The purpose of this master thesis is to investigate how nearby forests affect the energy production in wind turbines. To reach the purpose a case study is performed on three wind turbines sited on a field in a north-south line at Andersfält in the municipality of Halmstad, Sweden. Approximately 100 meters south of the southern wind turbine a forest is situated. The case study is divided into three sub studies where the difference in energy production, the affect of the forest and a wind meteorology model, WAsP, is studied. The result show that the forest have a significant influence and that the WAsP-model gives an incorrect result of the energy production in wind turbines sited near a forest..

På uppdrag av Sweco Systems i Umeå har detta examensarbete utförts under våren 2013. Syftet var att undersöka huruvida något av de energiberäknings-program som används på företaget kan anses vara lämpligt vid energikartläggningar av befintliga fastigheter.Inledningsvis utfördes en energikartläggning av fastigheten Odin 12 i Umeå, som i huvudsak utgörs av gallerian MVG. Med resultaten från denna energikartläggning som grund beräknades därefter fastighetens energianvändning i två olika program ? VIP-Energy och IDA Indoor Climate and Energy.Resultaten från den inledande kartläggningen visar att fastigheten har ett lågt behov av fjärrvärme, vilket förklaras av fastighetens höga elförbrukning. Den stora användningen av el genererar stora mängder internvärme som, förutom att sänka fjärrvärmebehovet, även medför att fastigheten under hela året har ett kylbehov.Utvärderingen av de två beräkningsprogrammen visar att VIP-Energy är ett lämpligt program att använda vid energikartläggningar.

An energy study has been performed on two blocks in an area called Gävle Strand. The buildings are owned by a tenant-owner?s association called brf Carolina and were built by the company Skanska 2008. The builder as well as brf Carolina are pussled by the fact that electricity use is higher than expected while heating is less. Skanska is also very interested in finding out how much heat recovery from stale exhaust air through a geo-thermal heat pump is contributing to the general heating requirement and energy balance in four out of the ten buildings located on the properties.To find possible answers to the higher electricity use a literature survey on user behaviour was conducted.

The purpose of this study was to investigate the association between physical activity and perceived stress, energy and musculoskeletal disorders among office-workers and warehouse-workers and also to see if there were any differences depending on work-place and gender. The method that was used to collect data was three different validated questionnaires that measured stress and energy (the Stress-Energy questionnaire), musculoskeletal disorders (intensity and localization of pain, a Pain Drawing questionnaire with a VAS-scale) and physical activity (IPAQ ? the short version). Eighty-eight workers participated in the study. Forty-seven of them were office-workers and forty-one were warehouse-workers.

To be able to handle tomorrows need for limited energy consumption we need to reduce our use of energy. The building sector stands for around 40 % of all energy consumption in the society. The government has put up a goal to reduce the energy consumption in our buildings with 20 % by year 2020 and 50 % by year 2050 compared with year 1995. To be able to do reach that goal we need a more energy efficient building stock.The main part of the energy used in our buildings is used for space heating. By installing ventilation systems with heat recovery on the exhaust air it is possible to use the heat-energy in the exhaust air to warm up the incoming air.

In this report we examine the NFC (Near Field Communication) technology as far as the development has come until today. We adress different use areas and explain the technical funcionality. By using data collection methods as a specialist interview and also a survery we want to detect potential risks and safety-issues in implementation of the new technology. Our main-focus in this report is to examine how NFC can play an important role in the developement of social interaction and social media. By compiling our data and research materials we will analyze and present a report conslusion.

AbstractThis report intends through a case study to investigate if lightweight concrete isappropriate as main material in the outer wall of a seven storey residential building.A technical design is carried out in accordance with the definitions and requirementsfor passive houses, given by FEBY?s1 ?Demand specification for passive houses?.A literature review is also carried out for a comparison between regular bolt wall andlight weight concrete wall, with a focus on the safety of moisture.The lightweight concrete block used in the report is as a celblock produced by thecompany H+H Sweden AB.The methods used have resulted in compliance with requirements andrecommendations from authorities. Calculations of energy, noise and moisture riskassessment has been carried out.The work has resulted in the conclusion that the lightweight concrete itself is notable to isolate in the extent necessary to obtain chosen U-value of 0,1 W/m2 ° C,without getting to thick. Therefore additional insulation is needed. There are fewrelevant reference objects built with only light weight concrete.

