paper examines possibilities to reduce the emissions of NOx by optimization of the SNCR-technique in a biofuel fired heat and power plant.

Analyses of pollen and charcoal in peat cores, together with age-structure data of Pinus sylvestris from a Ledum-Pinus-mire in the Tyresta National Park (south-east Sweden) show the regional vegetation succession and fire history over the last 9000 years. Five major stages of mire development are identified: 1. Lake (c 7000-6400 cal BC); 2. Wet fen (c 6400-6000 cal BC); 3. Deciduous fen (c 6000 cal BC to c cal AD 700); 4.

AbstractThe future of ethanol is depending on good solutions for the production. ENA energy power plant produces electrical power and district heating by heating biofuel. By building an integrated bioenergy plant surplus steam could be used to produce ethanol as fuel to vehicle.This would mean that ethanol is produced renewable energy and the energy for the process derives from the surplus of power.  ENA energy, MDH (the University of Mälardalen) and the energy authority has initiated a research project were different bioenergy combinations integrate with existing power plant.  As a part of the project which size an integrated factory should be to gain the best efficiency for the plant was investigated. Consideration will be taken to the cost of the production in order to be competitive to the price of imported ethanol.  Etanolens framtid vilar på bra lösningar för framställning.  I ENA energi kraftverk i Enköping produceras el och fjärrvärme genom eldning av biobränsle.  Genom att bygga ett integrerat bioenergikraftverk där skulle man kunna använda överskottsånga till att framställa etanol som fordonsbränsle.

In the EU the amount of waste increased by 14 percent during the years 2000 to 2010. EU?s target to reduce waste generation runs parallel with the aim of increasing the efficiency and profitability aligned with energy recovery. In Sweden the energy recovery through incineration is increasing steadily, and 46 percent of the municipal solid waste (MSW) is treated by combustion. This report aims to examine the profitability of processing MSW into Refuse Derived Fuel (RDF) from an economic-, energy- and environmental perspective.

The aim of this study is to describe a number of type stands of lodge pole pine in Norrbotten with respect on stem volume and total biomass. Further questions to answer is if there is stand characteristics that make the stands more suitable for pulpwood in early thinning, or if it is better to apply whole tree harvest. The study shall also give an indication if bio energy can be an economical interesting alternative for Sveaskog. Sampled trees represented the variation in the different stands. Five trees were selected from each stand to represent that stand. Stem volume and biomass (kg dry weight (DW) per hectare) for each fraction was calculated.

Reducing the CO2-pollution, resulting from the combustion of fossil coal for energyproduction, is important to affect environmental changes. One way to achieve a reductionis to use the oxy-fuel technology. The technology uses O2 and re-circulated flue gasduring the combustion which results in a flue gas mainly consisting of CO2. The flue gascould then be compressed and stored without environmental effects. A problem thatfollows from the compression is the risk of acidification in sensitive parts of the process.Acidification can occur because of reactions following from the contact of condensedwater and sulphur- and nitrogen-oxides which are also present in the flue gas.This report compiles and evaluates the basis of a scientific unit with the purpose ofexploring the possibilities of extracting impurities of SOx and NOx from the flue gases.The dimensions of the unit are based on basic conditions, defined for an existing oxy-fuelprocess at Chalmers, and on the results of computer modelling.

The fork lifter chipper truck is a concept which has been developed for harvest and transport of bio fuel. The system consists of one fork lifter chipper truck and 1, 2 or 3 transport lorries, usually two, which serves the fork lifter chipper truck. The system is driven by the fork lifter chipper truck that produces chipped material into a container on the truck. When the container has been filled the truck drives to the landing site where it?s offloaded.

The demand for food, feed, fibre and fuel has increased in Uganda over the past 50 years due to population growth. Recurring extreme climate events such as drought and flooding, in combination with large-scale land degradation, have led to declining crop yields. Lack of equipment, money and socio-economic issues has contributed to low yields. However, the soils in Uganda have the potential to produce much higher yields than they do today. This study, which was carried out in April-June 2013 in Kkingo District, south-east Uganda, examined the effects of agroforestry on yield of cooking bananas in small-holder farming systems. Six farms practising agroforestry and six farms with no agroforestry, which were chosen in cooperation with the NGO Vi Agroforestry, were compared.

Dagens transportsektor är beroende utav fossila drivmedel. Detta är problematiskt eftersom fossila bränslen är en ändlig resurs samtidigt som användningen utav dessa bidrar till den förstärkta växthuseffekten. Enligt EU:s klimatmål ska utsläppen av växthusgaser reduceras med 20 procent till år 2020. Handeln med utsläppsrätter, som flygsektorn inkluderas i från och med år 2012, har införts som ett styrmedel som skall verka för att företag ska minska sina utsläpp. Flygföretag kommer härigenom att ha ökade incitament att blanda in en viss procenthalt biojetbränsle i det fossila jetbränslet.

Biogas mainly consists of methane and carbon dioxide, where methane is theenergy-rich gas, and is naturally created when organic matter breaks down in absenceof oxygen, also known as anaerobic digestion. A biogas plant re-creates the anaerobicconditions inside a digester where the organic substrate is fed into and digests toproduce biogas. The gas is then used to produce energy by combustion and can beseen as a completely renewable fuel.Today, energy from biogas is used primarily by major stakeholders such asmunicipalities and thus the plants become very large with high investment- andconstruction costs. There are currently few small plants in Sweden, even though thepotential for agriculture and medium-sized to smaller farms to become self-sufficientin terms of electricity and heat is great. Farms have a natural stock of digestibleorganic material in form of manure or crops for example, which are constantlyavailable.

The worldwide industrial demand of energy, often in form of fossil fuel, is continuously growing and at the same time these resources are coming to an end (Hamamre, 2013). The interest and focus in renewable sources are then more important than ever and plants are suggested to be a good alternative for production of raw material for industrial purposes (Nilsson et al., 1998). But the world is also facing an increasing world population which also increase the nutritional needs, plants therefore need to be suitable for both industrial and nutritional purposes. To achieve this, common plants need to be improved but it also need new potential crops to be developed and introduced (Carlsson et al., 2009). Modern technology like gene engineering is an important tool to achieve these challenges (Carlsson et al., 2011). This work focused on analyzes and evaluation of different transgenic lines of field pepperweed (Lepidium campestre L.).