Storage of biomass is associated with problems like heat development, biomasslosses, and reduction of the fuel quality. Certain processes such as biological- andchemical degradation are responsible for these storage problems. This master?sthesis was carried out at Vattenfall Research and Development AB and is alignedtowards quantifying the biomass losses from short-term storage (1-2 months) ofbark and recovered wood. The biomass was stored in outdoor piles during differentseasons, campaign 1 (summer) and campaign 2 (autumn).

The objective of this work was to evaluate and compare three field methods for detection of mastitis, California Mastits Test (CMT), DeLaval cell counter DCC (DCC) and FMA2001 Farm Milk Analyzer (FMA2001). Furthermore, to investigate at what cell count level clinical symptoms of mastitis are seen, and finally to check if the clinical findings and cell counts could be related to bacteriological findings. DCC and FMA2001 are new analytic instruments to be used on dairy farms for detection of mastitis. CMT has been a widely used cow-side-test of milk quality in mastitis control efforts, but it cannot be used for estimating cell counts in scientific studies or investigations. Two hundred and eight quarter milk samples from 52 cows were analysed with DCC and CMT, and 168 of these samples with FMA2001. Microbiological examination was done on 38 milk samples with CMT scores of 4 and 5.

In this thesis an energy analysis of ethanol production at the ethanol plant of Lantmännen Agroetanol in Norrköping has been performed. The ethanol plant has been studied in combination with Händelöverket, the combined heat and power plant which provides the ethanol process with steam. The purpose of this study was to determine the energy consumption for the whole production chain from grain to ethanol. The analysis has included the energy consumption for cultivation of grain, production of chemicals, the production chain for wood chips, the steam production and the ethanol plant. The grain and wood chips are both considered raw materials there for the energy content in these are not included as energy input in the system.

In this thesis an energy analysis of ethanol production at the ethanol plant of Lantmännen Agroetanol in Norrköping has been performed. The ethanol plant has been studied in combination with Händelöverket, the combined heat and power plant which provides the ethanol process with steam. The purpose of this study was to determine the energy consumption for the whole production chain from grain to ethanol. The analysis has included the energy consumption for cultivation of grain, production of chemicals, the production chain for wood chips, the steam production and the ethanol plant. The grain and wood chips are both considered raw materials there for the energy content in these are not included as energy input in the system.

Scandinavian Biogas is involved in the planning of a combined ethanol and biogas factory in Karlskoga, Sweden. Besides biogas and ethanol large amounts of digester residues will be produced, about 450 000 liquid tonnes residue (~7,3 % Dry Substance( DS)). The objective of this thesis was to investigate possible uses of the residue from the biogas production process ScandgasEthanol developed by Scandinavian Biogas, and to derive a methodological approach how to evaluate and compare handling systems. Three systems where proposed and compared in this thesis; spreading of the untreated residue as fertilizer (system 1), dewatering to a higher DS content to reduce transportation before spreading as fertilizer (system 2) and production of a solid fuel by dewatering and drying the residue (system 3). The general conditions for the proposed systems were investigated in terms of practical viability, economical aspects, environmental impact and energy inputs/outputs.

The annual demands for forest fuels increases in Sweden. At present, large unutilized biomass resources is found in young, dense forests from which about five million oven-dry tonnes (ODt) (23 TWh) could annually be extracted as forest fuel. But harvesting small trees give high logging costs and new cost-efficient harvesting techniques are therefore required. The aim was to study the productivity of Vimek 608 BioCombi in forest fuel thinning of Lodgepole pine and to calculate the economy of the harvesting and estimate the thinning quality. The time study was performed in Åmarken in the county of Västerbotten.

The transportation sector is the only sector of the Swedish society that is still increasing the emissions of carbon dioxide and other green house gases. Diesel fuel represents one of the fuels that contributes to these emissions and the use of diesel fuels is increasing every year. The main purpose of this study was to make an estimation of the current business situation for producers of liquid diesel biofuels in Sweden such as biodiesel, synthetic diesel and crude tall diesel and examine the forces of competition of the industry today and its future prospects. The study revealed that the rivalry among the existing firms was low mainly due to the geographical spread of the companies. Moreover the success of the biodiesel industry was influenced by a long-term guarantee of the tax exempt for biofuels and by the price level of petroleum diesel.

