Outages in the electric grid can be costly for society. Because of this, reliability is one of the parameters used to regulate network companies. Reliability in electrical grids can be measured with SAIDI, system average interruption duration index, which for Fortum Distribution has increased in Stockholm?s distribution network (11 kV) in the early 2000?s.By using outage data for Stockholm from 2011-2013, sets of parameters to be used for reliability calculations in the network information program Tekla NIS were derived. Two different options for investment were then analysed: changing old cables with high fault frequencies, and installing automatic switching in distribution substations.

Since 2004, wind power has had the largest installation of new capacity compared to other energy sources in Sweden. Accommodating new wind power may require strengthening or rebuilding of the existing grid in areas where the grid is already loaded to maximum capacity. This master thesis examine the possibility of a new 400/130 kV substation in Yttermalung, Sweden, with a connection to the two neighboring regional grids in Dalarna and Värmland owned by Fortum. This substation would provide a new connection point to the Swedish transmission system as well as an interconnection of the two, currently separated, regional grids. Different expansion scenarios where a substation with and without series compensation or a phase shifting transformer (PST) to control active power flow were studied.

Barley is one of the most important cereals cultivated in the Nordic countries. Climate change brings warmer and moisture climate which favors fungal diseases. In the cropland barley can be seriously infested with hard fungus attack. Since it is important that the yield bears a high quality it is of great importance to find varieties more resistant to attacks.Pathogenesis-related (PR) proteins are stress proteins induced in the plant in response to infection and abiotic stress (van Loon, 1997). PRs are shown to have antimicrobial activity differing between bacteria, fungi and oomycetes (Tandrup Poulsen, 2001).

This report evaluates various methods that can be used to position a smartphone running the Android platform, without the use of any special hardware or infrastructure and in conditions where GPS is unavailable or unreliable; such as indoors. Furthermore, it covers the implementation of such a system with the use of a deterministic fingerprinting method that is reasonably device independent, a method which involves measuring a series of reference points, called fingerprints, in an area and using those to locate the user.The project was carried on behalf of Sigma, a Swedish software consulting company..

With this study, we have chosen to continue our B-essay about dual-diagnosis. In the essay we have done some research on how this target group feels about the treatment from the dependent unit, psychiatry unit, social services unit and the housing environment. We wanted to know about the feelings because during the B-essay we found out that individuals whit the dual-diagnosis is skipped between different caregivers. We used a qualitative method with six interviews from two different housings in south of Sweden. The information we got we used in our result and analysis part, where we found out that the caretaker?s thought the treatment were fine and that it was the surroundings they found the most fault with..

The background to this study is that the forest company, Holmen, has found large discrepancies between harvested volume and the measured volume at the industry. Factors like bark features, breakage, double tops, bends and stem damages was noted, and all stems were measured manually. Hypothesis testing with the method "random in pairs" were used to examine whether the harvester measured values significantly differed from the manually measured. The result of a properly calibrated harvester shows in average underestimation of the volume with Skogforsk Pine as a bark function. This means that the harvester isn´t the reason why the volume measured in the industry is lower, the fault is elsewhere. The study also indicates a need for a unique bark function for logepole pine..

Utfört examensarbete undersöker vinkelfelet i mätkretsen för riktade jordfelsskydd och hur det påverkar dess felbortkoppling. Uppkomna vinkelfel i mätkretsen kan påverka det riktade jordfelsskyddet så att verklig felström och uppmätt felström inte stämmer överens, vilket kan leda till uteblivna eller obefogade felbortkopplingar. Vattenfall ställer krav på att vinkelfelet får uppgå till max ±2 grader för mätkretsen. Eftersom vinkelfelet i många fall har en hög påverkan på jordfelsskyddets noggrannhet undersöks vad Vattenfalls vinkelkrav egentligen innebär. Största orsaken till vinkelfelet uppstår oftast i strömtransformatorn och därför undersöks hur mycket två strömtransformatorer med olika klassificeringar som är vanliga i elnätet påverkar vinkelfelet i mätkretsen.Jordfel är det vanligast uppkomna felet i mellanspänningsnät och dess storlek beror till stor del på hur mycket kapacitivt bidrag som finns på linjerna samt värdet på nollpunktsresistorn.

