Mulesing is a surgical husbandry procedure performed on lambs in Australia. The reason is toprevent severe fly-strike to the breech area, which otherwise risks to be soiled with faeces.This problem is mainly occurring in sheep of the Merino breed. Their fine wool is in demandworldwide due to high quality. Mulesing has been performed since the 1930?s, and eventhough alternative methods have been discussed nothing is yet generally accepted.

The lack of fresh and clean water today causes severe problems, mostly in developing countries. Waterborne diseases like typhoid, cholera, amoebic dysentery and diarrhea create health problems and deaths among people. There is a need for low cost interventions like household-based water treatment and safe storage (HWTS). Solvatten AB is a Swedish company based in Stockholm. Their product, Solvatten, is a household water treatment unit that can treat water containing viruses, parasites and bacteria.

Dead wood is important for many species. The amount of coarse dead wood (diameter >10 cm) is much lower in managed forest than in unmanaged forests. Stumps constitute the largest proportion of the volume of coarse dead wood in managed forests. Since stump harvest for biofuel may increase, the amount of dead wood will decrease even more, which may threaten biodiversity. The first aim of this study was to compare the amounts of fine woody debris (FWD, .

Saab Aerosystems has a long tradition and a lot of competence in the field of flight simulation. Their ambition to broaden the market horizon has led to a discussion about also selling vehicle simulation solutions, both for military and civilian use.The aim of this thesis is to investigate the driver?s experiences of the accelerations he or she is exposed to whilst driving in rough terrain. The results may be used as a basis for future decisions and can act as a platform for the construction of an effective simulation model.To investigate the driver?s exposure of acceleration, some kind of dynamic simulation is needed.

The release of green house gases and the environmental impacts humans have on the environment are huge and might cause irreversible changes to our earth. Meat is considered to have large impacts on the environment, especially beef meat and therefore there have lately been considerable discussions on the sustainable level of meat consumption and production. The main goal with this thesis is to study sustainable meat production and meat consumption in the county of Dalarna in Sweden. Indicators for sustainable meat production and meat consumption were developed and applied on three cases. Interviews were carried out with a municipality in the region that represents the consumer and three beef farmers that represents the producers.

AbstractThe purpose of this essay was to determent if the authors? idea to replace a personal trainer with a training program, which is provided by software, is viable and if there is a market for such a product. The method that was used, included eight people who enrolled in a training program which were designed by the authors in Microsoft excel. The programs were based on principals of periodization, and included the phases: anatomic adaptation, hypertrophy, maximum strength and muscle definition. The training program was personal and based on individual goal setting.

The release of green house gases and the environmental impacts humans have on the environment are huge and might cause irreversible changes to our earth. Meat is considered to have large impacts on the environment, especially beef meat and therefore there have lately been considerable discussions on the sustainable level of meat consumption and production. The main goal with this thesis is to study sustainable meat production and meat consumption in the county of Dalarna in Sweden. Indicators for sustainable meat production and meat consumption were developed and applied on three cases. Interviews were carried out with a municipality in the region that represents the consumer and three beef farmers that represents the producers.

The Societety Park (Societetsparken) of Varberg here in Sweden, established in the year 1883 (1856), is one of the most famous parks in Varberg. Today it is, more or less, only used as a park that you will walk through in the wintertime, under the summer season though, the park starts blooming and then it is used for public music and singalong evenings. Earlier it was an old health resort park with its fine old traditions.The Societetsparken was a private owned park until 1902 when the town purchased it. On this plot there was already a smaller park and it was established as early as in 1856. It was called Badhusparken (The Public Bath Park) and it belonged to the hot- and cold-bathhouses, and these baths were very well frequented.

Dead wood is important for many species. The amount of coarse dead wood (diameter >10 cm) is much lower in managed forest than in unmanaged forests. Stumps constitute the largest proportion of the volume of coarse dead wood in managed forests. Since stump harvest for biofuel may increase, the amount of dead wood will decrease even more, which may threaten biodiversity. The first aim of this study was to compare the amounts of fine woody debris (FWD, .

The aim of this study was to investigate if behaviour, ear positions and cortisol in lamb which were given access to play followed the different phases of the reward cycle of anticipation, consumption and relaxation. The study was done on 8 Dorset and 12 Dorset x Fine Wool uncastrated male lambs with an average age of 10 weeks. The lambs were housed pairwise in litter pens (2 x 3 m). Pairs of lambs were taken to a play arena (5.9 x 5.5 m) three times a week during five weeks (first week for learning). They were then first kept in a holding pen where they could look into the play arena for 5 minutes and thereafter released for 20 minutes in the play arena which had a ball, two chains and a tunnel.

The purpose of this thesis was to find out what experiences teachers have from using a class blog in teaching. What are the advantages and disadvantages by the use of blogs in education?I have used qualitative interviews with four teachers in grades 1 to 6 who have worked with a class blog in teaching between one and three years.The study has shown that teachers' experience is that the blog serves as motivation and promotes learning for many different pupils and that, together with other digital tools is more equal. The main benefits that teacher mention is the expanded concept of text that offers multiple forms of expression and the authentic reader, which makes it more real, important and meaningful. Other benefits that come up are that it helps students to see their learning and learn from and with each other.

An inquiry into the post-war European aesthetic and political landscape should take the international organization Unesco?s colour reproductions and travelling exhibitions of paintings into consideration. In these, the organization implements André Malraux? idea of the ?imaginary museum? as a framework for a future cosmopolitical, aesthetic (and utopian) community. During the late 1940?s, the Swedish government also discusses the need for raising an ?aesthetic awareness? amongst their citizens as a consequence to a poor knowledge in the fine arts.

The thesis has been made for NCC Teknik in Gothenburg. The NCC Corporation is one of the largest leading companies in Scandinavia within the construction industry. NCC is active throughout the whole construction process, where one part is to carry out soil investigations prior the construction of various buildings, for example residential buildings. NCC Technology wants to visualize the samples taken at the construction sites in 3D for clients, authorities and also internally to show in a simple and understandable way how contamination is spread out in the soil.The thesis includes the area of Limhamns läge in Malmö, previously an industrial area. The area has previously included a concrete factory and the contamination from that factory has lingered in the soil.

This thesis is divided into two parts. Part one contains a general description of the flexographic printingtechnique. Part two contains a more detailed investigation in the areas substrate, inktransfer and trends, which are only briefly commented in part one, and conclusions and comments.The major problem concerning substrate is washboard. This phenomena can be limited if one can control and minimize the amount of glue applied in the single- and double facer, use high surface weight on liner, use low surfaceweight on fluting and control the humidity during the conditioning of the corrugated board. Corrugated board with a smooth surface radically increases the quality in print.

This thesis is divided into two parts. Part one contains a general description of the flexographic printingtechnique. Part two contains a more detailed investigation in the areas substrate, inktransfer and trends, which are only briefly commented in part one, and conclusions and comments.The major problem concerning substrate is washboard. This phenomena can be limited if one can control and minimize the amount of glue applied in the single- and double facer, use high surface weight on liner, use low surfaceweight on fluting and control the humidity during the conditioning of the corrugated board. Corrugated board with a smooth surface radically increases the quality in print.