Car usage is determined by several facts, e.g. living conditions determined by geographical matters. There is a political will to control car usage with different kinds of incentives since car usage generates environmental problems. This essay analyses the differences between car usage in urban areas as opposed to thinly populated areas in Sweden and their significance on governmental incentives. By using statistics differences in car ownership during ten years between thinly populated areas, areas in the countryside and urban areas is studied.

The cost for forestry logistics in Sweden is about 25 percent of the total cost of getting the raw material to industry (Anon., 2010). There might be much to gain by taking a look at your supply chains on the logistic side in your company. In this report the logistic chains by Mellanskog for ENA Energi AB in Enköping has been looked in to. ENA Energis plant is a combined power and heating plant and about 99, 5 percent of their fuel consisted of bio energy in year 2009 (ENA Energi, 2011, länk A). The main purpose with this report is to look at three questions: 1. How does the supply chain look today? From forest to industry. 2.

Abstract Tripeptidyl-peptidase II (TPPII), is present in most eukaryotic cells. It cuts tripeptides from the N-terminus of peptides and is especially important for degrading peptides longer than 15 amino acids. TPPII also tailors long peptides into suitable substrates for the enzymes which transport and produce the peptides that MHC I present. Increased levels of TPPII have also been found in certain cancer cells, thus it is of interest to determine if TPPII could be used as a tumour marker.The aim of this study was to optimise and evaluate 3 different methods for quantifying TPPII. Western blot, enzyme-linked immunosorbent assay (ELISA) and fluorophore-linked immunosorbent assay (FLISA) protocols were optimised regarding incubation times and antibody dilutions.

This thesis is divided into two parts. Part one contains a general description of the flexographic printingtechnique. Part two contains a more detailed investigation in the areas substrate, inktransfer and trends, which are only briefly commented in part one, and conclusions and comments.The major problem concerning substrate is washboard. This phenomena can be limited if one can control and minimize the amount of glue applied in the single- and double facer, use high surface weight on liner, use low surfaceweight on fluting and control the humidity during the conditioning of the corrugated board. Corrugated board with a smooth surface radically increases the quality in print.

This thesis is divided into two parts. Part one contains a general description of the flexographic printingtechnique. Part two contains a more detailed investigation in the areas substrate, inktransfer and trends, which are only briefly commented in part one, and conclusions and comments.The major problem concerning substrate is washboard. This phenomena can be limited if one can control and minimize the amount of glue applied in the single- and double facer, use high surface weight on liner, use low surfaceweight on fluting and control the humidity during the conditioning of the corrugated board. Corrugated board with a smooth surface radically increases the quality in print.

This thesis is divided into two parts. Part one contains a general description of the flexographic printingtechnique. Part two contains a more detailed investigation in the areas substrate, inktransfer and trends, which are only briefly commented in part one, and conclusions and comments.The major problem concerning substrate is washboard. This phenomena can be limited if one can control and minimize the amount of glue applied in the single- and double facer, use high surface weight on liner, use low surfaceweight on fluting and control the humidity during the conditioning of the corrugated board. Corrugated board with a smooth surface radically increases the quality in print.

The development of quantitative, real-time PCR (qPCR) combined with the mapping of the canine genome opens new possibilities in veterinary medicine. This method provides a quick and accurate quantification of the expression of a specific gene at a given point in time and thereby also information of how the gene expression for a certain protein is influenced by various conditions and diseases. One possible area of application is identifying bio markers for cancer. Recently the protein serglycin (the core protein of an intracellular proteoglycan) was found to act as a selective marker for the disease acute myeloid leukemia in humans (Niemann et al, 2007). Serglycin is produced by most hematopoietic cells, although mast cells account for the largest amount of serglycin.

The aim for the study was to examine a harwarder´s (combined harvester-forwarder) productivity when harvesting forest fuel in first thinning stands that contains Lodgepole pine and calculate the economy of the harvesting work and estimate the quality of the thinning . The field study area where located near Arvån, about 15 kilometres south ?east from the city of Lycksele. The field studies were taken place in three different stands. All tree stands had the same tree age, but the tree species combination and the density varied.