Göteborg Energi AB är ett bolag med höga ambitioner att säkerställa ett stabilt distributionsnät för sina kunder. Med ett säkerställande följer åtgärder i form av beräkningar för komponenter som transformatorer av olika märkeffekt, hög- och lågspänningssäkringar och andra kritiska skyddsanordningar som t.ex. reläskydd. Vid ett flertal tillfällen under de senaste åren har det uppmärksammats en problematik där ett fel i lågspänningsnätet har löst ut anslutande transformator. Felet har grundat sig en svag selektivitet mellan transformatorsäkring och lågspänningssäkring.

This report describes a synchronous machine model with magnetic saturation in d-axis, neutralconnection and electrical exciter interface for the transient simulator PSCAD/EMTDC. It hasbeen designed and verified in comparison to the regular machine model in EMTDC.The performance of the model is very good when incorporating a linear as well as a saturatedmagnetising inductance. The dynamic deviation is only thousandths to ten thousandths perunit. By using a cubic interpolation of the saturation curve, the model gives a good representationof the saturation effect. The open source code implementation of the synchronousmachine model gives the possibility to easily adapt the model to specific requirements.The derived model makes it possible to simulate a synchronous machine with its excitationsystems, e.g.

Göteborg Energi AB är ett bolag med höga ambitioner att säkerställa ett stabilt distributionsnät för sina kunder. Med ett säkerställande följer åtgärder i form av beräkningar för komponenter som transformatorer av olika märkeffekt, hög- och lågspänningssäkringar och andra kritiska skyddsanordningar som t.ex. reläskydd. Vid ett flertal tillfällen under de senaste åren har det uppmärksammats en problematik där ett fel i lågspänningsnätet har löst ut anslutande transformator. Felet har grundat sig en svag selektivitet mellan transformatorsäkring och lågspänningssäkring.

Göteborg Energi AB är ett bolag med höga ambitioner att säkerställa ett stabilt distributionsnät för sina kunder. Med ett säkerställande följer åtgärder i form av beräkningar för komponenter som transformatorer av olika märkeffekt, hög- och lågspänningssäkringar och andra kritiska skyddsanordningar som t.ex. reläskydd. Vid ett flertal tillfällen under de senaste åren har det uppmärksammats en problematik där ett fel i lågspänningsnätet har löst ut anslutande transformator. Felet har grundat sig en svag selektivitet mellan transformatorsäkring och lågspänningssäkring.

This report describes a synchronous machine model with magnetic saturation in d-axis, neutralconnection and electrical exciter interface for the transient simulator PSCAD/EMTDC. It hasbeen designed and verified in comparison to the regular machine model in EMTDC.The performance of the model is very good when incorporating a linear as well as a saturatedmagnetising inductance. The dynamic deviation is only thousandths to ten thousandths perunit. By using a cubic interpolation of the saturation curve, the model gives a good representationof the saturation effect. The open source code implementation of the synchronousmachine model gives the possibility to easily adapt the model to specific requirements.The derived model makes it possible to simulate a synchronous machine with its excitationsystems, e.g.

A substation must be properly protected against lightning and other external effects to the equipment in the station or staff, for that we use relay protection. They should also protect against internal errors which may occur as ground faults. There are different types of protection relays, but most common are overcurrent-, distance-, residual current- and differential protection.The purpose of this thesis was to deepen our knowledge of relay protection and to use the theoretical knowledge we got from the university studies in the work process. In the process we discovered which parameters were the most essential and calculated these for all relay protections on the substation. We also carry out a comparison between two brands of relay protection, ABB and Alstom.During our work we will test and simulate the over-current relays in a program called NEPLAN, the program will also calculate the fault currents.

The purpose of this study was to investigate the association between physical activity and perceived stress, energy and musculoskeletal disorders among office-workers and warehouse-workers and also to see if there were any differences depending on work-place and gender. The method that was used to collect data was three different validated questionnaires that measured stress and energy (the Stress-Energy questionnaire), musculoskeletal disorders (intensity and localization of pain, a Pain Drawing questionnaire with a VAS-scale) and physical activity (IPAQ ? the short version). Eighty-eight workers participated in the study. Forty-seven of them were office-workers and forty-one were warehouse-workers.

This report discusses developing a software log tool for analysis of industrial processes. The target was to develop software that can help electro Engineers for monitor and fault finding in industrial processes. The tool is called PLS (Process log server), and is developed in Visual Studio.NET Framework 2005. PLS works as a client with Beijer Electronics OPC Server. The program is able to read data from PLC (Programmable Logic Controller), trough the OPC Server.