As the use of smartphones and other mobile technology in our society is constantly increasing,so too does the possibilities of visually impaired persons increase as they are becoming moreable to enhance their quality of life with the help of mobile assistive technology. The purposeof this study was to explore how rehabilitation and habilitation organizations, which areworking with the visually impaired, should approach new technology. We have researched thisby examining the possibilities, opportunities and barriers of using mobile assistive technology.Based on this, we formulated the following research question: What factors are important forrehabilitation and habilitation organizations to consider in order to support, promote andcreate quality of life through the use of mobile assistive technology in their work with thevisually impaired? To answer the above question an exploratory study was made at an eyeclinic in the Västra Götaland region. The study was done through a series of qualitativeinterviews with both staff and patients at the eye clinic.

This report is a study in voltagelevel in connection with regeneration of brake energy from the tramtype M31 in Gothenburg.In the act of braking, the tram M31 uses electrical braking where the electrical motors generates energy and if possible send it back to the overheadline, where other trams in the nearby can use this regenerated energy for its own driving force. In cases where no other energyconsumers are located in the same section, there is a resistance witch task is to convert this energy into heat. The regulation of this resistance appears to cause an increase in the voltagelevel into far too high levels.Investigations of the trams regulationequipment and its construction have been done. Further have measurements on the overheadline been performed in order to map the voltagevariations during a longer period of time.The result have been showing that the voltagelevel during regeneration often is as high as 880V-920V, more extreme values have not been observed in a large scale. The values are especially high compared to the nominal voltagelevel.

The cocoa produced in Fiji is exported to industrialized countries for processing of the raw material. The Swedish organization Cocoa Bello is involved in a project to provide the Fijian cocoa farmers with knowledge as well as resources to enable local processing and to attain added value of the cocoa crop. The purpose of this study is to discover a field of application for the Fijian cocoa among the rural population, using an ethnographic design. We spent one week in Namau Settlement, Fiji, where we applied in-depth interviews and participant obser-vations in six families. We found a number of aspects affecting food choices, such as social, economical and cultural beliefs.

As the Swedish governments long term goals include a reduction of fossil fuel dependency, increasing pressure is placed upon energy companies to create and develop new solutions for renewable energy. The following case study was done in collaboration with the company Sydved Energileveranser AB and one of their contractors, Enarssons Skogsentreprenad AB. The objective of the study is to examine the bioenergy situation in region of Skåne and evaluate the potential solutions in the region for a forest-fuel assortment, based on a bioenergy-cutting-system. As a part of this study I have compared ordinary manual cuttings done with a chain saw and cuttings made using the new ?bio- energy cutting system?. The cuttings made under both systems were tested in areas near agricultural fields or pasture land in order to maintain an open landscape.

Augmented reality is an interesting technology which has increased in popularity the last couple of years. Even though we see more and more of this technology the use of it doesn?t match up to its true potential. This paper aims to investigate the possibilities of this technology and illustrate how companies can use it in their business to reach out to customers in a new and exciting way. The study consists of three parts.

This thesis is about university spin-offs and the competition in high technology industries. In the light of efforts to increase the competitiveness of the European Union, an effective transfer of cutting edge technology from universities to the industry plays an important role. University spin-offs, start-ups founded to exploit academic inventions, are likely to face considerable market entry barriers. This is among other reasons due to high capital requirements for further technology development and lack of complementary resources. With a combination of relevant literature and empirical investigation, commercialisation of technologies within spin-offs is investigated and analysed.

In modern society in terms of economics and environmental impact, it is important to ensure that a company is as energy efficient as possible to reduce the amount of energy used. About 10 TWh of electricity used annually to pump drives in Swedish industry. Therefore, pumping system has great potential for energy savings.The objective of this report was to determine how much energy and money that can be saved with the insertion of variable speed drive to six pumps on Bleach plant 4 in Skutskär Mill. The work was performed with electrical measurements during one week, analysis of pump curves and the compilation of production data over a year.The results show that four of these six pumps were profitable and yielded an annual saving of 1172 MWh of electricity and 560 000 SEK. With an economic lifetime of 10 years and a discount rate of 6.8% the final result for the entire life-cycle savings became 3 355 000 SEK.

This qualitative case study, made with four companies, looks closer at how more effective information management, with the help of IT-systems, affect companies market communication and relations to customers and suppliers. Customer Relationship Management perspective is used and Enterprise Resource Planning-systems are the ground for new technology change. The main conclusions are that new technology affects the outcome of companies? relationships towards their customers and suppliers and that the processes and activities between the involved parties are more closely linked. Also involving your suppliers and external actors makes the information handling more effective and companies that do so most likely have a competitive advantage..